Surface electrode switching of a 16-electrode wireless EIT system using RF-based digital data transmission scheme with 8 channel encoder/decoder ICs

A Radio Frequency (RF) based digital data transmission scheme with 8 channel encoder/decoder ICs is proposed for surface electrode switching of a 16-electrode wireless Electrical Impedance Tomography (EIT) system. A RF based wireless digital data transmission module (WDDTM) is developed and the electrode switching of a EIT system is studied by analyzing the boundary data collected and the resistivity images of practical phantoms. An analog multiplexers based electrode switching module (ESM) is developed with analog multiplexers and switched with parallel digital data transmitted by a wireless transmitter/receiver (T-x/R-x) module working with radio frequency technology. Parallel digital bits are generated using NI USB 6251 card working in LabVIEW platform and sent to transmission module to transmit the digital data to the receiver end. The transmitter/receiver module developed is properly interfaced with the personal computer (PC) and practical phantoms through the ESM and USB based DAQ system respectively. It is observed that the digital bits required for multiplexer operation are sequentially generated by the digital output (D/O) ports of the DAQ card. Parallel to serial and serial to parallel conversion of digital data are suitably done by encoder and decoder ICs. Wireless digital data transmission module successfully transmitted and received the parallel data required for switching the current and voltage electrodes wirelessly. 1 mA, 50 kHz sinusoidal constant current is injected at the phantom boundary using common ground current injection protocol and the boundary potentials developed at the voltage electrodes are measured. Resistivity images of the practical phantoms are reconstructed from boundary data using EIDORS. Boundary data and the resistivity images reconstructed from the surface potentials are studied to assess the wireless digital data transmission system. Boundary data profiles of the practical phantom with different configurations show that the multiplexers are operating in the required sequence for common ground current injection protocol. The voltage peaks obtained at the proper positions in the boundary data profiles proved the sequential operation of multiplexers and successful wireless transmission of digital bits. Reconstructed images and their image parameters proved that the boundary data are successfully acquired by the DAQ system which in turn again indicates a sequential and proper operation of multiplexers as well as the successful wireless transmission of digital bits. Hence the developed RF based wireless digital data transmission module (WDDTM) is found suitable for transmitting digital bits required for electrode switching in wireless EIT data acquisition system. (C) 2011 Elsevier Ltd. All rights reserved.

Estudio de la cinemática de un móvil de dos ruedas y su control para mantener el equilibrio disponiendo de encoder

En este proyecto presentamos el diseño e implementación de un móvil de dos ruedas, en concreto un robot balancín. En él se estudiarán las teorías necesarias para que un móvil de dos ruedas se mantenga en equilibrio y poner dichas teorías en práctica.

JPEG encoder system-on-a-chip demonstrator

The design of a System-on-a-Chip (SoC) demonstrator for a baseline JPEG encoder core is presented. This combines a highly optimized Discrete Cosine Transform (DCT) and quantization unit with an entropy coder which has been realized using off-the-shelf synthesizable IP cores (Run-length coder, Huffman coder and data packer). When synthesized in a 0.35 µm CMOS process, the core can operate at speeds up to 100 MHz and contains 50 k gates plus 11.5 kbits of RAM. This is approximately 20% less than similar JPEG encoder designs reported in literature. When targeted at FPGA the core can operate up to 30 MHz and is capable of compressing 9-bit full-frame color input data at NTSC or PAL rates.

Progetto e realizzazione di un azionamento per macchina asincrona eptafase con misura della velocità mediante encoder.

In questa tesi si effettua lo studio di un azionamento elettrico con motore asincrono eptafase. In particolare si realizza un sistema automatico per il controllo della coppia mediante stimatori con encoder. Si ha così la possibilità di effettuare un controllo accurato della macchina asincrona eptafase anche a bassa velocità, cosa che risulterebbe più complessa se eseguita mediante controlli di tipo sensorless. Inoltre, grazie ad opportune strategie di controllo, è possibile assicurare un funzionamento accettabile degli azionamenti con motori multifase durante una condizione di guasto con una fase aperta, senza alcuna necessità di hardware aggiuntivo.

Skopos Theory La figura del traduttore come decoder e re-encoder

La Skopos Theory è una teoria introdotta nel mondo della traduzione dal linguista tedesco Hans Joseph Vermeer. Skopos è una parola di derivazione greca che significa “fine” o “scopo”. La teoria elaborata da Vermeer si basa sull’idea che ogni testo abbia uno skopos che determina i metodi e le strategie secondo le quali esso debba essere tradotto. Oltre alla Skopos Theory, che sarà la base della tesi, i testi a seguire verranno analizzati seguendo altri autori, quali Mona Baker e Laurence Venuti, che si rifanno all’idea di skopos e analizzano molto dettagliatamente la figura del traduttore come de-coder e re-encoder del testo.

Operator's, organizational, and direct support maintenance manual : encoder-decoder KY-801/GSC (NSN 5895-01-034-1061).

"September 1977."

Direct support and general support maintenance repair parts and special tools list including depot maintenance repair parts and special tools for azimuth laying set, guided missile AN/TSQ-110(X0-1) 1430-00-399-5318, encoder, shaft angle, digital (in container) 1430-01-034-2268, gyro reference unit (in container) 1430-01-033-4044 ...

Includes index.

A non-linear encoder using a binary counterfor pulse-code modulation

DUE TO COPYRIGHT RESTRICTIONS ONLY AVAILABLE FOR CONSULTATION AT ASTON UNIVERSITY LIBRARY AND INFORMATION SERVICES WITH PRIOR ARRANGEMENT