波浪场中水中悬浮隧道动力响应的研究

针对水中悬浮隧道在波浪力作用下动力响应的问题,通过Hamilton原理推导得到了悬浮隧道管段和锚索的运动控制方程,同时考虑了锚索横向和轴向变形之间的耦合作用,建立了悬浮隧道的动力响应模型,在时间域内采用逐步积分法迭代求解其运动控制方程.波浪力采用Airy线性波理论和Morison方程计算.计算结果表明:当锚索长细比较大时,锚索的自振模态会被激发,其横向和轴向变形之间的耦合作用不可忽略.随着入射波高或悬浮隧道重浮比的增加,悬浮隧道的横荡位移以及横摇角增大,但结构的垂荡位移以及锚索中的应力受波浪的影响较小.

环与杆高速碰撞动态响应的分析和预测

采用量纲分析的方法，讨论了环与杆高速碰撞时影响杆被击断的主要因素，分别给出了相对临界速度、临界方位角及环的临界厚度与主要物理参数的函数关系，并通过计算机仿真确定这种函数关系。

辛体系下曲线形水中悬浮隧道对波浪激励的动力响应研究

在哈密顿体系下建立曲线形水中悬浮隧道的运动方程,即哈密顿正则方程.用哈密顿混合能变分原理处理曲线形水中悬浮隧道的两端边界条件以及径向布设的张力腿弹性支承,建立满足边界条件的线性方程组,采用分离变量法和本征向量展开法求解哈密顿正则方程.为曲线形水中悬浮隧道的动力响应分析提供一类方法.最后结合案例,运用辛方法分析波浪作用下曲线形水中悬浮隧道的弯矩和扭矩,结果表明,可以忽略扭矩对弯矩的影响.

爆炸容器内冲击波系演化及壳体响应的数值研究

对中心装药爆炸后冲击波的产生、传播和壳体动态响应全过程进行了数值研究。认为RDX瞬时爆炸，爆炸近场采用自相似解；冲击波传播和波系演化采用PPM(the Piecewise Parabolic Method)格式求解Euler方程；壳体响应采用有限元方法求解拉氏坐标系下由虚功原理得到的动力学方程。壳体内壁面边界条件分别采用强耦合和弱耦合方法处理。结果表明：（1）当装药量相同时，薄壁壳体振型比厚壁宙体复杂得多，振幅也大；（2）当装药量不同，壳体厚度相同时，爆炸场冲击波的演化过程不同；（3）对少量装药，产生的冲击波强度低，壳体变形小，是否考虑内边界运动，对计算结果的影响不大；（4）在本文条件下，爆炸容器封头顶点所受的载荷最大，是取易发生破坏的地方，侧壁与爆点所在横截面的交线，也易破坏。

Propagation of Explosion Wave in Hard-Soft-Hard Layered Media

The paper presents a reasonable analysis for dynamic response and failure process of a plane multi-layered media, which are subjected to a blast loading. This blast loading is induced by a cylindric explosive put on the center of top surface of the layered media. With the help of numerical simulation technique provided by LS-DYNA software, the whole process of explosion wave propagation and attenuation can be revealed. The feature of local failure around the blasting site is also discussed in some detail. Our focus will be on the explosion wave attenuation for the hard-soft-hard sandwich layers. As seen in the paper, the computational results are delivered in a feasible way by comparing with experimental data.

Researches on essential mechanics issues for submerged floating tunnel

Since 2001, a research group in the Institute of Mechanics, Chinese Academy of Sciences, has been devoted to the research of essential mechanics issues for submerged floating tunnel (SFT). In addition to the structural design of the SFT prototype in Qiandao Lake, the relevant researches cover a number of topics. This paper briefly describes the research procedure and results, including dynamic response of SFT due to surface wave, vortex-induced vibration of anchoring system, structural analysis of curved SFT, temperature effects of curved SFT, structural dynamic response due to accidental load, and effects of structural parameters (buoyancy-weight ratio, tunnel length，tether stiffness，etc.) on dynamic response.

Development And Application Of Flexible Substrate Sensors In Instantaneous Heat Flux Measurement

A new type of sensor with the flexible substrate is introduced. It is applicable in measuring instantaneous heat flux on the model surface in a hypersonic shock tunnel. The working principle, structure and manufacture process of the sensor are presented. The substrate thickness and the dynamic response parameter of the sensor are calculated. Because this sensor was successfully used in measuring the instantaneous heat flux on the surface of a flat plate in a detonation-driven shock tunnel, it may be effective in measuring instantaneous heat flux on the model surface.

Femtosecond filamentation and supercontinuum generation in silver-nanoparticle-doped water

The authors report the investigation of filament and supercontinuum generation by focusing a femtosecond laser beam into water doped with silver nanoparticles. The silver nanoparticles enhance the nonlinear optical response of water, leading to broadening of supercontinuum spectra in self-focused femtosecond filaments. During the propagation of the supercontinuum light in the filament, the silver nanoparticles preferentially scatter the short-wavelength light near the plasmon resonant wavelength peak, followed by the scattering of the long-wavelength light. Thus, a side view of the filament shows a full-color spectrum in the visible range, which is herein called "rainbow filament." (c) 2007 American Institute of Physics.

