Solubility and permeability as in vitro predictors for in vivo performance of fenofibrate IR solid dosage forms

This current work focused on the simulation of in vivo dissolution and permeation in order to be able to predict the in vivo performance of orally administered fenofibrate immediate release formulations. Therefore, the effects of the formulation surfactants on in vivo solubility and permeation of fenofibrate under physiologically relevant excipient concentrations were emphasized.rnIt was shown that the surfactant sodium dodecyl sulfate (SDS) may decrease rather than increase the solubility of fenofibrate in vivo. This was related to the interference of SDS with the vesicular system of the biorelevant medium, FaSSIFmod, and therefore its solubilization capacity. rnMoreover, in vitro permeation studies revealed that SDS concentrations inversely correlated with fenofibrate permeability. Through combination of the observed permeation and solubility data a good in vitro/in vivo correlation regarding Cmax values in humans could be established for five fenofibrate formulations which were based on the same manufacturing technique.rnBesides the experimental part, the major characteristics and their potential implementation in a dissolution/permeation device were discussed based on the promising realization of the in vitro solubility and permeation methods. rn

Patterns in and kinetics of phase separation in binary mixtures

This work focused mainly on two aspects of kinetics of phase separation in binary mixtures. In the first part, we studied the interplay of hydrodynamics and the phase separation of binary mixtures. A considerably flat container (a laterally extended geometry), at an aspect ratio of 14:1 (diameter: height) was chosen, so that any hydrodynamic instabilities, if they arise, could be tracked. Two binary mixtures were studied. One was a mixture of methanol and hexane, doped with 5% ethanol, which phase separated under cooling. The second was a mixture of butoxyethanol and water, doped with 2% decane, which phase separated under heating. The dopants were added to bring down the phase transition temperature around room temperature.rnrnAlthough much work has been done already on classical hydrodynamic instabilities, not much has been done in the understanding of the coupling between phase separation and hydrodynamic instabilities. This work aimed at understanding the influence of phase separation in initiating any hydrodynamic instability, and also vice versa. Another aim was to understand the influence of the applied temperature protocol on the emergence of patterns characteristic to hydrodynamic instabilities. rnrnOn slowly cooling the system continuously, at specific cooling rates, patterns were observed in the first mixture, at the start of phase separation. They resembled the patterns observed in classical Rayleigh-Bénard instability, which arises when a liquid continuously is heated from below. To suppress this classical convection, the cooling setup was tuned such that the lower side of the sample always remained cooler by a few millikelvins, relative to the top. We found that the nature of patterns changed with different cooling rates, with stable patterns appearing for a specific cooling rate (1K/h). On the basis of the cooling protocol, we estimated a modified Rayleigh number for our system. We found that the estimated modified Rayleigh number is near the critical value for instability, for cooling rates between 0.5K/h and 1K/h. This is consistent with our experimental findings. rnrnThe origin of the patterns, in spite of the lower side being relatively colder with respect to the top, points to two possible reasons. 1) During phase separation droplets of either phases are formed, which releases a latent heat. Our microcalorimetry measurements show that the rise in temperature during the first phase separation is in the order of 10-20millikelvins, which in some cases is enough to reverse the applied temperature bias. Thus phase separation in itself initiates a hydrodynamic instability. 2) The second reason comes from the cooling protocol itself. The sample was cooled from above and below. At sufficiently high cooling rates, there are situations where the interior of the sample is relatively hotter than both top and bottom of the sample. This is sufficient to create an instability within the cell. Our experiments at higher cooling rates (5K/h and above) show complex patterns, which hints that there is enough convection even before phase separation occurs. Infact, theoretical work done by Dr.Hayase show that patterns could arise in a system without latent heat, with symmetrical cooling from top and bottom. The simulations also show that the patterns do not span the entire height of the sample cell. This is again consistent with the cell sizes measured in our