Preparation of prawn pickle and its storage characteristics

Prawn pickle was produced using smaller variety of prawn. Vinegar and salt was used to preserve the prawn muscle against spoilage. Different spices were used to get desired attractive flavour. Benzoic acid to the extent of 200 ppm was used as preservative. Several trials were carried out using different amounts of spices and different methods of preparation. After each trial the sample was subjected to sensory evaluation by judges consisting of five members who had previous experience of acting as panel members. Several trials were carried out to arrive at a final recipe as judged best by the taste panel. Utilizing this final recipe, a product was prepared and subjected to biochemical, bacteriological and organoleptic evaluation and found to be quite acceptable after seven months of storage in glass jar at ambient temperature. The product was subjected to large scale consumer acceptance trial involving 140 consumers, 42% of them ranked it excellent, 41% rated very good, 12% rated good while 5% of the consumers rated it as average.

Standardization and frozen storage of fish cutlet from bleached and unbleached mackerel mincemeat

In the present study, fish cutlets were prepared from bleached and unbleached mackerel mincemeat. Fish cutlets prepared from bleached meat had scored higher values for taste, flavour and overall acceptability as compared to those from unbleached mincemeat. Fish cutlets prepared with corn flour at the rate of 15% of fish mincemeat had scored higher values for all attributes as compared to other levels. Between the bleached and unbleached mincemeat, the scores for cutlet prepared with bleached mincemeat had higher score than that for the latter. There were no cracks in cutlets prepared with 15% and above corn flour levels as compared to those with lower levels. Fish cutlets prepared from bleached and unbleached mincemeat with spice mixture at 20 and 30% of the fish mince, respectively, had higher scores for taste, flavour, texture and overall acceptability as compared to those with other levels. Organoleptic quality of cutlet prepared from bleached and unbleached mackerel mince did not show changes in the appearance, colour and texture during storage. Changes were more prominent in flavour, taste and overall acceptability. Fish cutlets prepared from bleached mincemeat were acceptable for two months and those from unbleached mincemeat were acceptable up to one month from the point of view of organoleptic and biochemical qualities.

Preparation of an extruded fish snack using twin screw extruder and the storage characteristics of the product

A value-added extruded fish product was prepared with corn flour (80%) and fish (sciaenid) powder (20%), using a twin-screw extruder. The effect of different parameters like moisture, temperature, fish powder concentration, speed of the extruder and die-diameter on expansion ratio and crisp texture were studied. The storage characteristics of the final product were studied using three different types of packaging under nitrogen flushing. The study revealed that aluminum foil is the best packaging material to keep the product acceptable for more than three months.

Storage characteristics of solar-dried Indian mackerel

Fresh Rastrelliger kanagurta (Indian mackerel) was thoroughly washed, eviscerated, cleaned and salted overnight with dry salt (fish : salt :: 5:1). Salted mackerel was dried in solar drier and on cement floor under direct sun for three days. The temperature inside the drier was 948°C higher than the ambient temperature. The rate of drying was higher in solar drier than on cement floor. The dried fish packed in 300-gauge polythene bags was subjected to biochemical, microbiological and organoleptic evaluation at regular intervals to assess the storage life. The overall quality of fish dried in solar drier was better than that of the fish dried on cement floor under direct sun.

Bearings and energy storage

Passive magnetic bearings are ideal components for energy storage flywheels which require small dynamic loads and low-maintenance bearings with minimal power requirements. High temperature superconductors such as YBCO can be used to fabricate these bearings and achieve the desired magnetic properties. Stiffness and gap decay due to high speed can be addressed by dynamically altering bearing geometry to provide active control with bulk materials.

A preliminary study of two village tanks (reservoirs) in the Polonnaruwa area with biological notes on these reservoirs in Ceylon

The present study was initiated in conjunction with a project to utilize some of these small tanks as fishponds by introducing desirable species like Tilapia mossambica Peters and harvesting them at the end of a single season which may vary from 4-8 months depending on the reservoir. Two reservoirs Timbirigaswewa and Dalukanawewa were chosen for this study. Both of these are in the Polonnaruwa area (Fig. 1). Timbirigaswewa (Fig 4) is as all rain fed tank of about 30 acres while Dalukanawewa (Fig. 2) is stream fed with an acreage of just over 100.

