ON THE RATE-EQUATIONS OF SEMICONDUCTOR-LASERS FOR MEASURING SPONTANEOUS EMISSION FACTOR

The rate equations used for measuring spontaneous emission factor beta is examined through the comparison of numerical results, The results show that beta obtained by using total spontaneous emission rate R(sp) = N/tau sp is about double of that using R(sp) = BN2, The magnitude difference between the measured beta and that predicted by classical theory [8] will disappear by using more reasonable R(sp) = BN2. The results also show that the magnitude of beta may be underestimated by ignoring the nonradiative recombination rates.

PULSED ELECTRICAL OPERATION OF 1.5-MU-M VERTICAL-CAVITY SURFACE-EMITTING LASERS

Vertical cavity surface emitting lasers operating in the 1.3- and 1.5-mu m wavelength ranges are highly attractive for telecommunications applications. However, they are far less well-developed than devices operating at shorter wavelengths. Pulsed electrically-injected lasing at 1.5 mu m, at temperatures up to 240 K, is demonstrated in a vertical-cavity surface-emitting laser with one epitaxial and one dielectric reflector. This is an encouraging result in the development of practical sources for optical fiber communications systems.

Photoluminescence spectroscopy of sputtering Er-doped silicon-rich silicon nitride films

Er-doped silicon-rich silicon nitride (SRN) films were deposited on silicon substrate by an RF magnetron reaction sputtering system. After high temperature annealing, the films show intense photoluminescence in both the visible and infrared regions. Besides broad-band luminescence centered at 780 nm which originates from silicon nanocrystals, resolved peaks due to transitions from all high energy levels up to ~2H_(11/2) to the ground state of Er~(3+) are observed. Raman spectra and HRTEM measurements have been performed to investigate the structure of the films, and possible excitation processes are discussed.

掺Er光纤宽带光源的研究和应用

简述了近年来国内外掺Er光纤（EDF）光源的最新发展，详细分析了EDF光源的工作原理；介绍了EDF的基本结构，并概述了其各自的特点；总结了当前几种重要的EDF光源及其研究状况；指出了未来EDF光源发展方向。

Analysis of directional emission in square resonator lasers with an output waveguide

Square microcavity laser with an output waveguide is proposed and analyzed by the finite-difference time-domain (FDTD) technique. For a square resonator with refractive index of 3.2, side length of 4 microns, and output waveguide of 0.4-micron width, we have got the quality factors (Q factors) of 6.7×10~2 and 7.3×10~3 for the fundamental and first-order transverse magnetic (TM) mode near the wavelength of 1.5 microns, respectively. The simulated intensity distribution for the first-order TM mode shows that the coupling efficiency in the waveguide reaches 53%. The numerical simulation shows that the first-order transverse modes have fairly high Q factor and high coupling efficiency to the output waveguide. Therefore the square resonator with an output waveguide is a promising candidate to realize single-mode directional emission microcavity lasers.

掺Er/Er+O的GaN薄膜光学性质的研究

利用Raman散射谱研究了GaN注Er以及Er+O共注样品的振动模，并讨论了共注入O对Er离子发光的影响. 在Raman散射谱中，对于注Er的GaN样品出现了300 cm~(-1)和670 cm~(-1)两个新的Raman峰，而对于Er+O共注样品，除了上述两个峰外，在360 cm~(-1)处出现了另外一个新的峰，其中300 cm~(-1)峰可以用disorder-activated Raman scattering (DARS)来解释，670 cm~(-1)峰是由于与N空位相关的缺陷引起的，而360 cm~(-1)峰是由O注入引起的缺陷络合物产生的. 由于360 cm~(-1)模的缺陷出现，从而导致Er+O共注入GaN薄膜红外光致发光(PL)强度的下降

掺Er／Pr的GaN薄膜深能级的研究

利用深能级瞬态谱（DLTS）、傅里叶变换红外光谱（FT-IR）对GaN以及GaN掺Er／Pr的样品进行了电学和光学特性分析．研究发现未掺杂的GaN样品只在导带下0．270eV处有一个深能级；GaN注入Er经900℃，30min退火后的样品出现了四个深能级，能级位置位于导带下0．300eV，0．188eV，0．600eV和0．410eV；GaN注入Pr经1050℃，30min退火后的样品同样出现了四个深能级。能级位置位于导带下0．280eV，0．190eV，0．610eV和0．390eV；对每一个深能级的来源进行了讨论．光谱研究表明，掺Er的GaN样品经900℃，30min退火后，可以观察到Er的1538nm处的发光。而且对能量输运和发光过程进行了讨论．