experiment.rnrnThe second mixture also showed patterns at specific heating rates, when it was continuously heated inducing phase separation. In this case though, the sample was turbid for a long time until patterns appeared. A meniscus was most probably formed before the patterns emerged. We attribute the reason of patterns in this case to Marangoni convection, which is present in systems with an interface, where local differences in surface tension give rise to an instability. Our estimates for the Rayleigh number also show a significantly lower number than that's required for RB-type instability.rnrnIn the first part of the work, therefore, we identify two different kinds of hydrodynamic instabilities in two different mixtures. Both are observed during, or after the first phase separation. Our patterns compare with the classical convection patterns, but here the origins are from phase separation and the cooling protocol.rnrnIn the second part of the work, we focused on the kinetics of phase separation in a polymer solution (polystyrene and methylcyclohexane), which is cooled continuously far down into the two phase region. Oscillations in turbidity, denoting material exchange between the phases are seen. Three processes contribute to the phase separation: Nucleation of droplets, their growth and coalescence, and their subsequent sedimentation. Experiments in low molecular binary mixtures had led to models of oscillation [43] which considered sedimentation time scales much faster than the time scales of nucleation and growth. The size and shape of the sample therefore did not matter in such situations. The oscillations in turbidity were volume-dominated. The present work aimed at understanding the influence of sedimentation time scales for polymer mixtures. Three heights of the sample with same composition were studied side by side. We found that periods increased with the sample height, thus showing that sedimentation time determines the period of oscillations in the polymer solutions. We experimented with different cooling rates and different compositions of the mixture, and we found that periods are still determined by the sample height, and therefore by sedimentation time. rnrnWe also see that turbidity emerges in two ways; either from the interface, or throughout the sample. We suggest that oscillations starting from the interface are due to satellite droplets that are formed on droplet coalescence at the interface. These satellite droplets are then advected to the top of the sample, and they grow, coalesce and sediment. This type of an oscillation wouldn't require the system to pass the energy barrier required for homogenous nucleation throughout the sample. This mechanism would work best in sample where the droplets could be effectively advected throughout the sample. In our experiments, we see more interface dominated oscillations in the smaller cells and lower cooling rates, where droplet advection is favourable. In larger samples and higher cooling rates, we mostly see that the whole sample becomes turbid homogenously, which requires the system to pass the energy barrier for homogenous nucleation.rnrnOscillations, in principle, occur since the system needs to pass an energy barrier for nucleation. The height of the barrier decreases with increasing supersaturation, which in turn is from the temperature ramp applied. This gives rise to a period where the system is clear, in between the turbid periods. At certain specific cooling rates, the system can follow a path such that the start of a turbid period coincides with the vanishing of the last turbid period, thus eliminating the clear periods. This means suppressions of oscillations altogether. In fact we experimentally present a case where, at a certain cooling rate, oscillations indeed vanish. rnrnThus we find through this work that the kinetics of phase separation in polymer solution is different from that of a low molecular system; sedimentation time scales become relevant, and therefore so does the shape and size of the sample. The role of interface in initiating turbid periods also become much more prominent in this system compared to that in low molecular mixtures.rnrnIn summary, some fundamental properties in the kinetics of phase separation in binary mixtures were studied. While the first part of the work described the close interplay of the first phase separation with hydrodynamic instabilities, the second part investigated the nature and determining factors of oscillations, when the system was cooled deep into the two phase region. Both cases show how the geometry of the cell can affect the kinetics of phase separation. This study leads to further fundamental understandings of the factors contributing to the kinetics of phase separation, and to the understandings of what can be controlled and tuned in practical cases. rn

