18 resultados para Valence fluctuations.
em Instituto Politécnico do Porto, Portugal
Resumo:
In this work, we investigated structural, morphological, electrical, and optical properties from a set of Cu2ZnSnS4 thin films grown by sulfurization of metallic precursors deposited on soda lime glass substrates coated with or without molybdenum. X-ray diffraction and Raman spectroscopy measurements revealed the formation of single-phase Cu2ZnSnS4 thin films. A good crystallinity and grain compactness of the film was found by scanning electron microscopy. The grown films are poor in copper and rich in zinc, which is a composition close to that of the Cu2ZnSnS4 solar cells with best reported efficiency. Electrical conductivity and Hall effect measurements showed a high doping level and a strong compensation. The temperature dependence of the free hole concentration showed that the films are nondegenerate. Photoluminescence spectroscopy showed an asymmetric broadband emission. The experimental behavior with increasing excitation power or temperature cannot be explained by donor-acceptor pair transitions. A model of radiative recombination of an electron with a hole bound to an acceptor level, broadened by potential fluctuations of the valence-band edge, was proposed. An ionization energy for the acceptor level in the range 29–40 meV was estimated, and a value of 172 ±2 meV was obtained for the potential fluctuation in the valence-band edge.
Resumo:
BACKGROUND: Examining changes in brain activation linked with emotion-inducing stimuli is essential to the study of emotions. Due to the ecological potential of techniques such as virtual reality (VR), inspection of whether brain activation in response to emotional stimuli can be modulated by the three-dimensional (3D) properties of the images is important. OBJECTIVE: The current study sought to test whether the activation of brain areas involved in the emotional processing of scenarios of different valences can be modulated by 3D. Therefore, the focus was made on the interaction effect between emotion-inducing stimuli of different emotional valences (pleasant, unpleasant and neutral valences) and visualization types (2D, 3D). However, main effects were also analyzed.METHODS: The effect of emotional valence and visualization types and their interaction were analyzed through a 3x2 repeated measures ANOVA. Post-hoc t-tests were performed under a ROI-analysis approach. RESULTS: The results show increased brain activation for the 3D affective-inducing stimuli in comparison with the same stimuli in 2D scenarios, mostly in cortical and subcortical regions that are related to emotional processing, in addition to visual processing regions. CONCLUSIONS: This study has the potential of clarify brain mechanisms involved in the processing of emotional stimuli (scenarios’ valence) and their interaction with three-dimensionality.
Resumo:
A presente dissertação apresenta o resultado de uma pesquisa realizada, através da recolha de dados, nos distritos do Porto e Aveiro, onde foram analisados os fatores determinantes do (in)sucesso estratégico de clínicas/gabinetes (CG) particulares com a valência de terapia da fala (TF). Inicia com a apresentação de algumas considerações conceptuais relativas à empresa, organização e inovação. De seguida, são descritos os principais passos a dar em Portugal para a constituição de uma empresa e é feita uma abordagem aos temas da viabilidade estratégica de um projeto e do conceito de plano de negócios. A parte teórica do presente projeto de investigação encerra com os fatores de sucesso e insucesso empresarial descritos na literatura. Neste trabalho, procura-se analisar as principais determinantes de sobrevivência das novas empresas ligadas à área da TF. Para tal, procedeu-se à recolha de dados junto de proprietários e/ou gestores de CG particulares com TF, nos distritos de Porto e Aveiro, selecionados a partir da base de dados da Entidade Reguladora da Saúde (ERS), das Páginas Amarelas Online e da Internet com as palavraschave: “clínicas, gabinetes, terapia da fala”. Os resultados estatisticamente tratados e analisados evidenciam a importância dos seguintes fatores como estatisticamente significativos para o sucesso de uma CG privada com TF nos distritos de Porto e Aveiro: maior antiguidade da CG, maior número de utentes, de concorrentes e de TF a trabalhar, assim como a realização de rastreios na área da TF. Fatores como: proprietário com formação na área da gestão, maior número de valências, publicidade e acessibilidades na CG, parecem contribuir para o aumento das hipóteses de sobrevivência de CG particulares com TF nos distritos de Porto e Aveiro, ainda que não sejam estatisticamente significativos. Em contrapartida, a falta de um plano de negócios parece ser um fator que influencia o insucesso destas CG.
Resumo:
Objectivo: Analisar a variação do centro de pressão (CP) com a utilização do calçado MBT, no equilíbrio estático a curto e longo prazo. Metodologia: A amostra é constituída por dois grupos, experimental e controlo. O estudo consistiu em dois momentos de avaliação, na recolha os indivíduos estão sobre a plataforma, estáticos. Os dados recolhidos foram a área, distância e velocidade das oscilações do CP. Resultados: As variáveis estudadas estão aumentadas com o uso das MBT. A longo prazo não se verificou diferenças significativas entre os grupos. Conclusão: As sapatilhas MBT proporcionam o aumento das oscilações do CP a curto prazo.
