SEM observation of the bond integrity of fiber-reinforced composite posts cemented into root canals

Objectives. To test the null hypothesis that continuity of resin cement/dentin interfaces is not affected by location along the root canal walls or water storage for 3 months when bonding fiber posts into root canals. Methods. Fiber posts were luted to bovine incisors using four resinous luting systems: Multilink, Variolink II, Enforce Dual and Enforce PV. After cementation, roots were longitudinally sectioned and epoxy resin replicas were prepared for SEM analysis (baseline). The original halves were immersed in solvent, replicated and evaluated. After 3 months water storage and a second solvent immersion, a new set of replicas were made and analyzed. The ratio (%) between the length (mm) of available bonding interface and the actual extension of bonded cement/dentin interface was calculated. Results. Significant lower percent values of bond integrity were found for Multilink (8.25%) and Variolink 11 (10.08%) when compared to Enforce Dual (25.11%) and Enforce PV (27.0%) at baseline analysis. The same trend was observed after immersion in solvent, with no significant changes. However, bond integrity was significantly reduced after 3 months water storage and a second solvent immersion to values below 5% (Multilink = 3.31%, Variolink=1.87%, Enforce Dual=1.20%, and Enforce PV=0.75%). The majority of gaps were depicted at the apical and middle thirds at baseline and after immersion in solvent. After 3 months, gaps were also detected at the cervical third. Significance. Bond integrity at the cement/dentin interface was surprisingly low after cementation of fiber posts to root canals with all resin cements. That was not significantly altered after immersion in solvent, but was further compromised after 3 months water storage. Gaps were mainly seen at middle and apical thirds throughout the experiment and extended to the cervical third after water storage for 3 months. Bond integrity of fiber posts luted to root canals was affected both by location and water storage. (C) 2007 Academy of Dental Materials. Published by Elsevier Ltd. All rights reserved.

Feasibility of an evidence-based literature search service for general practitioners

Objective: To test the feasibility of an evidence-based clinical literature search service to help answer general practitioners' (GPs') clinical questions. Design: Two search services supplied GPs who submitted questions with the best available empirical evidence to answer these questions. The GPs provided feedback on the value of the service, and concordance of answers from the two search services was assessed. Setting: Two literature search services (Queensland and Victoria), operating for nine months from February 1999. Main outcome measures: Use of the service; time taken to locate answers; availability of evidence; value of the service to GPs; and consistency of answers from the two services. Results: 58 GPs asked 160 questions (29 asked one, 11 asked five or more). The questions concerned treatment (65%), aetiology (17%), prognosis (13%), and diagnosis (5%). Answering a question took a mean of 3 hours 32 minutes of personnel time (95% Cl, 2.67-3.97); nine questions took longer than 10 hours each to answer, the longest taking 23 hours 30 minutes. Evidence of suitable quality to provide a sound answer was available for 126 (79%) questions. Feedback data for 84 (53%) questions, provided by 42 GPs, showed that they appreciated the service, and asking the questions changed clinical care. There were many minor differences between the answers from the two centres, and substantial differences in the evidence found for 4/14 questions. However, conclusions reached were largely similar, with no or only minor differences for all questions. Conclusions: It is feasible to provide a literature search service, but further assessment is needed to establish its cost effectiveness.

Analysis of Piezoelectric sensor to detect flexural waves

The electromechanical transfer characteristics of adhesively bonded piezoelectric sensors are investigated. By the use of dynamic piezoelectricity theory, Mindlin plate theory for flexural wave propagation, and a multiple integral transform method, the frequency-response functions of piezoelectric sensors with and without backing materials are developed and the pressure-voltage transduction functions of the sensors calculated. The corresponding simulation results show that the sensitivity of the sensors is not only dependent on the sensors' inherent features, such as piezoelectric properties and geometry, but also on local characteristics of the tested structures and the admittance and impedance of the attached electrical circuit. It is also demonstrated that the simplified rigid mass sensor model can be used to analyze successfully the sensitivity of the sensor at low frequencies, but that the dynamic piezoelectric continuum model has to be used for higher frequencies, especially around the resonance frequency of the coupled sensor-structure vibration system.

