Comparison of the gate drive parameter space for driving power MOSFETs using conventional and cascode configurations

Conventional voltage driven gate drive circuits utilise a resistor to control the switching speed of power MOS-FETs. The gate resistance is adjusted to provide controlled rate of change of load current and voltage. The cascode gate drive configuration has been proposed as an alternative to the conventional resistor-fed gate drive circuit. While cascode drive is broadly understood in the literature the switching characteristics of this topology are not well documented. This paper explores, through both simulation and experimentation, the gate drive parameter space of the cascode gate drive configuration and provides a comparison to the switching characteristics of conventional gate drive.

Characterisation of the cascode gate drive of power MOSFETs in clamped inductive switching applications

This thesis proposes a novel gate drive circuit to improve the switching performance of MOSFET power switches in power electronic converters. The proposed topology exploits the cascode configuration, allowing the minimisation of switching losses in the presence of practical circuit constraints, which enables efficiency and power density improvements. Switching characteristics of the new topology are investigated and key mechanisms that control the switching process are identified. Unique analysis tools and techniques are also developed to demonstrate the application of the cascode gate drive circuit for switching performance optimisation.

Anodized nanoporous WO3 Schottky contact structure for hydrogen and ethanol sensing

This paper reports the development of nanoporous tungsten trioxide (WO3) Schottky diode-based gas sensors. Nanoporous WO3 films were prepared by anodic oxidation of tungsten foil in ethylene glycol mixed with ammonium fluoride and a small amount of water. Anodization resulted in highly ordered WO3 films with a large surface-to-volume ratio. Utilizing these nanoporous structures, Schottky diode-based gas sensors were developed by depositing a platinum (Pt) catalytic contact and tested towards hydrogen gas and ethanol vapour. Analysis of the current–voltage characteristics and dynamic responses of the sensors indicated that these devices exhibited a larger voltage shift in the presence of hydrogen gas compared to ethanol vapour at an optimum operating temperature of 200 °C. The gas sensing mechanism was discussed, associating the response to the intercalating H+ species that are generated as a result of hydrogen and ethanol molecule breakdowns onto the Pt/WO3 contact and their spill over into nanoporous WO3.

Lock the gate: Fracking, investor-state dispute settlement, and the Trans-Pacific Partnership

There has been much debate about the relationship between international trade, the environment, biodiversity protection, and climate change.The Obama Administration has pushed such issues into sharp relief, with its advocacy for sweeping international trade agreements, such as the Trans-Pacific Partnership and the Trans-Atlantic Trade and Investment Partnership. There has been much public concern about the impact of the mega-trade deals upon the protection of the environment. In particular, there has been a debate about whether the Trans-Pacific Partnership will promote dirty fracking. Will the Trans-Pacific Partnership transform the Pacific Rim into a Gasland?There has been a particular focus upon investor-state dispute settlement being used by unconventional mining companies. Investor-state dispute settlement is a mechanism which enables foreign investors to seek compensation from national governments at international arbitration tribunals. In her prescient 2009 book, The Expropriation of Environmental Governance, Kyla Tienhaara foresaw the rise of investor-state dispute resolution of environmental matters. She observed:'Over the last decade there has been an explosive increase of cases investment arbitration. This is significant in terms of not only the number of disputes that have arisen and the number of states that have been involved, but also the novel types of dispute that have emerged. Rather than solely involving straightforward incidences of nationalization or breach of contract, modern disputes often revolve around public policy measures and implicate sensitive issues such as access to drinking water, development on sacred indigenous sites and the protection of biodiversity.'In her study, Kyla Tienhaara observed that investment agreements, foreign investment contracts and investment arbitration had significant implications for the protection for the protection of the environment. She concluded that arbitrators have made it clear that they can, and will, award compensation to investors that claim to have been harmed by environmental regulation. She also found that some of the cases suggest that the mere threat of arbitration is sufficient to chill environmental policy development. Tienhaara was equally concerned by the possibility that a government may use the threat of arbitration as an excuse or cover for its failure to improve environmental regulation. In her view, it is evident that arbitrators have expropriated certain fundamental aspects of environmental governance from states. Tienhaara held: As a result, environmental regulation has become riskier, more expensive, and less democratic, especially in developing countries. This article provides a comparative analysis of the battles over fracking, investment, trade, and the environment in a number of key jurisdictions including the United States, Canada, Australia, and New Zealand. Part 1 focuses upon the United States. Part 2 examines the dispute between the Lone Pine Resources Inc. and the Government of Canada over a fracking moratorium in Quebec. Part 3 charts the rise of the Lock the Gate Alliance in Australia, and its demands for a moratorium in respect of coal seam gas and unconventional mining. Part 4 focuses upon parallel developments in New Zealand. This article concludes that Pacific Rim countries should withdraw from investor-state dispute settlement procedures, because of the threat posed to environmental regulation in respect of air, land, and water.

