866 resultados para Particulados sólidos


Relevância:

100.00% 100.00%

Publicador:

Resumo:

The main problem on the exploration activity on petroleum industry is the formation water resulted on the fields producing. The aggravating of this problem is correlated with the advancing technologies used on the petroleum extractions and on its secondary approach objecting the reobtainment of this oil. Among the main contaminants of the water formation are corrosives gases such as: O2, CO2 and H2S, some solids in suspension and dissolved salts. Concerning to those gases the CO2 is the one that produce significant damage for carbon steel on corrosion process of the petroleum and gas industries. Corrosion inhibitors for carbon steel in formation water is one of the most used agents in control of those damages. In this context, the poor investigations of carbon steel corrosion proceeding from solids in suspension is an opened field for studies. On this work the inhibitor effect of the commercial CORRTREAT 703 was evaluated on some specific solids in suspension at saline medium containing 10.000 ppm of de-aerated chloride using CO2 until non oxygen atmosphere been present. For that, quartz, calcium carbonate, magnetite and iron sulphide were subjected to this investigation as the selected solids. The effect of this inhibitor on corrosion process correlated with those specific solids, was measured using electrochemical (resistance of linear polarization and galvanic pair) and gravimetrical techniques. During all the experimental work important parameters were monitored such as: pH, dissolved oxygen, temperature, instantaneous corrosion rate and galvanic current. According to the obtained results it was proved that the suspension solids calcium carbonate and iron sulphide decrease the corrosion process in higher pH medium. Meanwhile the quartz and magnetite been hardness increase corrosion by broking of the passive layer for erosion. In the other hand, the tested inhibitor in concentration of 50 ppm, showed to be effective (91%) in this corrosion process

Relevância:

100.00% 100.00%

Publicador:

Resumo:

A batch of eighty-four coupons of low carbon steel were investigated at laboratory conditions under a corrosive, cavitative-corrosive (CO2) and corrosive-erosive (SiO2 + CO2) in an aqueous salt solution and two levels of temperature. The following measurements were made on Vickers (HV0,05, HV0,10, HV0,20) Microhardness tests at three levels of subsurface layer. A turbulent flow collided on the cylindrical sample, with and without mechanical stirring and gas bubbling, with and without fluid contamination by solid particles of SiO2, at two temperatures. Surface Roughness and Waviness, under two conditions "as received, after machining" and "after worn out", as well as gravimetric and electrochemical parameter were measured on the two opposite generatrices of each cylindrical sample, on the flow upstream (0°) and downstream (180°) by Profilometry, Mass Variation and Linear Polarization Resistance (LPR). The results of the Microhardness and Surface Texture of all coupons were subjected to statistical comparison, using the software Statgraphics® Centurion XVI, 95% statistical certainty, and significant differences were observed in some arrays of measurements. The corrosive wear rate measured by LPR and mass variation shown to be sensitive to the presence of bubbles and hydrodynamic fluctuations inside the cell, considering the temperature and contamination of corrosive fluid by solid particles. The main results of visual inspection relative to some topologies of the surface damages involving different mechanisms that were seen to give explanation for some fluctuations in wear rates of the steel experimentally investigated

Relevância:

100.00% 100.00%

Publicador:

Resumo:

The main problem on the exploration activity on petroleum industry is the formation water resulted on the fields producing. The aggravating of this problem is correlated with the advancing technologies used on the petroleum extractions and on its secondary approach objecting the reobtainment of this oil. Among the main contaminants of the water formation are corrosives gases such as: O2, CO2 and H2S, some solids in suspension and dissolved salts. Concerning to those gases the CO2 is the one that produce significant damage for carbon steel on corrosion process of the petroleum and gas industries. Corrosion inhibitors for carbon steel in formation water is one of the most used agents in control of those damages. In this context, the poor investigations of carbon steel corrosion proceeding from solids in suspension is an opened field for studies. On this work the inhibitor effect of the commercial CORRTREAT 703 was evaluated on some specific solids in suspension at saline medium containing 10.000 ppm of de-aerated chloride using CO2 until non oxygen atmosphere been present. For that, quartz, calcium carbonate, magnetite and iron sulphide were subjected to this investigation as the selected solids. The effect of this inhibitor on corrosion process correlated with those specific solids, was measured using electrochemical (resistance of linear polarization and galvanic pair) and gravimetrical techniques. During all the experimental work important parameters were monitored such as: pH, dissolved oxygen, temperature, instantaneous corrosion rate and galvanic current. According to the obtained results it was proved that the suspension solids calcium carbonate and iron sulphide decrease the corrosion process in higher pH medium. Meanwhile the quartz and magnetite been hardness increase corrosion by broking of the passive layer for erosion. In the other hand, the tested inhibitor in concentration of 50 ppm, showed to be effective (91%) in this corrosion process

