700 resultados para Mn luminescence
Resumo:
采用离子能量为 100keV,剂量为 3× 1016cm- 2的离子注入技术,室温下往 n型 Ge( 111)单晶 衬底注入 Mn+离子,注入后的样品进行 400℃热处理.利用 X-射线衍射法 (XRD)和原子力显微 镜( AFM)对注入后的样品进行了结构和形貌分析, 俄歇电子能谱法 (AES)进行了组分分析,交变 梯度样品磁强计( AGM)进行了室温磁性测量.结果表明原位注入样品的结构是非晶的,热处理后 发生晶化现象.没有在样品中观察到新相形成. Mn离子较深的注入进 Ge衬底,在 120 nm处 Mn原子百分比浓度达到最高为 8%.热处理后的样品表现出了室温铁磁特性.
Resumo:
通过室温和350℃注Mn后热退火,在GaAs/AlGaAs超晶格中引入了不同的亚微米磁性颗粒.利用原子力显微镜、能量散射X射线谱、X射线衍射和交变梯度磁强计研究了该颗粒膜材料的结构和磁学性质.通过比较这些颗粒的饱和磁化强度、剩余磁化强度、矫顽力和剩磁比,发现350℃注Mn的样品含有MnGa和MnAs两种磁性颗粒,而室温注Mn的样品主要含有MnAs颗粒.
Resumo:
利用俄歇电子能谱(AES)和X射线衍射(XRD)分析了室温条件下离子束外延生长Ga、Mn、As样品,在不同的温度条件下进行退火后组分和元素分布的变化.结果表明退火有助于样品内部元素的均匀分布,温度为400 ℃会导致MnO2和Ga5.2Mn的结晶.
Resumo:
利用低能双离子束外延技术,在400 ℃条件下生长样品(Ga, Mn, As)/GaAs。样品光致发光谱出现三个峰,即1.5042eV处的GaAs激子峰、1.4875eV处的弱碳峰和低能侧的一宽发光带。宽发光带的中心位置在1.35eV附近,半宽约0.1eV在840 ℃条件下对样品进行退火处理,退火后的谱结构类似退火前,但激子峰和碳杂质峰的峰位分别移至1.5066eV和1.4894eV,同时低能侧的宽发光带的强度大大增加。这一宽发射的来源还不清楚,原因可能是体内杂质和缺陷形成杂质带,生成Mn_2As新相,Mn占Ga位或形成GaMnAs合金。
Resumo:
国家攀登计划,国家973计划
Resumo:
主要采用了X射线衍射、Mossbauer谱、磁测量等方法系统研究了块体巨磁电阻材料La_(2/3)Ca_(1/3)Mn_(1-x)Fe_xO_3在不同铁含量(0≤x≤0.84)时结构、性能、磁性的变化,并给予合理的解释。在0
Resumo:
于2010-11-23批量导入
Resumo:
Erbium-doped silica glasses were made by sol-gel process. Intensive photoluminescence (PL) spectra from the Er-doped silica glasses at room temperature were measured. A broadband peak at 1535 ma, corresponding to the I-4(13/2)-I-4(15/2) transition, its full width at half-maximum (FWHM) of 10 nm, and a shoulder at 1546 nm in the PL spectra were observed. At lower temperatures, main line of 1535 nm and another line of 1552 Mn instead of 1546 nm appear. So two types of luminescence centers must exist in the samples at different temperature. The intensity of main line does not decrease obviously with increasing temperature. By varying the Er ion concentration in the range of 0.2 wt% - 5wt%, the highest photoluminescence intensity was obtained at 0.2wt% erbium doped concentration. Luminescence intensity decreases with increasing erbium concentration. Cooperative upconversion was used to explain the concentration quenching of luminescence from silica glass with high erbium concentration. Extended X-ray absorption fine structure measurements were carried out. It was found that the majority of the erbium impurities in the glasses have a local structure of eight first neighbor oxygen atoms at a mean distance of 0.255 nm, which is consistent with the typical coordination structure of rare earth ion.
