CONSTRUCTION AND APPLICATIONS OF A DUAL MASS-SELECTED LOW-ENERGY ION-BEAM SYSTEM

A direct ion beam deposition system designed for heteroepitaxy at a low substrate temperature and for the growth of metastable compounds has been constructed and tested. The system consists of two mass-resolved low-energy ion beams which merge at the target with an incident energy range 50-25 000 eV. Each ion beam uses a Freeman ion source for ion production and a magnetic sector for mass filtering. While a magnetic quadrupole lens is used in one beam for ion optics, an electrostatic quadrupole lens focuses the other beam. Both focusing approaches provide a current density more than 100-mu-A/cm2, although the magnetic quadrupole gives a better performance for ion energies below 200 eV. The typical current of each beam reaches more than 0.3 mA at 100 eV, with a ribbon beam of about 0.3-0.5 x 2 cm2. The target is housed in an ultrahigh vacuum chamber with a base pressure of 1 x 10(-7) Pa and a typical pressure of 5 x 10(-6) Pa when a noncondensable beam like argon is brought into the chamber. During deposition, the target can be heated to 800-degrees-C and scanned mechanically with an electronic scanning control unit. The dual beam system has been used to grow GaN using a Ga+ and a N+ beam, and to study the oxygen and hydrogen ion beam bombardment effects during carbon ion beam deposition. The results showed that the simultaneous arrival of two beams at the target is particularly useful in compound formation and in elucidation of growth mechanisms.

ON THE FORMATION OF THE SBGA HETEROANTISITE IN METALORGANIC VAPOR-PHASE EPITAXIAL GAAS-SB

Metalorganic vapor-phase epitaxial growth of GaAs doped with isovalent Sb is reported. By increasing the trimethylantimony concentration during growth the total Sb concentration was varied between 1 X 10(17)-1 X 10(19) cm-3. A new deep level defect with an activation energy of the thermal emission rates of E(c) - 0.54 eV is observed. The defect concentration increases with increasing As partial pressure and with increasing Sb doping. It is also found that the EL2 concentration decreases with increasing Sb doping. The new energy level is suggested to be the 0/ + transition of the Sb(Ga) heteroantisite defect. No photocapacitance quenching effect, reflecting a metastable state as seen for EL2 (As(Ga)), is observed for Sb(Ga).

AN ANALYSIS OF CHARGE STATES FOR LOCAL VIBRATIONAL-MODES BY OXYGEN DEFECTS IN SEMI-INSULATING GAAS

The high-resolution spectral measurements for new local vibrational modes near 714 cm-1 due to the oxygen defect in semi-insulating GaAs are analyzed on the basis of a model calculation by self-consistent bond orbital approach. Two charge states of oxygen atom with 1 and 2 extra electrons are assigned to be responsible for these local modes. The observed frequencies are explained by the properties of Ga-O-1 and Ga-O-2 bonds and the calculated cohesive energy indicates that the O-2 state is stable. The results are in good agreement with the kinetic analysis.

Optical and structural properties of anodized AlxGa1-xAs layers

The optical and structural properties of anodized AlxGa1-xAs films were investigated by using optical reflectance, X-ray photoemission and Auger electron spectroscopy (XPS and AES). II was found that the anodization process occurs progressively from the surface to the bulk of AlxGa1-xAs and the formed oxidation film comprises mainly oxides of Al and Ga together with a relatively small amount of As. The refractive indexes of the anodized Al0.8Ga0.2As film and Al0.8Ga0.2As film itself were deduced to be about 1.80 and 3.25, respectively, indicating that the anodization film is desirable for anti-reflection coating of the surface of AlxGa1-xAs/GaAs solar cells. (C) 1997 Elsevier Science S.A.

Stoichiometric defects in semi-insulating GaAs

The influences of arsenic interstitials and dislocations on the lattice parameters of undoped semi-insulating (SI) GaAs single crystals were analyzed. It was shown that the dislocations in such crystals serve as effective gettering sites for arsenic interstitials due to the deformation energy of dislocations. The average excess arsenic in GaAs epilayers grown by molecular-beam epitaxy (MBE) at low temperatures (LT) is about 1%, and the lattice parameters of these epilayers are larger than those of liquid-encapsulated Czochralski-grown (LEG) SI-GaAs by about 0.1%. The atomic ratio, [As]/([Ga] + [As]), in SI-GaAs grown by low-pressure (LP) LEC is the nearest to the strict stoichiometry compared with those grown by high-pressure (HP) LEC and vertical gradient freeze (VGF). After multiple wafer annealing (MWA), the crystals grown by HPLEC become closer to be strictly stoichiometric.

Photoluminescence and activation on SI-GaAs by Si+ implantation and following rapid thermal annealing

Photoluminescence (PL) and electrical characteristics of SI-GaAs, Si+-implanted and following rapid thermal annealing (RTA), were investigated, The PL spectra of Si-GA-C-As, Ga-i-Si-As, and V-As-Si-As were obtained. This paper concentrates on the PL peak at 1.36 eV which was proven as an emission of the Si-Ga-V-Ga combination by Si+ + P+ dual implantation. The results indicate that the peak at 1.36 eV appears when the ratio of As:Ga increased during the processing. Also high activation was obtained for the sample under the same conditions. More discussion on the mechanism of Si+ implanted SI-GaAs has been made based on the Morrow model [J. Appl. Phys, 64 (1988) 1889].

