Pt/ZnO/SiC thin film for hydrogen gas sensing

Zinc oxide (ZnO) is one of the most promising electronic and photonic materials to date. In this work, we present an enhanced ZnO Schottky gas sensor deposited on SiC substrates in comparison to those reported previously in literature. The performance of ZnO/SiC based Schottky thin film gas sensors produced a forward lateral voltage shift of 12.99mV and 111.87mV in response to concentrations of hydrogen gas at 0.06% and 1% in air at optimum temperature of 330 ºC. The maximum change in barrier height was calculated as 37.9 meV for 1% H2 sensing operation at the optimum temperature.

A water-dielectric capacitor using hydrated graphene oxide film

Despite the widespread use of paper, plastic or ceramics in dielectric capacitors, water has not been commonly used as a dielectric due to its tendency to become conductive as it easily leaches ions from the environment. We show here that when water is confined between graphene oxide sheets, it can retain its insulating nature and behave as a dielectric. A hydrated graphene oxide film was used as a dielectric spacer to construct a prototype water-dielectric capacitor. The capacitance depends on the water content of the hydrated GO film as well as the voltage applied to the device. Our results show that the capacitance per unit area of the GO film is in the range of 100–800 mF cm �2, which is 5–40 times that of the double layer capacitance per surface area of activated carbon.

Gravity-driven fingering simulations for a thin liquid film flowing down the outside of a vertical cylinder

A numerical study is presented to examine the fingering instability of a gravity-driven thin liquid film flowing down the outer wall of a vertical cylinder. The lubrication approximation is employed to derive an evolution equation for the height of the film, which is dependent on a single parameter, the dimensionless cylinder radius. This equation is identified as a special case of that which describes thin film flow down an inclined plane. Fully three-dimensional simulations of the film depict a fingering pattern at the advancing contact line. We find the number of fingers observed in our simulations to be in excellent agreement with experimental observations and a linear stability analysis reported recently by Smolka & SeGall (Phys Fluids 23, 092103 (2011)). As the radius of the cylinder decreases, the modes of perturbation have an increased growth rate, thus increasing cylinder curvature partially acts to encourage the contact line instability. In direct competition with this behaviour, a decrease in cylinder radius means that fewer fingers are able to form around the circumference of the cylinder. Indeed, for a sufficiently small radius, a transition is observed, at which point the contact line is stable to transverse perturbations of all wavenumbers. In this regime, free surface instabilities lead to the development of wave patterns in the axial direction, and the flow features become perfectly analogous to the two-dimensional flow of a thin film down an inverted plane as studied by Lin & Kondic (Phys Fluids 22, 052105 (2010)). Finally, we simulate the flow of a single drop down the outside of the cylinder. Our results show that for drops with low volume, the cylinder curvature has the effect of increasing drop speed and hence promoting the phenomenon of pearling. On the other hand, drops with much larger volume evolve to form single long rivulets with a similar shape to a finger formed in the aforementioned simulations.

Tracing the influence of non-narrative film and expanded cinema sound on experimental music

This study surveys and interrogates key conceptual frameworks and artistic practises that flow through the distinct but interconnected traditions of non-narrative film and experimental music, and examines how these are articulated in my own creative sound practise.

Reshaping children’s knowledge through film making: What to film, how to film and why

How can teachers reinvigorate content area knowledge and representation through filmmaking? We give examples of what to film, how to film, and why, drawing on our visual ethnographic research with Year 5 students in a working class suburb of Logan, Queensland. The unit developed content knowledge of Indigenous places and practices through sensitising activities in nature. Valuing students’ funds of knowledge, we interpreted local places through epistemologies of different cultures. Through filmmaking workshops by a digital artist, students filmed community members in a local shopping mall about their perceptions of health and happiness in local places. Students were positioned as future community leaders, presenting their films at a national conference. To conclude, we map the dominant and marginalised, local and specialised, and print and visual forms of knowledge that were interwoven, reshaped, and shared through multimodal design.

