Novel optical PVC probes for on-site detection/determination of fluoroquinolones in a solid/liquid interface: Application to the determination of Norfloxacin in aquaculture water

A novel optical disposable probe for screening fluoroquinolones in fish farming waters is presented, having Norfloxacin (NFX) as target compound. The colorimetric reaction takes place in the solid/liquid interface consisting of a plasticized PVC layer carrying the colorimetric reagent and the sample solution. NFX solutions dropped on top of this solid-sensory surface provided a colour change from light yellow to dark orange. Several metals were tested as colorimetric reagents and Fe(III) was selected. The main parameters affecting the obtained colour were assessed and optimised in both liquid and solid phases. The corresponding studies were conducted by visible spectrophotometry and digital image acquisition. The three coordinates of the HSL model system of the collected image (Hue, Saturation and Lightness) were obtained by simple image management (enabled in any computer). The analytical response of the optimised solid-state optical probe against concentration was tested for several mathematical transformations of the colour coordinates. Linear behaviour was observed for logarithm NFX concentration against Hue+Lightness. Under this condition, the sensor exhibited a limit of detection below 50 μM (corresponding to about 16 mg/mL). Visual inspection also enabled semi-quantitative information. The selectivity was ensured against drugs from other chemical groups than fluoroquinolones. Finally, similar procedure was used to prepare an array of sensors for NFX, consisting on different metal species. Cu(II), Mn(II) and aluminon were selected for this purpose. The sensor array was used to detect NFX in aquaculture water, without any prior sample manipulation.

Development of electrochemical methods for determination of tramadol - analytical application to pharmaceutical dosage forms

A square-wave voltammetric (SWV) method and a flow injection analysis system with amperometric detection were developed for the determination of tramadol hydrochloride. The SWV method enables the determination of tramadol over the concentration range of 15-75 µM with a detection limit of 2.2 µM. Tramadol could be determined in concentrations between 9 and 50 µM at a sampling rate of 90 h-1, with a detection limit of 1.7 µM using the flow injection system. The electrochemical methods developed were successfully applied to the determination of tramadol in pharmaceutical dosage forms, without any pre-treatment of the samples. Recovery trials were performed to assess the accuracy of the results; the values were between 97 and 102% for both methods.

Perspetivas dos profissinais e dos pais de crianças com incapacidades sobre autodeterminação

Mestrado em Educação Especial: Multideficiência e Problemas de Cognição

Electrochemical study of butylate: application to the analysis of water

The electroactivity of butylate (BTL) is studied by cyclic voltammetry (CV) and square wave voltammetry (SWV) at a glassy carbon electrode (GCE) and a hanging mercury drop electrode (HMDE). Britton–Robinson buffer solutions of pH 1.9–11.5 are used as supporting electrolyte. CV voltammograms using GCE show a single anodic peak regarding the oxidation of BTL at +1.7V versus AgCl/ Ag, an irreversible process controlled by diffusion. Using a HMDE, a single cathodic peak is observed, at 1.0V versus AgCl/Ag. The reduction of BTL is irreversible and controlled by adsorption. Mechanism proposals are presented for these redox transformations. Optimisation is carried out univaryingly. Linearity ranges were 0.10–0.50 mmol L-1 and 2.0–9.0 µmolL-1 for anodic and cathodic peaks, respectively. The proposed method is applied to the determination of BTL in waters. Analytical results compare well with those obtained by an HPLC method.

Direct electroanalytical determination of fluvastatin in a pharmaceutical dosage form: batch and flow analysis

The reduction of luvastatin (FLV) at a hanging mercury-drop electrode (HMDE) was studied by square-wave adsorptive-stripping voltammetry (SWAdSV). FLV can be accumulated and reduced at the electrode, with a maximum peak current intensity at a potential of approximately 1.26V vs. AgCl=Ag, in an aqueous electrolyte solution of pH 5.25. The method shows linearity between peak current intensity and FLV concentration between 1.0 10 8 and 2.7 10 6 mol L 1. Limits of detection (LOD) and quantification (LOQ) were found to be 9.9 10 9 mol L 1 and 3.3 10 8 mol L 1, respectively. Furthermore, FLV oxidation at a glassy carbon electrode surface was used for its hydrodynamic monitoring by amperometric detection in a flow-injection system. The amperometric signal was linear with FLV concentration over the range 1.0 10 6 to 1.0 10 5 mol L 1, with an LOD of 2.4 10 7 mol L 1 and an LOQ of 8.0 10 7 mol L 1. A sample rate of 50 injections per hour was achieved. Both methods were validated and showed to be precise and accurate, being satisfactorily applied to the determination of FLV in a commercial pharmaceutical.

