Prolapse-free relativistic Gaussian basis sets for the superheavy elements up to Uuo (Z=118) and Lr (Z=103)

Prolapse-free basis sets suitable for four-component relativistic quantum chemical calculations are presented for the superheavy elements UP to (118)Uuo ((104)Rf, (105)Db, (106)Sg, (107)Bh, (108)Hs, (109)Mt, (110)Ds, (111)Rg, (112)Uub, (113)Uut, (114)Uuq, (115)Uup, (116)Uuh, (117)Uus, (118)Uuo) and Lr-103. These basis sets were optimized by minimizing the absolute values of the energy difference between the Dirac-Fock-Roothaan total energy and the corresponding numerical value at a milli-Hartree order of magnitude, resulting in a good balance between cost and accuracy. Parameters for generating exponents and new numerical data for some superheavy elements are also presented. (c) 2007 Elsevier B.V. All rights reserved.

Silicon monosulphide radiative association

Rate coefficients for radiative association of silicon and sulphur atoms to form silicon monosulphide (SiS) molecule are estimated. The radiative association is due mainly to approach in the E(1)Sigma(+) and A(1)Pi states of SiS. For temperatures ranging from similar to 1000 to similar to 14 000 K, the rate coefficients are found to vary from 8.43 x 10(-17) to 2.69 x 10(-16) cm(3) s(-1). Our calculated rate coefficient is higher than the values used in modelling the chemistry of Type Ia supernovae.

Formation of SO, SO+, and S-2 by radiative association

Rate coefficients for radiative association of SO, SO+, and S-2 are estimated. For temperatures ranging from 300 to 14,000 K, the direct radiative association rate coefficients are found to vary with temperature from 1.73 x 10(-19) to 7.29 x 10(-19) cm(3) s(-1) and from 1.49 x 10(-21) to 3.70 x 10(-19) cm(3) s(-1) for S-2 and SO, respectively. The rate coefficients for formation through the inverse predissociation for S-2 are found to vary from 3.59 x 10(-18) to 1.44 x 10(-20) cm(3) s(-1). For SO+, the direct rate coefficient varies rapidly with temperature from 3.62 x 10(-27) cm(3) s(-1) at 2000 K to 2.34 x 10(-20) cm(3) s(-1) at 14,000 K. The direct radiative association rate coefficients increase with the increase in temperature, but the inverse predissociation rate coefficients decrease with the increase in temperature.

Radiative association of C and P, and Si and P atoms

The rate coefficients for the formation of carbon monophosphide (CP) and silicon monophosphide (SiP) by radiative association are estimated for temperatures ranging from 300 to 14 100 K. In this temperature range, the radiative association rate coefficients are found to vary from 1.14 x 10(-18) to 1.62 x 10(-18) cm(3) s(-1) and from 3.73 x 10(-20) to 7.03 x 10(-20) cm(3) s(-1) for CP and SiP, respectively. In both cases, rate coefficients increase slowly with the increase in temperature.

Formation of SiC by radiative association

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Radiative association of Ti and O atoms

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

The formation of AlF by radiative association

The formation of the aluminium monofluoride molecule AlF by radiative association of the Al and F atoms is estimated. The radiative association of Al(P-2) and F(P-2) atoms is found to be dominated by the approach along the A(1) potential energy curve accompanied by spontaneous emission into the X-1 Sigma(+) ground state of the AlF. For temperatures ranging from 300 to 14 000 K, the rate coefficients are found to vary from 1.35 x 10(-17) to 9.31 x 10(-16) cm(3) s(-1), respectively. These values indicate that only a small amount of AlF molecules can be formed by radiative association in the inner envelope of carbon-rich stars and other hostile environments.

Tungsten permanent chemical modifier for fast estimation of Se contents in soil by graphite furnace atomic absorption spectrometry

A tungsten carbide coating on the integrated platform of a transversely heated graphite atomizer was used as a modifier for the direct determination of Se in soil extracts by graphite furnace atomic absorption spectrometry. Diethylenetriaminepentaacetic acid (0.0050 mol L-1) plus ammonium hydrogencarbonate (1.0 mol L-1) extracted predominantly available inorganic selenate from soil. The formation of a large amount of carbonaceous residue inside the atomizer was avoided with a first pyrolysis step at 600 degreesC assisted by air during 30 s. For 20 muL of soil extracts delivered to the atomizer and calibration by matrix matching, an analytical curve (10.0-100 mug of L-1) with good linear correlation (r = 0.999) between integrated absorbance and analyte concentration was established. The characteristic mass was similar to63 pg of Se, and the lifetime of the tube was similar to750 firings. The limit of detection was 1.6 mug L-1, and the relative standard deviations (n = 12) were typically <4% for a soil extract containing 50 mug of L-1. The accuracy of the determination of Se was checked for soil samples by means of addition/recovery tests. Recovery data of Se added to four enriched soil samples varied from 80 to 90% and indicated an accurate method.

Effect of the Insertion and Polymerization Technique in Composite Resin Restorations: Analysis of Marginal Gap by Atomic Force Microscopy

This in vitro study evaluated the marginal gap at the composite tooth/resin interface in class V cavities under the influence of two insertion techniques and a curing system by means of atomic force microscopy (AFM). Forty enamel and dentin cavities were prepared on the buccal surface in bovine teeth with quadratic forms measuring 2 mm X 2 mm and depth of 1.5 mm. The teeth were then divided into four groups: group A, 10 cavities were restored in one increment, light cured by halogen light; group B, 10 cavities filled with bulk filling, light cured by the light emitting diodes (LED); group C, 10 cavities were restored by the incremental technique, light cured by halogen light; group D, 10 cavities were restored by the incremental technique, light cured by the LED. The teeth underwent the polishing procedure and were analyzed by AFM for tooth/restoration interface evaluation. The data were compared between groups using the nonparametric Kruskall-Wallis and Mann-Whitney tests (p < 0.05). The results showed a statistically significant difference between groups A and B and groups A and C. It was concluded that no insertion and polymerization technique was able to completely seal the cavity.

