Skeletal muscle mitochondrial and lipid droplet content assessed with standardized grid sizes for stereology.

Skeletal muscle mitochondrial (Mito) and lipid droplet (Lipid) content are often measured in human translational studies. Stereological point counting allows computing Mito and Lipid volume density (Vd) from micrographs taken with transmission electron microscopes. Former studies are not specific as to the size of individual squares that make up the grids, making reproducibility difficult, particularly when different magnifications are used. Our objective was to determine which size grid would be best at predicting fractional volume efficiently without sacrificing reliability and to test a novel method to reduce sampling bias. Methods: ten subjects underwent vastus lateralis biopsies. Samples were fixed, embedded, and cut longitudinally in ultrathin sections of 60 nm. Twenty micrographs from the intramyofibrillar region were taken per subject at Ã-33,000 magnification. Different grid sizes were superimposed on each micrograph: 1,000 Ã- 1,000 nm, 500 Ã- 500 nm, and 250 Ã- 250 nm. Results: mean Mito and Lipid Vd were not statistically different across grids. Variability was greater when going from 1,000 Ã- 1,000 to 500 Ã- 500 nm grid than from 500 Ã- 500 to 250 Ã- 250 nm grid. Discussion: this study is the first to attempt to standardize grid size while keeping with the conventional stereology principles. This is all in hopes of producing replicable assessments that can be obtained universally across different studies looking at human skeletal muscle mitochondrial and lipid droplet content.

Smart instrumentation for determination of ligament stiffness and ligament balance in total knee arthroplasty.

Ligament balance is an important and subjective task performed during total knee arthroplasty (TKA) procedure. For this reason, it is desirable to develop instruments to quantitatively assess the soft-tissue balance since excessive imbalance can accelerate prosthesis wear and lead to early surgical revision. The instrumented distractor proposed in this study can assist surgeons on performing ligament balance by measuring the distraction gap and applied load. Also the device allows the determination of the ligament stiffness which can contribute a better understanding of the intrinsic mechanical behavior of the knee joint. Instrumentation of the device involved the use of hall-sensors for measuring the distractor displacement and strain gauges to transduce the force. The sensors were calibrated and tested to demonstrate their suitability for surgical use. Results show the distraction gap can be measured reliably with 0.1mm accuracy and the distractive loads could be assessed with an accuracy in the range of 4N. These characteristics are consistent with those have been proposed, in this work, for a device that could assist on performing ligament balance while permitting surgeons evaluation based on his experience. Preliminary results from in vitro tests were in accordance with expected stiffness values for medial collateral ligament (MCL) and lateral collateral ligament (LCL).

Smart suction device for less blood trauma: a comparison with Cell Saver.

OBJECTIVE: The major source of hemolysis during cardiopulmonary bypass remains the cardiotomy suction and is primarily due to the interaction between air and blood. The Smart suction system involves an automatically controlled aspiration designed to avoid the mixture of blood with air. This study was set-up to compare this recently designed suction system to a Cell Saver system in order to investigate their effects on blood elements during prolonged intrathoracic aspiration. METHODS: In a calf model (n=10; mean weight, 69.3+/-4.5 kg), a standardized hole was created in the right atrium allowing a blood loss of 100 ml/min, with a suction cannula placed into the chest cavity into a fixed position during 6 h. The blood was continuously aspirated either with the Smart suction system (five animals) or the Cell Saver system (five animals). Blood samples were taken hourly for blood cell counts and biochemistry. RESULTS: In the Smart suction group, red cell count, plasma protein and free hemoglobin levels remained stable, while platelet count exhibited a significant drop from the fifth hour onwards (prebypass: 683+/-201*10(9)/l, 5 h: 280+/-142*10(9)/l, P=0.046). In the Cell Saver group, there was a significant drop of the red cell count from the third hour onwards (prebypass: 8.6+/-0.9*10(12)/l, 6 h: 6.3+/-0.4*10(12)/l, P=0.02), of the platelet count from the first hour onwards (prebypass: 630+/-97*10(9)/l, 1 h: 224+/-75*10(9)/l, P<0.01), and of the plasma protein level from the first hour onwards (prebypass: 61.7+/-0.6 g/l, 1 h: 29.3+/-9.1 g/l, P<0.01). CONCLUSIONS: In this experimental set-up, the Smart suction system avoids damage to red cells and affects platelet count less than the Cell Saver system which induces important blood cell destruction, as any suction device mixing air and blood, as well as severe hypoproteinemia with its metabolic, clotting and hemodynamic consequences.