Electrochemical determination of citalopram by adsorptive stripping voltammetry–determination in pharmaceutical products

The electrochemical behavior of citalopram was studied by square-wave and square-wave adsorptive-stripping voltammetry (SWAdSV). Citalopram can be reduced and accumulated at a mercury drop electrode, with a maximum peak current intensity being obtained at a potential of approximately -1.25V vs. AgCl/Ag, in an aqueous electrolyte solution of pH 12. A SWAdSV method has been developed for the determination of citalopram in pharmaceutical preparations. The method shows a linear range between 1.0x10-7 and 2.0x10-6 mol L-1 with a limit of detection of 5x10-8 mol L-1 for an accumulation time of 30 s. The precision of the method was evaluated by assessing the repeatability and intermediate precision, achieving good relative standard deviations in all cases (≤2.3%). The proposed method was applied to the determination of citalopram in five pharmaceutical products and the results obtained are in good agreement with the labeled values.

DNA-based biosensor for the electrocatalytic determination of antioxidant capacity in beverages

Reactive oxygen species (ROS) are produced as a consequence of normal aerobic metabolism and are able to induce DNA oxidative damage. At the cellular level, the evaluation of the protective effect of antioxidants can be achieved by examining the integrity of the DNA nucleobases using electrochemical techniques. Herein, the use of an adenine-rich oligonucleotide (dA21) adsorbed on carbon paste electrodes for the assessment of the antioxidant capacity is proposed. The method was based on the partial damage of a DNA layer adsorbed on the electrode surface by OH• radicals generated by Fenton reaction and the subsequent electrochemical oxidation of the intact adenine bases to generate an oxidation product that was able to catalyze the oxidation of NADH. The presence of antioxidant compounds scavenged hydroxyl radicals leaving more adenines unoxidized, and thus, increasing the electrocatalytic current of NADHmeasured by differential pulse voltammetry (DPV). Using ascorbic acid (AA) as a model antioxidant species, the detection of as low as 50nMof AA in aqueous solution was possible. The protection efficiency was evaluated for several antioxidant compounds. The biosensor was applied to the determination of the total antioxidant capacity (TAC) in beverages.

Electrochemical determination of dihydrocodeine in pharmaceuticals

Two analytical methods for the quality control of dihydrocodeine in commercial pharmaceutical formulations have been developed and compared with reference methods: a square wave voltammetric (SWV) method and a flow injection analysis system with electrochemical detection (FIA-EC). The electrochemical methods proposed were successfully applied to the determination of dihydrocodeine in pharmaceutical tablets and in oral solutions. These methods do not require any pretreatment of the samples, the formulation only being dissolved in a suitable electrolyte. Validation of the methods showed it to be precise, accurate and linear over the concentration range of analysis. The automatic procedure based on a flow injection analysis manifold allows a sampling rate of 115 determinations per hour.

Determination of polyphenols in wines by reaction with 4-aminoantipyrine and photometric flow-injection analysis

A new flow-injection analytical procedure is proposed for the determination of the total amount of polyphenols in wines; the method is based on the formation of a colored complex between 4-aminoantipyrine and phenols, in the presence of an oxidizing reagent. The oxidizing agents hexacyanoferrate(III), peroxodisulfate, and tetroxoiodate(VII) were tested. Batch trials were first performed to select appropriate oxidizing agents, pH, and concentration ratios of reagents, on the basis of their effect on the stability of the colored complex. Conditions selected as a result of these trials were implemented in a flow-injection analytical system in which the influence of injection volume, flow rate, and reaction- coil length, was evaluated. Under the optimum conditions the total amount of polyphenols, expressed as gallic acid, could be determined within a concentration range of 36 to 544 mg L–1, and with a sensitivity of 344 L mol–1 cm–1 and an RSD <1.1%. The reproducibility of analytical readings was indicative of standard deviations <2%. Interference from sugars, tartaric acid, ascorbic acid, methanol, ammonium sulfate, and potassium chloride was negligible. The proposed system was applied to the determination of total polyphenols in red wines, and enabled analysis of approximately 55 samples h–1. Results were usually precise and accurate; the RSD was <3.9% and relative errors, by the Folin–Ciocalteu method, <5.1%.

