1MeVSi＋衬底加温注入Al（0.3）Ca（0.7）As/GaAs超晶格和GaAs的晶格损伤研究

用卢瑟福背散射沟道技术研究了1MeVSi~+在衬底加温和室温下以不同剂量注入Al＿(0．3)Ga＿(0．7)As／GaAs超晶格和GaAs后的晶格损伤。在衬底加温下, 观察到Al＿(0．3)Ga＿(0．7)As／GaAs超晶格和GaAs都存在一个动态退火速率与缺陷产生速率相平衡的剂量范围, 以及两种速率失去平衡的临界剂量。用热尖峰与碰撞模型解释了晶格损伤积累与注入剂量和衬底温度的关系。

GaAs/Al（0.4）Ga（0.6）As多量子肼红外探测器光吸收计算

于2010-11-23批量导入

GaAs/Al（0.33）Ga（0.67）As短周期超晶格中能带不连续性随压力的变化

于2010-11-23批量导入

GaAs/Ga（0.7）Al（0.3）超晶格中场致激子峰展宽机制的研究

于2010-11-23批量导入

GaAs/Ga（0.7）Al（0.3）As短周期超晶格中的自电光双稳和多稳态效应

国家自然科学基金

含杂六角密积结构原子簇Al（12）M的电子结构

于2010-11-23批量导入

Al/a-Si:H界面反应和热处理行为光发射研究

国家自然科学基金

Au、Al/a-Si:H热退火行为研究

于2010-11-23批量导入

Observation of deep electron states in n-type Al-doped ZnS1-xTex grown by molecular beam epitaxy

Deep level transient spectroscopy (DLTS) technique was used to investigate deep electron states in n-type Al-doped ZnS1-xTex epilayers grown by molecular fiction epitaxy (MBE), Deep level transient Fourier spectroscopy (DLTFS) spectra of the Al-doped ZnS1-xTex (x = 0. 0.017, 0.04 and 0.046. respectively) epilayers reveal that At doping leads to the formation of two electron traps at 0.21 and 0.39 eV below the conduction hand. 1)DLTFS results suggest that in addition to the rules of Te as a component of [lie alloy as well as isoelectronic centers, Te is also involved in the formation of all electron trip, whose energy level relative to the conduction hand decreases a, Te composition increases.

High efficiency, low vertical divergence angle 980nnn Al-free active region lasers with novel large optical cavity and asymmetrical cladding layers

980nm InGaAs/InGaAsP/AlGaAs strained quantum well lasers,vitta novel large optical cavity and asymmetrical claddings was fabricated bg MOCVD. Very high differential quantum efficiency elf 90% (1.15W/A) and low vertical divergence angle of 24 degrees at long cavity length were obtained for 100 mu m stripe lasers. The differential quantum efficiency is up to 94% (1.20) at cavity length of 500 mu m.

Optical properties of self-assembled ternary In(GA/Al)As quantum dots on (100) and (N 1 1)B InP substrates

In this paper, we investigated the self-assembled quantum dots formed on (100) and (N11)B (N = 2, 3, 4, 5) InP substrates by molecular beam epitaxy (MBE). Two kinds of ternary QDs (In0.9Ga0.1As and In0.9Al0.1As QDs) are grown on the above substrates; Transmission electron microscopy (TEM) and photoluminescence (PL) results confirm QDs formation for all samples. The PL spectra reveal obvious differences in integral luminescence, peak position, full-width at half-maximum and peak shape between different oriented surfaces. Highest PL integral intensity is observed from QDs on (411)B surfaces, which shows a potential for improving the optical properties of QDs by using high-index surface. (C) 2000 Elsevier Science B.V. All rights reserved.

High power 980 nm Al-free strained quantum-well lasers for erbium-doped fiber amplifiers

In this paper, we reported on the fabrication of 980 nm InGaAs/InGaAsP strained quantum-well (QW) lasers with broad waveguide. The laser structure was grown by low-pressure metalorganic chemical vapor deposition on a n(+)- GaAs substrate. For 3 mu m stripe ridge waveguide lasers, the threshold current is 30 mA and the maximum output power and the output power operating in fundamental mode are 350 mW and 200 mW, respectively. The output power from the single mode fiber is up to 100 mW, the coupling efficiency is 50%. We also fabricated 100 mu m broad stripe coated lasers with cavity length of 800 mu m, a threshold current density of 170 A/cm(2), a high slope efficiency of 1.03 W/A and a far-field pattern of 40 x 6 degrees are obtained. The maximum output power of 3.5 W is also obtained for 100 mu m wide coated lasers. (C) 2000 Elsevier Science B.V. All rights reserved.