A survey of estuarine oxygen concentrations in relation to the passage of migratory salmonids

This report presents the first attempt at a national assessment of an Environmental Quality Standard (EQS) for dissolved oxygen (DO) in estuaries with the objective of allowing the passage of migratory salmonids. Under the Control of Pollution Act, Water Authorities and River Purification Boards have powers to control discharges to estuaries and need to define an EQS for the calculation of consent conditions. The object of any such standards is to permit the existence of good quality salmonid fisheries with only very occasional restrictions to the passage of fish. The report gives brief summaries of the DO regime in estuaries, the oxygen requirements of salmonids, and of tentative standards proposed by various authorities. These standards are then compared with DO and fishery data from UK estuaries, provided by the appropriate regulatory authorities. It concludes that a minimum annual lower 95-percentile of 5.0 mg/1 will meet the objective in most estuaries, and that a lower value of 3.0 mg/1 will permit the establishment of a more restricted fishery. However, more stringent standards may be needed in estuaries containing high concentrations of toxic pollutants. containing high concentrations of toxic pollutants.

Influence of oxygen partial pressure on the structure and photoluminescence of direct current reactive magnetron sputtering ZnO thin films

The effects of oxygen partial pressure on the structure and photoluminescence (PL) of ZnO films were studied. The films were prepared by direct current (DC) reactive magnetron sputtering with various oxygen concentrations at room temperature. With increasing oxygen ratio, the structure of films changes from zinc and zinc oxide phases, single-phase ZnO, to the (002) orientation, and the mechanical stresses exhibit from tensile stress to compressive stress. Films deposited at higher oxygen pressure show weaker emission intensities, which may result from the decrease of the oxygen vacancies and zinc interstitials in the film. This indicates that the emission in ZnO film originates from the oxygen vacancy and zinc interstitial-related defects. From optical transmittance spectra of ZnO films, the plasma edge shifts towards the shorter wavelength with the improvement of film stoichiometry. (C) 2004 Elsevier B.V. All rights reserved.

The effects of oxygen partial pressure on the optical absorption edge and the UV emission energy of ZnO films

The optical absorption edge and ultraviolet (UV) emission energy of ZnO films deposited by direct current (DC) reactive magnetron sputtering at room temperature have been investigated. With the oxygen ratio increasing, the structure of films changes from zinc and zinc oxide coexisting phase to single-phase ZnO and finally to the highly (002) orientation. Both the grain size and the stress of ZnO film vary with the oxygen partial pressure. Upon increasing the oxygen partial pressure in the growing ambient, the visible emission in the room-temperature photoluminescence spectra was suppressed without sacrificing the band-edge emission intensity in the ultraviolet region. The peaks of photoluminescence spectra were located at 3.06---3.15 eV. From optical transmittance spectra of ZnO films, the optical band gap edge was observed to shift towards shorter wavelength with the increase of oxygen partial pressure.

Effects of oxygen partial pressure on packing density and laser damage threshold of TiO2 thin films

TiO2 films are deposited by electron beam evaporation as a function of oxygen partial pressure. The packing density, refractive index, and extinction coefficient all decrease with the increase of pressure, which also induces the change of the film's microstructure, such as the increase of voids and H2O concentration in the film. The laser-induced damage threshold (LIDT) of the film increases monotonically with the rise of pressure in this experiment. The porous structure and low nonstoichiometric defects absorption contribute to the film's high LIDT. The films prepared at the lowest and the highest pressure show nonstoichiometric and surface-defects-induced damage features, respectively.(C) 2007 American Institute of Physics.

Influences of oxygen partial pressure on structure and related properties of ZrO2 thin films prepared by electron beam evaporation deposition

ZrO2 thin films were prepared by electron beam evaporation at different oxygen partial pressures. The influences of oxygen partial pressure on structure and related properties of ZrO2 thin films were studied. Transmittance, thermal absorption, structure and residual stress of ZrO2 thin films were measured by spectrophotometer, surface thermal lensing technique (STL), X-ray diffraction and optical interferometer, respectively. The results showed that the structure and related properties varied progressively with the increase of oxygen partial pressure. The refractive indices and the packing densities of the thin films decreased when the oxygen partial pressure increased. The tetragonal phase fraction in the thin films decreased gradually as oxygen partial pressure increased. The residual stress of film deposited at base pressure was high compressive stress, the value decreased with the increase of oxygen partial pressure, and the residual stress became tensile with the further increase of oxygen pressure, which was corresponding to the evolution of packing densities and variation of interplanar distances. (c) 2007 Elsevier B.V. All rights reserved.

Influence of oxygen plasma treatment on properties of ZrO2 films prepared by e-beam evaporation techniques

Zirconia films were prepared by e-beam evaporation, and oxygen plasma treatment was used to modify film properties. Spectrophotometry, x-ray diffractometry (XRD), and atomic force microscopy were used to characterize refractive index, extinction coefficient, rnicrostructure, and surface roughness, respectively. The experimental results indicate that both refractive index and extinction coefficient of the films were reduced slightly after oxygen plasma treatment, with the decrease of intrinsic stress and surface roughness. From XRD spectra, the intensity decrease of the T(110) diffraction peak was clearly observed after the treatment, which was caused by the restructuring of the film atoms. (C) 2008 Elsevier Ltd. All rights reserved.