Relevância:

60.00% 60.00%

Publicador:

Resumo:

É apresentada metodologia para estudos e avaliações em tempo real, de unidades para dedantação de particulados sólidos em estações de tratamento de esgoto (ETE) empregando-se traçadores radioativos. Um tanque decantador foi construído e os testes foram realizados usando-se 110mAg e 140La na marcação da fase sólida do esgoto e a técnica permitiu levantar-se a curva resposta da unidade e as funções distribuição do tempo de residência (RTD) para diversas situações experimentais e também identificar problemas operacionais que interferem na qualidade final do processo de tratamento do efluente. Os resultados serviram como diretriz para elaborar uma nova configuração da unidade, tornando-a mais eficiente.

Relevância:

30.00% 30.00%

Publicador:

Resumo:

Fluidization consists in a bed of solid particles acquire fluid behavior by using a fluid (in this case air) flowing through the solid particles. Because of this, it can be a good mix of these materials, as well as to show increased rates of heat and mass transport. The fluid flowing through the spaces between the particles gives an interstitial velocity, that if is too low does not cause movement of the particulates. The gradual increase in speed will generate small vibrations between the particles promotes its fluidization. Our study focus in the fluid state of solid bed , when the fluid velocity reaches a state where the drag forces are sufficient to support the weight of the solid particles making these solids behave like fluids . Knowledge of the minimum velocity required to fluidize that particles is of great importance since below this speed there is no fluidization, and far above it, the solids are carried out of the bed. The fluidized bed reactor is widely used in physics and engineering, particularly in gas-solid fluidization, with emphasis on thermochemical processes

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Este trabajo fue realizado en el laboratorio químico de la Estación Experimental Agropecuaria La Calera en la terminación del año de 1964 y principios de 1965 con las especies: naraja dulce (Citrus sinensis); grape fruit (Citrus paradisi); mandarina (Citrus reticulata) y limón agrio (Citrus limonum). El objeto del trabajo fue el investigar la relación sólidos totales solubles sobre acidez total en base a un tamaño promedio del fruto (los cuales están especificados para cada especie en el cuadro V) y comparar estos resultados con los encontrados en otros países que consideran a esta relación como indice para la cosecha en la industrialización de los cítricos. Se utilizaron tras arboles de naranja dulce criolla, identificados en este trabajo como : No. 28, 29 y 30; dos variedades de grape fruit: DUNCAN y FOSTER, dos variedades de mandarina; variedad carazo, cascara roja y variedad criolla, cascara amarilla y dos variedades de limón agrio: Criollo y Bear's Seedless. Los valores obtenidos de la relación sólidos totales solubles sobre acidez total son: naranja dulce del 9.2:1 a 9.3:1 (cuadro No. I), para la grape fruit FOSTER fue de 3.78:1, para la DUNCAN 6.6:1 (cuadro No. II); para la mandarina se obtuvo una relación de 21.1:1 a 18.6:1 (cuadro No. III) y para el limón ácido un porcentaje de ácido cítrico de 6.81 a 6.89 (cuadro No. IV). Estos resultados coinciden con los encontrados por Chandler (2) haciendo mención que en la naranja dulce, la relación sólidos/ácidos de este ensayo es mayor que la relación 8:1 encontrada en los Estados Unidos, debido quizás al mayor periodo cálido en que se desarrollan nuestros cítricos. Con respecto a la mandarina, la relación mencionada es mayor en la variedad Carazo, de color de cascara mas intenso. Este resultado coincide con el encontrado por Chandler (2). Esta relación no se encontró con la grape fruit. Con respecto al limon agrio, el porcentaje de ácido cítrico fue menor que el promedio de los resultados de FELIU (4), pudiendo deberse la diferencia al factor climático, tal como se explico con la naranja dulce. Finalmente se recomienda que estos resultados sean acompañados con un estudio de la palatabilidad de las frutas.