High current-density anodic electro-dissolution in flow-injection systems for the determination of aluminium, copper and zinc in non-ferroalloys by flame atomic absorption spectrometry

An automatic Procedure with a high current-density anodic electrodissolution unit (HDAE) is proposed for the determination of aluminium, copper and zinc in non-ferroalloys by flame atonic absorption spectrometry, based on the direct solid analysis. It consists of solenoid valve-based commutation in a flow-injection system for on-line sample electro-dissolution and calibration with one multi-element standard, an electrolytic cell equipped with two electrodes (a silver needle acts as cathode, and sample as anode), and an intelligent unit. The latter is assembled in a PC-compatible microcomputer for instrument control, and far data acquisition and processing. General management of the process is achieved by use of software written in Pascal. Electrolyte compositions, flow rates, commutation times, applied current and electrolysis time mere investigated. A 0.5 mol l(-1) HNO3 solution was elected as electrolyte and 300 A/cm(2) as the continuous current pulse. The performance of the proposed system was evaluated by analysing aluminium in Al-allay samples, and copper/zinc in brass and bronze samples, respectively. The system handles about 50 samples per hour. Results are precise (R.S.D < 2%) and in agreement with those obtained by ICP-AES and spectrophotometry at a 95% confidence level.

New limits on doubly charged bileptons from CERN LEP data and the search at future electron-positron and electron-photon colliders

We show that the accumulated CERN LEP-II data taken at √s = 130-206 GeV can establish more restrictive bounds on doubly charged bilepton couplings and masses than any other experiment so far. We also analyze the discovery potential of a prospective linear collider operating in both e+e- and e γ modes.

Comparative studies of the sample decomposition of green and roasted coffee for determination of nutrients and data exploratory analysis

The contents of some nutrients in 35 Brazilian green and roasted coffee samples were determined by flame atomic absorption spectrometry (Ca, Mg, Fe, Cu, Mn, and Zn), flame atomic emission photometry (Na and K) and Kjeldahl (N) after preparing the samples by wet digestion procedures using i) a digester heating block and ii) a conventional microwave oven system with pressure and temperature control. The accuracy of the procedures was checked using three standard reference materials (National Institute of Standards and Technology, SRM 1573a Tomato Leaves, SRM 1547 Peach Leaves, SRM 1570a Trace Elements in Spinach). Analysis of data after application of t-test showed that results obtained by microwave-assisted digestion were more accurate than those obtained by block digester at 95% confidence level. Additionally to better accuracy, other favorable characteristics found were lower analytical blanks, lower reagent consumption, and shorter digestion time. Exploratory analysis of results using Principal Component Analysis (PCA) and Hierarchical Cluster Analysis (HCA) showed that Na, K, Ca, Cu, Mg, and Fe were the principal elements to discriminate between green and roasted coffee samples. ©2007 Sociedade Brasileira de Química.

Effective range from tetramer-dissociation data for cesium atoms

The shifts in the four-body recombination peaks, due to an effective range correction to the zero-range model close to the unitary limit, are obtained and used to extract the corresponding effective range of a given atomic system. The approach is applied to an ultracold gas of cesium atoms close to broad Feshbach resonances, where deviations of experimental values from universal model predictions are associated with effective range corrections. The effective range correction is extracted with a weighted average given by 3.9±0.8R vdW, where RvdW is the van der Waals length scale, which is consistent with the van der Waals potential tail for the Cs2 system. The method can be generally applied to other cold atom experimental setups to determine the contribution of the effective range to the tetramer dissociation position. © 2013 American Physical Society.

Evaluation of lines of boron, phosphorus and sulfur by high-resolution continuum source flame atomic absorption spectrometry for plant analysis

The wavelength-integrated absorbance (WIA) and summation of absorbance (∑ lines) of different lines were evaluated to enhance sensitivity and determine B, P and S in medicinal plants by HR-CS FAAS. The lowest LOD for B (0.5mgL-1) and P (13.7mgL-1) was obtained by integration of lines 249.773nm (3pixels) and 247.620nm (5pixels), respectively. The ∑ lines for CS at 257.595nm and 257.958nm furnished LOD=30.5mgL-1, ca. 10% lower than the LOD obtained for the WIA using 257.595nm and 5pixels. Data showed the advantage of WIA over ∑ lines to improve sensitivity for all analytes. Under optimized conditions, calibration curves in the 1.0-100mgL-1 B and 50.0-2000mgL-1 P, S ranges were consistently obtained. Results obtained with the HR-CS FAAS method were in agreement at 98% and 95% confidence level with certified values for B and P, respectively. And results for S were in accordance to non-certified values. Concentrations of B, P, and S in 12 medicinal plants analyzed by the proposed method varied within the 19.4-34.5mgkg-1 B, 719-3910mgkg-1 P and 1469-7653mgkg-1 S ranges. © 2012 Elsevier B.V.

Applying spatial analysis of genetic and environmental data to predict connection corridors to the New World screwworm populations in South America

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)