Effect of temperature on dislocation emission from crack tip for BCC metal Mo

The effect of thermally activated energy on the dislocation emission from a crack tip in BCC metal Mo is simulated in this paper. Based on the correlative reference model on which the flexible displacement boundary scheme is introduced naturally, the simulation shows that as temperature increases the critical stress intensity factor for the first dislocation emission will decrease and the total number of emitted dislocations increase for the same external load. The dislocation velocity and extensive distance among partial dislocations are not sensitive to temperature. After a dislocation emission, two different deformation slates are observed, the stable and unstable deformation states. In the stable deformation slate, the nucleated dislocation will emit from the crack tip and piles up at a distance far away from the crack tip, after that the new dislocation can not be nucleated unless the external loading increases. In the unstable deformation state, a number of dislocations can be emitted from the crack lip continuously under the same external load.

Dislocations emission and crack extension at the atomistic crack tip in body-centered-cubic metal Mo

The behaviors of a crack in body-centered-cubic metal Mo under different loading modes were studied using the molecular dynamics method. Dislocation emission was observed near the crack tip in response to mode II loading with theta = 0 degrees in which theta is the inclination angle of the slip plane with respect to the crack plane, and two full dislocations were observed at the stress level of K-II = 1.17 MPa m(1/2) without any evidence of crack extension. Within the range of 0 degrees less than or equal to theta less than or equal to 45 degrees, crack extension was observed in response to mode I loading, and the effect of crystal orientation on the crack propagation was studied, The crack propagated along the [111] slip direction without any evidence of dislocations emission.

P2O5-B2O3-R2O-MO-Al2O3系统玻璃物化性质的研究

以Yb^3+-Er^3+共掺的P2O5-B2O3-R2O-MO-Al2O3(R=Li，Na，K；M=Zn，Ca，Sr，Ba)系统玻璃为研究对象，分别分析了改变B2O3，的含量，以及加入不同种类的碱金属和碱土金属氧化物对玻璃的物理化学性质的影响。研究结果表明，当B2O3的含量增加，玻璃的Tg，Tf上升，热膨胀系数下降；随着修饰体阳离子半径减小，玻璃的溶解速率下降，化学稳定性变好。

Mo���子溅射能量对Mo���Si薄膜微结构的影响

用磁控溅射法制备了Mo���Si薄膜，用AFM和XRD分别研究了Mo���子的溅射能量不同时，Mo���Si薄膜表面形貌和晶相的变化。通过比较发现，随着Mo���子溅射能量的增大，Mo���Si薄膜表面粗糙度增加，Mo���Si的特征X射线衍射峰也越来越强，并且Mo���层和Si膜层之间生成了Mo-Si2。Mo���子的溅射能量是诱导非晶Si结晶和MoSi2生成的主要原因。

纳米Mo���的光学特性及最小连续膜厚研究

利用Lambda-900分光光度计，在波长为310～1250nm范围内测量了离子束溅射沉积不同厚度纳米Mo���的反射率和透射率。选定波长为310nm，350nm，400nm，500nm，550nm，632nm，800nm，1200nm时对薄膜的反射率、透射率和吸收率随膜厚变化的关系进行了讨论。实验结果显示，纳米Mo���的光学特性有明显的尺寸效应。提出将薄膜对光波长为550nm时的反射率和透射率随Mo���厚度变化关系的交点对应的厚度作为特征厚度，该厚度可认为是纳米Mo���生长从不连续膜进入连续膜的最小连续膜厚。利用

不同膜层数的Mo/Si多层膜的表界面粗糙度和软X射线反射率

用磁控溅射法制备了顶层分别是Mo���层和Si膜层的两个系列的Mo/Si多层膜，它们的周期厚度相同但是膜层数各不相同。Mo/Si多层膜的周期厚度和界面粗糙度由小角X射线衍射（SAXRD）曲线拟和得到。用原子力显微镜测量了Mo/Si多层膜的表面粗糙度。在国家同步辐射实验室测量了Mo/Si多层膜的软X射线反射率。通过理论和试验研究，发现Mo/Si多层膜的软X射线反射率主要由周期数和界面粗糙度决定，表面粗糙度对Mo/Si多层膜的软X射线反射率影响较小。

研究扩散屏障层对Mo/Si多层膜软X射线反射率影响的模拟

在特定波长下,用四层结构模型模拟了Mo/Si多层膜的软X射线反射率.研究了扩散屏障层dMo-on-Si和dSi-on-Mo���Mo/Si多层膜软X射线反射率的影响.研究发现,扩散屏障层并不总是损害Mo/Si多层膜的光学性能,通过合理设计dMo-on-Si和dSi-on-Mo���度,增加dMo-on-Si与dSi-on-Mo���比值,也能提高多层膜的软X射线反射率.