Determinantes do sucesso das iniciativas empresariais apoiadas pelo microcrédito

Dissertação de Mestrado apresentada ao Instituto de Contabilidade e Administração do Porto para a obtenção do grau de Mestre em Contabilidade e Finanças sob orientação de: Amélia Ferreira da Silva “Esta versão contém as críticas e sugestões dos elementos do júri”

A elaboração do Portefólio de Transição [identificação de interesses e aspetos positivos da funcionalidade por uma jovem com incapacidade intelectual]

O presente estudo teve como objetivo analisar em que medida o envolvimento de uma jovem de 19 anos, com incapacidade intelectual, na elaboração de um portefólio de transição para a vida ativa, se revela um processo promotor do autoconhecimento e exploração pessoal, através de uma identificação mais abrangente das suas experiências, interesses e competências funcionais. O efeito valorativo da elaboração do portefólio - processo desenvolvido ao longo de 27 sessões - no reconhecimento de experiências e interações positivas de funcionalidade que sejam tomadas, pela própria jovem, como um ponto de partida para novas oportunidades no domínio de uma vida adulta autónoma, foi avaliado através da condução de uma entrevista – nos momentos pré e pós elaboração do portefólio – e do registo contínuo da participação da jovem ao longo das sessões. O guião da entrevista procurou incorporar tópicos que permitissem obter, através da perspetiva da jovem, um retrato da sua funcionalidade e do seu perfil pessoal. Socorremo-nos de técnicas de análise de conteúdo para examinar mudanças no conteúdo do discurso da jovem, procurando, com base nessa análise, quantificar e analisar a diversidade de experiências, interesses, funcionalidades e suportes reconhecidas pela própria antes e após elaboração do portefólio. Os resultados deste estudo indicam que a elaboração do portefólio promoveu a construção de um maior autoconhecimento, pela jovem, das suas competências, interesses e aspirações - havendo no momento pós-elaboração do portefólio uma maior referência a aspetos positivos da sua funcionalidade, nestas dimensões de análise. Assim, este estudo parece sugerir que o processo de elaboração do portefólio poder-se-á afigurar como uma metodologia facilitadora na condução de uma transição consonante com os princípios avançados na abordagem de planeamento centrado na pessoa.

A expansão sistematizada de oportunidades de escolha como estratégia de suporte à participação

Baseado nos pressupostos subjacentes às práticas pedagógicas centradas na criança, este estudo tem por objetivo analisar a perspetiva dos educadores de infância sobre a promoção de oportunidades de escolha em contextos de ensino pré-escolar, tendo por referência o processo de inclusão de crianças com necessidades adicionais de suporte, bem como examinar os efeitos de um programa de intervenção, centrado na expansão de oportunidades de escolha, na participação de uma criança em situação de incapacidade. A fim de responder ao primeiro objetivo foi auscultada a opinião de 71 educadores de infância, através de uma pesquisa por inquérito. Já para o escrutínio dos efeitos do programa de intervenção, foi desenvolvido um estudo de caso único, tipo AB, avaliando o seu impacte na participação de uma criança de 4 anos com Paralisia Cerebral, através do uso de grelhas de observação e de uma entrevista semiestruturada à educadora. Os resultados sugerem que existe uma diferença significativa na facilidade de implementação de oportunidades de escolha, quando consideradas crianças com desenvolvimento típico e com necessidades adicionais de suporte, que parece também variar em função das diferentes rotinas do contexto pré-escolar e correlacionar-se com o nível de severidade da incapacidade. As características das crianças e as exigências curriculares são entendidas como as principais barreiras à implementação destas práticas. Os resultados sugerem, ainda, que o programa de intervenção – baseado no planeamento de oportunidades de escolha embebidas nos diferentes momentos da rotina do contexto pré-escolar - teve impacte positivo na participação da criança, com expansão dos indicadores de envolvimento, interação/comunicação e satisfação