Electronic properties of zinc-blende GaN, AlN, and their alloys Ga1-xAlxN

The electronic properties of wide-energy gap zinc-blende structure GaN, A1N, and their alloys Ga(1-x)A1(x)N are investigated using the empirical pseudopotential method. Electron and hole effective mass parameters, hydrostatic and shear deformation potential constants of the valence band at Gamma and those of the conduction band at Gamma and X are obtained for GaN and AIN, respectively. The energies of Gamma, X, L conduction valleys of Ga(1-x)A1(x)N alloy versus Al fraction x are also calculated. The information will be useful for the design of lattice mismatched heterostructure optoelectronic devices based on these materials in the blue light range application. (C) 1995 American Institute of Physics.

OPTICAL AND STRUCTURAL-PROPERTIES OF AP-MOVPE GAINP/GAAS HETEROSTRUCTURES

Lattice matched GaInP/GaAs heterostructures were grown by atmospheric pressure-metal organic vapor phase epitaxy (AP-MOVPE). Compositional intermixing of As/P and Ga/In near the heterointerfaces was studied by photoluminescence (PL) spectroscopy. Indium segregation, memory effect of In into GaAs and the carry-over of As in the GaInP layer during the growth process were considered as three major factors giving rise to the anomalous emissions in the PL spectra. Both thermal annealing and zinc doping strongly enhanced the compositional interdiffusion near the heterointerfaces.

Zn杂质扩散诱导AlGaInP/GaInP量子阱混杂

杂质扩散诱导量子阱混杂技术可用于制作腔面非吸收窗口,提高大功率半导体激光器的输出功率。以Zn_3As_2为扩散源,采用闭管扩散方式,在550℃下对650nm半导体激光器的外延片进行了一系列Zn杂质扩散诱导量子阱混杂的实验。实验发现,随着扩散时间从20～120min,样品光致发光(PL)谱蓝移偏移增加,峰值波长蓝移53nm;当扩散时间超过60min后,样品的PL谱中不仅出现了常见的蓝移峰,同时还出现了红移峰,峰值波长红移32nm。分析表明PL谱蓝移来自Zn扩散引起的AlGaInP/GaInP间的量子阱混杂;红移来自Zn杂质扩散对样品中Ga_(0.51)In_(0.49)P缓冲层的影响。还研究了扩散温度(550℃)和扩散时间对样品晶体品质的影响,并在理论上计算了AlGaInP/GaInP量子阱混杂中的Al-Ga的互扩散系数。

Morphology Evolution of (331)A High-Index Surfaces During Atomic Hydrogen Assisted Molecular Beam Epitaxy (MBE)

Step like morphology of (331)A high-index surfaces during atomic hydrogen assisted molecular beam epitaxy (MBE) growth has been investigated. Atomic Force Microscope (AFM) measurements show that in conventional MBE, the step heights and terrace widths of GaAs layers increase monotonically with increasing substrate temperatures. The terrace widths and step densities increase with increasing the GaAs layer thickness and then saturates. And, in atomic hydrogen assisted MBE, the terrace width reduces and density increases when depositing the same amount of GaAs. It attributes this to the reduced surface migration length of Ga adatoms with atomic hydrogen. Laterally ordered InAs self-aligned nano-wires were grown on GaAs (331)A surfaces and its optical polarization properties were revealed by photoluminescence measurements.

解理面预处理方法对二次外延的影响

利用超晶格解理面方法制备定位生长的InAs量子线．首先以分子束外延技术在GaAs衬底上生长GaAs／AlGaAs超晶格，然后将样品取出外延系统进行解理，对解理面进行预处理之后在（110）解理面上进行二次外延．实验结果显示超晶格解理面的预处理方法对二次外延有重大影响，其中择优腐蚀比自然氧化更有利于量子线的定位生长，过高温度的脱氧除气会导致解理面的GaAs部分出现坑状结构，表明（110）面上的Ga原子容易脱附．同时，Ga原子在（110）面上的迁移长度比较大，原子的择优扩散方向为[001-bar]方向．

表面处理对p-GaN欧姆接触的影响

分别用稀盐酸、王水以及(NH_4)_2S溶液处理p-GaN表面,通过测试样品表面Ols的X射线光电子能谱(XPS),比较了这些溶液去除p-GaN表面氧化层的能力;在经不同溶液处理后的样品表面,以相同的条件制作Ni/Au电极,并测试其与p-GaN的比接触电阻,结果表明经稀盐酸处理后的样品表面,由于其氧含量较高,不能与Ni/Au形成良好的欧姆接触,而经王水和(NH_4)_2S溶液处理后的p-GaN表面,能与Ni/Au形成良好的欧姆接触;最后,通过比较样品表面的Ga/N原子浓度比,探讨了王水处理p-GaN表面能够形成良好欧姆接触的原因.

稀磁半导体的研究进展

本文主要介绍了III-V族稀磁半导体(Ga,Mn)As的研究进展,包括(Ga,Mn)As的生长制备、基本磁性质、磁输运特征、磁光性质、磁性起源、相关的异质结构和自旋注入等,同时还简单介绍了其它稀磁半导体如IV族、III-VI族和IV-VI族等稀磁半导体的研究进展,在文章的最后描述了理想的稀磁半导体应该具备的特征以及对未来的展望。

GaAs基上的InAs量子环制备

在分子束外延系统中,利用3 nm GaAs薄盖层将InAs自组装量子点部分覆盖,然后在500℃以及As_2气氛中退火一分钟,制成纳米尺度的InAs量子环.这一形成敏感地依赖于退火时的生长条件和生长InAs自组装量子点时的淀积量.InAs在GaAs表面的扩散以及同时发生的In-Ga互混控制着InAs量子环的形成.