InGaN/AlGaN双异质结绿光发光二极管

报道了用LP-MOVPE技术在蓝宝石(α-Al_2O_3)衬底上生长出以双掺Zn和Si的InGaN为有源区的绿光InGaN/AlGaN双异质结结构，并研制成功发射波长为520-540nm的绿光LED。

InAlGaAs/GaAs量子阱的生长及其界面特性

该文研究了以InAlGaAs作垒层的InAlGaAs/GaAs量子阱的低压金属有机化合物化学汽相淀积(LP-MOCVD)生长及其界面特性，发现在适当生长条件下可以解决InGaAs和AlGaAs在生长温度范围不兼容的问题，得到了高质量的InAlGaAs/GaAs量子阱材料。同时用X光和低温光致发光(PL)谱研究了量子阱结构的界面特性，表明适当的界面生长中断不仅可以改善界面平整度，而且能改善垒层InAlGaAs的质量。

1.27μm吸收型部分增益耦合MQW-DFB激光器

采用LP-MOCVD和LPE相结合,成功地研制出了吸收型部分增益耦合MQW-DFB激光器。扫描显微镜照片显示了清晰的被掩埋的吸收型增益耦合光栅,表明光栅掩埋生长前升温过程磷烷的保护是成功的。宽接触(broad area)脉冲电流大范围单纵模工作,条型器件室温连续直流工作阈电流为22mA至35mA,单模成品率高,边模抑制比(SMSR)超过37dB,没有观察到饱和吸收现象。

低压-金属有机物汽相外延生长的Ga（1-x）InxAs/InP激光器中深能级的研究

应用深能级瞬态谱(DLTS)技术详细研究低压-金属有机物汽相外延(LP-MOVPE)生长的Ga_(0.74)In_(0.53)As/InP量子阱、宽接触和质子轰击条形异质结激光器中的深能级。样品的DLTS表明,在宽接触激光器的i-Ga_(0.47)In(0.53)As有源层里观察到 H1(Ev+0.09eV)和E1(E_c-0.35eV)陷阱,它们可能分别与样品生长过程中扩散到i-Ga_(0.47)In_(0.53)As有源层的Zn和材料本身的原生缺陷有关。而条形激光器的i-Ga_(0.47)In_(0.53)A_s有源层的 H_2(E_v+0.11eV)和 E_2(E_q-0.42eV)陷阱则可能是H1和E1与质子轰击引起的损伤相互作用的产物 。

Fabrication of 1.3 mu m Si-based MEMS tunable optical filter

In this paper we report the fabrication of 1.3 mum Si-based MEMS tunable optical filter, by surface micromaching. Through wet etching of polyimide sacrificial layer, a tunable Fabry-Perot filter was successfully fabricated. We make the capacitance measurement of the prototype device, compare the experimental curve with the theoretical one, and explain the difference between them.

Optical characterization of the Ge/Si (001) islands in multilayer structure

We show that the observed temperature dependence of the photoluminescence (PL) features can be consistently explained in terms of thermally activated carrier transfer processes in a multilayer structure of the self-organized Ge/Si(001) islands. The type II (electron confinement in Si) behavior of the Ge/Si islands is verified. With elevated temperature, the thermally activated electrons and holes enter the Ge islands from the Si and from the wetting layer (WL), respectively. An involvement of the type I (spatially direct) into type II (spatially indirect) recombination transition takes place at a high temperature.

1.5 mu m DFB integrated with vertical tapered spotsize converter fabricated by selective MOVPE

1.5 mu m DFB LD butt-joint integrated with vertical tapered spotsize converter was fabricated by LP-MOVPE. The vertical far field angle (FWHM) was decreased from 34degrees to 10degrees the threshold currents was as low as 19.8mA, the output power was 9.6mw at 100mA without HR coating and the SMSR was 35.8dB. The 1-dBm misalignment tolerance was 3.2 mu m, while the counterpart of the device without SSC was 2.2 mu m.

SiGe/Si quantum well resonant-cavity-enhanced photodetector

Resonant-cavity-enhanced photodetectors have been demonstrated to be able to improve the bandwidth-efficiency product. We report a novel SiGe/Si multiple quantum-well resonant-cavity-enhanced photodetector fabricated on a separation-by-implanted-oxygen wafer operating near 1300nm. The buried oxide layer in SIMOX is used as a bottom mirror to form a vertical cavity with silicon dioxide/silicon Bragg reflector deposited on the top surface. The quantum efficiency at the wavelength of 1300nm is measured with 3.5% at a reverse bias of 15V, which is enhanced by 10 folds compared with a conventional photodetector with the same absorption structures.

