Performance, carcass traits and costs of Suffolk lambs finishing systems with early weaning and controlled suckling

The performance, carcass traits and finishing costs of Suffolk lambs were evaluated in three systems: (1) lambs weaned with 22 kg of body weight (BW) and supplemented with concentrate on pasture until slaughter; (2) lambs weaned with 22 kg BW and fed in feedlot until slaughter; (3) lambs maintained in controlled nursing after 22 kg BW and creep fed in feedlot until slaughter. Average daily gain (ADG) was 224 g/d for lambs weaned and supplemented with concentrate on pasture, 386 g/d for lambs weaned in feedlot and 481 g/d for lambs under controlled nursing. Empty body weight and visceral fat deposition were highest in lambs from feedlot systems. Carcass weights and carcass yields were highest for lambs in controlled nursing. Finishing total costs were highest in controlled nursing and lowest in the system with weaning in feedlot. High concentrate diet associated with controlled nursing in feedlot allowed lambs to reach the growth potential and carcasses with higher weights, higher yields and higher fat content. After weaning, lambs in feedlot fed with high concentrate diet had higher weight gain than lambs supplemented with concentrate on pasture. Carcasses produced under these two systems presented the same characteristics. The system with weaning in feedlot showed the lowest cost per kg carcass.

Calculating an upper bound on the finishing time of a group of threads executing on a GPU: a preliminary case study

Graphics processor units (GPUs) today can be used for computations that go beyond graphics and such use can attain a performance that is orders of magnitude greater than a normal processor. The software executing on a graphics processor is composed of a set of (often thousands of) threads which operate on different parts of the data and thereby jointly compute a result which is delivered to another thread executing on the main processor. Hence the response time of a thread executing on the main processor is dependent on the finishing time of the execution of threads executing on the GPU. Therefore, we present a simple method for calculating an upper bound on the finishing time of threads executing on a GPU, in particular NVIDIA Fermi. Developing such a method is nontrivial because threads executing on a GPU share hardware resources at very fine granularity.

Utilisation of reactive lysine from meat and bone meals of different ash content by growing-finishing pigs

Selostus: Tuhkapitoisuuden vaikutus lihaluujauhon reaktiivisen lysiinin hyväksikäyttöön lihasioilla

Lysine supplementation of barley wet distillers' solids diets for growing-finishing pigs

Selostus: Rankkivalkuaisdieetin lysiinitäydennyksen vaikutus sikojen tuotantotuloksiin

Effect of supplemental vitamin E on the performance of growing-finishing pigs fed stored versus freshly harvested barley and on the storage stability and eating quality of frozen pork

Lihasikojen E-vitamiinin tarve ruokittaessa vastapuidulla ohralla ja rehuun lisätyn E-vitamiinin vaikutus lihan pakastussäilyvyyteen ja syöntilaatuun

Apparent ileal amino acid digestibility and the nutritive value of the triticale cultivars Moreno and Ulrika for growing-finishing pigs

Selostus: Ruisvehnälajikkeiden Ulrika ja Moreno rehuarvo lihasikojen ruokinnassa

Faba beans in diets for growing-finishing pigs

Selostus: Härkäpapu lihasikojen ruokinnassa

Applying precision feeding techniques in growing-finishing pig operations

The high cost of feed ingredients, the use of non-renewable sources of phosphate and the dramatic increase in the environmental load resulting from the excessive land application of manure are major challenges for the livestock industry. Precision feeding is proposed as an essential approach to improve the utilization of dietary nitrogen, phosphorus and other nutrients and thus reduce feeding costs and nutrient excretion. Precision feeding requires accurate knowledge of the nutritional value of feedstuffs and animal nutrient requirements, the formulation of diets in accordance with environmental constraints, and the gradual adjustment of the dietary nutrient supply to match the requirements of the animals. After the nutritional potential of feed ingredients has been precisely determined and has been improved by the addition of enzymes (e.g. phytases) or feed treatments, the addition of environmental objectives to the traditional feed formulation algorithms can promote the sustainability of the swine industry by reducing nutrient excretion in swine operations with small increases in feeding costs. Increasing the number of feeding phases can also contribute to significant reductions in nutrient excretion and feeding costs. However, the use of precision feeding techniques in which pigs are fed individually with daily tailored diets can further improve the efficiency with which pigs utilize dietary nutrients. Precision feeding involves the use of feeding techniques that allow the provision of the right amount of feed with the right composition at the right time to each pig in the herd. Using this approach, it has been estimated that feeding costs can be reduced by more than 4.6%, and nitrogen and phosphorus excretion can both be reduced by more than 38%. Moreover, the integration of precision feeding techniques into large-group production systems can provide real-time off-farm monitoring of feed and animals for optimal slaughter and production strategies, thus improving the environmental sustainability of pork production, animal well-being and meat-product quality.

