ESTIMATION OF THE STRAIN STATE OF GEXSI1-X/SI STRAINED-LAYER SUPERLATTICES BY DOUBLE-CRYSTAL X-RAY-DIFFRACTION

20-period strained-layer superlattices of nominal composition and width Ge0.2Si0.8 (5 nm)/Si(25 nm) and Ge0.5Si0.5 (5 nm)/Si(25 nm) were studied by double-crystal X-ray diffraction. The Ge content x was determined by computer simulation of the diffraction features from the superlattice. This method is shown to be independent of the relaxation of the superlattice. Alternatively, x can be obtained from the measured difference DELTAa/a in lattice spacing perpendicular to the growth plane. It is sensitive to the relaxation. Comparing the results obtained in these two different ways, information about the relaxation of the superlattices can be obtained.

KINEMATICAL STUDY OF GEXSI1-X/SI STRAINED-LAYER SUPERLATTICE BY A DOUBLE CRYSTAL X-RAY-DIFFRACTION METHOD

Two samples of nominal 20-period Ge0.20Si0.80(5 nm)/Si(25 nm) and Ge0.5Si0.5(5 nm)/Si(25 nm) strained-layer superlattices (SLSs) were studied by the double-crystal X-ray diffraction method. It is convenient to define the perpendicular strains relative to the average crystal. Computer simulations of the rocking curves were performed using a kinematical step model. An excellent agreement between the measured and simulated satellite patterns is achieved. The dependence of the sensitivity of the rocking curves to the structural parameters of the SLS, such as the alloying concentration x and the layer thicknesses and the L component of the reflection g = (HKL), are clearly demonstrated.

Identified particle production, azimuthal anisotropy, and interferometry measurements in Au plus Au collisions at root s(NN)=9.2 GeV

We present the first measurements of identified hadron production, azimuthal anisotropy, and pion interferometry from Au + Au collisions below the nominal injection energy at the BNL Relativistic Heavy-Ion Collider (RHIC) facility. The data were collected using the large acceptance solenoidal tracker at RHIC (STAR) detector at root s(NN) = 9.2 GeV from a test run of the collider in the year 2008. Midrapidity results on multiplicity density dN/dy in rapidity y, average transverse momentum < p(T)>, particle ratios, elliptic flow, and Hanbury-Brown-Twiss (HBT) radii are consistent with the corresponding results at similar root s(NN) from fixed-target experiments. Directed flow measurements are presented for both midrapidity and forward-rapidity regions. Furthermore the collision centrality dependence of identified particle dN/dy, < p(T)>, and particle ratios are discussed. These results also demonstrate that the capabilities of the STAR detector, although optimized for root s(NN) = 200 GeV, are suitable for the proposed QCD critical-point search and exploration of the QCD phase diagram at RHIC.

EFFECT OF V, NB, AND TA DOPING ON THE 2223 PHASE-FORMATION AND THE CRYSTAL-STRUCTURE IN THE BISRCACUO SYSTEM

X-ray diffraction and electrical and diamagnetic analyses revealed that the 2223 phase was significantly enhanced by high-valence cation (V5+, Nb5+, Ta5+, etc.) doping in BiSrCaCuO samples. The optimum nominal composition was Bi1.6M0.4Sr2Ca2Cu3 O(y)(M =

EFFECT OF CODOPING SB AND V TO THE BIPBSRCACUO SYSTEM

With XRD, R- T curves, and a.c chi measurements, the doping and codoping effects of Sb and V to a Cu-deficient Pb-doped Bi system have been studied. A sample singly doped with V possesses a T(c) about 2 K lower than that of a sample singly doped with Sb. This is attributed to the different sites of their substitution. It was observed that for promoting 2223 phase formation, Sb and V works cooperatively, and the codoping of Sb may enhance the 2223 phase formed. With a low doping level of Sb, the optimum doping amount of V is 0.3, i.e., with a nominal composition of Bi1.5Pb0.3Sb0.06Sr2Ca2Cu2.4V0.3Oy. A sample in which the 2223 phase is the dominant phase and which has a zero resistance transition temperature of 105 K has been obtained.

ANALYSIS OF A NEW SUPERCONDUCTING PHASE IN THE BISRCACUO SYSTEM

By doping Sb, Ba and In to the Bi-system and with the variation of nominal atomic ratio of Cu, Sr and Ca, a new possible phase is found with T(c) almost-equal-to 105 K, but with a structure of 2212 phase. Effects of post-sintering treatment from air-quenched to O2-annealed were investigated for the approximately 105 K new phase.