一种闭环控制的光纤光栅动态色散补偿仪

利用啁啾光纤光栅的应变调谐特性，将色散补偿的啁啾光纤光栅斜贴于悬臂梁的侧面，通过应力实现啁啾量调整而改变其色散补偿量的大小，同时利用固定在同一悬臂梁的均匀布拉格光栅传感器，实现了闭环自动控制色散补偿量，研制出了一种新型的光纤光栅动态色散补偿仪。该色散补偿仪工作在1550nm波段，典型性能数据为：色散动态补偿范围-1000-1680ps／nm，插入损耗小于1．5dB，动态调谐步进响应时间小于50ms，基本上能满足10Gb／s光纤通信系统中色散动态补偿的要求。

The refractive nonlinearities of InAs/GaAs quantum dots above-bandgap energy

The third-order optical nonlinear refractive properties of InAs/GaAs quantum dots grown by molecular beam epitaxy have been measured using the reflection Z-scan technique at above-bandgap energy. The nonlinear refractive index and nonlinear absorption index of the InAs/GaAs quantum dots were determined for wavelengths from 740 to 777 nm. The measured results are compared with the nonlinear refractive response of several typical III-V group semiconductor materials. The corresponding mechanisms responsible for the large nonlinear response are discussed.

Study on in-plane optical anisotropy of Si0.75Ge0.25/Si/Si0.5Ge0.5 asymmetric superlattice by reflectance difference spectroscopy - art. no. 071908

Si0.75Ge0.25/Si/Si0.5Ge0.5 trilayer asymmetric superlattices were prepared on Si (001) substrate by ultrahigh vacuum chemical vapor deposition at 500 degrees C. The nonlinear optical response caused by inherent asymmetric interfaces in this structure predicted by theories was verified by in-plane optical anisotropy in (001) plane measured via reflectance difference spectroscopy. The results show Si0.75Ge0.25/Si/Si0.5Ge0.5 asymmetric superlattice is optically biaxial and the two optical eigen axes in (001) plane are along the directions [110] and [-110], respectively. Reflectance difference response between the above two eigen axes can be influenced by the width of the trilayers and reaches as large as similar to 10(-4)-10(-3) in 15-period 2.7 nm-Si0.75Ge0.25/8 nm-Si/1.3 nm-Si0.5Ge0.5 superlattice when the normal incident light wavelength is in the range of 500-1100 nm, which is quite remarkable because the optical anisotropy does not exist in bulk Si.

An analysis of the performance of a new high-speed single-way analog switch

This paper introduces a new highspeed single-way analog switch which has both highspeed high-resolution mono-direction analog transmission gate function and high-speed digital logic gate function with normal bipolar technology. The analysis of static and transient switching performances as an analog transmission gate is emphasized in the paper. In order to reduce the plug-in effect on high-speed high-resolution systems, an optimum design scheme is also given. This scheme is to achieve accelerated dynamic response with very low bias power dissipation. The analysis of PSPICE simulation as well as the circuit test results confirms the feasibility of the scheme. Now, the circuit has been applied effectively to the designs of novel highspeed A/D and D/A converters.

地震作用下顺层岩质边坡动力响应的试验研究

基于相似理论建立顺层岩质边坡力学模型,并介绍爆炸模型试验的设计思路及试验方法.以导爆索为爆源,通过水下爆炸模型试验,研究近场地震作用下原型边坡的变形破坏模式以及支护结构对边坡稳定性的影响.试验结果表明,顺层岩质边坡的在近场地震作用下的破坏主要表现方式为节理岩体间的层间滑动,破坏模式为应力波导致的滑移-拉裂破坏;重力式挡墙的压应力峰值分布随着墙高的变化呈现先增大后减小的钟形分布;结合汶川地震现场考察及试验结果发现,支护结构对边坡稳定性起着重要作用

Controlling parameter for wave types of long flexible riser undergoing vortex-induced vibration

Submerged floating tunnel (SFT) is a popular concept of crossing waterways. The failure of the cable may occur due to vortex-induced-vibration (VIV), and the stability of the cable is crucial to the safety of the entire tunnel. Investigation results in recent years show that the vortex-induced vibration of the flexible cables with large aspect ratio reveals some new phenomena, for example, the vortex-induced wave, multi-mode competition, wide band random vibration, which have brought new challenges to the study of vortex-induced vibration of long flexible cables. In this paper, the dimensionless parameter controlling the wave types of dynamic response of slender cables undergoing vortex-induced vibration is investigated by means of dimensional analysis and finite element numerical simulations. Our results indicate that there are three types of response for a slender cable, i.e. standing wave vibration, traveling wave vibration and intermediate state. Based on dimensional analysis the controlling parameter is found to be related to the system damping including fluid damping and structural damping, order number of the locked-in modes and the aspect ratio of cable. Furthermore through numerical simulations and parameter regression, the expression and the critical value of controlling parameter is presented. At last the physical meaning of the parameter is analyzed and discussed.

Morphology and melt rheology of nylon 11/clay nanocomposites

Nylon 11 (PA11)/clay nanocomposites have been prepared by melt-blending, followed by melt-extrusion through a capillary. Transmission electron n-Licroscopy shows that the exfoliated clay morphology is dominant for low nanofiller content, while the intercalated one is prevailing for high filler loading. Melt rheological properties of PA11 nanocomposites have been studied in both linear and nonlinear viscoelastic response regions. In the linear regime, the nanocomposites exhibit much higher storage modulus (G') and loss modulus (G") values than neat PAIL The values of G' and G" increase steadily with clay loading at low concentrations, while the G' and G" for the sample with 5 wt % clay show an inverse dependence and lie between the modulus values of the samples with 1 and 2 wt % of clay. This is attributed to the alignment/orientation of nanoclay platelets in the intercalated nanocomposite induced by capillary extrusion. In the nonlinear regime, the nanocomposites show increased shear viscosities when compared with the neat resin. The dependence of the shear viscosity on clay loading has analogous trend to that of G' and G".