Die Einheit des Bewusstseins und das Phänomen der Synästhesie

Synästhetiker schmecken Berührungen, sehen Farben und Formen, wenn sie Musik hören oder einen Duft riechen. Es wurden auch so außergewöhnliche Formen wie Wochentage-Farben-, Berührung-Geruch- oder Schmerz-Farben-Synästhesien gefunden. Die von Neuro- wissenschaftlern und Philosophen als „Bindung“ genannte Fähigkeit mehrere Reize, die in verschiedenen Hirnarealen verarbeitet werden, miteinander zu koppeln und zu einer einheitlichen Repräsentation bzw. erfahrenen Einheit des Bewusstseins zusammenzufassen, betrifft jeden gesunden Mensch. Synästhetiker sind aber Menschen, deren Gehirne zur „Hyperbindung“ oder zum hyperkohärentem Erleben befähigt sind, da bei ihnen wesentlich mehr solcher Kopplungen entstehen. Das Phänomen der Synästhesie ist schon seit mehreren Jahrhunderten bekannt, aber immer noch ein Rätsel. Bisher glaubten Forscher, solche Phänomene beruhten bloß auf überdurchschnittlich dichten neuronalen Verdrahtungen zwischen sensorischen Hirnregionen. Aus der aktuellen Forschung kann man jedoch schließen, dass die Ursache der Synästhesie nicht allein eine verstärkte Verbindung zwischen zwei Sinneskanälen ist. Laut eigener Studien ist der Sinnesreiz selbst sowie seine fest verdrahteten sensorischen Pfade nicht notwendig für die Auslösung des synästhetischen Erlebens. Eine grundlegende Rolle spielt dabei dessen Bedeutung für einen Synästhetiker. Für die Annahme, dass die Semantik für die synästhetische Wahrnehmung das Entscheidende ist, müssten synästhetische Assoziationen ziemlich flexibel sein. Und genau das wurde herausgefunden, nämlich, dass normalerweise sehr stabile synästhetische Assoziationen unter bestimmten Bedingungen sich auf neue Auslöser übertragen lassen. Weitere Untersuchung betraf die neu entdeckte Schwimmstil-Farbe-Synästhesie, die tritt hervor nicht nur wenn Synästhetiker schwimmen, aber auch wenn sie über das Schwimmen denken. Sogar die Namen dieser charakteristischen Bewegungen können ihre Farbempfindungen auslösen, sobald sie im stimmigen Kontext auftauchen. Wie man von anderen Beispielen in der Hirnforschung weiß, werden häufig benutzte neuronale Pfade im Laufe der Zeit immer stärker ausgebaut. Wenn also ein Synästhetiker auf bestimmte Stimuli häufig stoßt und dabei eine entsprechende Mitempfindung bekommt, kann das mit der Zeit auch seine Hirnanatomie verändern, so dass die angemessenen strukturellen Verknüpfungen entstehen. Die angebotene Erklärung steht also im Einklang mit den bisherigen Ergebnissen. Die vorliegende Dissertation veranschaulicht, wie einheitlich und kohärent Wahrnehmung, Motorik, Emotionen und Denken (sensorische und kognitive Prozesse) im Phänomen der Synästhesie miteinander zusammenhängen. Das synästhetische nicht-konzeptuelle Begleiterlebnis geht mit dem konzeptuellen Inhalt des Auslösers einher. Ähnlich schreiben wir übliche, nicht-synästhetische phänomenale Eigenschaften den bestimmten Begriffen zu. Die Synästhesie bringt solche Verschaltungen einfach auf beeindruckende Weise zum Ausdruck und lässt das mannigfaltige Erleben stärker integrieren.

Representation theorems for indefinite quadratic forms and applications

Diese Arbeit widmet sich den Darstellungssätzen für symmetrische indefinite (das heißt nicht-halbbeschränkte) Sesquilinearformen und deren Anwendungen. Insbesondere betrachten wir den Fall, dass der zur Form assoziierte Operator keine Spektrallücke um Null besitzt. Desweiteren untersuchen wir die Beziehung zwischen reduzierenden Graphräumen, Lösungen von Operator-Riccati-Gleichungen und der Block-Diagonalisierung für diagonaldominante Block-Operator-Matrizen. Mit Hilfe der Darstellungssätze wird eine entsprechende Beziehung zwischen Operatoren, die zu indefiniten Formen assoziiert sind, und Form-Riccati-Gleichungen erreicht. In diesem Rahmen wird eine explizite Block-Diagonalisierung und eine Spektralzerlegung für den Stokes Operator sowie eine Darstellung für dessen Kern erreicht. Wir wenden die Darstellungssätze auf durch (grad u, h() grad v) gegebene Formen an, wobei Vorzeichen-indefinite Koeffzienten-Matrizen h() zugelassen sind. Als ein Resultat werden selbstadjungierte indefinite Differentialoperatoren div h() grad mit homogenen Dirichlet oder Neumann Randbedingungen konstruiert. Beispiele solcher Art sind Operatoren die in der Modellierung von optischen Metamaterialien auftauchen und links-indefinite Sturm-Liouville Operatoren.