Nd65Al10Fe25-xCox (x=0,5,10) bulk metallic glasses with wide supercooled liquid regions

Bulk metallic glasses of Nd65Al10Fe25-xCox (x=0,5,10) have been prepared in the form of 3 mm diam rods. Results of differential scanning calrimetry, dynamic mechanical thermal analysis (DMTA), and x-ray diffraction are presented for these alloys. It is shown that the glass transition and crystallization have been observed by DMTA. The reduced glass transition temperature of these glasses, defined as the ratio between the glass transition temperature T-g and the melting temperature T-l is in the range from 0.55 to 0.62. All these glasses have a large supercooled liquid region (SLR), ranging from 80 to 130 K. The high value of reduced glass transition temperature and wide SLR agree with their good glass formation ability.

High-pressure sintering study of a novel hard material (W0.5Al0.5)C-0.5 without binder metal

A novel hard material of (W0.5Al0.5)C-0.5 has been successfully sintered under high-pressure (4.5 GPa). The influence of sintering time and temperature on the microstructure, Vickers microhardness and density of the as-prepared specimens are well described. Interestingly, sintering temperature has an amazing influence on the hardness, density and microstructure of the specimen while the sintering time does not. It is found that the most suitable sintering condition from our work is 1600 degrees C and 10 min under pressure of 4.5 GPa. The hardness and relative density of the as-prepared sample can reach 2340 kg mm(-2) and 98.62%, respectively. The cell parameters of the sintered specimen is found to be little smaller than that of the powder, which we propose is related to the high pressure.

Crystallization and characterization of substoichiometric compound (W0.5Al0.5)C-0..5 obtained by solid-state reaction

(W0.5Al0.5)C-0.5 substoichiometric compound is synthesized by a combination of mechanical milling and high-pressure reactive sintering. X-ray diffraction is used to monitor the phase changes and crystallization of (W0.5Al0.5) C-0.5 during the whole reaction process. As a result, (W0.5Al0.5) C-0.5 is identified as the hexagonal WC-type belonging to the P-6m2 space group (No. 187), and the lattice parameters of (W0.5Al0.5)C-0.5 are calculated to be a = 2.907 (1) angstrom, c = 2.838 (1) angstrom, which are very similar to those of WC even if there are approximately 50 pct carbon vacancies in the cell of (W0.5Al0.5)C-0.5 as compared with WC. The substoichiometric (W0.5Al0.5)C-0.5 compound has a Vickers microhardness of 2385 +/- 70 kg mm(-2), which is as high as that of WC, while its density is far lower than that of WC.

Impact of cathode evaporation on a free-burning arc

A free-burning, high-intensity argon arc at atmospheric pressure was modelled during the evaporation of copper from the cathode. The effect of cathode evaporation on the temperature, mass flow, current flow and Cu concentration was studied for the entire plasma region. The copper evaporates from the tip of the cathode with an evaporation rate of 1 mg s-1. The copper vapour in the cathode region has a velocity of 210 m s-1 with a mass concentration of above 90% within 0.5 mm from the arc axis. The vapour passes from the cathode toward the anode with a slight diffusion in the argon plasma. Higher temperatures and current densities were calculated in the core of the arc caused by the cathode evaporation.

Experimental study on a nonlinear photonics process of Er(0.5)Yb(3): FOV oxyfluoride nanophase vitroceramics

We study the nonlinear photonics of rare-earth-doped oxyfluoride nanophase vitroceramics (FOV), oxyfluoride glass (FOG), and ZBLAN fluoride glass. We found that an interesting fluorescence intensity inversion phenomenon between red and green fluorescence occurs from Er(0.5)Yb(3):FOV The dynamic range Sigma of the intensity inversion between red and green fluorescence of Er(0.5)Yb(3):FOV is about 5.753 x 10(2), which is 100 to 1000 times larger than those of other materials. One of the applications of this phenomenon is double-wavelength fluorescence falsification-preventing technology, which is proved to possess the novel antifriction loss and antiscribble properties. (c) 2007 Optical Society of America.

Yb掺杂原子数分数为0．5％的Yb：Y3Al5O12晶体的光谱分析

采用提拉法生长了Yb掺杂原子数分数为0．5％的Yb：Y3Al5O12。（Yb2YAG）晶体，对晶体的吸收光谱和荧光光谱进行了分析。与Yb掺杂原子数分数为5％的Yb：YAG晶体进行了对比，得出采用940nm激光二极管（LD）抽运晶体最为合适。原子数分数为0．5％的Yb：YAG晶体相对于原子数分数为5％的Yb：YAG晶体白吸收效应的影响要小。测量了原子数分数为0．5％的Yb：YAG晶体的荧光寿命为0．95ms，与理论值很接近。因此采用原子数分数为0．5%的Yb：YAG晶体作为激光工作物质将有利于高效、小型集成

The response of antioxidant systems in Nostoc sphaeroides against UV-B radiation and the protective effects of exogenous antioxidants