Small access (30F) clinical central venous smart cannulation: is it adequate?

OBJECTIVES: To assess the performance of 45F vs. 36F smartcanula in CPB with gravity drainage alone. METHODS: Twenty patients were randomly assigned to two groups receiving for venous drainage a smartcanula which is collapsed over a mandrel for trans-atrial insertion into the inferior vena cava and expanded in situ to either 45F or 36F. RESULTS: Valve replacement/repair was realized in 7/10 and/or CABG in 6/10 for 36F (69+/-13 years) vs. 5/10 and 5/10, respectively, for 45F (63+/-11 years: NS). Body weight and surface area (BSA) were 83+/-9 kg (1.9+/-0.2 m2, max 2.2 m2) for 36F vs. 79+/-6 kg: NS (1.9+/-0.1 m2 (NS), max 2.1 m2) for 45F. Insertion and access orifice diameter (area) was 6 mm and 10 mm (78.5 mm2) for the 36F vs. 6 mm and 13 mm (132 mm2) for the 45F (+69%). Calculated target pump flow (2.4 l/min/m2) was 4.7+/-0.4 l/min for 36F vs. 4.5+/-0.3 l/min for 45F. Achieved pump flow accounted for 5.0+/-0.3 l/min for 36F (8% above target) vs. 4.8+/-0.3 l/min for 45F (8% above target): NS. The water balance during the pump run (clear volume added minus hemofilter and urine output) was 2.2+/-0.3 l for 36F vs. 2.0 l for 45F: NS. CONCLUSION: Due to its 'open' wall (the vena cava provides the seal), its reduced wall thickness (range: 0.0-0.4 mm), and its self-expanding design, the 36F smartcanula requiring a 30F access orifice has sufficient drainage capacity by gravity alone for full CPB in adults with a BSA up to 2.2 mm2.

Smart antennas in software radio base stations

The application of adaptive antenna techniques to fixed-architecture base stations has been shown to offer wide-ranging benefits, including interference rejection capabilities or increased coverage and spectral efficiency.Unfortunately, the actual implementation ofthese techniques to mobile communication scenarios has traditionally been set back by two fundamental reasons. On one hand, the lack of flexibility of current transceiver architectures does not allow for the introduction of advanced add-on functionalities. On the other hand, theoften oversimplified models for the spatiotemporal characteristics of the radio communications channel generally give rise toperformance predictions that are, in practice, too optimistic. The advent of software radio architectures represents a big step toward theintroduction of advanced receive/transmitcapabilities. Thanks to their inherent flexibilityand robustness, software radio architecturesare the appropriate enabling technology for theimplementation of array processing techniques.Moreover, given the exponential progression ofcommunication standards in coexistence andtheir constant evolution, software reconfigurabilitywill probably soon become the only costefficientalternative for the transceiverupgrade. This article analyzes the requirementsfor the introduction of software radio techniquesand array processing architectures inmultistandard scenarios. It basically summarizesthe conclusions and results obtained withinthe ACTS project SUNBEAM,1 proposingalgorithms and analyzing the feasibility ofimplementation of innovative and softwarereconfigurablearray processing architectures inmultistandard settings.

Smart antennas: state of the art

Aim of this contribution is to illustrate the state of the art of smart antenna research from several perspectives. The bow is drawn from transmitter issues via channel measurements and modeling, receiver signal processing, network aspects, technological challenges towards first smart antenna applications and current status of standardization. Moreover, some future prospects of different disciplines in smart antenna research are given.

Smart List : Llistat intel·ligent de compres

Treball de final de carrera que consisteix en una aplicació per a mòbils que connecta el servei REST amb un servidor.

