Microgravity experiments of two-phase flow patterns aboard Mir Space Station

A first experimental study on two-phase how patterns at a long-term, steady microgravity condition was conducted on board the Russian Space Station "MIR" in August 1999. Carbogal and air are used as the liquid and the gas phase, respectively. Bubble, slug, slug-annular transitional, and annular hows are observed. A new region of annular how with lower liquid superficial velocity is discovered, and the region of the slug-annular transitional flow is wider than that observed by experiments on board the parabolic aircraft. The main patterns are bubble, slug-annular transitional and annular flows based on the experiments on board MIR space station. Some influences on the two-phase how patterns in the present experiments are discussed.

PLOD3基因3'调控区的人类特异突变改变miR-124a对PLOD3的调控

microRNAs(miRNAs)是一类在转录后水平调控基因表达的不编码蛋白质的小RNA(长度20-24个碱基).其中,miR-124a是一个在哺乳动物中枢神经系统高度表达的miRNA,在神经前体细胞向神经元分化的过程中起着举足轻重的作用.由于miRNAs特异性地识别靶基因的3'端调控区(3'UTR)的靶序列,因此,在人类起源过程中基因3'UTR的单核苷酸序列变异有可能导致miRNA调控的改变.通过靶基因预测和3'UTR区在哺乳动物代表物种间的同源序列比较,我们发现miR-124a的靶基冈中有一个基因(PLOD3)3UTR的靶位点中存在人类特异突变位点.利用体外报告基因系统,发现PLOD3基因3'UTR靶位点中所含的一个人类特异的突变导致miR-124a对PLOD3的调控效率降低.研究表明,miRNAs靶基因3'UTR的序列变异具有功能效应,它有可能足人类中枢神经系统在起源和演化中发挥关键作用的重要遗传机制之一.

Hierarchy of structure functions for passive scalars advected by turbulent flows

A hierarchical model is proposed for the joint moments of the passive scalar dissipation and the velocity dissipation in fluid turbulence. This model predicts that the joint probability density function (PDF) of the dissipations is a bivariate log-Poisson. An analytical calculation of the scaling exponents of structure functions of the passive scalar is carried out for this hierarchical model, showing a good agreement with the results of direct numerical simulations and experiments.

亚微米氮化钛膜的纳米压痕和划痕测定Coatings

采用等离子电弧沉积的方法分别在GT35和40CrNiMo钢上沉积厚约为0.5mm 的氮化钛(TiN)膜。为了筛选基材，采用纳米压痕和划痕技术评价膜基界面结合和固体润滑效果。纳米压痕结果，采用等离子电弧沉积的方法，分别在GT35和40CrNiMo钢上沉积厚约为0.5$\mu $m 的氮化钛(TiN)膜。为了筛选基材，采用纳米压痕和划痕技术，评价膜基界面结合和固体润滑效果。纳米压痕结果，GT35，40CrNiMo和TiN的纳米硬度/弹性模量的典型值分别约为11.5 Gpa/330 Gpa，6.0 Gpa/210 Gpa，30 Gpa/450 Gpa。纳米划痕结果，GT35有较理想的膜基结合能力；GT35，40CrNiMo，TiN及其有机膜的摩擦系数分别约为0.25，0.45，0.15，0.10。同40CrNiMo相比，GT35是较为理想的基体材料。纳米压痕和划痕技术能提供丰富的近表面的弹塑性变形、断裂和摩擦等的信息，是评价亚微米薄膜力学性能的有效手段。

Glass Transition and Thermal Stability of Hard Magnetic Bulk NdAlFeCo Metallic Glass

Glass transition and thermal stability of bulk Nd60Al10Fe20Co10 metallic glass were investigated by means of dynamic mechanical thermal analysis (DMTA), differential scanning calorimetry (DSC), X-ray diffraction (XRD) and scanning electronic microscopy (SEM). The glass transition temperature, not revealed by DSC, is alternatively determined by DMTA via storage modulus E' and loss modulus E" measurement to be 498 K at a heating rate of 0.167 K s (-1). The calculated reduced glass transition temperature (T-g/T-m) is 0.63. The large value of T-g/T-m of this alloy is consistent with its good glass-forming ability. The crystallization process of the metallic glass is concluded as follows: amorphous --> amorphous + metastable FeNdAl phase --> amorphous + primary delta-FeNdAl phase --> primary delta-phase + eutectic delta-phase + Nd3Al + Nd3Co. The appearance of hard magnetism in this alloy is ascribed to the presence of amorphous phase with highly relaxed structure. The hard magnetism disappeared after the eutectic crystallization of the amorphous phase. (C) 2002 Elsevier Science B.V. All rights reserved.

Observation and modeling for terrestrial processes in alpine meadow

The water-heat transfer process between land and atmosphere in Haibei alpine meadow area has been systematically observed. A multi-layer coupling model for land-atmosphere interaction was presented with special attention paid to the moisture transfer in leaf stomata under unsaturated condition. A profound investigation on the physical process of turbulent transfer inside the vegetation has been performed with a revised formula of water absorption for root system. The present model facilitates the study of vertically distributed physical variables in detail. Numerical simulation was conducted according to the transfer process of Kinesia humility meadow in the area of Haibei Alpine Meadow Ecosystem Station, CAS. The calculated results agree well with observation.

烧蚀图象研究概述

本文着重介绍了林同骥和他的合作者们在烧蚀图象方面的研究工作,包括再入飞行器、地面实验模型和吉林陨石三部分。他们发现烧蚀图象是受烧蚀表面的边界层雷诺数控制的。研究了两种典型的烧蚀图象:有序熔楔和菱形花纹。得到了再入飞行器和模型的转捩雷诺数。

理想塑性材料扩展裂纹的平面应变问题

本文从三维塑性流动理论出发,导出了理想塑性材料平面应变问题的基本方程.进而对扩展裂纹问题建立了完整的定解方程和速度场求解公式.已有的渐近方程只是预解方程和零级定解方程的组合.本文证实了已有的中心扇形区,虽然满足了渐近方程,但不能适应高阶渐近方程.

