Deep levels in high resistivity GaN epilayers grown by MOCVD

Undoped high resistivity (HR) GaN epilayers were grown on (0001) sapphire substrate by metalorganic chemical vapor deposition (MOCVD). Thermally stimulated current (TSC) and resistivity measurements have been carried out to investigate deep level traps. Deep levels with activation energies of 1.06eV and 0.85eV were measured in sample 1. Gaussian fitting of TSC spectra showed five deep levels in different samples. (c) 2006 WILEY VCH Vertag GmbH & Co. KGaA, Weinheim

Study on surface morphology of GaN growth by MOCVD on GaN/Si(111) template

The surface morphology of GaN grown by MOCVD on GaN/Si template was studied. Rough morphology and deep pinhole defects on some surface areas of the samples were observed and studied. The formation of rough morphology is possibly related to Ga-Si alloy produced due to poor thermal stability of template at high temperature. The deep pinhole defects generated are deep down to the surface of MBE-grown GaN/Si template. The stress originated from the large thermal expansion coefficient difference between GaN and Si may be related to the formation of the pinhole defects. The surface morphology of the GaN can be improved by optimizing the GaN/Si template and decreasing the growth temperature.

Growth and characterization of semi-insulating GaN films grown by MOCVD

High resistivity unintentionally doped GaN films were grown on (0001) sapphire substrates by metalorganic chemical vapor deposition. The surface morphology of the layer was measured by both atomic force microscopy and scanning electron microscopy. The results show that the films have mirror-like surface morphology with root mean square of 0.3 nm. The full width at half maximum of double crystal X-ray diffraction rocking curve for (0002) GaN is about 5.22 arc-min, indicative of high crystal quality. The resistivity of the GaN epilayers at room temperature and at 250 degrees C was measured to be approximate 10(9) and 10(6) Omega(.)cm respectively, by variable temperature Hall measurement. Deep level traps in the GaN epilayers were investigated by thermally stimulated current and resistivity measurements.

High-performance EML grown on taper-masked pattern substrates by ultra-low-pressure MOCVD

A novel in-plane bandgap energy controlling technique by ultra-low pressure (22 mbar) selective area growth (SAG) has been developed. To our knowledge, this is the lowest pressure condition during SAG process ever reported. In this work, high crystalline quality InGaAsP-InP MQWs with a photoluminescence (PL) full-width at half-maximum (FWHM) of less than 35meV are selectively grown on mask-patterned planar InP substrates by ultra-low pressure (22 mbar) metal-organic chemical vapor deposition (MOCVD). In order to study the uniformity of the MQWs grown in the selective area, novel tapered masks are designed and used. Through optimizing growth conditions, a wide wavelength shift of over 80 nm with a rather small mask width variation (0-30 mu m) is obtained. The mechanism of ultra-low pressure SAG is detailed by analyzing the effect of various mask designs and quantum well widths. This powerful technique is then applied to fabricate an electroabsorption-modulated laser (EML). Superior device characteristics are achieved, such as a low threshold current of 19mA and an output power of 7mW. (c) 2005 Elsevier B.V. All rights reserved.

MOCVD设备研制及氮化物材料生长研究

Submitted by 阎军 (yanj@red.semi.ac.cn) on 2010-06-08T13:11:28Z No. of bitstreams: 1 MOCVD设备研制及氮化物材料生长研究—殷海波-200718013626085.pdf: 3776668 bytes, checksum: efab1d75bd6d03744fd23a7a554f17e7 (MD5)

InN layers grown by MOCVD on SrTiO3 substrates

Epitaxial wurtzite InN thin films have been grown by metal-organic chemical vapor deposition on (1 1 1) SrTiO3 (STO) substrates. Interestingly, twin domain epitaxy induced by the surface reconstruction of STO is observed with the in-plane orientation relationships of [(1) over bar 1 0 0]InN parallel to [<(1)over bar > 1 0]STO and [2 <(1 1)over bar > 0]InN parallel to[<(1)over bar > 1 0]STO, which is helpful to release the strain. The InN films on STO substrates exhibit a strong photoluminescence emission around 0.78 eV. Particularly, using STO substrates opens up a possibility to integrate InN with the functional oxides. (C) 2009 Elsevier B.V. All rights reserved

ZnO 材料的MOCVD 生长研究

Submitted by 阎军 (yanj@red.semi.ac.cn) on 2010-04-07T05:45:44Z No. of bitstreams: 1 王振华-ZnO材料的MOCVD生长研究.pdf: 1940715 bytes, checksum: 24795c3f40c326b4bbc7fa587639975e (MD5)

ZnMgO合金材料的MOCVD生长及物性研究

Submitted by 阎军 (yanj@red.semi.ac.cn) on 2010-04-07T06:58:54Z No. of bitstreams: 1 杨安丽-ZnMgO合金材料的MOCVD生长及物性研究.pdf: 4721220 bytes, checksum: 6fe8feefb955f1426360aab6207d8f74 (MD5)

SrTiO3衬底上MOCVD生长ZnO和InN薄膜

Submitted by 阎军 (yanj@red.semi.ac.cn) on 2010-06-02T02:26:43Z No. of bitstreams: 1 贾彩虹.pdf: 7912674 bytes, checksum: c12b25fca62da81c5084da11c9f12e7a (MD5)

InGaN薄膜材料的MOCVD生长及物性研究

Submitted by 阎军 (yanj@red.semi.ac.cn) on 2010-06-07T01:04:23Z No. of bitstreams: 1 郭严博士论文.pdf: 26872311 bytes, checksum: 3c26f92ff401022162e7b6407ef6a1ae (MD5)