Resumo:
Unintentionally doped and Si-doped single crystal n-GaN films have been grown on alpha-Al2O3 (0001) substrates by LP-MOCVD. Room temperature photoluminescence measurement showed that besides the bandedges, the spectrum of an undoped sample was a broad deep-level emission band peaking from 2.19 to 2.30eV, whereas the spectrum for a Si-doped sample was composed of a dominant peak of 2.19eV and a shoulder of 2.32eV. At different temperatures, photoconductance buildup and its decay were also observed for both samples.. The likely origins of persistent photoconductivity and yellow luminescence, which might be associated with deep defects inclusive of either Ga vacancy(V-Ga)/Ga vacancy complex induced by impurities or N antisite (N-Ga), will be proposed.
Resumo:
In this study, we report the dependences of infrared luminescence properties of Er-implanted GaN thin films (GaN:Er) on the kinds of substrates used to grow GaN, the growth techniques of GaN, the implantation parameters and annealing procedures. The experimental results showed that the photoluminescence (PL) intensity at 1.54 mum was severely influenced by different kinds of substrates. The integrated PL peak intensity from GaN:Er /Al2O3 (00001) was three and five times stronger than that from GaN:Er /Si (111) grown by molecular beam epitaxy (MBE) and by metalorganic chemical vapor deposition (MOCVD), respectively. The PL spectra observed from GaN:Er/Al2O3 (0001) grown by MOCVD and by MBE displayed a similar feature, but those samples grown by MOCVD exhibited a stronger 1.54 mum PL. It was also found that there was a strong correlation between the PL intensity with ion implantation parameters and annealing procedures. Ion implantation induced damage in host material could be only partly recovered by an appropriate annealing temperature procedure. The thermal quenching of PL from 15 to 300 K was also estimated. In comparison with the integrated PL intensity at 15 K, it is reduced by only about 30 % when going up to 300 K for GaN:Er/Al2O3 sample grown by MOCVD. Our results also show that the strongest PL intensity comes from GaN:Er grown on Al2O3 substrate by MOCVD. (C) 2004 Elsevier B.V. All rights reserved.
Resumo:
The ground and excited state excitonic transitions of stacked InAs self-organized quantum dots (QDs) in a laser diode structure are studied. The interband absorption transitions of QDs are investigated by non-destructive PV spectra, indicating that the strongest absorption is related to the excited states with a high density and coincides with the photon energy of lasing emission. The temperature and excitation (electric injection) intensity dependences of photoluminescence and electroluminescence indicate the influence of state filling effect on the luminescence of threefold stacked QDs. The results indicate that different coupling channels exist between electronic states in both vertical and lateral directions.
Resumo:
CdS/ZnS core/shell nanocrystals were prepared from an aqueous/alcohol medium. A red shift of the absorption spectrum and an increase of the room temperature photoluminescence intensity accompanied shell growth.
Resumo:
We analyze low-temperature Raman and photoluminescence spectra of MBE-grown GaN layers on sapphire. Strong and sharp Raman peaks are observed in the low frequency region. These peaks, which are enhanced by excitation in resonance with yellow luminescence transitions, are attributed to electronic transitions related to shallow donor levels in hexagonal GaN. It is proposed that a low frequency Raman peak at 11.7 meV is caused by a pseudo-local vibration mode related to defects involved in yellow luminescence transitions. The dependence of the photoluminescence spectra on temperature gives additional information about the residual impurities in these GaN layers.
Resumo:
This paper describes the design and fabrication process of a two-dimensional GaAs-based photonic crystal nanocavity with InAs quantum dots (QDs) emitters and analyzes the optical characteristics of cavity modes at room temperature. The micro-luminescence spectrum recorded from the nanocavities exhibits a narrow optical transition at the lowest order resonance wavelength of about 1137 nm with about 1 nm emission linewidth. In addition, the spectra of photonic crystal nanocavities processed under different etching conditions show that the verticality of air hole sidewall is an important factor determing the luminescence characteristics of photonic crystal nanocaivties. Finally,,the variance of resonant modes is also discussed as a function of r/a ratio and will be used in techniques aimed at improving the probability of achieving spectral coupling of a single QD to a cavity mode.