966 resultados para Q-switched lasers
Resumo:
制作了一种新型的半导体可饱和吸收镜--表面态型半导体可饱和吸收镜.用表面态型半导体可饱和吸收镜作为被动锁模吸收体实现了半导体端面泵浦Yb∶YAG激光器被动调Q锁模.在泵浦功率仅有1.4 W的情况下,获得了调Q锁模脉冲序列,锁模平均输出功率1 mW,锁模脉冲重复频率200 MHz.
Resumo:
用离子注入的半绝缘GaAs晶片作为吸收体和输出镜,在双包层掺镱光纤激光器上实现了调Q锁模.离子注入的能量为400keV的As+离子,注入剂量为1016/cm2,然后在600℃下退火20min.当抽运功率为5W时,脉冲平均输出功率为200mW,调Q包络重复频率为50kHz,半高宽为4μs,锁模脉冲重复频率为15MHz。
Resumo:
Monolithic electro-absorption modulated distributed-feedback(DFB) lasers are proposed and fabricated by using a modified double stack active layer.The 38mA threshold,9dB extinction ratio (from 0.5V to 3.0V),and about 5mW output power at the 100mA operation current are achieved.Compared with other reported results (only 1.5mW at the same operation current) of the traditional stack active structure,the proposed structure improves the output power of devices.
Resumo:
Ridge-waveguide distributed-feedback(DFB) lasers with highly strained InGaAs/InGaAsP active regions,emitting at 1.78 μm were fabricated by low pressure metal-organic vapor phase epitaxy(LP-MOVPE) and tested.The lasers exhibited threshold current of 33 mA for 900 μm long cavities at room temperature.A maximum light output power of 8 mW from one facet and an external differential quantum efficiency of 7% were also obtained.In oddition,the side mode suppression ratio (SMSR) is 27.5 dB.
Resumo:
介绍了国际上流行的长波长半导体可饱和吸收镜的研制方法及其在固体激光器被动锁模和被动调Q中所起的作用,并分别就Cr4+:YAG,Cr:Forsterite等激光器进行了阐述.
Resumo:
A novel self-aligned coupled waveguide (SACW) multi-quantum-well (MQW) distributed Bragg reflector (DBR) laser is proposed and demonstrated for the first time. By selectively removing the MQW layer and leaving the low SCH/SACW layer the Bragg grating is partially formed on this layer. By optimizing the thickness of the low SCH/SACW layer, a ~80% coupling efficiency between the MQW gain region and the passive region are obtained. The typical threshold current of the SACW DBR laser is 39 mA, the slope efficiency can reach to 0.2 mW/mA and the output power is more than 20 mW with a more than 30dB side mode suppression ratio.
Resumo:
A fitting process is used to measure the cavity loss and the quasi-Fermi-level separation for Fabry- Perot semiconductor lasers. From the amplified spontaneous emission (ASE) spectrum, the gain spectrum and single-pass ASE obtained by the Cassidy method are applied in the fitting process. For a 1550nm quantum well InGaAsP ridge waveguide laser, the cavity loss of about ~24cm~(-1) is obtained.
Resumo:
较全面介绍了几种掺钕激光晶体的光学性质。就掺钕激光晶体主要的三个波长探讨了用一种新型的吸收体(半导体可饱和吸收镜)进行被动调Q和锁模。
Resumo:
Small signal equivalent circuit model and modulation properties of vertical cavity-surface emitting lasers (VCSEL's) are presented. The modulation properties both in analytic-equation calculation and in circuit model simulation are studied. The analytic-equation calculation of the modulation properties is calculated by using Mathcad program and the circuit model simulation is simulation is simulated by using Pspice program respectively. The results of calculation and the simulation are in good agreement with each other. Experiment is performed to testify the circuit model.
Resumo:
于2010-11-23批量导入
Resumo:
国家自然科学基金
Resumo:
国家863计划
Resumo:
于2010-11-23批量导入
Resumo:
于2010-11-23批量导入