Stabilisation of low softening point petroleum pitch fibres by HNO3

This paper deals with the stabilisation of low softening point pitch fibres obtained from petroleum pitches using HNO3 as oxidising agent. This method presents some advantages compared with conventional methods: pitches with low softening point (SP) can be used to prepare carbon fibres (CF), the stabilisation time has been reduced, the CF yields are similar to those obtained after general methods of stabilisation, and the initial treatments to increase SP when low SP pitches are used to prepare CF, are avoided. The parent pitches were characterised by different techniques such as diffuse reflectance infrared Fourier transform spectroscopy (DRIFTS), elemental analysis and solvent extraction with toluene and quinoline. The interaction between HNO3 and the pitch fibres, as well as the changes occurring during the heat treatment, have been followed by DRIFTS.

Isotropic petroleum pitch as a carbon precursor for the preparation of activated carbons by KOH activation

Results show that it is possible to activate a low softening point isotropic petroleum pitch, without intermediate pre-treatments, by chemical activation with KOH. The chemical activation is carried out by direct heat treatment of a mixture of the isotropic pitch and KOH. It produces activated carbons (ACs) with micropore volumes as high as 1.12 cm3/g, and BET surface areas around 3000 m2/g. The activating agent/precursor ratios studied (from 1/1 to 4/1; wt./wt.) show, as expected, that increasing the ratio enhances the adsorption characteristics of the resulting AC.

Activated carbon fibre monoliths

Activated carbon fibre monoliths were prepared by physical activation of carbon fibre monoliths derived from two kinds of pitch-based carbon fibre (CF) (carbon fibres from a coal tar pitch and carbon fibres derived from a petroleum pitch). The monoliths were conformed using a coal tar pitch binder. The carbon fibre monoliths and the activated carbon fibre monoliths were studied by scanning electron microscopy (SEM) and gas adsorption (i.e. N2 at 77 K and CO2 at 273 K). The results obtained reveal that monoliths perform a good activation process that produce a quite high development of microporosity (BET surface areas around 2600 m2/g and N2 micropore volume of 1.23 cm3/g). On the other hand, it is remarkable that the activation process used allow to easily control the degree of activation and hence to select the adsorption capacities of the activated carbon fibre monoliths.

Stabilisation of low softening point petroleum pitch fibres by iodine treatment

A method using iodine has been developed for the stabilisation of low softening point (SP) pitch fibres that avoids air stabilisation in the production of carbon fibres (CF). The interaction between iodine and petroleum pitches has been studied by following the changes in the hydrogen content, aromatic or aliphatic, during the heat treatment of iodine-treated pitch fibres. Two low SP petroleum pitches were used and the iodine-treated pitch fibres were analysed by TGA, DSC, DRIFT, XPS and SEM. The results confirm that using this novel method pitches with low SP can be used to prepare CF with two advantages, compared with conventional methods. The stabilisation time is considerably reduced and treatments to increase the SP, usually required when low SP pitches are used to prepare CF, can be avoided.

New insights on the direct activation of isotropic petroleum pitch by alkaline hydroxides

The paper provides interesting evidences that a low softening point isotropic petroleum pitch can be used as a good carbon precursor for the preparation of activated carbons. The activation is carried out by KOH and/or NaOH and the resulting activated carbons present well developed porosity. Such hydroxide activations can be done directly on the pristine petroleum pitch (P) or on the pitch that has been submitted to an air stabilisation followed by a N2 heat treatment (TAN). In general, KOH activation produces better results than NaOH, both in terms of porosity and yield, the results obtained for the activation of TAN being impressive because of the good porosity developments and high yields reached. The different treatments carried out over the petroleum pitch precursor clearly show that they significantly influence the extent of microporosity development. This is due to different changes occurring in the porous structure of the precursor as a function of the treatment carried out. The efficiency of the activation process increases as the mesophase content of the precursor decreases, as well as the mesophase formation during the activation process is avoided.

Effect of the stabilisation time of pitch fibres on the molecular sieve properties of carbon fibres

The stabilisation of pitch fibres (PFs) is the most important step for their subsequent use in the preparation of carbon fibres (CFs) and their resulting characteristics. The present work studies the influence that the stabilisation time has on the porosity of the CFs, and on the subsequent properties as carbon molecular sieve (CMS). The increase of the stabilisation time carried out at 573 K, from 2 to 8 h favours their CMS properties producing a decrease in the microposity accessible to N2, which gets completely blocked after 6 and 8 h, while the narrow microporosity (V-DR CO2) remains accessible. Adsorption kinetic studies with CH4 and CO2 were performed to assess the possibility of using these CFs as CMS by comparing them with Takeda 3A CMS. The results suggest that there is an optimal stabilisation time which allows the preparation of CFs from an abundant raw precursor with properties similar to Takeda 3A CMS.

Biodiesel production by acid catalysis with heteropolyacids supported on activated carbon fibers

Different catalysts, based on heteropolyacids supported on activated carbon fibers, have been prepared for palmitic acid esterification reaction. The influence of the catalyst (heteropolyacid) and the support on the catalytic activity have been analyzed. The results prove that an adequate combination of both is required to achieve the most suitable catalysts. Regarding to the heteropolyacid, phosphomolybdic acid seems to be the most suitable appropriate taking into account its lowest leaching. About the support, it must show an optimum microporosity, which must be wide enough to allow the entrance and exit of the reagents and products but not too wide in order to avoid the leaching of the catalyst. In addition, both decreasing of the catalytic activity and its recovery over several cycles have been analyzed.