Normal-incident SiGe/Si MQWs photodetectors operating at 1.3 mu m

A normal-incident SiGe/Si multiple quantum wells (MQWs) photodetector was reported. The structure and fabrication process of the photodetector were introduced. The photocurrent spectra measurement showed that the response spectra was expanded to 1.3 mu m wavelength. The quantum efficiency of the photodetector was 0.1% at 1.3 mu m and 20% at 0.95 mu m.

650nm AlGaInP quantum well lasers for the application of DVD

Main application of 650nm band laser diodes are for digital versatile disk (DVD). We demonstrate here the 650nm AlGaInP LD grown by LP-MOCVD with the structure of selected buried ridge waveguide. Excellent performance of LD have been achieved such as threshold current, threshold current density as low as 20mA and 350A/cm(2) respectively at room temperature, the operating temperature up to 90 for the linear power output of 5mw. RIN is about -130db/Hz, The samples of LD have been certified by PUH manufacturers.

High brightness AlGaInP orange light emitting diodes

Orange AlGaInP high brightness light emitting diodes (LEDs) were fabricated by low pressure metalorganic chemical vapor deposition(LP-MOCVD) technology. AlGaInP double heterojunction structure was used as active layer. 15 pairs of Al0.5Ga0.5As/AlAs distributed Bragg reflector and 7 mu m Al0.8Ga0.2As current spreading layer were employed to reduce the absorption of GaAs substrate and upper anode respectively. At 20mA the LEDs emitting wavelength was between 600-610nm with 18.3nm FWHM, 0.45mW radiation power and 1.7% external quantum efficiency. Brightness of the LED chips and LED lamps with 15 degrees viewing angle(2 theta(1/2)) reached 30mcd and 1000mcd respectively.

Growth and characterization of GaN on LiGaO2 and LiAlO2

The nearly lattice-matched LiGaO2 and LiAlO2 substrates have been used for the growth of GaN by LP-MOVPE. GaN epilayers have been grown on the two substrates at very low input partial pressure of hydrogen and relatively low growth temperature. The difference in the growth rate, crystal and optical qualities of hexagonal GaN epilayers grown on LiAlO2 and LiGaO2 substrate with two polar domains are investigated. LiAlO2 and LiGaO2 single crystal with a single domain structure and an adequate surface plane are promising substrates for the growth of high quality of hexagonal GaN thin films.

High performance 1.55 mu m InGaAsP/InP strained layer quantum well laser diodes fabricated by MOCVD overgrowth method

High performance uncooled 1.55 mu m InGaAsP/InP strained layer quantum well (SL-QW) lasers grown by low pressure metal organic chemical vapor deposition (LP-MOCVD) were reported in this paper. Whole MOCVD over growth method were applied in this work. The threshold currents of 5mA and the highest lasing temperature of 122 degrees C were obtained.

Visible vertical cavity surface emitting laser

We have designed and fabricated the visible vertical-cavity surface-emitting lasers (VCSEL's) by using metalorganic vapor phase epitaxy (MOVPE). We use the 8 lambda optical cavities with 3 quantum wells in AlGaInP/AlGaAs red VCSEL's to reduce the drift leakage current and enhance the model gain in AlGaInP active region. The structure has a p-type stack with 36 DBR pairs on the top and an n-type with 55-1/2 pairs on the bottom. Using micro-area reflectance spectrum, we try to get a better concordance between the center wavelength of DBR and the emitting wavelength of the active region. We used a component graded layer of 0.05 lambda thick (x = 0.5 similar to 0.9) at the p-type DBR AlGaAs/AlAs interface to reduce the resistance of p-type DBR. We use selective oxidation to define the current injection path. Because the oxidation rate of a thick layer is faster than a thinner one, we grown a thick AlAs layer close to the active region. In this way, we got a smaller active region for efficient confinement of injected carriers (the aperture area is 3 x 3 mu m) to reduce the threshold and, at the same time, a bigger conductive area in the DBR layers to reduce the resistance. We employ Zn doping on the p-side of the junction to improve hole injection and control the Zn dopant diffusion to get proper p-i-n junction. At room temperature, pulse operation of the laser has been achieved with the low threshold current of 0.8mA; the wavelength is about 670nm.

The study of single mode 650nm AlGaInP quantum well laser diodes for DVD

Single mode 650nm AlGaInP quantum well laser diodes grown by low pressure metal organic chemical vapor deposition (LP-MOCVD) was reported in this paper. Selected buried rigewaveguid were applied for single mode operation especially for DVD use. The operating temperature over 90 degree at CW output power 5 mW was achieved.