Analysis and Prediction of Transient Opacity Spikes Using Dimensional Modeling

Dimensional modeling, GT-Power in particular, has been used for two related purposes-to quantify and understand the inaccuracies of transient engine flow estimates that cause transient smoke spikes and to improve empirical models of opacity or particulate matter used for engine calibration. It has been proposed by dimensional modeling that exhaust gas recirculation flow rate was significantly underestimated and volumetric efficiency was overestimated by the electronic control module during the turbocharger lag period of an electronically controlled heavy duty diesel engine. Factoring in cylinder-to-cylinder variation, it has been shown that the electronic control module estimated fuel-Oxygen ratio was lower than actual by up to 35% during the turbocharger lag period but within 2% of actual elsewhere, thus hindering fuel-Oxygen ratio limit-based smoke control. The dimensional modeling of transient flow was enabled with a new method of simulating transient data in which the manifold pressures and exhaust gas recirculation system flow resistance, characterized as a function of exhaust gas recirculation valve position at each measured transient data point, were replicated by quasi-static or transient simulation to predict engine flows. Dimensional modeling was also used to transform the engine operating parameter model input space to a more fundamental lower dimensional space so that a nearest neighbor approach could be used to predict smoke emissions. This new approach, intended for engine calibration and control modeling, was termed the "nonparametric reduced dimensionality" approach. It was used to predict federal test procedure cumulative particulate matter within 7% of measured value, based solely on steady-state training data. Very little correlation between the model inputs in the transformed space was observed as compared to the engine operating parameter space. This more uniform, smaller, shrunken model input space might explain how the nonparametric reduced dimensionality approach model could successfully predict federal test procedure emissions when roughly 40% of all transient points were classified as outliers as per the steady-state training data.

Sustainable Air Traffic Management System Development Methodology

As it is defined in ATM 2000+ Strategy (Eurocontrol 2001), the mission of the Air Traffic Management (ATM) System is: “For all the phases of a flight, the ATM system should facilitate a safe, efficient, and expedite traffic flow, through the provision of adaptable ATM services that can be dimensioned in relation to the requirements of all the users and areas of the European air space. The ATM services should comply with the demand, be compatible, operate under uniform principles, respect the environment and satisfy the national security requirements.” The objective of this paper is to present a methodology designed to evaluate the status of the ATM system in terms of the relationship between the offered capacity and traffic demand, identifying weakness areas and proposing solutions. The first part of the methodology relates to the characterization and evaluation of the current system, while a second part proposes an approach to analyze the possible development limit. As part of the work, general criteria are established to define the framework in which the analysis and diagnostic methodology presented is placed. They are: the use of Air Traffic Control (ATC) sectors as analysis unit, the presence of network effects, the tactical focus, the relative character of the analysis, objectivity and a high level assessment that allows assumptions on the human and Communications, Navigation and Surveillance (CNS) elements, considered as the typical high density air traffic resources. The steps followed by the methodology start with the definition of indicators and metrics, like the nominal criticality or the nominal efficiency of a sector; scenario characterization where the necessary data is collected; network effects analysis to study the relations among the constitutive elements of the ATC system; diagnostic by means of the “System Status Diagram”; analytical study of the ATC system development limit; and finally, formulation of conclusions and proposal for improvement. This methodology was employed by Aena (Spanish Airports Manager and Air Navigation Service Provider) and INECO (Spanish Transport Engineering Company) in the analysis of the Spanish ATM System in the frame of the Spanish airspace capacity sustainability program, although it could be applied elsewhere.

Sight distance for traffic safety analysis using GIS

Sight distance is of major importance for road safety either when designing new roads or analysing the alignment of existing roads. It is essential that available sight distance in roads is long enough for emergency stops or overtaking manoeuvres. Also, it is vital for engineers/researchers that the tools used for that analysis are both powerful and intuitive. Based on ArcGIS, the application to be presented not only performs an exhaustive sight distance calculation, but allows an accurate analysis of 3D alignment, using all new tools, from a Digital Elevation Model and vehicle trajectory. The software has been successfully utilised to analyse several two-lane rural roads in Spain. In addition, the software produces thematic maps representing sight distance in which supplementary information about crashes, traffic flow, speed or design consistency could be included, allowing traffic safety studies.

