PHOTOLUMINESCENCE STUDIES OF INXGA1-XAS/GAAS STRAINED QUANTUM-WELLS UNDER HYDROSTATIC-PRESSURE

The photoluminescence from InxG1-xAs/GaAs strained quantum wells with thickness from 30 to 160 angstrom have been studied at 77 K under hydrostatic pressure up to 60 kbar. It was found that the pressure coefficients of the exciton peaks corresponding to transitions from the first conduction subband to the heavy-hole subband increased with reduced well width, in contrast to the case of GaAs/AlxGa1-xAs quantum wells. Calculations revealed that the increased barrier height with pressure was the major cause of the change in the pressure coefficients. Two peaks related to indirect transitions were observed at pressures higher than 50 kbar. They are attributed to type-I transitions from the lowest conduction-band edge, which are the strain splitted X(xy) valleys, to the heavy-hole subband in the InxGa1-xAs well.

PRESSURE BEHAVIOR OF INXGA1-XAS/GAAS STRAINED QUANTUM-WELLS WITH DIFFERENT WIDTHS

The photoluminescence of InxGa1-xAs/GaAs strained quantum wells with widths of 30 angstrom to 160 angstrom have been studied at 77 K under hydrostatic pressure up to 60 kbar. It is found that the pressure coefficients of exciton peaks from 1st conduction subband to heavy hole subband increase from 9.74 meV/kbar for a 160 angstrom well to 10.12 meV/kbar for a 30 angstrom well. The calculation based on the Kronig-Penney model indicated that the extension of the electronic wave function to the barrier layer in the narrow wells is one of the reasons for the increase of the pressure coefficients with the decrease of well width. Two peaks related to indirect transitions were observed at pressures higher than 50 kbar.

GSMBE growth and characterization of InxGa1-xAs/InP strained-layer MQWs in a P-i-N configuration

InxGa1-xAs/InP (0.39 less than or equal to x less than or equal to 0.68) strained-layer quantum wells having 20 wells with thickness of 50 Angstrom in a P-i-N configuration were grown by gas source molecular beam epitaxy (GSMBE). High-resolution X-ray diffraction rocking curves show the presence of up to seven orders of sharp and intense satellite reflection, indicative of the structural perfection of the samples. Low-temperature photoluminescence and low-temperature absorption spectra were used to determine the exciton transition energies as a function of strain. Good agreement is achieved between exciton transition energies obtained experimentally at low temperature with those calculated using the deformation potential theory.

Electroluminescence and photoluminescence of Si/SiGe self-assembly quantum dot structures

Comparative electroluminescence (EL) and photoluminescence (PL) measurements were performed on Si/Si0.6Ge0.4 self-assembly quantum dots (QDs) structures. The samples were grown pseudomorphically by molecular beam epitaxy, and PIN diodes for electroluminescence were fabricated. Assisted TEM pictures shows the SiGe self-assembly QDs are platelike. And it showed that the diameters of QDs are in range from 40nm to 140nm with the most in 120nm. Both EL and PL has a wide luminescence peak due to wide distribution of QDs dimensions. At low temperature (T=14K), EL peak has a red shift compared to the corresponding PL peak. Its full-width at half-maximum (FWHM) is about 97meV, a little smaller than that of corresponding PL peak. The reasons of position and FWHM changes of EL peak from QDs have been discussed.

Synthesis of carbon nanotube bundles with mesoporous structure by a self-assembly solvothermal route

A kind of carbon nanotube bundle has been synthesized by a simple one-step solvothermal reaction between Na and hexachlorobenzene (HCB) using NiCl2 as catalyst precursor. Before the reaction, NiCl2 was initially dispersed ultrasonically in cyclohexane then prereduced by Na at 230degreesC to produce small Ni particles in reduced state. The tubes thus-produced have a uniform outer diameter of about 20 nm, an inner diameter of 4 nm, and are highly ordered assembled as bundles which have a 2D hexagonal arrangement as proven by SAXS and TEM experiments.