Pt/WO3 nanoplatelet/SiC Schottky diode based hydrogen gas sensor

This paper presents the fabrication and study of a Schottky diode based on Pt/WO3 nanoplatelet/SiC for H2 gas sensing applications. The nanostructured WO3 films were synthesized from tungsten (sputtered on SiC) via an acidetching method using a 1.5 M HNO3 solution. Scanning electron microscopy of the developed films revealed platelet crystals with thicknesses in the order of 20-60 nm and lengths between 100-700 nm. The current-voltage characteristic and dynamic response of the diodes were measured in the presence of air and 1% H2 gas balanced in air from 25 to 300°C. Upon exposure to 1% H2, voltage shifts of 0.64, 0.93 and 1.14 V were recorded at temperatures of 120, 200 and 300°C, respectively at a constant forward bias current of 500 μA.

Modeling of Channel Potential and Subthreshold Slope of Symmetric Double-Gate Transistor

A new physically based classical continuous potential distribution model, particularly considering the channel center, is proposed for a short-channel undoped body symmetrical double-gate transistor. It involves a novel technique for solving the 2-D nonlinear Poisson's equation in a rectangular coordinate system, which makes the model valid from weak to strong inversion regimes and from the channel center to the surface. We demonstrated, using the proposed model, that the channel potential versus gate voltage characteristics for the devices having equal channel lengths but different thicknesses pass through a single common point (termed ``crossover point''). Based on the potential model, a new compact model for the subthreshold swing is formulated. It is shown that for the devices having very high short-channel effects (SCE), the effective subthreshold slope factor is mainly dictated by the potential close to the channel center rather than the surface. SCEs and drain-induced barrier lowering are also assessed using the proposed model and validated against a professional numerical device simulator.

Within-Die Gate Delay Variability Measurement using Re-configurable Ring Oscillator

We report a circuit technique to measure the on-chip delay of an individual logic gate (both inverting and non-inverting) in its unmodified form using digitally reconfigurable ring oscillator (RO). Solving a system of linear equations with different configuration setting of the RO gives delay of an individual gate. Experimental results from a test chip in 65nm process node show the feasibility of measuring the delay of an individual inverter to within 1pS accuracy. Delay measurements of different nominally identical inverters in close physical proximity show variations of up to 26% indicating the large impact of local or within-die variations.

Theoretical Optimization of Metal Para-Normal Silicon Schottky-Barrier Solar-Cell

The theoretical optimization of the design parametersN A ,N D andW P has been done for efficient operation of Au-p-n Si solar cell including thermionic field emission, dependence of lifetime and mobility on impurity concentrations, dependence of absorption coefficient on wavelength, variation of barrier height and hence the optimum thickness ofp region with illumination. The optimized design parametersN D =5×1020 m−3,N A =3×1024 m−3 andW P =11.8 nm yield efficiencyη=17.1% (AM0) andη=19.6% (AM1). These are reduced to 14.9% and 17.1% respectively if the metal layer series resistance and transmittance with ZnS antireflection coating are included. A practical value ofW P =97.0 nm gives an efficiency of 12.2% (AM1).

Within-Die Gate Delay Variability Measurement Using Reconfigurable Ring Oscillator

We report the design and characterization of a circuit technique to measure the on-chip delay of an individual logic gate (both inverting and noninverting) in its unmodified form. The test circuit comprises of digitally reconfigurable ring oscillator (RO). The gate under test is embedded in each stage of the ring oscillator. A system of linear equations is then formed with different configuration settings of the RO, relating the individual gate delay to the measured period of the RO, whose solution gives the delay of the individual gates. Experimental results from a test chip in 65-nm process node show the feasibility of measuring the delay of an individual inverter to within 1 ps accuracy. Delay measurements of different nominally identicall inverters in close physical proximity show variations of up to 28% indicating the large impact of local variations. As a demonstration of this technique, we have studied delay variation with poly-pitch, length of diffusion (LOD) and different orientations of layout in silicon. The proposed technique is quite suitable for early process characterization, monitoring mature process in manufacturing and correlating model-to-hardware.

Garden gate to Daijas' father's house Architecture; Residences; Exterior

Verso: Das Gartentor zu Daijas Vaterhaus Georg lebete um die Ecke

On the ideality factor of Schottky diodes at low temperatures

Abstract is not available.

Effect of organic gate dielectric material properties on interfacial charging and discharging of pentacene MIM device

The effect of material properties of an environmentally friendly, optically transparent dielectric material, polyterpenol, on the carrier transients within the pentacene-based double-layer MTM device was investigated. Polyterpenol films were RF plasma polymerised under varied process conditions, with resultant films differing in surface chemistry and morphology. Independent of type of polyterpenol, time-resolved EFISHG study of IZO/polyterpenol/pentacene/Au structures showed similar transient behaviour with carriers injected into pentacene from Au electrode only, confirming polyterpenol to be a suitable blocking layer for visualisation of single-species carrier transportation during charging and discharging under different bias conditions. Polyterpenol fabricated under higher input power show better promise due to higher chemical and thermal stability, improved uniformity, and absence of defects.

Jer. (Jerusalem) - Temple Pl. (place) - Golden Gate

Digital image

Entrance Gate to Old City of Jerusalem

Digital image

The Gate, Internment camp at Huyton, near Liverpool.

Signed and dated lower right. See also 78.1689