996 resultados para 323-U1339B


Relevância:

10.00% 10.00%

Publicador:

Resumo:

Pen-based user interface has become a hot research field in recent years. Pen gesture plays an important role in Pen-based user interfaces. But it’s difficult for UI designers to design, and for users to learn and use. In this purpose, we performed a research on user-centered design and recognition pen gestures. We performed a survey of 100 pen gestures in twelve famous pen-bases systems to find problems of pen gestures currently used. And we conducted a questionnaire to evaluate the matching degree between commands and pen gestures to discover the characteristics that a good pen gestures should have. Then cognition theories were applied to analyze the advantages of those characteristics in helping improving the learnability of pen gestures. From these, we analyzed the pen gesture recognition effect and presented some improvements on features selection in recognition algorithm of pen gestures. Finally we used a couple of psychology experiments to evaluate twelve pen gestures designed based on the research. It shows those gestures is better for user to learn and use. Research results of this paper can be used for designer as a primary principle to design pen gestures in pen-based systems.

Relevância:

10.00% 10.00%

Publicador:

Resumo:

在长期定位试验的基础上,通过田间实地测定0~400 cm土壤含水量,分析和比较了不同种植方式下苜蓿草地土壤水分的变化。结果表明,连作苜蓿地、轮作苜蓿地的400 cm土层平均土壤含水量分别为10.6%和11.4%,均低于土壤稳定湿度,其干燥化指数为24.6%和37.2%,分别属强烈干燥化和严重干燥化,而小麦连作的干燥化指数为86.4%,属轻度干燥化。连作苜蓿地土壤干层最厚,400 cm处仍十分干燥,而轮作苜蓿地和连作小麦地到240 cm以下时,土壤水分开始有所恢复。连作苜蓿地和轮作苜蓿地通过降雨可恢复部分土壤水分,可恢复的土壤深度为40 cm和60 cm,而连作小麦地可达100 cm。不同施肥措施下连作苜蓿地土壤干燥化程度都很严重,施肥措施不是造成土壤干燥化的主要原因。轮作系统中不同轮作年限苜蓿地的土壤水分状况有一定的差异,但是均没有形成深厚的土壤干层。与连作苜蓿相比,轮作苜蓿不会大量消耗土壤深层水分而形成深厚的土壤干层,有利于土壤水分的可持续利用。

Relevância:

10.00% 10.00%

Publicador:

Resumo:

接枝及嵌段共聚物作为阻尼材料,人们已经做了一定的工作。但是,从接枝与嵌段共聚物的对比中,系统地研究合成方法及多种因素对阻尼性能的影响规律,尚未见报导。这个工作就是从事这方面的研究,认为这种研究对于阻尼材料的分子设计及材料的推广应用具有意义的。所造反的反应体系及合成方法是,由端羟基聚醚即端羟基聚四氢呋喃及端羟基环氧丙烷,与顺丁烯二酸酐反应,以N,N-二四基苄胺为催化剂,合成了不同分子量的聚四氢呋喃大分子单体、不同结构(线型、支化型)的聚环氧丙烷大分子单体和相应的遥爪低聚物。由这些大分子单体和遥爪低聚物与苯乙烯共聚,用过氧化环已酮一环烷酸钴为氧化、还原引发体系,合成了各种嵌段、接枝共聚物。用DSC研究上述大分子单体及遥抓苯乙烯的固化反应动力学,结果表明:反应级数约为2,反应活化能为60 ~ 100kJ/mol;频率因子的对数LnA为17.4 ~ 26.7(min~(-1))。由这些动力学参数及Arrhenius方程可预测适当的固化反应条件。我们用粘弹谱仪研究了嵌段及接枝共聚物的阻尼性能,对于接枝共聚物,阴尼峰随着聚醚含量的增加具有先下降后升高的变化趋势,升高的原因,是由于共聚物中支链节的相互缠结,增大了分子间相对运动时的摩擦所致。具有较长的支链或支链上带有侧基的共聚物,阻尼性能较好。嵌段共聚物的阻尼峰随着聚醚含量的增加,具有下降的趋势,聚醚起到内部增塑的作用聚醚上侧基的存在,也有助于阻尼性能的提高,这在比较聚四氢呋喃/聚苯乙烯嵌段共聚物与聚环氧丙烷/聚苯乙烯嵌段共聚物的阻尼性能时,可以观察到。我们还研究了不同添加剂对共聚物阻尼性能的影响,实验结果表明,环氧树脂作为添加剂时,使共聚物的阻尼性能得到提高;而丁腈羟作为添加剂时,仅使共聚物的阻尼峰变宽,而阻尼峰值变小。红外光谱跟踪反应过程及电镜照片表明,这些添加剂都不同程度地参与了固化反应。关于这些共聚物的力学性能,测定的结果表明,嵌段共聚物比较,前者的抗张强度较大,伸长率较小。在嵌段和接枝共聚中,聚醚含量增加,两者的抗张强度均呈下降的趋势,聚醚起到增塑的作用。为了评价材料的耐热性能,我们做了各共聚物的热重分析,(TG)实验,实验结果表明,各共聚物具有较好的热稳定性,尤以嵌段共聚物为好。加有添加剂时,有助于热稳定性能的提高。以PPO/PS嵌段及接枝共聚物为例;嵌段共聚物的分解温度为352 ℃; 接枝共聚物分解温度为323 ℃;加有丁腈羟添加剂后,接枝共聚物的分解温度为358 ℃。