Relevância:

20.00% 20.00%

Publicador:

Resumo:

El presente trabajo de investigación está enmarcado dentro de la producción orgánica animal que se impulsa como línea de investigación en el departamento de Medicina Veterinaria de la Facultad de Ciencia Animal de la UNA, que busca mejorar la inocuidad de los alimentos. El objetivo del experimento fue la evaluación del uso de microorganismos benéficos de montaña en forma sólida y líquida sobre parámetros productivos y sanitarios en pollos de engorde de la línea Arbor Acres - Ross. Los tratamientos utilizados fueron: T1 (alimento concentrado + 5 g de microorganismos benéficos de montaña en forma sólida = MBM sólido), T2 (agua de bebida + 17% de microorganismos benéficos de montaña = MBM líquido) y T3 (concentrado comercial testigo). Las evaluaciones correspondieron a los 28, 35 y 42 días. Las variables productivas evaluadas fueron Ganancia media diaria, Peso vivo, Conversión alimenticia y Rendimiento en canal; las variables sanitarias fueron Mortalidad y Prevalencia. Utilizando un DCA unifactorial se evaluó el efecto de los tratamientos. Mediante el análisis de varianza se obtuvo que los tratamientos sólo tuvieron influencia significativa (P<0.5) sobre las variables Ganancia media diaria y Peso vivo a los 42 días, mediante separación de medias por Duncan se obtuvo que para la Ganancia media diaria el mayor valor lo obtuvo el T2 (MBM líquido) con 65.30 g, seguido del T1 (MBM sólido) con 62.32 g y T3 (testigo) con 60.36 g. Para el peso vivo el comportamiento fue igual, presentando mayor Peso vivo el T2 con 2780.20 g, seguido del T1 con 2655.16 g y el T3 con 2572.83 g. La conversión alimenticia entre los tratamientos resultó similar con mejor valor en el T2 con 1.55 seguido del T1 con 1.59 y T3 con 1.60. El rendimiento en canal mediante medias situó al T2 con el mayor valor de 66.70%, seguido del T1 con 65.45% y T3 con 61%. La mortalidad por tratamientos fue igual con valor de 2.63% y la prevalencia por tratamiento fue nula, con todo esto se denota que es factible biológicamente el uso de microorganismos de montaña como suplemento alimenticio para mejorar el comportamiento productivo de pollos de engorde. Palabras clave: M.O benéficas, parámetros productivos, parámetros sanitarios, Arbor Acres-Ross. v

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Trata da Lei n. 12.305, de 2 de agosto de 2010, que institui a Política Nacional de Resíduos Sólidos; altera a Lei n° 9.605, de 12 de fevereiro de 1998; e dá outras providências; e legislação correlata

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Consultoria Legislativa - Área XI - Meio Ambiente e Direito Ambiental, Organização Territorial, Desenvolvimento Urbano e Regional.

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Consultoria Legislativa - Área XI - Meio Ambiente e Direito Ambiental, Organização Territorial e Desenvolvimento Urbano e Regional

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Consultoria Legislativa - Área XI - Meio Ambiente e Direito Ambiental, Organização Territorial e Desenvolvimento Urbano e Regional.

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Consultoria Legislativa - Área XI - Meio Ambiente e Direito Ambiental, Organização Territorial e Desenvolvimento Urbano e Regional.

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Pretende identificar o enfoque dado por diversos países desenvolvidos à questão dos resíduos sólidos. Foram escolhidos a Alemanha, considerada referência na gestão de resíduos, a União Europeia, por meio de suas diretivas, outros dois países europeus, França e Espanha, dois países do continente americano, Canadá e Estados Unidos, e o Japão. Em seguida, compara-se a lei brasileira com a legislação dos demais países. Maior atenção será dada ao enfoque da responsabilidade pós-consumo, tratada na Lei brasileira como responsabilidade compartilhada pelo ciclo de vida do produto.

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Áudio MP3 da Lei 12305, de 2 de agosto de 2010, que institui a Política de Nacional de Resíduos Sólidos. Apresenta também a sua regulamentação pelo Decreto 7404, de 23 de dezembro de 2010. Texto atualizado até maio de 2011.

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Duración (en horas): De 41 a 50 horas. Destinatario: Estudiante