Flash-lamp-pumped picosecond Nd:YAG regenerative amplifier

A flash-lamp-pumped Nd

Offset quantum-well method for tunable distributed Bragg reflector lasers and electro-absorption modulated distributed feedback lasers

A two-section offset quantum-well structure tunable laser with a tuning range of 7 nm was fabricated using offset quantum-well inethod. The distributed Bragg reflector （DBR） was realized just by selectively wet etching the multiquantum-well （MQW） layer above the quaternary lower waveguide. A threshold current of 32 mA and an output power of 9 mW at 100 mA were achieved. Furthermore, with this offset structure method, a distributed feedback （DFB） laser was integrated with an electro-absorption modulator （EAM）, which was capable of producing 20 dB of optical extinction.

Application of step-scan FTIR to the research of quantum cascade lasers

The principle of step-scan Fourier transform infrared （FTIR） spectroscopy is introduced. Double modulation step-scan FTIR technique is used to obtain the quantum cascade laser＇s stacked emission spectra in the time domain. Optical property and thermal accumulation of devices due to large drive current are analyzed.

Room Temperature Operation of Strain-Compensated 5.5μm Quantum Cascade Lasers

Room temperature operation is an important criterion for high performance of quantum cascade lasers. A strain-compensated quantum cascade laser（λ≈5.5μm） with optimized waveguide structure lasing at room temperature is reported. Accurate control of layer thickness and strain-compensated material composition is demonstrated using X-ray diffraction. An output power of at least 45mW per facet is realized for a 20μm-wide and 2mm-long laser at room temperature.

Theoretical Analysis of Gain and Threshold Current Density for Long Wavelength GaAs-Based Quantum-Dot Lasers

Quantum dot gain spectra based on harmonic oscillator model are calculated including and excluding excitons. The effects of non-equilibrium distributions are considered at low temperatures. The variations of threshold current density in a wide temperature range are analyzed and the negative characteristic temperature and oscillatory characteristic temperature appearing in that temperature range are discussed. Also,the improvement of quantum dot lasers＇ performance is investigated through vertical stacking and p-type doping and the optimal dot density, which corresponds to minimal threshold current density,is calculated.

Effect of Mesa Size on Thermal Characteristics of Vertical-cavity Surface-emitting Lasers

The effect of mesa size on the thermal characteristics of etched mesa vertical-cavity surfaceemitting lasers(VCSELs) is studied. The numerical results show that the mesa size of the top mirror strongly influences the temperature distribution inside the etched mesa VCSEL. Under a certain driving voltage, with decreasing mesa size, the location of the maximal temperature moves towards the p-contact metal, the temperature in the core region of the active layer rises greatly, and the thermal characteristics of the etched mesa VCSELs will deteriorate.

电光腔倒空激光二极管抽运Nd∶YAG锁模激光器

设计了一个简单的直腔,将电光腔倒空与激光二极管端面抽运Nd∶YAG半导体可饱和吸收镜锁模激光器结合,实现了锁模脉冲的产生、放大和输出。在连续抽运功率5 W的条件下,获得了脉冲宽度为11 ps的锁模单脉冲输出和脉冲宽度为200 ns的调Q脉冲输出,腔倒空单脉冲能量为30 nJ,重复频率为10 Hz。连续锁模运转时单个锁模脉冲的能量约为2 nJ,利用腔倒空将单脉冲的能量提高了15 倍左右。文章详细讨论了腔倒空脉冲及调Q脉冲的产生机理,并分析了加在电光晶体上的高压电脉冲以及偏振片的偏振度对腔倒空脉冲及调Q脉冲的影响。

激光二极管侧面抽运Nd∶YAG锁模激光器的研究

利用谐振腔的稳定条件对激光二极管侧面抽运的Nd∶YAG锁模直腔的稳区特性和谐振腔内的光斑分布进行了分析。根据对腔参量的分析，选取合适的腔参量设计了一个简单的侧面抽运直腔，该谐振腔腔形简单，没有像散，振荡光模式好，有利于激光器的锁模运转。实验中采用国内自行研制的半导体可饱和吸收镜，实现了激光二极管侧面抽运半导体可饱和吸收镜锁模Nd∶YAG激光器的连续锁模运转，平均输出功率为2 W，锁模脉冲宽度为10 ps,重复频率为100 MHz。结合实验结果进一步讨论了半导体可饱和吸收镜的一些参量如饱和恢复时间、调制深度等对实现稳定连续锁模的影响。