Spatio-temporal scanning and statistical test of the accelerating moment release (AMR) model using Australian earthquake data

The Accelerating Moment Release (AMR) preceding earthquakes with magnitude above 5 in Australia that occurred during the last 20 years was analyzed to test the Critical Point Hypothesis. Twelve earthquakes in the catalog were chosen based on a criterion for the number of nearby events. Results show that seven sequences with numerous events recorded leading up to the main earthquake exhibited accelerating moment release. Two occurred near in time and space to other earthquakes preceded by AM R. The remaining three sequences had very few events in the catalog so the lack of AMR detected in the analysis may be related to catalog incompleteness. Spatio-temporal scanning of AMR parameters shows that 80% of the areas in which AMR occurred experienced large events. In areas of similar background seismicity with no large events, 10 out of 12 cases exhibit no AMR, and two others are false alarms where AMR was observed but no large event followed. The relationship between AMR and Load-Unload Response Ratio (LURR) was studied. Both methods predict similar critical region sizes, however, the critical point time using AMR is slightly earlier than the time of the critical point LURR anomaly.

Fully spatial wide-band beamforming using a rectangular array of planar monopoles

This paper describes a spatial beamformer which by using a rectangular array antenna steers a beam in azimuth over a wide frequency band without frequency filters or tap-delay networks. The weighting coefficients are real numbers which can be realized by attenuators or amplifiers. A prototype including a 4 x 4 array of square planar monopoles and a feeding network composed of attenuators, power divider/combiners and a rat-race hybrid is developed to test the validity of this wide-band beamforming concept. The experimental results prove the validity of this wide-band spatial beamformer for small size arrays.

Multiple-acquisition parallel imaging combined with a transceive array for the amelioration of high-field RF distortion: a modeling study

A new method for ameliorating high-field image distortion caused by radio frequency/tissue interaction is presented and modeled, The proposed method uses, but is not restricted to, a shielded four-element transceive phased array coil and involves performing two separate scans of the same slice with each scan using different excitations during transmission. By optimizing the amplitudes and phases for each scan, antipodal signal profiles can be obtained, and by combining both images together, the image distortion can be reduced several-fold. A hybrid finite-difference time-domain/method-of-moments method is used to theoretically demonstrate the method and also to predict the radio frequency behavior inside the human head. in addition, the proposed method is used in conjunction with the GRAPPA reconstruction technique to enable rapid imaging. Simulation results reported herein for IIT (470 MHz) brain imaging applications demonstrate the feasibility of the concept where multiple acquisitions using parallel imaging elements with GRAPPA reconstruction results in improved image quality. (c) 2006 Wiley Periodicals, Inc.

Mixed order parameters, accidental nodes and broken time reversal symmetry in organic superconductors: a group theoretical analysis

We present a group theoretical analysis of several classes of organic superconductor. We predict that highly frustrated organic superconductors, such as K-(ET)(2)Cu-2(CN)(3) (where ET is BEDT-TTF, bis(ethylenedithio) tetrathiafulvalene) and beta'-[Pd(dmit)(2)](2)X, undergo two superconducting phase transitions, the first from the normal state to a d-wave superconductor and the second to a d + id state. We show that the monoclinic distortion of K-(ET)(2)Cu(NCS)(2) means that the symmetry of its superconducting order parameter is different from that of orthorhombic-K-(ET)(2)Cu[N(CN)(2)] Br. We propose that beta'' and theta phase organic superconductors have d(xy) + s order parameters.

Evaluating the properties of a stage-specific self-efficacy scale for physical activity using classical test theory, confirmatory factor analysis and item response modeling

The purpose of this paper was to evaluate the psychometric properties of a stage-specific selfefficacy scale for physical activity with classical test theory (CTT), confirmatory factor analysis (CFA) and item response modeling (IRM). Women who enrolled in the Women On The Move study completed a 20-item stage-specific self-efficacy scale developed for this study [n = 226, 51.1% African-American and 48.9% Hispanic women, mean age = 49.2 (67.0) years, mean body mass index = 29.7 (66.4)]. Three analyses were conducted: (i) a CTT item analysis, (ii) a CFA to validate the factor structure and (iii) an IRM analysis. The CTT item analysis and the CFA results showed that the scale had high internal consistency (ranging from 0.76 to 0.93) and a strong factor structure. Results also showed that the scale could be improved by modifying or eliminating some of the existing items without significantly altering the content of the scale. The IRM results also showed that the scale had few items that targeted high self-efficacy and the stage-specific assumption underlying the scale was rejected. In addition, the IRM analyses found that the five-point response format functioned more like a four-point response format. Overall, employing multiple methods to assess the psychometric properties of the stage-specific self-efficacy scale demonstrated the complimentary nature of these methods and it highlighted the strengths and weaknesses of this scale.

On the absolute calibration of bench-top small-angle X-ray scattering instruments: a comparison of different standard methods

Absolute calibration relates the measured (arbitrary) intensity to the differential scattering cross section of the sample, which contains all of the quantitative information specific to the material. The importance of absolute calibration in small-angle scattering experiments has long been recognized. This work details the absolute calibration procedure of a small-angle X-ray scattering instrument from Bruker AXS. The absolute calibration presented here was achieved by using a number of different types of primary and secondary standards. The samples were: a glassy carbon specimen, which had been independently calibrated from neutron radiation; a range of pure liquids, which can be used as primary standards as their differential scattering cross section is directly related to their isothermal compressibility; and a suspension of monodisperse silica particles for which the differential scattering cross section is obtained from Porod's law. Good agreement was obtained between the different standard samples, provided that care was taken to obtain significant signal averaging and all sources of background scattering were accounted for. The specimen best suited for routine calibration was the glassy carbon sample, due to its relatively intense scattering and stability over time; however, initial calibration from a primary source is necessary. Pure liquids can be used as primary calibration standards, but the measurements take significantly longer and are, therefore, less suited for frequent use.