Resumo:
Metals are ubiquitous in the environment and accumulate in aquatic organisms and are known for their ability to enhance the production of reactive oxygen species (ROS). In aquatic species, oxidative stress mechanisms have been studied by measuring antioxidant enzyme activities and oxidative damages in tissues. The aim of this study was to apply and validate a set of oxidative stress biomarkers and correlate responses with metal contents in tissues of common octopus (Octopus vulgaris). Antioxidant enzyme activity (catalase — CAT, superoxide dismutase — SOD and glutathione S-transferases — GST), oxidative damages (lipid peroxidation — LPO and protein carbonyl content — PCO) andmetal content (Cu, Zn, Pb, Cd and As) in the digestive gland and armof octopus, collected in the NWPortuguese coast in different periods, were assessed after capture and after 14 days in captivity. CAT and SOD activitieswere highly responsive to fluctuations inmetal concentrations and able to reduce oxidative damage, LPO and PCO in the digestive gland. CAT activity was also positively correlated with SOD and GST activities, which emphasizes that the three enzymes respond in a coordinated way to metal induced oxidative stress. Our results validate the use of oxidative stress biomarkers to assess metal pollution effects in this ecological and commercial relevant species.Moreover, octopus seems to have the ability to control oxidative damage by triggering an antioxidant enzyme coordinated response in the digestive gland.
Resumo:
The temperature dependence of electrical conductivity and the photoconductivity of polycrystalline Cu2ZnSnS4 were investigated. It was found that at high temperatures the electrical conductivity was dominated by band conduction and nearest-neighbour hopping. However, at lower temperatures, both Mott variable-range hopping (VRH) and Efros–Shklovskii VRH were observed. The analysis of electrical transport showed high doping levels and a large compensation ratio, demonstrating large degree of disorder in Cu2ZnSnS4. Photoconductivity studies showed the presence of a persistent photoconductivity effect with decay time increasing with temperature, due to the presence of random local potential fluctuations in the Cu2ZnSnS4 thin film. These random local potential fluctuations cannot be attributed to grain boundaries but to the large disorder in Cu2ZnSnS4.
Resumo:
Cu2ZnSnS4 is a promising semiconductor to be used as absorber in thin film solar cells. In this work, we investigated optical and structural properties of Cu2ZnSnS4 thin films grown by sulphurization of metallic precursors deposited on soda lime glass substrates. The crystalline phases were studied by X-ray diffraction measurements showing the presence of only the Cu2ZnSnS4 phase. The studied films were copper poor and zinc rich as shown by inductively coupled plasma mass spectroscopy. Scanning electron microscopy revealed a good crystallinity and compactness. An absorption coefficient varying between 3 and 4×104cm−1 was measured in the energy range between 1.75 and 3.5 eV. The band gap energy was estimated in 1.51 eV. Photoluminescence spectroscopy showed an asymmetric broad band emission. The dependence of this emission on the excitation power and temperature was investigated and compared to the predictions of the donor-acceptor-type transitions and radiative recombinations in the model of potential fluctuations. Experimental evidence was found to ascribe the observed emission to radiative transitions involving tail states created by potential fluctuations.
Resumo:
We consider reliable communications in Body Area Networks (BAN), where a set of nodes placed on human body are connected using wireless links. In order to keep the Specific Absorption Rate (SAR) as low as possible for health safety reasons, these networks operate in low transmit power regime, which however, is known to be error prone. It has been observed that the fluctuations of the Received Signal Strength (RSS) at the nodes of a BAN on a moving person show certain regularities and that the magnitude of these fluctuations are significant (5 - 20 dB). In this paper, we present BANMAC, a MAC protocol that monitors and predicts the channel fluctuations and schedules transmissions opportunistically when the RSS is likely to be higher. The MAC protocol is capable of providing differentiated service and resolves co-channel interference in the event of multiple co-located BANs in a vicinity. We report the design and implementation details of BANMAC integrated with the IEEE 802.15.4 protocol stack. We present experimental data which show that the packet loss rate (PLR) of BANMAC is significantly lower as compared to that of the IEEE 802.15.4 MAC. For comparable PLR, the power consumption of BANMAC is also significantly lower than that of the IEEE 802.15.4. For co-located networks, the convergence time to find a conflict-free channel allocation was approximately 1 s for the centralized coordination mechanism and was approximately 4 s for the distributed coordination mechanism.