用不同的Mo���溅射功率制备Mo���Si多层膜

用磁控溅射法制备了周期厚度和周期数均相同的Mo���Si多层膜，用原子力显微镜和小角X射线衍射分别研究了Mo���溅射功率不相同时，Mo���Si多层膜表面形貌和晶相的变化。随后在国家同步辐射实验室测量了Mo���Si多层膜的软X射线反射率。研究发现，随着Mo���溅射功率的增大，Mo���Si多层膜的表面粗糙度增加，Mo���特征X射线衍射峰也增强，Mo���Si多层膜的软X射线峰值反射率先增大后减小。

Mo���Si软X射线多层膜的界面粗糙度研究

用磁控溅射法分别制备了以Mo���层和Si膜层为顶层的Mo���Si多层膜系列，利用小角X射线衍射确定了各多层膜的周期厚度。以不同周期数的Mo���Si多层膜的新鲜表面近似等同于同一多层膜的内界面，通过原子力显微镜研究了多层膜界面粗糙度随膜层数的变化规律。并在国家同步辐射实验室测量了各多层膜的软X射线反射率。研究表明：随着膜层数的增加，Mo���层和Si膜层的界面粗糙度先减小后增加然后再减小，多层膜的峰值反射率先增加后减小。

Molecular phylogeny of wood mice (Apodemus, Muridae) in East Asia

Sequences of the mitochondrial cytochrome b (1140 bp) and nuclear IRBP (1152 bp) genes were used to assess the evolutionary history of Apodemus, using the complete set of Asian species. Our results indicate that speciation in Asia involved three radiations, which supports an earlier study. The initial radiation yielded A. argenteus (Japanese endemic), A. gurkha (Nepalese endemic), and the ancestral lineage of the remaining Asian species. This lineage subsequently diverged into four groups: agrarius-chevrieri (agrarius group), draco-latronum-semotus (draco group), A. peninsulae, and A. speciosus (Japanese endemic). The final step consisted of divergence within two species groups as a consequence of the geography of the Yunnan-Guizhou plateau and Taiwan. The ecological ability of two Apodemus-species to inhabit one locality via niche partitioning likely drove the second radiation and shaped the basic geographical pattern seen today: A. argenteus and A. speciosus in Japan, A. agrarius and A. peninsulae in northern China, and the A. agrarius and A. draco groups in southern China. The three radiations are estimated to have occurred 7.5, 6.6, and 1.8-0.8 Mya respectively, using the IRBP clock, based on rat-mouse divergence 12 Mya. (C) 2003 The Linnean Society of London.

Molecular phylogeny and taxonomy of wood mice (genus Apodemus Kaup, 1829) based on complete mtDNA cytochrome b sequences, with emphasis on Chinese species

Phylogenetic relationships among 15 species of wood mice (genus Apodemus) were reconstructed to explore some long-standing taxonomic problems. The results provided support for the monophyly of the genus Apodemus, but could not reject the hypothesis of paraphyly for this genus. Our data divided the 15 species into four major groups: (1) the Sylvaemus group (A. sylvaticus, A. flavicollis, A. alpicola, and A. uralensis), (2) the Apodemus group (A. peninsulae, A. chevreri, A. agrarius, A. speciosus, A. draco, A. ilex, A. semotus, A. latronum, and A. mystacinus), (3) A. argenteus, and (4) A. gurkha. Our results also suggested that orestes should be a valid subspecies of A. draco rather than an independent species; in contrast, A. ilex from Yunnan may be regarded as a separate species rather than a synonym of orestes or draco. The species level status of A. latronum, tscherga as synonyms of A. uralensis, and A. chevrieri as a valid species and the closest sibling species of A. agrarius were further corroborated by our data. Applying a molecular clock with the divergences of Mus and Rattus set at 12 million years ago (Mya) as a calibration point, it was estimated that five old lineages (A. mystacinus and four major groups above) diverged in the late Miocene (7.82-12.74 Mya). Then the Apodemus group (excluding A. mystacinus) split into two subgroups: agrarius and draco, at about 7.17-9.95 Mya. Four species of the Sylvaemus group were estimated to diverge at about 2.92-5.21 Mya. The Hengduan Mountains Region was hypothesized to have played important roles in Apodemus evolutionary histories since the Pleistocene. (C) 2004 Elsevier Inc. All rights reserved.