Relations between physiologic parameters and pulse transit time during loaded breathing

Pulse transit time (PTT) is a non-invasive measure, defined as time taken for the pulse pressure waves to travel from the R-wave of electrocardiogram to a selected peripheral site. Baseline PTT value is known to be influenced by physiologic variables like heart rate (HR), blood pressure (BP) and arterial compliance (AC). However, few quantitative data are available describing the factors which can influence PTT measurements in a child during breathing. The aim of this study was to investigate the effects of changes in breathing efforts on PTT baseline and fluctuations. Two different inspiratory resistive loading (IRL) devices were used to simulate loaded breathing in order to induce these effects. It is known that HR can influence the normative PTT value however the effect of HR variability (HRV) is not well-studied. Two groups of 3 healthy children ( 0.05) HR changes during all test activities. Results showed that HRV is not the sole contributor to PTT variations and suggest that changes in other physiologic parameters are also equally important. Hence, monitoring PTT measurement can be indicative of these associated changes during tidal or increased breathing efforts in healthy children.

Towards a Modeling Environment for Earth Systems Simulations

The developments of models in Earth Sciences, e.g. for earthquake prediction and for the simulation of mantel convection, are fare from being finalized. Therefore there is a need for a modelling environment that allows scientist to implement and test new models in an easy but flexible way. After been verified, the models should be easy to apply within its scope, typically by setting input parameters through a GUI or web services. It should be possible to link certain parameters to external data sources, such as databases and other simulation codes. Moreover, as typically large-scale meshes have to be used to achieve appropriate resolutions, the computational efficiency of the underlying numerical methods is important. Conceptional this leads to a software system with three major layers: the application layer, the mathematical layer, and the numerical algorithm layer. The latter is implemented as a C/C++ library to solve a basic, computational intensive linear problem, such as a linear partial differential equation. The mathematical layer allows the model developer to define his model and to implement high level solution algorithms (e.g. Newton-Raphson scheme, Crank-Nicholson scheme) or choose these algorithms form an algorithm library. The kernels of the model are generic, typically linear, solvers provided through the numerical algorithm layer. Finally, to provide an easy-to-use application environment, a web interface is (semi-automatically) built to edit the XML input file for the modelling code. In the talk, we will discuss the advantages and disadvantages of this concept in more details. We will also present the modelling environment escript which is a prototype implementation toward such a software system in Python (see www.python.org). Key components of escript are the Data class and the PDE class. Objects of the Data class allow generating, holding, accessing, and manipulating data, in such a way that the actual, in the particular context best, representation is transparent to the user. They are also the key to establish connections with external data sources. PDE class objects are describing (linear) partial differential equation objects to be solved by a numerical library. The current implementation of escript has been linked to the finite element code Finley to solve general linear partial differential equations. We will give a few simple examples which will illustrate the usage escript. Moreover, we show the usage of escript together with Finley for the modelling of interacting fault systems and for the simulation of mantel convection.

Test of a mediation model of perceived organisational support

This study examined the mediating influence of trust in organization (TIO) and organization-based self-esteem (OBSE) on the relationship between perceived organization support (POS) and its work outcomes. Data were obtained from employee–supervisor dyads from multiple organizations located in a major city in southern China. Structural equation modeling results revealed that: (a) POS related to TIO and OBSE and (b) TIO and OBSE fully mediated the relationship between POS and the work outcomes of organizational commitment and in-role performance, but partially mediated the POS–organizational citizenship behavior relationship.

Antecedents and outcomes of abusive supervision:test of a trickle-down model

The authors examined antecedents of abusive supervision and the relative importance of interactional and procedural justice as mediators of the relationship between abusive supervision and the work outcomes of affective organizational commitment and individual- and organization-directed citizenship behaviors. Data were obtained from subordinate-supervisor dyads from a telecommunication company located in southeastern China. Results of moderated regression analysis revealed that authoritarian leadership style moderated the relationship between supervisors' perceptions of interactional justice and abusive supervision such that the relationship was stronger for supervisors high rather than low in authoritarian leadership style. In addition, results of structural equation modeling analysis revealed that subordinates' perceptions of interactional but not procedural justice fully mediated the relationship between abusive supervision and the work outcomes. Implications for future investigations of abusive supervision are discussed. Copyright 2007 by the American Psychological Association.

Countering the trend towards careerist orientation in the age of downsizing:test of a social exchange model

Predicated on the assumption that employee careerist orientation resulting from organizational actions to cut costs constitutes a potential threat to their long-term profitability and success, this study proposed and tested a social exchange model of careerist orientation in the People's Republic of China. Specifically, it was hypothesized that organizational justice and career growth opportunities will be related to careerist orientation, but the relationship will be mediated by trust in employer. Structural equation modeling results provided support for the model. Trust in organization fully mediated the relationship between careerist orientation and its antecedents.