256 resultados para AlN powders
Resumo:
An AlGaN/GaN HBT structure was grown by low-pressure metalorganic chemical vapor deposition (MOCVD) on sapphire substrate. From the high-resolution x-ray diffraction and transmission electron microscopy (TEM) measurements, it was indicated that the structure is of good quality and the AlGaN/GaN interfaces are abrupt and smooth. In order to obtain the values of Si doping and electronic concentrations in the AlGaN emitter and GaN emitter cap layers, Secondary Ion Mass Spectroscopy (SIMS) and electrochemical CV measurements were carried out. The results showed that though the flow rate of silane (SiH4) in growing the AlGaN emitter was about a quarter of that in growing GaN emitter cap and subcollector layer, the Si sputtering yield in GaN cap layer was much smaller than that in the AlGaN emitter layer. The electronic concentration in GaN was about half of that in the AlGaN emitter layer. It is proposed that the Si, Al co-doping in growing the AlGaN emitter layer greatly enhances the Si dopant efficiency in the AlGaN alloy. (c) 2006 WILEY-VCH Verlag GmbH & Co KGaA, Weinheim.
Resumo:
The influence of band bending and polarization on the valence band offset measured by x-ray photoelectron spectroscopy (XPS) is discussed, and a modification method based on a modified self-consistent calculation is proposed to eliminate the influence and thus increasing the precision of XPS. Considering the spontaneous polarization at the surfaces and interfaces and the different positions of Fermi levels at the surfaces, we compare the energy band structures of Al/Ga-polar AlN/GaN and N-polar GaN/AlN heterojunctions, and give corrections to the XPS-measured valence band offsets. Other AlN/GaN heterojunctions and the piezoelectric polarization are also introduced and discussed in this paper.
Resumo:
X-ray photoelectron spectroscopy has been used to measure the valence band offset (VBO) of the w-InN/h-BN heterojunction. We find that it is a type-II heterojunction with the VBO being -0.30 +/- A 0.09 eV and the corresponding conduction band offset (CBO) being 4.99 +/- A 0.09 eV. The accurate determination of VBO and CBO is important for designing the w-InN/h-BN-based electronic devices.
Resumo:
We report on an aluminum oxynitride (AlON) film which was successfully made using the reactiver r.f. sputtering method in an N2-O2 mixture. The fabrication process, atomic components, breakdown field and refractive index of the AlON film are shown in detail. The AlON film is a new polyfilm combining the good properties of Al2O3 and AlN, and it is very interesting with regard to optoelectronic devices and integrated optic circuits.
Resumo:
After x-irradiation for 10 s, luminescence from BaFBr:Eu2+ phosphors by photostimulation of longer wavelength than F absorption bands was observed and assigned to the surface states or intrinsic defects of the powders. It is found that the luminescence by photostimulation into F bands can be reduced via electron migration from F centers into the surface states or intrinsic defects, thus reducing the x-ray storage or image stability. Surface passivation can lower these defects and improve the phosphors or imaging plate quality. (C) 1996 American Institute of Physics.
Resumo:
用电子束蒸发方法在Si(111)衬底上蒸发了Au/Cr和Au/Ti/Al/Ti两种金属缓冲层,然后在金属缓冲层上用气源分子束外延(GSMBE)生长GaN.两种缓冲层的表面都比较平整和均匀,都是具有Au(111)面择优取向的立方相Au层.在Au/Cr/Si(111)上MBE生长的GaN,生长结束后出现剥离.在Au/Ti/Al/Ti/Si(111)上无AlN缓冲层直接生长GaN,得到的是多晶GaN;先在800℃生长一层AlN缓冲层,然后在710℃生长GaN,得到的是沿GaN(0001)面择优取向的六方相GaN.将Au/Ti/Al/Ti/Si(111)在800℃下退火20min,金属层收缩为网状结构,并且成为多晶,不再具有Au(111)方向择优取向.
Resumo:
分别在金属有机化学汽相沉积(MOCVD)生长的i-Al0.33Ga0.67N/AlN/n-GaN和p-Al0.45Ga0.55N/i—Al0.45Ga0.55N/n+-Al0.65Ga0.35N的异质结构上,成功研制了太阳盲区的肖特基型和PIN型紫外探测器。研究结果表明,Au与i—Al0.33Ga0.67N形成了较好的肖特基结,响应波长从250—290nm,峰值(286nm)响应率约为0.08A/W;PIN型紫外探测器的响应波长从230~275nm,峰值(246nm)响应率约为0.02A/W。
Resumo:
The results of second-order Raman-scattering experiments on n- and p-type 4H-SiC are presented,covering the acoustic and the optical overtone spectral regions.Some of the observed structures in the spectra are assigned to particular phonon branches and the points in the Brillouin zone from which the scattering originates.There exists a doublet at 626/636cm-1 with energy difference about 10cm-1 in both n- and p-type 4H-SiC,which is similar to the doublet structure with the same energy difference founded in hexagonal GaN,ZnO, and AlN.The cutoff frequency at 1926cm-1 of the second-order Raman is not the overtone of the A1(LO) peak of the n-type doping 4H-SiC,but that of the undoping one.The second-order Raman spectrum of 4H-SiC can hardly be affected by doping species or doping density.