Resumo:
Significant research efforts are being devoted to Body Area Networks (BAN) due to their potential for revolutionizing healthcare practices. Energy-efficiency and communication reliability are critically important for these networks. In an experimental study with three different mote platforms, we show that changes in human body shadowing as well as those in the relative distance and orientation of nodes caused by the common human body movements can result in significant fluctuations in the received signal strength within a BAN. Furthermore, regular movements, such as walking, typically manifest in approximately periodic variations in signal strength. We present an algorithm that predicts the signal strength peaks and evaluate it on real-world data. We present the design of an opportunistic MAC protocol, named BANMAC, that takes advantage of the periodic fluctuations of the signal strength to achieve high reliability even with low transmission power.
Resumo:
A QoS adaptation to dynamically changing system conditions that takes into consideration the user’s constraints on the stability of service provisioning is presented. The goal is to allow the system to make QoS adaptation decisions in response to fluctuations in task traffic flow, under the control of the user. We pay special attention to the case where monitoring the stability period and resource load variation of Service Level Agreements for different types of services is used to dynamically adapt future stability periods, according to a feedback control scheme. System’s adaptation behaviour can be configured according to a desired confidence level on future resource usage. The viability of the proposed approach is validated by preliminary experiments.
Resumo:
Mestrado em Engenharia Química - Ramo Optimização Energética na Indústria Química
Resumo:
To increase the amount of logic available to the users in SRAM-based FPGAs, manufacturers are using nanometric technologies to boost logic density and reduce costs, making its use more attractive. However, these technological improvements also make FPGAs particularly vulnerable to configuration memory bit-flips caused by power fluctuations, strong electromagnetic fields and radiation. This issue is particularly sensitive because of the increasing amount of configuration memory cells needed to define their functionality. A short survey of the most recent publications is presented to support the options assumed during the definition of a framework for implementing circuits immune to bit-flips induction mechanisms in memory cells, based on a customized redundant infrastructure and on a detection-and-fix controller.
Resumo:
Studying changes in brain activation according to the valence of emotion-inducing stimuli is essential in the research on emotions. Due to the ecological potential of virtual reality, it is also important to examine whether brain activation in response to emotional stimuli can be modulated by the three-dimensional (3D) properties of the images. This study uses functional Magnetic Resonance Imaging to compare differences between 3D and standard (2D) visual stimuli in the activation of emotion-related brain areas. The stimuli were organized in three virtual-reality scenarios, each with a different emotional valence (pleasant, unpleasant and neutral). The scenarios were presented in a pseudo-randomized order in the two visualization modes to twelve healthy males. Data were analyzed through a GLM-based fixed effects procedure. Unpleasant and neutral stimuli activated the right amygdala more strongly when presented in 3D than in 2D. These results suggest that 3D stimuli, when used as “building blocks” for virtual environments, can induce increased emotional loading, as shown here through neuroimaging.
Resumo:
Dissertação de Mestrado apresentada ao Instituto de Contabilidade e Administração do Porto para a obtenção do grau de Mestre em Contabilidade e Finanças sob orientação de Professor Doutor Adalmiro Alvaro Malheiro de Castro Andrade Pereira
Resumo:
Atualmente a vantagem competitiva de uma empresa passa pela sua rápida adaptação às variações de procura do mercado, sendo necessário garantir elevados níveis de produtividade e, simultaneamente, grande flexibilidade, indispensável ao fabrico de pequenos lotes. A necessidade de ajuste do processo e a diminuição da média de vida do produto levam a paragens cada vez mais frequentes da célula de fabrico para programação e afinação, com consequentes perdas de produtividade. De forma a dar resposta a estes problemas, neste trabalho é testada a viabilidade da utilização da programação e simulação offline de tarefas de lixamento na Grohe Portugal, complementando a solução com o desenvolvimento de um novo método de afinação do programa, permitindo uma adaptação às flutuações do processo produtivo. Para isso foi necessário analisar o estado da arte dos robôs industriais na área de acabamento superficial e respetivos métodos de programação. Em seguida, após um trabalho prévio rigoroso de preparação e modelação da célula de trabalho, é possível fazer a programação offline das várias rotinas e trajetórias complexas que compõem um ciclo de lixamento de um produto, contribuindo para o aumento da qualidade do produto final sem comprometer os níveis de produtividade. Nesta dissertação são descritos e detalhados alguns dos procedimentos fulcrais no sucesso da aplicação deste método de programação. Por último é feita uma nova abordagem ao método de ajuste ponto-a-ponto convencional, desenvolvendo-se para isso um sistema de ajuste automático do programa, dotando o robô da capacidade de se adaptar às variações do processo, assegurando a consistência do mesmo. Foram realizados testes em pequena escala, extrapolando-se os resultados para a aplicação deste novo método no processo produtivo da Grohe Portugal, como forma de complemento ao método convencional de ajuste ponto-a-ponto do programa, reduzindo o tempo de paragem da célula de trabalho.