Web Client for Smart Messaging Exchange

TeliaSoneran älykkään viestintäjärjestelmän kehitysluonnoksella (SME) pilotoidaan prototyyppipalveluita, joiden avulla asiakkaat voivat välittää viestejä matkapuhelimilla sekä tietokoneilla. SME:n peruspalveluita voidaan käyttää SIP-standardin mukaisilla asiakasohjelmilla sekä SME:n omilla WAP- ja WWW-käyttöliittymillä. Käyttäjät voivat nähdä toistensa tilatiedon, muuttaa omaa tilatietoaan sekä lähettää SIP-pikaviestejä, sähköpostiviestejä ja tekstiviestejä. Käyttäjät voivat myös ylläpitää listaa yhteyshenkilöistään, vastaanottaa pikaviestejä ja selata vastaanotettuja viestejä. Diplomityössä käsitellään yleisesti SME-järjestelmän rakennetta ja paneudutaan tutkimaan työssä toteutetun SME:n WWW-asiakasohjelman toteutusta. Diplomityössä käydään läpi projektiin liittyviä standardeja, suosituksia, toteustekniikoita sekä palveluita. Lisäksi tarkastellaan työssä hyödynnettyjä ohjelmointirajapintoja, nykyisiä älypuhelimia sekä niiden Internet-selaimia, jotka rajoittavat WWW-asiakaspalvelun toteutuksessa käytettyjä toteutustekniikkavaihtoehtoja. Lopuksi esitellään toteutettujen ohjelmistojen sisäistä rakennetta ja toimintaa.

Use of scenario analysis in studying emerging technology – Case Grid computing

Tutkimuksen selvitettiin miten skenaarioanalyysia voidaan käyttää uuden teknologian tutkimisessa. Työssä havaittiin, että skenaarioanalyysin soveltuvuuteen vaikuttaa eniten teknologisen muutoksen taso ja saatavilla olevan tiedon luonne. Skenaariomenetelmä soveltuu hyvin uusien teknologioiden tutkimukseen erityisesti radikaalien innovaatioiden kohdalla. Syynä tähän on niihin liittyvä suuri epävarmuus, kompleksisuus ja vallitsevan paradigman muuttuminen, joiden takia useat muut tulevaisuuden tutkimuksen menetelmät eivät ole tilanteessa käyttökelpoisia. Työn empiirisessä osiossa tutkittiin hilaverkkoteknologian tulevaisuutta skenaarioanalyysin avulla. Hilaverkot nähtiin mahdollisena disruptiivisena teknologiana, joka radikaalina innovaationa saattaa muuttaa tietokonelaskennan nykyisestä tuotepohjaisesta laskentakapasiteetin ostamisesta palvelupohjaiseksi. Tällä olisi suuri vaikutus koko nykyiseen ICT-toimialaan erityisesti tarvelaskennan hyödyntämisen ansiosta. Tutkimus tarkasteli kehitystä vuoteen 2010 asti. Teorian ja olemassa olevan tiedon perusteella muodostettiin vahvaan asiantuntijatietouteen nojautuen neljä mahdollista ympäristöskenaariota hilaverkoille. Skenaarioista huomattiin, että teknologian kaupallinen menestys on vielä monen haasteen takana. Erityisesti luottamus ja lisäarvon synnyttäminen nousivat tärkeimmiksi hilaverkkojen tulevaisuutta ohjaaviksi tekijöiksi.

A conceptual model for grid learning services automatic composition

Peer-reviewed

Modelling of North-West Russian market behavior considering technical restrictions of transmission grid

Nowadays the Finnish-Russian electric energy interaction is carried out through the back-to-back DC Vyborg substation and several power plants working synchronously with Finnish power system. Constant amount of energy flows in one direction — from Russia to Finland. But the process of electricity market development in Russian energy system makes the new possibilities of electrical cooperation available. The goal of master's thesis is to analyze the current state and possible evolution trends of North-West Russian system in relation with future possible change in power flow between Russia and Finland. The research is done by modelling the market of North-West Russia and examination of technical grid restrictions. The operational market models of North-West region of Russia for the years 2008 and 2015 were created during the research process. The description of prepared market models together with modelling results and their analysis are shown in the work. The description of power flow study process and results are also presented.