Investigation on properties of TiO2 thin films deposited at different oxygen pressures

TiO2 thin films were prepared by electron beam evaporation at different oxygen partial pressures. The influences of oxygen partial pressure on optical, mechanical and structural properties of TiO2 thin films were studied. The results showed that with the increase of oxygen partial pressure, the optical transmittance gradually increased, the transmittance edge gradually shifted to short wavelength, and the corresponding refractive index decreased. The residual stresses of all samples were tensile, and the value increased as oxygen partial pressure increasing, which corresponded to the evolutions of the packing densities. The structures of TiO2 thin films all were amorphous because deposition particles did not possess enough energy to crystallize. (C) 2007 Elsevier Ltd. All rights reserved.

Influence of oxygen post-treatment on laser-induced damage of antireflection coatings prepared by electron-beam evaporation and ion beam assisted deposition

Antireflection coatings at the center wavelength of 1053 nm were prepared on BK7 glasses by electron-beam evaporation deposition (EBD) and ion beam assisted deposition (IBAD). Parts of the two kinds of samples were post-treated with oxygen plasma at the environment temperature after deposition. Absorption at 1064 nm was characterized based on surface thermal lensing (STL) technique. The laser-induced damage threshold (LIDT) was measured by a 1064-nm Nd:YAG laser with a pulse width of 38 ps. Leica-DMRXE Microscope was applied to gain damage morphologies of samples. The results revealed that oxygen post-treatment could lower the absorption and increase the damage thresholds for both kinds of as-grown samples. However, the improving effects are not the same. (c) 2008 Elsevier B.V. All rights reserved.

Current Approaches for Predicting a Lack of Response to Anti-EGFR Therapy in KRAS Wild-Type Patients

Targeting epidermal growth factor receptor (EGFR) has been one of the most effective colorectal cancer strategies. Anti-EGFR antibodies function by binding to the extracellular domain of EGFR, preventing its activation, and ultimately providing clinical benefit. KRAS mutations in codons 12 and 13 are recognized prognostic and predictive biomarkers that should be analyzed at the clinic prior to the administration of anti-EGFR therapy. However, still an important fraction of KRAS wild-type patients do not respond to the treatment. The identification of additional genetic determinants of primary or secondary resistance to EGFR targeted therapy for further improving the selection of patients is urgent. Herein, we review the latest published literature highlighting the most important genes that may predict resistance to anti-EGFR monoclonal antibodies in colorectal cancer patients. According to the available findings, the evaluation of BRAF, NRAS, PIK3CA, and PTEN status could be the right strategy to select patients who are likely to respond to anti-EGFR therapies. In the future, the combination of those biomarkers will help establish consensus that can be introduced into clinical practice.

Estudo dos efeitos da radioterapia no tecido cardíaco e sua associação com o metabolismo energético

Durante o tratamento radioterápico para tumores localizados na região torácica, parte do coração frequentemente é incluída no campo de tratamento e pode receber doses de radiação ionizante, significativas em relação à terapêutica. A irradiação do coração é capaz de causar importantes complicações cardíacas ao paciente, caracterizadas por alterações funcionais progressivas cerca de 10 a 20 anos após a exposição do órgão. Devido ao seu alto grau de contração e grande consumo energético, o tecido cardíaco é altamente dependente do metabolismo oxidativo que ocorre nas mitocôndrias. Danos as estas organelas podem levar ao decréscimo da produção de energia, tendo um impacto direto sobre a performance cardíaca. Ainda, ao interagir com as células, a radiação ionizante pode gerar uma série de eventos bioquímicos que conduzem a uma resposta celular complexa, em que muitas proteínas parecem estar envolvidas. Tendo em vista tais conhecimentos, o objetivo do estudo foi avaliar o aspecto ultraestrutural do tecido cardíaco, a bioenergética mitocondrial e a expressão diferencial de proteínas após irradiação. Os ensaios foram realizados em amostras de tecido cardíaco de ratos Wistar irradiados com dose única de 20 Gy direcionada ao coração. As análise tiveram início 4 e 32 semanas após irradiação. A análise ultraestrutural foi realizada através de microscopia eletrônica de transmissão. A respiração mitocondrial foi mensurada em oxígrafo, a partir das taxas de consumo de oxigênio pelas fibras cardíacas. A identificação de proteínas diferencialmente expressas foi investigada através de duas técnicas proteômicas: 2D-DIGE (2-D Fluorescence Difference Gel Electrophoresis) e uma abordagem label-free seguida de espectrometria de massas. Os resultados mostraram que os efeitos tardios da radiação incluem a degeneração das mitocôndrias e das unidades contráteis do tecido cardíaco, disfunções na cadeia respiratória mitocondrial e expressão diferencial de proteínas envolvidas no metabolismo energético de carboidratos, lipídeos e da fosfocreatina. De forma geral, o estudo mostrou que a irradiação cardíaca prejudica o processo de síntese energética, conduzindo a um déficit da taxa respiratória mitocondrial como efeito tardio. Tal evento pode culminar em disfunções mecânicas no coração, caracterizando o desenvolvimento de doenças cardíacas radioinduzidas.