Relevância:

10.00% 10.00%

Publicador:

Relevância:

10.00% 10.00%

Publicador:

Relevância:

10.00% 10.00%

Publicador:

Resumo:

The composition and microstructure of buried layers of AlN formed by high energy N+ ion implantation into polycrystalline Al have been determined. Both bulk and evaporated thin films of Al have been implanted with 100 and 200 keV N+ ions to doses of up to 1.8 x 10(18)/cm2. The layers have been characterised using SIMS, XTEM, X-ray diffraction, FTIR, RBS and in terms of their microhardness. It is found that, for doses greater than the critical dose, buried, polycrystalline AlN layers are formed with preferred (100) or (002) orientations, which are sample specific. With increasing dose the nitrogen concentration saturates at the value for stoichiometric AlN although the synthesised compound is found to be rich in oxygen.

Relevância:

10.00% 10.00%

Publicador:

Resumo:

Dichlorosilane, a gas at normal temperature with a boiling point of 8.3 degrees C, is very difficult to sample and detect using conventional methods. We reduced phosphorus in dichlorosilane to PH3 by hydrogen at high temperature, then PH3 was separated from chlorosilanes by NaOH solution and from other hydrides by chromatographic absorption. Thus the problem of interference of chlorosilanes and other hydrides was overcome and PH, was measured by a double flame photometric detector at 526 nm. This method was sensitive, reliable and convenient and the sensitivity reached as low as 0.04 mu g/l.

Relevância:

10.00% 10.00%

Publicador:

Resumo:

Silicon crystal-facet-dependent nanostructures have been successfully fabricated on a (100)-oriented silicon-on-insulator wafer using electron-beam lithography and the silicon anisotropic wet etching technique. This technique takes ad-vantage of the large difference in etching properties for different crystallographic planes in alkaline solution. The mini-mum size of the trapezoidal top for those Si nanostructures can be reduced to less than 10nm. Scanning electron microscopy(SEM) and atomic force microscopy (AFM) observations indicate that the etched nanostructures have controllable shapes and smooth surfaces.

Relevância:

10.00% 10.00%

Publicador:

Resumo:

A monolithically integrated optoelectronic receiver is presented. A silicon-based photo-diode and receiver circuits are integrated on identical substrates in order to eliminate the parasitics induced by hybrid packaging. Implemented in the present deep sub-micron MS/RF (mixed signal, radio frequency) CMOS,this monolithically OEIC takes advantage of several new features to improve the performance of the photo-diode and eventually the whole OEIC.

Relevância:

10.00% 10.00%

Publicador:

Resumo:

为了生长制作器件所需的外延片,采用低压金属有机物化学气相沉积方法在半绝缘InP衬底上生长了InP/InGaAs异质结双极晶体管(HBT)结构、1.55μm多量子阱激光二极管以及两者集成的光发射光电集成电路材料结构.激光器结构的生长温度为655℃,有源区为5个周期的InGaAsP/ InGaAsP多量子阱(阱区λ=1.6μm,垒区λ=1.28μm);HBT结构则采用550℃低温生长,其中基区采用Zn掺杂,掺杂浓度约为2×1019cm-3.对生长的各种结构分别进行了X射线双晶衍射,光致发光谱和二次离子质谱仪的测试,结果表明所生长的材料结构已满足制作器件的要求.

Relevância:

10.00% 10.00%

Publicador:

Resumo:

Resonant cavity enhancement (RCE) typed optical detector and modulator which operating at wavelength band of 1.06 μm is reported. The peak quantum efficiency of detector is reasonably high as 50% without bias, and the photocurrent contrast ratio of modulator is 3.6 times at -3.5 V as compared to 0 V. The incident angle dependence of RCE device's photoelectric response is investigated carefully.