A titrimetric respirometer measuring the nitrifiable nitrogen in wastewater using in-sensor-experiment

Measurement of nitrifiable nitrogen contained in wastewater by combining the existing respirometric and titrimetric principles is reported. During an in-sensor-experiment using nitrifying activated sludge. both the dissolved oxygen (DO) and pH in the mixed liquor were measured, and the FH was controlled at a set-point through titration of base or acid. A combination of the oxygen uptake rate (OUR), which was obtained from the measured DO signal, and the titration data allowed calculation of the nitrifiable nitrogen and the short-term biological oxygen demand (BOD) of the wastewater sample that was initially added to the sludge. The calculation was based solely on stoichiometric relationships. The approach was preliminarily tested with two types of wastewaters using a prototype sensor. Good correlation was obtained. (C) 2000 Elsevier Science Ltd. All rights reserved.

Observation of bound states of solitons in a passively mode-locked fiber laser

We report on an experimental observation of bound states of solitons in a passively mode-locked fiber soliton ring laser. The observed bound solitons are stable and have discrete, fixed soliton separations that are independent of the experimental conditions.

Telemedicine and clinical genetics: establishing a successful service

There is a surprising lack of published experience on the use of videoconferencing in clinical genetics. Patients were randomly allocated to either a telegenetic (cases) or face-to-face (control) conventional clinic. The telegenetic consultation was done by videoconferencing, using ISDN lines at 384 kbit/s. Evaluation by the doctor and counsellor took place immediately after each appointment. The patient was asked to evaluate the appointment by telephone questionnaire about four weeks after the event. Forty-two patients were invited to participate and 33 (79%) returned their consent forms. Four patients declined to participate and were seen in ordinary face-to-face clinics. Preliminary results showed that the assessment of the telegenetics consultations by doctors, counsellors and patients was very favourable, and they responded positively when asked if they would be happy to use telemedicine in the future. For use in selected consultations, videoconferencing does appear to fulfil a useful role in clinical genetics.

Videoconferencing in the Queensland health service

Videoconferencing was introduced in the Queensland health service in 1995. By the end of 1999, there were more than 150 videoconferencing units in health facilities around the state. Six audits of videoconferencing usage were conducted using similar methodology at six-month intervals from November 1997 to May 2000. Between November 1997 and November 1999, the number of calls more than doubled, from 566 to 1378. Hours of usage almost trebled, from 671 to 1724. The average duration of calls remained similar, at about I h 12 min. The proportion of calls involving more than two sites (multipoint videoconferences) increased from 44% to 65%. The majority of the activity was for education (including training). Videoconferencing was also used for administration and clinical care. Mental health staff were the heaviest users, but use by health professionals from other specialty areas increased during the study period. The Queensland health service has realized a number of important benefits from telehealth.

Curriculum development for professional ethics in Australian human service university programmes

Australian academics and practitioners in the human services are particularly susceptible to social, political and economic influences in respect of their relevance, viability and operations. In fact, it can be argued that the impact of these influences has placed human service practitioners and academics in a perpetual state of vulnerability. Australian universities have been challenged to make their programmes more relevant and viable to the community at large, and practitioners face increasing workloads with limited resources based on restricted fiscal allocation, and the changing relationship between government and service providers. Drawing on interview data from twenty-one (n = 21) practitioners, this article highlights their identified problems regarding the notion of professionalism in the human services with a particular focus on ethical dilemmas in human service practice. Gleaning these details will be a basis for recommending necessary professionalethics curricula content in human services programmes offered in Australian universities. Moreover, while the research data is Australian based, the authors contend that the universal theories and principles underpinning human service practice justify the significance and value of the data as an important source for international consideration in curriculum development of human service academic programmes.

Credibility and staff conduct make or break bank customer service quality

Service quality is assessed by customers along the dimensions of staff conduct, credibility, communication, and access to teller services. Credibility and staff conduct emerge as the highest loading first-order factors. This highlights the significance of rectifying mistakes while keeping customers informed, and employing branch staff that are responsive and civilized in their conduct. Discovery of a valid second-order factor, namely, overall customer service quality, underscores the importance of providing quality service across all its dimensions. For example, if the bank fails to rectify mistakes and keep customers informed but excels in all other dimensions, its overall customer service quality can still be rated poorly.

Equity in regional service provision

Most transportation agencies stipulate that an important planning goal is to provide equitable and just public transport services. However, who is to be served and the type of service that should be provided has been ambiguous. This paper develops a methodology for examining equity in the provision of public transportation services. An approach for identifying areas in need of public transport is developed based upon the use of socio-demographic and economic information. Public transport need is then related to levels of access to service. This approach makes it possible to establish the degree to which public transport services may be considered equitable in relation to need and suitable access. A detailed analysis of the southeast Queensland region of Australia illustrates how this approach may be used to inform public transport decision making.