强CO_2激光辐照下离子注入Si反射率的动态干涉效应

本文从理论和实验研究了连续CO_2激光辐照下磷离子注入Si对He-Ne激光束反射率呈现的动态干涉效应。从反射强度随时间的变化看出,Si片离子注入层固相外延的速率在整个再结晶过程中是不均匀的。

具有中间穿透裂纹载流薄板裂纹前缘的应力场

用复变函数方法研究了带有中间穿透裂纹的载流薄板在瞬间电流通入时,在裂纹尖端处由于电流集中及电磁热效应而形成的点热源的计算方法,进而推导并计算了由此热源在裂纹前缘产生的温度场和应力场。通过控制通入电流密度,可以使裂纹尖端温升达到熔化状态,至使裂尖钝化,由温升产生的压应力可以遏制裂纹的扩展。在文中讨论了裂尖附近材料的热传导系数、线胀系数、弹性模量随温度的变化,及其对应力场的影响。

铁磁/半导体异质结材料MnSb/Si的物理气相沉积生长

采用一种新的生长铁磁 /半导体异质结材料的方法——物理气相沉积方法生长了一种铁磁 /半导体异质结材料 Mn Sb/Si.对所获得的样品进行特征 X射线能谱分析表明 Mn和 Sb在 Si衬底上的沉积速率相近 ,它们的原子百分数之比接近 1∶ 1.X射线衍射分析发现薄膜中形成了 Mn Sb相 ,样品在室温下测出磁滞回线也从侧面验证了存在 Mn Sb相 .用原子力显微镜对样品的表面进行观察 ,发现 Mn Sb呈有规则形状的小晶粒状 ,晶粒大小比较均匀 ,尺寸大多数在 5 0 0 nm左右 .

亚微米氮化钛膜的纳米压痕和划痕测定

采用等离子电弧沉积的方法，分别在GT35和40CrNiMo钢上沉积厚约为0.5μm的氮化钛(TiN)膜。为了筛选基材，采用纳米压痕和划痕技术，评价膜基界面结合和固体润滑效果。纳米压痕结果，GT35，40CrNiMo和TiN的纳米硬度/弹性模量的典型值分别约为11.5 GPa/330GPa, 6.0 GPa/210GPa, 30GPa/450GPa。纳米划痕结果，GT35有较理想的膜基结合能力；GT35，40CrNiMo，TiN及其有机膜的磨擦系数分别约为0.25，0.45，0.15, 0.10。同40CrNiMo相比，GT35是较为理想的基体材料。纳米压痕和划痕技术能提供丰富的近表面的弹塑性变形、断裂和磨擦等的信息，是评价亚微米薄膜力学性能的有效手段。

Two-phase flow and pool boiling heat transfer in microgravity

Researches on two-phase flow and pool boiling heat transfer in microgravity, which included groundbased tests, flight experiments, and theoretical analyses, were conducted in the National Microgravity Laboratory/CAS. A semi-theoretical Weber number model was proposed to predict the slug-to-annular flow transition of two-phase gas–liquid flows in microgravity, while the influence of the initial bubble size on the bubble-to-slug flow transition was investigated numerically using the Monte Carlo method. Two-phase flow pattern maps in microgravity were obtained in the experiments both aboard the Russian space station Mir and aboard IL-76 reduced gravity airplane. Mini-scale modeling was also used to simulate the behavior of microgravity two-phase flow on the ground. Pressure drops of two-phase flow in microgravity were also measured experimentally and correlated successfully based on its characteristics. Two space experiments on pool boiling phenomena in microgravity were performed aboard the Chinese recoverable satellites. Steady pool boiling of R113 on a thin wire with a temperature-controlled heating method was studied aboard RS-22, while quasi-steady pool boiling of FC-72 on a plate was studied aboard SJ-8. Ground-based experiments were also performed both in normal gravity and in short-term microgravity in the drop tower Beijing. Only slight enhancement of heat transfer was observed in the wire case, while enhancement in low heat flux and deterioration in high heat flux were observed in the plate case. Lateral motions of vapor bubbles were observed before their departure in microgravity. The relationship between bubble behavior and heat transfer on plate was analyzed. A semi-theoretical model was also proposed for predicting the bubble departure diameter during pool boiling on wires. The results obtained here are intended to become a powerful aid for further investigation in the present discipline and development of two-phase systems for space applications.

Designing superresolution optical pupil filter with constrained global optimization algorithm

In this paper, a new method for designing three-zone optical pupil filter is presented. The phase-only optical pupil filter and the amplitude-only optical pupil filters were designed. The first kind of pupil for optical data storage can increase the transverse resolution. The second kind of pupil filter can increase the axial and transverse resolution at the same time, which is applicable in three-dimension imaging in confocal microscopy. (C) 2007 Elsevier GmbH. All rights reserved.

一种核黄素敏化的宽带全息记录材料

制备了一种核黄素敏化的以聚乙烯醇为基质的新型全息存储材料，并研究了材料的全息特性,用Ar^＋激光器激发的488nm的蓝光对材料曝光，结果表明该材料具有较高的衍射效率和曝光灵敏度，衍射效率高达53％，灵敏度为3．3cm^2／J，折射率调制度为4．5×10^-4研究了材料的透过率与随时间和入射角度变化的关系，说明在曝光记录过程中有噪音光栅生成．在存储介质膜中存储了全息图像，再现图像较为清晰，说明该材料适合用作高密度全息存储介质．