Development and Automatization of a Planar Jet Wind Tunnel for the X-wire Calibration


Autoria(s): Eryildiz, Mehmet Berkay
Contribuinte(s)

Bellani, Gabriele

Data(s)

13/10/2022

Resumo

The scope of this study is to design an automatic control system and create an automatic x-wire calibrator for a facility named Plane Air Tunnel; whose exit creates planar jet flow. The controlling power state as well as automatic speed adjustment of the inverter has been achieved. Thus, the wind tunnel can be run with respect to any desired speed and the x-wire can automatically be calibrated at that speed. To achieve that, VI programming using the LabView environment was learned, to acquire the pressure and temperature, and to calculate the velocity based on the acquisition data thanks to a pitot-static tube. Furthermore, communication with the inverter to give the commands for power on/off and speed control was also done using the LabView VI coding environment. The connection of the computer to the inverter was achieved by the proper cabling using DAQmx Analog/Digital (A/D) input/output (I/O). Moreover, the pressure profile along the streamwise direction of the plane air tunnel was studied. Pressure tappings and a multichannel pressure scanner were used to acquire the pressure values at different locations. Thanks to that, the aerodynamic efficiency of the contraction ratio was observed, and the pressure behavior was related to the velocity at the exit section. Furthermore, the control of the speed was accomplished by implementing a closed-loop PI controller on the LabView environment with and without using a pitot-static tube thanks to the pressure behavior information. The responses of the two controllers were analyzed and commented on by giving suggestions. In addition, hot wire experiments were performed to calibrate automatically and investigate the velocity profile of a turbulent planar jet. To be able to analyze the results, the physics of turbulent planar jet flow was studied. The fundamental terms, the methods used in the derivation of the equations, velocity profile, shear stress behavior, and the effect of vorticity were reviewed.

Formato

application/pdf

Identificador

http://amslaurea.unibo.it/26985/1/Thesis%20-%20Mehmet%20Berkay%20ERYILDIZ.pdf

Eryildiz, Mehmet Berkay (2022) Development and Automatization of a Planar Jet Wind Tunnel for the X-wire Calibration. [Laurea magistrale], Università di Bologna, Corso di Studio in Aerospace engineering [LM-DM270] - Forli' <http://amslaurea.unibo.it/view/cds/CDS5723/>

Idioma(s)

en

Publicador

Alma Mater Studiorum - Università di Bologna

Relação

http://amslaurea.unibo.it/26985/

Direitos

Free to read

Palavras-Chave #Automatization, VI coding, calibration, hot wire anemometry #Aerospace engineering [LM-DM270] - Forli'
Tipo

PeerReviewed

info:eu-repo/semantics/masterThesis