987 resultados para 169-1034


Relevância:

100.00% 100.00%

Publicador:

Resumo:

Continuous coring in Saanich Inlet (Ocean Drilling Program, ODP Leg 169S), British Columbia, Canada, yielded a detailed record of Late Quaternary climate, oceanography, marine productivity, and terrestrial vegetation. Two sites (1033 and 1034) were drilled to maximum depths of 105 and 118 m, recovering sediments ranging in age from 13,300 to less than 300 14C yr. Earliest sediments consist of dense, largely massive, gray glaciomarine muds with dropstones and sand and silt laminae deposited during the waning stages of glaciation. Deposition of organic-rich olive gray sediments began in the fjord about 12,000 14C yr ago, under well-oxygenated conditions as reflected by the presence of bioturbation and a diverse infaunal bivalve community. At about 10,500 14C yr, a massive, gray unit, 40-50 cm thick, was emplaced in a very short span of time. The unit is marked by a sharp lower contact, a gradational upper contact and an abundance of reworked Tertiary microfossils. It has been interpreted as resulting from massive flood events caused by the collapse of glacial dams in the Fraser Valley of mainland British Columbia. Progressively greater anoxia in bottom waters of Saanich Inlet began about 7000 14C yr ago. This is reflected in the preservation of varved sediments consisting of diatomaceous spring-summer laminae and terrigenous winter laminae. Correlation of the sediments was based on: marked lithologic changes, the presence of massive intervals (reflecting localized sediment gravity flow events), the Mazama Ash, occasional thin gray laminae (indicative of abnormal flood events in nearby watersheds), varve counts between marker horizons, and 71 accelerator mass spectrometry (AMS) radiocarbon dates.

Relevância:

100.00% 100.00%

Publicador:

Relevância:

100.00% 100.00%

Publicador:

Resumo:

Ocean Drilling Program Leg 169S retrieved a complete Holocene sequence from Saanich Inlet, British Columbia, Canada. Fish and diatom remains were extracted from sediments at Site 1034. Very small fish bones, teeth and scales were ubiquitous except in the lowermost glaciomarine clays; scales degraded with depth. In the identifiable fraction, Pacific herring were the most abundant with Pacific hake and cartilaginous fish yielding significant fractions. Fish remains appear just before 12 000 BP but greatest diversity does not occur until about 6500 BP. A smoothed abundance curve highlights two periods of maximal abundance at about 1500 and 6500 BP. Abundances in the last 1000 years are lower than the rest of the record. A correlation with abundances of seven phytoplankton taxa is significant; diatoms explain about a third of the variance. This study demonstrates the use of fish and diatoms from the same paleosedimentary matrix to examine millennia-scale correlations between primary and tertiary production.

Relevância:

100.00% 100.00%

Publicador:

Resumo:

This paper explores the paleoseismic record potentially preserved in the upper 40 m of hydraulic piston cores collected in 1996 at two sites in Saanich Inlet, British Columbia, during ocean drilling program (ODP) Leg 169S. The ODP cores are missing 1-2 m of water-rich sediment directly underlying the seafloor, but this sediment is preserved in shorter piston cores collected in 1989 and 1991. The upper part of the ODP cores consists of rhythmically laminated (varved) marine mud with intercalated massive beds, interpreted to be debris flow deposits. Some of the debris flow deposits are linked to past earthquakes, including the 1946 Vancouver Island earthquake (M7.2), a great (M8-9) plate-boundary earthquake at the Cascadia subduction zone in January 1700, and a large crustal or plate-boundary earthquake about 1000 yr ago. Earthquakes may also be responsible for debris flows in about AD 1600, 1500, 1250, 1150, 850, 450, 350, 180, and BC 200, 220, 500, 900, and 1050. If so, the average recurrence interval for moderate to large earthquakes, which trigger debris flows in Saanich Inlet, is about 150 yr. This recurrence interval is broadly consistent with the frequency of moderate to large earthquakes in the region during the historical period. Debris flows, however, can also be triggered by non-seismic processes, making it difficult to assemble a complete earthquake record from the Saanich Inlet cores. We propose that extensive debris flow deposits, emplaced by single large failures or many smaller coincident failures, probably have a seismic origin.

Relevância:

100.00% 100.00%

Publicador:

Resumo:

The Holocene section in Saanich Inlet, Vancouver Island, British Columbia, is 50-70 m thick. Cores from Saanich Inlet obtained during Leg 169S of the Ocean Drilling Program afford an excellent opportunity to obtain an ultrahigh-resolution paleomagnetic and environmental magnetic record for the Holocene and Late Pleistocene of western Canada. We have used an automated, long-core cryogenic magnetometer to study over 380 m of continuous u-channel samples from ODP Sites 1033 and 1034, the two sites that constitute Leg 169S. Holocene records of paleomagnetic inclination and intensity show excellent intra-site correlation and can be used to fine-tune the lithologic correlation among cores from each site. The Late Pleistocene magnetic records provide a means of intra-site correlation of the otherwise featureless marine clay. Near the Holocene/Late Pleistocene boundary, both sites contain a magnetic intensity feature that is interpreted as a Missoula-type flood event on the Fraser River. The composite Holocene inclination records from the two sites are quite similar and provide a means of comparing current age-models that are based on radiocarbon dating of material from each site. This comparison shows only minor differences in the available age-models. It also provides strong evidence that the sediments of Saanich Inlet represent a reliable record of geomagnetic field behavior.