Analysis of the piston ring/liner oil film development during warm-up for an SI-engine

A one-dimensional ring-pack lubrication model developed at MIT is applied to simulate the oil film behavior during the warm-up period of a Kohler spark ignition engine [1]. This is done by making assumptions for the evolution of the oil temperatures during warm-up and that the oil control ring during downstrokes is fully flooded. The ring-pack lubrication model includes features such as three different lubrication regimes, i.e. pure hydrodynamic lubrication, boundary lubrication and pure asperity contact, non-steady wetting of both inlet and outlet of the piston ring, capability to use all ring face profiles that can be approximated by piece-wise polynomials and, finally, the ability to model the rheology of multi-grade oils. Not surprisingly, the simulations show that by far the most important parameter is the temperature dependence of the oil viscosity. This dependence is subsequently examined further by choosing different oils. The baseline oil is SAE 10W30 and results are compared to those using the SAE 30 and the SAE 10W50 oils.

Improving discharge characteristics of indirect integral collector storage systems with multi-element storage

Desired performance of unpressurized integral collector storage systems hinges on the appropriate selection of storage volume and the immersed heat exchanger. This paper presents analytical results expressing the relation between storage volume, number of heat exchanger transfer units and temperature limited performance. For a system composed of a single storage element, the limiting behavior of a perfectly stratified storage element is shown to be superior to a fully-mixed storage element, consistent with more general analysis of thermal storage. Since, however, only the fully-mixed limit is readily obtainable in a physical system, the present paper also examines a division of the storage volume into separate compartments. This multi-element storage system shows significantly improved discharge characteristics as a result of improved elemental area utilization and temperature variation between elements, comparable in many cases to a single perfectly-stratified storage element. In addition, the multi-element system shows increased robustness with respect to variations in heat exchanger effectiveness and initial storage temperature.

Storage life of silverbelly (Leiognathus sp.) with delayed icing

Silver belly (leiognathus splendens) caught in September spoiled faster than the fish caught in May. This could be due to seasonal changes. For silver belly, Total Volatile Base (TVB) value could be used as a measure of spoilage. At the beginning of spoilage TVB value is between 30-40 mg. N/100g sample. The main spoilage for silver belly appears to start between 6 and 8 hours (at 28° C-30°C) after landing on board. Therefore it is not necessary to ice silverbelly immediately; it seems to be sufficient if icing can be done within 6 hours of landing on board.

Increase of storage shelf life of locally produced salted/dried fish by redrying and/or packeting

Experiments were undertaken to prolong the storage life of salted/dried fish by re-drying and/or packing. The storage life under normal conditions is 51 days; re-drying the fish at 50°C for 12 hours extends the storage life only by 7 days. However, re-drying and packing gizzard shad (Gonialosa manminna ) in polyethylene maintains the fish in excellent conditions for well over 87 days. The use of air tight bags for storing good quality salted dried fish is recommended.

The storage of red snapper (Lutjanus spp.) in ice, chilled sea water and chilled fresh water

The results are given of trials conducted to determine the effect on quality of holding fish (Lutjanus species) in chilled freshwater and also to compare the quality loss of fish stored in chilled seawater and chilled freshwater and in ice. No adverse effects were observed when storing in chilled freshwater apart from loss of external appearance after 6 days storage; taste panel tests showed acceptable conditions up to 15 days. Chilled seawater is unsuitable for storage as it spoils the intake of salt from the medium, making the flesh unpalatable.

Changes in lipids of mussel during storage

Proximate composition, lipid and fatty acid components of dried mussel and changes in lipids during 1 year storage were studied. Male mussel contained lower fat contents and higher contents of polyunsaturated fatty acids of C20:5n-3, and C22:6n-3. High percentages of Cl6:1, Cl7:1, Cl8:3n-3, C20:3n-8 existed in NL and C!6:0, C18:0, Cl8:1n-9, C20:2n-6, C20:5n- 3, C22:6n-3 were very rich in PL. Triglycerides phosphatidylcholine, cholesterol were major components of mussel lipids. Free fatty acids (FFA) increased greatly and phospholipids decreased during storage, saturated fatty acids showed an increase trend and polyunsaturated fatty adds decreased differently. Dried mussels were vacuum packed and air packed and packaging methods had a great influence on the oxidation of mussellip,ids, indicating preference of vacuum packaging.

Minimize frequency fluctuations of isolated power system with wind farm by using superconducting magnetic energy storage

Wind power generation as one of the most popular renewable energy applications is absorbing more and more attention all over the world. However, output power fluctuations of wind farm due to random variations of wind speed can cause network frequency and voltage flicker in power systems. The power quality consequently declines, particularly in an isolated power system such as the power system in a remote community or a small island. This paper proposes an application of superconducting magnetic energy storage (SMES) to minimize output fluctuations of an isolated power system with wind farm. The isolated power system is fed by a diesel generator and a wind generator consisting of a wind turbine and squirrel cage induction machine. The control strategy is detailed and the proposed system is evaluated by simulation in Matlab/Simulink.