Numerical solutions for thin film flow down the outside and inside of a vertical cylinder

We consider a model for thin film flow down the outside and inside of a vertical cylinder. Our focus is to study the effect that the curvature of the cylinder has on the gravity-driven instability of the advancing contact line and to simulate the resulting fingering patterns that form due to this instability. The governing partial differential equation is fourth order with a nonlinear degenerate diffusion term that represents the stabilising effect of surface tension. We present numerical solutions obtained by implementing an efficient alternating direction implicit scheme. When compared to the problem of flow down a vertical plane, we find that increasing substrate curvature tends to increase the fingering instability for flow down the outside of the cylinder, whereas flow down the inside of the cylinder substrate curvature has the opposite effect. Further, we demonstrate the existence of nontrivial travelling wave solutions which describe fingering patterns that propagate down the inside of a cylinder at constant speed without changing form. These solutions are perfectly analogous to those found previously for thin film flow down an inclined plane.

Exploring Indigenous representations in Australian film and literature for the Australian Curriculum

The Australian Curriculum: English, v.5 (ACARA, 2013) now being implemented in Queensland asks teachers and curriculum designers to incorporate the cross curriculum priority (CCP)of Indigenous issues through Aboriginal and Torres Strait Islander histories and cultures. In the Australian Curriculum English, (AC:E) one way to address this CCP is by including texts by and about Aboriginal and Torres Strait Islander people. With the rise of promising and accomplished young, Indigenous filmmakers such as Ivan Sen, Rachael Perkins, Wayne Blair and Warwick Thornton, this guide focuses on the suitable films for schools implementing the Australian Curriculum in terms of cultural representations. This annotated guide suggests some films suitable for inclusion in classroom study and suggests some companion texts (novels, plays, television series and animations, documentaries, poetry and short stories) that may be studied alongside the films. Some of these are by Indigenous filmmakers and writers, and others features Aboriginal and Torres Strait Island representations in character and/or themes.

Effectiveness of cysteine proteases on protein/pigment film removal

Objective: Theaflavin (TF) from the black tea can react to human salivary proline-rich proteins (PRPs) to form stains on exposed dental surfaces. Here, we employed a model of protein/pigment film using TF and dephosphorylated bovine b-casein (Db-CN), which has an extended conformation, similar to that of salivary PRPs, on a sensor surface to assess the efficacy of cysteine proteases (CPs) including papain, stem bromelain, and ficin, on removing TF bound to Db-CN and the control TF readsorption on the residual substrate surfaces was also measured. Methods: The protein/pigment complex film was built by using a quartz crystal microbalance with dissipation (QCM-D). The efficacies of CPs were assessed by Boltzman equation model. The surface details were detected by grazing angle infrared spectroscopy spectra, atomic force microscopy images, and contact angles. Results: The efficacy order of CPs on hydrolyzing protein/pigment complex film is ficin > papain > bromelain. The results from grazing angle infrared spectroscopy spectra, atomic force microscopy images, and contact angles demonstrated that TF bound on the Db- CN was effectively removed by the CPs, and the amount of TF readsorption on both the residual film of the Db-CN/TF and the Db-CN was markedly decreased after hydrolysis. Conclusion: This study indicates the potential application of the CPs for tooth stain removal and suggests that these enzymes are worthy of further investigation for use in oral healthcare.

Graphene-based thin film supercapacitor with graphene oxide as dielectric spacer

Thin film supercapacitors are produced by using electrochemically exfoliated graphene (G) and wet-chemically produced graphene oxide (GO). Either G/GO/G stacked film or sole GO film are sandwiched by two Au films to make devices, where GO is the dielectric spacer. The addition of graphene film for charge storage can increase the capacitance about two times, compared to the simple Au electrode. It is found that the GO film has very high dielectric constant, accounting for the high capacitance of these devices. AC measurements reveal that the relative permittivity of GO is in the order of 104 within the frequency range of 0.1–70 Hz.