Anaerobic biodigestion of pigs feces in the initial, growing and finishing stages fed with diets formulated with corn or sorghum

The objective of this study was to evaluate the quality and the production of biogas and biofertilizer obtained from biodigester supplied with pig feces in the initial, growing and finishing stages, fed with diets formulated based on corn or sorghum. Twenty bench biodigesters were used with hydraulic retention time of 30 days and daily loads that contained 4 to 6% of total solids (TS) and 3.6 to 5.2% of volatile solids (VS). In the effluent of the biodigesters, mean levels of TS were observed ranging between 1.6 and 2.0% and of VS between 1.2 and 1.6%. The mean reductions of TS were 57.7 to 64.7% and of VS from 61.7 to 69.0%, and there was only difference in the finishing phase, in which the major averages reductions were produced by the biodigesters supplied with feces from animals fed with diets based on corn. In biodigesters supplied with feces from animals in the initial and growing stages fed with diets based on corn, were observed higher average productions of biogas and the greatest average potentials of biogas production. The average potentials obtained were 0.033; 0.181; 0.685; 0.788 and 1.132 m³ per kg of affluent, manure, TS added, VS added and VS reduced, respectively. No differences were found on the average content of methane in the biogas between diets and stages. The average concentrations of nutrients N, P, K, Ca, Mg, Na, Fe, Mn, Zn and Cu in the biodigester affluent and effluent, ranged between diets and stages.

Use of interactive performance optimization for identifying the ideal profile of swine finishing producers

The present research aimed to develop a modeling capable of identifying the ideal profile of swine finishing producers using the interactive performance optimization, which began by verifying qualitative the criteria considered most relevant to the decision-making, generating a closed structured diagnosis that covers the socioeconomic aspects about the activity, until the design of a mathematical model able to translate the data obtained in quantitative information. For the verification, it was proposed a practical study for a universe of 120 members of a cooperative in the state of Rio Grande do Sul, Brazil. The results showed that, from the application and the definition of the ideal profile, it was possible to verify that 82 producers are in the group of those who have obtained a "Good" performance, and to 44 the result is in the range between 86% to 90% from the ideal, which means that most have short or medium-term conditions to evolve their status for the considered "Very Good", where only 12.5% of the producers are currently.

Influence of tail biting on weight gain, lesions and condemnations at slaughter of finishing pigs

The present study assessed the association of tail-biting lesions in finishing pigs with weight gain, occurrence of locomotion or respiratory disorders and abscesses during finishing period, and carcass condemnation at slaughter. The study was carried out on 4 different farms. For each animal with a tail biting lesion, two control pigs were selected. The total number of animals in the study was 312, with 104 of them being tail-bitten. Tail lesions were classified according to the degree of severity into four scores: score 0 -normal tail withou lesion; score 1-3 - increasing lesion severity, and score 4 - healed lesions. Overall, the occurrence of severe tail lesions (score 3) varied from 55 to 73% of tail-bitten pigs among farms. On all farms, healing of tail lesions was observed in 95% to 100% of the animals at the evaluation performed within 41-43 days after the commencement of the study. In two out of the four evaluated farms, pigs with score of 3 showed lower weight gain (P<0.05) compared with score 0 pigs. Before slaughter, the occurrence of locomotion problems and nodules/abscesses was associated (P<0.05) with the presence of tail-biting lesions. At slaughter, tail-biting lesions were associated (P<0.05) with the presence of abscesses, lung lesions (pleuritis and embolic pneumonia) or arthritis in carcasses. Carcass condemnation was associated with the presence of tail-biting lesions (P<0.05). Overall, carcass condemnation rate was 21.4%, of which animals with tail-biting lesions accounted for 66.7% of condemnations. Among the animals diagnosed with cannibalism at farm level, only two had not healed their lesions at slaughter. The fact that there were a lot of carcass condemnations, despite the fact that tail-bitten animals had no more active lesions, suggests that different situations may be observed between the field and slaughter, reinforcing the need to analyze pigs both at farm and slaughter to allow proper assessment of losses related to tail biting. Collectively, the observations of the present study show that complications associated with tail-biting found in slaughterhouses are probably underestimating field prevalence.

Effect of genotype, finishing system, and sex on physiochemical characteristics of goat meat

Seventy-eight kids of both sexes and five genotypes were used: Alpine, ½ Boer + ½ Alpine (½ BA), ¾ Boer + ¼ Alpine, ½ Anglo-nubian + ½ Alpine and "tricross" (½ Anglo-nubian + ¼ Boer + ¼ Alpine) with initial average weight of 14.1 ± 2.5. The objective was to evaluate the effect of genotype, finishing system, and sex on the physiochemical characteristics of goat meat. Finishing systems were: ST1 - kid + dam in pasture and ST2 - weaned kid and feedlot. Kids in ST1 were kept in an area with Panicum maximum cv. Tanzania, and after grazing, water and mineral salt/mix were fed ad libitum to the animals. The animals in ST2 were confined in collective pens distributed according to genotypes and received diet with 16% CP and 73% TDN. The values of pH, a* (red content), Cooking Loss (CL), and Ether Extract (EE) percentage were influenced by genotype. Values for red content (a*) and L* (brightness), CL and percentages of moisture, protein, EE, and ash were influenced by the finishing system. Longissimus dorsi muscle from animals ½ BA exhibited better physiochemical characteristics. For greater tenderness and higher percentages of fat, consumers should choose female kid goat meat.