Reduced carbon and energy footprint in highway operations: the Highway Energy Assessment (HERA) methodology

Global demand for mobility is increasing and the environmental impact of transport has become an important issue in transportation network planning and decision-making, as well as in the operational management phase. Suitable methods are required to assess emissions and fuel consumption reduction strategies that seek to improve energy efficiency and furthering decarbonization. This study describes the development and application of an improved modeling framework – the HERA (Highway EneRgy Assessment) methodology – that enables to assess the energy and carbon footprint of different highways and traffic flow scenarios and their comparison. HERA incorporates an average speed consumption model adjusted with a correction factor which takes into account the road gradient. It provides a more comprehensive method for estimating the footprint of particular highway segments under specific traffic conditions. It includes the application of the methodology to the Spanish highway network to validate it. Finally, a case study shows the benefits from using this methodology and how to integrate the objective of carbon footprint reductions into highway design, operation and scenario comparison.

Modelagem e simulação de redes em chip sem fio.

O paradigma das redes em chip (NoCs) surgiu a fim de permitir alto grau de integração entre vários núcleos de sistemas em chip (SoCs), cuja comunicação é tradicionalmente baseada em barramentos. As NoCs são definidas como uma estrutura de switches e canais ponto a ponto que interconectam núcleos de propriedades intelectuais (IPs) de um SoC, provendo uma plataforma de comunicação entre os mesmos. As redes em chip sem fio (WiNoCs) são uma abordagem evolucionária do conceito de rede em chip (NoC), a qual possibilita a adoção dos mecanismos de roteamento das NoCs com o uso de tecnologias sem fio, propondo a otimização dos fluxos de tráfego, a redução de conectores e a atuação em conjunto com as NoCs tradicionais, reduzindo a carga nos barramentos. O uso do roteamento dinâmico dentro das redes em chip sem fio permite o desligamento seletivo de partes do hardware, o que reduz a energia consumida. Contudo, a escolha de onde empregar um link sem fio em uma NoC é uma tarefa complexa, dado que os nós são pontes de tráfego os quais não podem ser desligados sem potencialmente quebrar uma rota preestabelecida. Além de fornecer uma visão sobre as arquiteturas de NoCs e do estado da arte do paradigma emergente de WiNoC, este trabalho também propõe um método de avaliação baseado no já consolidado simulador ns-2, cujo objetivo é testar cenários híbridos de NoC e WiNoC. A partir desta abordagem é possível avaliar diferentes parâmetros das WiNoCs associados a aspectos de roteamento, aplicação e número de nós envolvidos em redes hierárquicas. Por meio da análise de tais simulações também é possível investigar qual estratégia de roteamento é mais recomendada para um determinado cenário de utilização, o que é relevante ao se escolher a disposição espacial dos nós em uma NoC. Os experimentos realizados são o estudo da dinâmica de funcionamento dos protocolos ad hoc de roteamento sem fio em uma topologia hierárquica de WiNoC, seguido da análise de tamanho da rede e dos padrões de tráfego na WiNoC.

The effect of truck size and weight on accident experience and traffic operations. Volume II: traffic operations. Final report.

Federal Highway Administration, Washington, D.C.

An evaluation of the 1979 Texas law (V.C.S., Sec. 73.A.) which requires frontage road traffic to yield at freeway ramps. Interim report.

Texas State Department of Highways and Public Transportation, Transportation Planning Division, Austin

State of the art: residential traffic management.

Federal Highway Administration, Office of Research, Washington, D.C.

Tourist traffic in small historic cities: analysis, strategies, and recommendations. Final report.

Transportation Department, Office of University Research, Washington, D.C.

Advanced filtering and prediction software for urban traffic control systems. Final report.

Transportation Department, Office of University Research, Washington, D.C.

Effects of taper length on traffic operations in construction zones.

Federal Highway Administration, Office of Research, Washington, D.C.

Demand-responsive decentralized urban traffic control : part 1, single-intersection policies /

"February 1982."

Computerized allocation of police traffic services; a demonstration study. Final report.

National Highway Traffic Safety Administration, Washington, D.C.

Computerized allocation of police traffic services; reference volume I. Computer-sensor system description. Final report.

National Highway Traffic Safety Administration, Washington, D.C.

Guidelines for flashing traffic control devices. Final report.

Federal Highway Administration, Office of Research and Development, Washington, D.C.