UV radiation is one of many harmful factors found in space that are detrimental to organisms on earth in space exploration. In the present work, we examined the role of antioxidant system in Nostoc sphaeroides Kutz (Cyanobacterium) and the effects of exogenously applied antioxidant molecules on its photosynthetic rate under UV-B radiation. It was found that UV-B radiation promoted the activity of antioxidant system to protect photosystem 11 (PSII) and exogenously applied antioxidant: sodium nitroprusside (SNP) and N-acetylcysteine (NAC) had an obvious protection on PSII activity under UV-B radiation. The activity of superoxide dismutase (SOD, EC 1.15.1.1), catalase (CAT, EC 1.11.1.6), peroxidase (POD, EC 1.11.1.7) and content of NIDA (malondialdehyde) and ASC (ascorbate) were improved by 0.5 mM and 1 mM SNP, but 0.1 mM SNP decreased the activity of antioxidant system. Addition of exogenous NAC decreased the activity of SOD, POD, CAT and the content MDA and ASC. In contrast, exogenously applied NAC increased GSH content. The results suggest that exogenous SNP and NAC may protect algae by different mechanisms: SNP may play double roles as both sources of reactive free radicals as well as ROS scavengers in mediating the protective role of PSII on algae under UV-B radiation. On the other hand, NAC functions as an antioxidant or precursor of glutathione, which could protect PSII directly from UV-B radiation. (c) 2007 COSPAR, Published by Elsevier Ltd. All rights reserved.

Third-order optical nonlinearities of lead-free (Na1-xKx)(0.5)Bi0.5TiO3 thin films

(Na1-xKx)(0.5)Bi0.5TiO3 (NKBT) (x = 0.1, 0.2, and 0.3) thin films with good surface morphology and rhombohedral perovskite structure were fabricated on quartz substrates by a sol-gel process. The fundamental optical constants (the band gaps, linear refractive indices and absorption coefficients) of the films were obtained through optical transmittance measurements. The nonlinear optical properties were investigated by Z-scan technique performed at 532 nm with a picosecond laser. A two-photon absorption effect closely related with potassium-doping content was found in thin films, and the nonlinear refractive index n(2) increases evidently with potassium-doping. The real part of the third-order nonlinear susceptibility chi((3)) is much larger than its imaginary part, indicating that the third-order optical nonlinear response of the NKBT films is dominated by the optical nonlinear refractive behavior. These results show that NKBT thin films have potential applications in nonlinear optics. (C) 2007 Elsevier B.V. All rights reserved.

In_(0.5)Ga_(0.50As/In_(0.5)Al_(0.5)As应变耦合量子点的形貌和光学性质

提出了利用分子束外延方法生长In_(0.5)Ga_(0.5)As/In_(0.5)Al_(0.5)As应变耦合量子点,并分析量子点的形貌和光学性质随GaAs隔离层厚度变化的特点.实验结果表明,随着耦合量子点中的GaAs隔离层厚度从2 nm增加到10 nm,In_(0.5)Ga_(0.5)As量子点的密度增大、均匀性提高,Al原子扩散和浸润层对量子点PL谱的影响被消除,而且InAlAs材料的宽禁带特征使其成为InGaAs量子点红外探测器中的暗电流阻挡层.由此可见,选择合适的GaAs隔离层厚度形成InGaAs/InAlAs应变耦合量子点将有益于InGaAs量子点红外探测器的研究.

1GHz 0.5μm CMOS低噪声放大器的设计

从低噪声放大器(LNA)的设计原理出发,提出并设计了一种工作于1GHz的实用LNA.电路采用共源-共栅的单端结构,用HSPICE软件对电路进行分析和优化.模拟过程中选用的器件采用TSMC 0.5μm CMOS工艺实现.模拟结果表明所设计的LNA功耗小于15mW,增益大于10dB,噪声系数为1.87dB,IIP3大于10dBm,输入反射小于-50dB.可用于1GHz频段无线接收机的前端.

多层In_(0.55)Al_(0.45)As/A_(0.5)Ga_(0.5)As量子点的变温光致发光研究

测量了自组织多层In_(0.55)Al_(0.45)As/Al_(0.5)Ga_(0.5)As量子点的变温光致发光谱，同时观察到来自浸润层和量子点的发光，首次直接观察了浸润层和量子点之间的载流子热转移。分析发光强度随温度的变化发现浸润发光的热淬灭包括两个过程

低压金属有机化合物气相外延生长的 （Al_x Ga_（1-x））_（0 .5 1）In_（0 .49）P折射率测量（英文）

采用测量反射谱方法确定了低压金属有机化合物气相外延生长的GaAs衬底匹配(Al_xGa_(1-x))_(0.51)In_(0.49)P外延材料的折射率。实验中测量的反射谱波长范围为05-2.5μm。在拟合实验数据过程中采用了单振子模型。折射率数据用于分析应变量子阱GaInP/AlGaInP可见光激光二极管波导，计算出的器件远场图与实验数据吻合很好。

不同尺寸分布的自组织In_(0.55)Al_(0.45)As/Al_(0.5)Ga_(0.5)As量子点的静压光谱

在15K测量了不同尺寸分布的In_(0.55)Al_(0.45)As/Al_(0.5)Ga_(0.5)As量子点的静压我致发光，静压范围为0--1.3GPa。常压下观察到三个发光峰，分别来源于不同尺寸的量子点(横向直径分别为26、52和62nm)的发光。它产的压力系数分别为82、94和98meV/GPa,都小于In_(0.55)Al_(0.45)As体材料带边的压力系数，特别是尺寸为26nm的小量子点比In_(0.55)Al_(0.45)As体材料带边小17%，并且压力系数随量子点尺寸的变小而减小。理论计算表明有效质量的增在和Γ-X混合是量子点压力系数变小的主要原因，并得到横向直径为26和52nm的小量子点的Γ－X混合势为15和10meV。根据实验还确定In_(0.55)Al_(0.45)As/Al_(0.5)Ga_(0.5)As量子点系统X能带具有Ⅱ类结构，并且估算出价带不连续量为0.15±0.02。