Influence of peroxometallic intermediaries present on polyoxometalates nanoparticles surface on the adipic acid synthesis

The cyclohexene oxidation by hydrogen peroxide catalysed by polyoxometalates (POM) has been shown as an adequate green route for the adipic acid synthesis. In this study, it has been demonstrated that POM's salts are effective catalysts for this reaction and how peroxopolyoxometalates intermediaries are the truly responsible species of the POM's salts catalytic activity and solubility. However, the latter can be reduced by calcining the catalyst previously. Polyoxomolybdates salts generally present a higher activity than polyoxotungstenates salts. Finally, it must be remarked the positive effect exerted by the acetic acid stabilising the peroxide of hydrogen against its decomposition.

Trabajo de coordinación para la implementación del cuarto curso del Grado en Química

En el curso 2013-14 se implantará el cuarto y último curso del Grado en Química. La experiencia adquirida durante la implementación de los tres primeros cursos ha puesto de manifiesto la conveniencia de realizar un proceso de coordinación entre los profesores de las diferentes asignaturas que garantice la consecución de las competencias previstas en la memoria del título. Por ello, se ha creado en la Facultad de Ciencias de la Universidad de Alicante una red de investigación en docencia universitaria que ha estado trabajando desde el inicio del presente curso académico en este tema. Dicha red está constituida por el Vicedecano de Ordenación Académica de la Facultad de Ciencias, la Coordinadora Académica de Química y los profesores coordinadores de todas las asignaturas del 4º curso del grado (excepto Prácticas Externas y Trabajo Fin de Grado). En esta comunicación se presentarán los resultados del trabajo de investigación realizado por estos profesores que ha permitido elaborar las guías docentes de las asignaturas, planificar y coordinar las actividades a realizar para que los alumnos adquieran las competencias transversales, realizar un cronograma de actividades de evaluación y otro de prácticas de laboratorio que asegure la distribución homogénea del trabajo del alumno durante el curso académico.

Limitaciones y recomendaciones metodológicas en las publicaciones sobre salud de la población inmigrante en España

El objetivo es describir las limitaciones y las recomendaciones metodológicas identificadas por los autores de artículos originales sobre inmigración y salud en España. Se realizó una revisión bibliográfica de artículos originales publicados en español e inglés entre 1998 y 2012, combinando descriptores de inmigración y salud. Se incluyeron 311 artículos; de ellos, 176 (56,6%) mencionaban limitaciones y 15 (4,8%) emitían recomendaciones. Entre las limitaciones más mencionadas destacan el reducido tamaño de las muestras, problemas de validez interna y representatividad de la muestra con infrarrepresentación o sobrerrepresentación de determinados grupos, problemas de validez de la información recogida y datos faltantes relacionados sobre todo con los instrumentos de medición, y ausencia de variables clave de ajuste o estratificación. En función de los resultados obtenidos, se proponen una serie de recomendaciones para minimizar las limitaciones habituales y avanzar en la calidad de los trabajos científicos sobre inmigración y salud en nuestro ámbito.

Efectos y comparación de un entrenamiento integrado y otro analítico en las distintas capacidades que componen el juego

Los deportes colectivos están en continua evolución, por lo que se trata de mejorar en todas las facetas posibles para llegar al máximo rendimiento. De todas ellas en este trabajo nos vamos a centrar en la metodología del entrenamiento, más concretamente en qué tipo de ejercicios (analíticos o integrados) producen mayor rendimiento en cada una de las distintas capacidades en las que hemos dividido el juego (Capacidad de ejecución, capacidad de percepción y capacidad de decisión) para los dos tipos de deportes colectivos que existen (de campo compartido y de campo dividido). Tras un estudio de revisión de la bibliografía escrita para la materia que nos concierne, vemos que el rendimiento de las capacidades motrices en líneas generales mejora más con los entrenamientos analíticos, que con los de tipo integrado. Por contra vemos que para la mejora de las capacidades perceptivo-motrices el entrenamiento integrado ofrece mejores resultados que en los analíticos, puesto que en estos últimos no se trabaja. También tenemos que en los deportes colectivos de campo dividido, exceptuando el trabajo de fuerza y flexibilidad, gana una gran importancia para el rendimiento el entrenamiento integrado, puesto que al no haber contacto directo con el oponente, las situaciones son mucho más sencillas de reproducir en entrenamientos, y por consiguiente deberemos de trabajar las capacidades de manera integrada. Por último se realizan unas recomendaciones de entrenamiento, y de preparación física, como resultado de las conclusiones obtenidas a lo largo del estudio de revisión bibliográfica.

Dimeric assemblies of lanthanide-stabilised dilacunary Keggin tungstogermanates: A new class of catalysts for the selective oxidation of aniline

In this work we demonstrate the efficiency of some dimeric [Ln4(H2O)6(β-GeW10O38)2]12− anions composed of lanthanide-stabilised dilacunary Keggin tungstogermanate fragments (ββ-Ln4, Ln = Dy, Ho, Er, Tm) as heterogeneous catalysts for the organic phase oxidation of aniline with hydrogen peroxide. The results obtained evidence total conversion of aniline at room temperature, as well as full selectivity towards nitrosobenzene, and the catalysts are able to retain both their activity and selectivity after several runs. Peroxopolyoxometalate intermediaries have been identified as the catalytically active species during the aniline-to-nitrosobenzene oxidation process.