International acclaim : the role(s) of the international film festival in supporting emerging women’s cinema

International Film Festivals act as important sites for the exhibition of contemporary world cinema. Film festivals represent an increasingly transnational film culture, where audiences, filmmakers, distributors, press, critics and academics come together from all over the world to discover new films, network with one another and debate about the past, present and future of cinema. This research project investigates the role that international film festivals play within the wider international film industry, with a specific focus on emerging women filmmakers. It therefore explores the arena of contemporary women.s cinema at its intersection with the international film festival industry. The significance and original contribution of the research is its intervention in the growing field of film festival studies through a specific investigation of how international film festivals support emerging women filmmakers. The positioning of the research at the intersection of feminist film theory and festival research within the broader context of transnational cinema allows the examination of each festival, the attending filmmakers and their films to be addressed within a more refined and nuanced lens. A core method for the thesis is the close textual analysis of particular emerging women filmmakers. films which are screened at the respective festivals. The research also utilises the qualitative research strategies of the case study and the interview to ¡°seek to understand the context or setting of the participants through visiting this context and gathering information personally¡± (Creswell 2003, 9). The textual analysis is used in dialogue with the interviews and the participant observational data gathering to provide a related context for understanding these films and their cultural meanings, both personally for the filmmaker and transnationally across the festival circuit. The focus of the case studies is the Brisbane International Film Festival, the International Film Festival Rotterdam and the Toronto International Film Festival. These three festivals were chosen for their distinct geographical locations in the Asia Pacific, Europe and North America, as well as for their varying size and influence on the international film festival circuit. Specifically, I investigate the reasons behind why the organisers of a particular festival have chosen a certain woman.s film, how it is then packaged or displayed within the programme, and how all of this impacts on the filmmaker herself. The focus of my research is to investigate film festivals and their .real-life. applications and benefits for the filmmakers being supported, both through the exhibition of their films and through their attendance as festival guests. The research finds that the current generation of emerging women filmmakers has varying levels of experience and success at negotiating the international film festival circuit. Each of the three festivals examined include and promote the films of emerging women filmmakers through a range of strategies, such as specific programming strands dedicated to showcasing emerging talent, financial support through festival funds, providing visibility within the programme, exposure to international audiences and networking opportunities with industry professionals and other filmmakers. Furthermore, the films produced by the emerging women filmmakers revealed a strong focus on women.s perspectives and experiences, which were explored through the interweaving of particular aesthetic and cinematographic conventions.

Optimal catalyst thickness in titanium dioxide fixed film reactors: Mathematical modelling and experimental validation

The use of immobilised TiO2 for the purification of polluted water streams introduces the necessity to evaluate the effect of mechanisms such as the transport of pollutants from the bulk of the liquid to the catalyst surface and the transport phenomena inside the porous film. Experimental results of the effects of film thickness on the observed reaction rate for both liquid-side and support-side illumination are here compared with the predictions of a one-dimensional mathematical model of the porous photocatalytic slab. Good agreement was observed between the experimentally obtained photodegradation of phenol and its by-products, and the corresponding model predictions. The results have confirmed that an optimal catalyst thickness exists and, for the films employed here, is 5 μm. Furthermore, the modelling results have highlighted the fact that porosity, together with the intrinsic reaction kinetics are the parameters controlling the photocatalytic activity of the film. The former by influencing transport phenomena and light absorption characteristics, the latter by naturally dictating the rate of reaction.

Microstructure of an artificial grain boundary weak link in an YBa2Cu3O(7-δ) thin film grown on a (100)(110), [001]-tilt Y-ZrO2 bicrystal

The microstructure of an artificial grain boundary in an YBa2Cu3O7-δ (YBCO) thin film grown on a (100)(110), [001]-tilt yttria-stabilized-zirconia (YSZ) bicrystal substrate has been studied using transmission electron microscopy (TEM). The orientation relationship between the YBCO film and the YSZ substrate was [001]YBCO∥[001]YSZ and [110]YBCO∥[100]YSZ for each half of the bicrystal film. However, the exact boundary geometry of the bicrystal substrate was not transferred to the film. The substrate boundary was straight while the film boundary was wavy. In several cases there was bending of the lattice confined within a distance of a few basal-plane lattice spacings from the boundary plane and microfaceting. No intergranular secondary phase was observed but about 25% of the boundary was covered by c-axis-tilted YBCO grains and a-axis-oriented grains, both of which were typically adjacent to CuO grains or surrounded by a thin Cu-rich amorphous layer.