1.55μm偏振不灵敏光放大器结构材料的生长

采用张应变量子阱结构，生长了光放大器材料。利用宽接触激光器TE和TM模的输出功率曲线判断并调整量子阱材料的应变量，得到了偏振灵敏度较低的光放大器结构。

Design of Tensile Strained InGaAsP/InGaAsP MQW for 1.55μmpolarization Indepent Semiconductor Optical Amplifier

The theoretical optimization of tensile strained InGaAsP/InGaAsP MQW for 1.5μm window polarization-independent semiconductor optical amplifier is reported. The valence-band structure of the MQw is calculated by using K·P method, in which 6×6 Luttinger effective-mass Hamiltonian is taken into account. LThe polarization dependent optical gain is calculated with various well width, strain, and carrier density.

1.55μm Fabry-Perot Thermo-Optical Tunable Filter with amorphous-Si as Cavity

A 1.55μm Fabry-Perot (F-P) thermo-optical tunable filter is fabricated. The cavity is made of amorphous silicon (a-Si) layer grown by electron-beam evaporation technique. Due to the excellent thermo-optical property of a-Si, the refractive index of the F-P cavity will be changed by heating; the transmittance resonant peak will therefore shift substantially. The measured tuning range is 12nm, FWHM (full-width-at-half-maximum) of the transmission peak is 9nm, and heating efficiency is 0.1K/mW. The large FWHM is mainly due to the non-ideal coating deposition and mirror undulation. Possible improvements to increase the efficiency of heating are suggested.

镜面起伏对1.55 μm Si基MEMS光滤波器的影响

用传输矩阵方法，在简化的光学模型基础上，分别讨论了分布式Bragg反射镜DBR（Distributed Bragg Reflector）的生长精度及镜面起伏对1.55 μm Si基MEMS（Micro-Electro-Mechanical-System）可调谐光滤波器透射谱的影响。计算表明

1.55μm波长发光的自组织InAs量子点生长

通过引入较长停顿时间，采用分子束外延循环生长方法在350℃低温获得了一种横向聚合的InAs自组织量子点，在荧光光谱中观察到1.55μm波长的发光峰。通过AFM和PL谱的联合研究，表明此低温循环生长方法有利于在长波长发光的量子点的形成。

1.55μm InGaAsP-MQW自对准压缩台面高速DBF激光器

采用一种自对准压缩台面结构制作高速1.55μm DFB激光器。激光器的典型阈值为12mA，单面斜率效率达0.157mW/mA，出光功率大于20mW。由于采用窄条p-InP作为电流阻挡层，因此激光器的寄生电容可降至2.5pF，-3DB调制带宽可达9.1GHz。

多层In_(0.55)Al_(0.45)As/A_(0.5)Ga_(0.5)As量子点的变温光致发光研究

测量了自组织多层In_(0.55)Al_(0.45)As/Al_(0.5)Ga_(0.5)As量子点的变温光致发光谱，同时观察到来自浸润层和量子点的发光，首次直接观察了浸润层和量子点之间的载流子热转移。分析发光强度随温度的变化发现浸润发光的热淬灭包括两个过程

不同尺寸分布的自组织In_(0.55)Al_(0.45)As/Al_(0.5)Ga_(0.5)As量子点的静压光谱

在15K测量了不同尺寸分布的In_(0.55)Al_(0.45)As/Al_(0.5)Ga_(0.5)As量子点的静压我致发光，静压范围为0--1.3GPa。常压下观察到三个发光峰，分别来源于不同尺寸的量子点(横向直径分别为26、52和62nm)的发光。它产的压力系数分别为82、94和98meV/GPa,都小于In_(0.55)Al_(0.45)As体材料带边的压力系数，特别是尺寸为26nm的小量子点比In_(0.55)Al_(0.45)As体材料带边小17%，并且压力系数随量子点尺寸的变小而减小。理论计算表明有效质量的增在和Γ-X混合是量子点压力系数变小的主要原因，并得到横向直径为26和52nm的小量子点的Γ－X混合势为15和10meV。根据实验还确定In_(0.55)Al_(0.45)As/Al_(0.5)Ga_(0.5)As量子点系统X能带具有Ⅱ类结构，并且估算出价带不连续量为0.15±0.02。

半绝缘InP的优化生长条件以及掩埋的1.55μm激光器

于2010-11-23批量导入

Monolithic Integration of MQW DFB Laser and EA Modulator in 1.55μm

国家863计划

1.55μm InGaAsP/InP DH激光器中的0.95μm发光带与Auger复合

于2010-11-23批量导入

High performance 1.55 mu m InGaAsP/InP strained layer quantum well laser diodes fabricated by MOCVD overgrowth method

High performance uncooled 1.55 mu m InGaAsP/InP strained layer quantum well (SL-QW) lasers grown by low pressure metal organic chemical vapor deposition (LP-MOCVD) were reported in this paper. Whole MOCVD over growth method were applied in this work. The threshold currents of 5mA and the highest lasing temperature of 122 degrees C were obtained.

5×5阵列PHOSWICH闪烁探测器望远镜

描述了一个 5× 5阵列带电粒子 PHOSWICH闪烁探测器望远镜结构。它的每一个单元由 1片厚度为 1mm,面积为 2 4 mm× 2 4 mm快塑料闪烁体 NE10 2 A和 1个前表面为 2 4 mm× 2 4 mm,后表面为 37mm×37mm,厚度为 4 0 mm的 Cs I( Tl)晶体组成的。在兰州放射性离子次级束流线 ( RIBL L )上测试到 Z/ΔZ =2 0