原子力显微镜管式扫描器运动学建模与误差分析

针对样本扫描模式原子力显微镜,对其管式扫描器-样本-探针系统进行了运动学分析,建立了该系统的运动学模型,该模型表明:对于给定原子力显微镜扫描器,样本上与探针接触点的横向和纵向位移取决于探针尖端相对于扫描管轴心的偏置量、所加电压(或名义扫描范围)及样本厚度。据此模型,对由于弯曲运动模式所产生的两种重要误差—交叉耦合误差及扫描范围误差进行了定量分析,分析表明:扫描范围误差主要受样本厚度及名义扫描范围影响,而Z向交叉耦合误差主要受探针偏置量及名义扫描范围影响,实验验证了所建立的运动学模型和误差计算公式的正确性;另外,还提出了相应的减小误差的方法。

基于模型扰动抑制的直线伺服系统设计

针对高精度、微进给永磁直线交流同步电机 (PMLSM )驱动系统 ,采用基于模型的扰动抑制 (MBDA)方法 ,对诸如摩擦力、切削力、负载变动之类的扰动进行抑制。MBDA是利用一个与系统并行的标称模型 ,通过输出反馈 ,将系统输出与标称模型输出进行比较 ,得出误差信号 ,并通过设计一个补偿器将误差信号反馈给被控对象的输入端 ,从而实现扰动抑制。同时 ,针对速度环设计了积分 -比例 (IP)控制器 ,以满足系统快速跟踪指令的要求 ,并且其具有较强的抗扰动能力。仿真结果表明 ,该控制方法响应速度快 ,抗干扰能力强

从第四轮“关于科研单位的组织与业绩的国际比较研究”（ICSOPRU）看满意度对科研单位业绩的影响

What role satisfaction plays in the factors contributing to performance continues to be a major area of interest in the study of industrial and organization psychology, but there is a lack of quantative study dealing with this question in research units. The author has a try in this paper to answer this question using the data from China, Ghana, Hungary and Mexico of the Fourth Round International Comparative Study on the Organization and Performance of Research Units (ICSOPRU). The data-analysis include the principle component factor analysis of the performance and the satisfaction items in the Fourth Round ICSOPRU Questionnaires, and the multiple classification analysis, the multivariate nominal analysis of the performance and the satisfaction factors. The main findings show that a certain facet of the satisfaction explains the largest proportion of variances of a certain dimention of the performance and has a higher relative importance in contributing to the understanding of the performance. There also a comparison between the results from the four countries and that from China.

Structure and chemical composition of supported Pt-Sn electrocatalysts for ethanol oxidation

Carbon supported PtSn alloy and PtSnOx particles with nominal Pt:Sn ratios of 3:1 were prepared by a modified polyol method. High resolution transmission electron microscopy (HRTEM) and X-ray microchemical analysis were used to characterize the composition, size, distribution, and morphology of PtSn particles. The particles are predominantly single nanocrystals with diameters in the order of 2.0-3.0 nm. According to the XRD results, the lattice constant of Pt in the PtSn alloy is dilated due to Sn atoms penetrating into the Pt crystalline lattice. While for PtSnOx nanoparticles, the lattice constant of Pt only changed a little. HRTEM micrograph of PtSnOx clearly shows that the change of the spacing of Pt (111) plane is neglectable, meanwhile, SnO2 nanoparticles, characterized with the nominal 0.264 nm spacing of SnO2 (10 1) plane, were found in the vicinity of Pt particles. In contrast, the HRTEM micrograph of PtSn alloy shows that the spacing of Pt (111) plane extends to 0.234 nm from the original 0.226 nm. High resolution energy dispersive X-ray spectroscopy (HR-EDS) analyses show that all investigated particles in the two PtSn catalysts represent uniform Pt/Sn compositions very close to the nominal one. Cyclic voltammograms (CV) in sulfuric acid show that the hydrogen ad/desorption was inhibited on the surface of PtSn alloy compared to that on the surface of the PtSnOx catalyst. PtSnOx catalyst showed higher catalytic activity for ethanol electro-oxidation than PtSn alloy from the results of chronoamperometry (CA) analysis and the performance of direct ethanol fuel cells (DEFCs). It is deduced that the unchanged lattice parameter of Pt in the PtSnOx catalyst is favorable to ethanol adsorption and meanwhile, tin oxide in the vicinity of Pt nanoparticles could offer oxygen species conveniently to remove the CO-like species of ethanolic residues to free Pt active sites. (C) 2005 Elsevier Ltd. All rights reserved.