Resumo:
采用AlN插入层技术在Si(111)衬底上实现无微裂GaN MOCVD生长.通过对GaN外延层的a,c轴晶格常数的测量,得到了GaN所受张应力与AlN插入层厚度的变化关系.当AlN厚度在7~13nm范围内,GaN所受张应力最小,甚至变为压应力.因此,GaN微裂得以消除.同时研究了AlN插入层对GaN晶体质量的影响,结果表明,许多性能相比于没有AlN插入层的GaN样品有明显提高.
Resumo:
利用衍衬、SAED、HRTEM对在(111)Si上外延生长的六方GaN进行了观察分析。GaN外延层与缓冲层和基底的取向关系为(0001)_(GaN)∥(0001)_(AlN)∥(111)_(Si),[11(2-bar)0]_(GaN)∥[11(2-bar)0]_(AlN)∥[110]_(Si)。GaN外延层中存在倒反畴。GaN中位错以刃型位错为主。In_(0.1) Ga_(0.9) N/GaN的多重量子阱结构(MQW)具有阻挡穿透位错,降低位错密度的作用。
Resumo:
介绍了用NH_3-MBE技术在蓝宝石C面上外延的高质量的GaN单层膜以及GaN/AlN/GaN极化感应二维电子气材料。外延膜都是N面材料。形成的二维电子气是“倒置二维电子气”。GaN单层膜的室温电子迁移率为300cm~2/Vs。二维电子气材料的迁移率为680cm~2/Vs(RT)和1700cm~2/Vs(77K),相应的二维电子气的面密度为3.2×10~(13)cm~(-2)(RT)和2.6×10~(13)cm~(-2)(77K)。
Resumo:
High quality crack free GaN epilayers were grown on Si(111) substrates. Low temperature AlN interlayer grown under low V/III ratio was used to effectively eliminate the formation of micro-cracks. It is found that tensile stress in the GaN epilayer decreases as the N/Al ratio decreases used for AlN interlayer growth. The high optical and structural qualities of the GaN/Si samples were characterized by RBS, PL and XRD measurements. The RT-PL FWHM of the band edge emission is only 39.5meV The XRD FWHM of the GaN/Si sample is 8.2arcmin, which is among the best values ever reported.
Resumo:
Metal-semiconductor-metal (MSM) structures were fabricated by RF-plasma-assisted MBE using different buffer layer structures. One type of buffer structure consists of an AlN high-temperature buffer layer (HTBL) and a GaN intermediate temperature buffer layer (ITBL), another buffer structure consists of just a single A IN HTBL. Systematic measurements in the flicker noise and deep level transient Fourier spectroscopy (DLTFS) measurements were used to characterize the defect properties in the films. Both the noise and DLTFS measurements indicate improved properties for devices fabricated with the use of ITBL and is attributed to the relaxation of residue strain in the epitaxial layer during growth process. (C) 2003 Elsevier Ltd. All rights reserved.
Resumo:
High-quality GaN epilayers were consistently obtained using a home-made gas-sourer MBE system on sapphire substrates. Room-temperature electron mobility of the grown GaN film is 300 cm(2)/V s with a background electron concentration as low as 2 x 10(17) cm(-3) The full-width at half-maximum of the GaN (0 0 0 2) double-crystal X-ray rocking curve is 6 arcmin. At low temperature (3.5 K), the FWHM of the: near-band-edge photoluminescence emission line is 10 meV. Furthermore, using piezoelectric effect alone with the high-quality films, two-dimensional electron gas was formed in a GaN/AlN/GaN/sapphire structure. Its room-temperature and low-temperature (77 K) electron mobility is 680 cm(2)/V s and 1700 cm(2)/V s, and the corresponding sheet electron density is 3.2 x 10(13) and 2.6 x 10(13) cm(-2), respectively. (C) 2001 Published by Elsevier Science.
Resumo:
Epitaxial growth of SiC on complex substrates was carried out at substrate temperature from 1200 degreesC to 1400 degreesC. Three kinds of new complex substrates, c-plane sapphire, AlN/sapphire, and GaN/AlN/sapphire, were used in this study. We obtained a growth rate in the range of 1-6 mum/h. Thick (6 mum) SIC epitaxial layers with no cracks were successfully obtained on AlN/sapphire and GaN/AlN/sapphire substrates. X-ray diffraction patterns have confirmed that single-crystal SiC was obtained on these complex substrates. Analysis of optical transmission spectra of the SIC grown on sapphire substrates shows the lowest-energy gap near 2.2 eV, which is the value for cubic SiC. The undoped SIC showed n-type electrical conductivity. (C) 2001 Elsevier Science B.V. All rights reserved.