Relevância:

100.00% 100.00%

Publicador:

Resumo:

We have analysed the concentrations of Li, K, Rb, Cs, and B, and the isotopic ratios of Li and B of a suite of pore fluids recovered from ODP Sites 1037 (Leg 169; Escanaba Trough) and 1034 (Leg 169S; Saanich Inlet). In addition, we have analysed dissolved K, Rb, and Cs concentrations for estuarine mixing of the Ganges-Brahmaputra river system. Together, these data sets have been used to assess the role of sediments in the marine geochemical cycles of the alkali elements and boron. Uptake onto clay minerals during estuarine mixing removes 20-30% of the riverine input of dissolved Cs and Rb to the oceans. Prior to this study, the only other recognised sink of Rb and Cs was uptake during low-temperature alteration of the oceanic crust. Even with this additional sink there is an excess of inputs over outputs in their modern oceanic mass balance. Pore fluid data show that Li and Rb are transferred into marine sediments during early diagenesis. However, modeling of the Li isotope systematics of the pore fluids from Site 1037 shows that seawater Li taken up during marine sedimentation can be readily returned to solution in the presence of less hydrated cations, such as NH4+. This process also appears to result in high concentrations of pore fluid Cs (relative to local seawater) due to expulsion of adsorbed Cs from cation exchange sites. Flux calculations based on pore fluid data for a series of ODP sites indicate that early diagenesis of clay sediments removes around 8% of the modern riverine input of dissolved Li. Although NH4+-rich fluids do result in a flux of Cs to the oceans, on the global scale this input only augments the modern riverine Cs flux by ~3%. Nevertheless, this may have implications for the fate of radioactive Cs in the natural environment and waste repositories.

Relevância:

60.00% 60.00%

Publicador:

Resumo:

Sites 1033 and 1034 of ODP Leg 169S in Saanich Inlet have an unusual diagenetic system, that has the appearance of being depth reversed, i.e. a bacterial methane accumulation zone underlain by a sulphate reduction zone. During the late Pleistocene grey, undifferentiated, glacio-marine clays were deposited with low Corg contents (<0.4 wt.%), and interstitial fluids replete in SO4 (ca. 27 mM), devoid of CH4 and low in nutrients. This indicates oxic conditions are present, reflecting the open exchange of waters with Haro Strait during the Pleistocene before the Saanich Peninsula emerged. In the earliest Holocene (ca. 11,000 years BP) the inlet was formed, severely restricting water circulation, and leading to the presence of anoxic bottom waters. The sediments are laminated and show a dramatic rise to high Corg, Norg and Stot contents (up to 2.5, 0.4, 1.4 wt.%, respectively) over a period of ca. 1000 years. The nutrient concentrations are especially high (TA, NH4, PO4 up to 115 meq/l, 20 mM and 400 µM, respectively), SO4 is exhausted and CH4 is prolific. Stable carbon isotope ratio measurements of CH4 and co-existing CO2 indicate that methanogenesis is via carbonate reduction (delta13C-CH4 ca. -60 to - 70 per mil, delta13C-CO2 ca. +10 per mil). At the sulphate-methane interfaces, both at the near-surface and at 50 mbsf (Site 1033) and 80 mbsf (Site 1034) methane consumption by sulphate reducing bacteria is intensive.

Relevância:

30.00% 30.00%

Publicador:

Resumo:

Saanich Inlet has been a highly productive fjord since the last glaciation. During ODP Leg 169S, nearly 70 m of Holocene sediments were recovered from Hole 1034 at the center of the inlet. The younger sediments are laminated, anaerobic, and rich in organic material (1-2.5 wt.% Corg), whereas the older sediments below 70 mbsf are non-laminated, aerobic, with glacio-marine characteristics and have a significantly lower organic matter content. This difference is also reflected in the changes of interstitial fluids, and in biomarker compositions and their carbon isotope signals. The bacterially-derived hopanoid 17alpha(H),21beta(H)-hop-22(29)-ene (diploptene) occurs in Saanich Inlet sediments throughout the Holocene but is not present in Pleistocene glacio-marine sediments. Its concentration increases after ~6000 years BP up to present time to about 70 µg/g Corg, whereas terrigenous biomarkers such as the n-alkane C31 are low throughout the Holocene (<51 µg/g Corg) and even slightly decrease to 36 µg/g Corg at the most recent time. The increasing concentrations of diploptene in sediments younger than ~6000 years BP separate a recent period of higher primary productivity, stronger anoxic bottom waters, and higher bacterial activity from an older period with lesser activity, heretofore undifferentiated. Carbon isotopic compositions of diploptene in the Holocene are between ~31.5 and ~39.6 per mil PDB after ~6000 years BP. These differences in the carbon isotopic record of diploptene probably reflect changes in microbial community structure of bacteria living at the oxic-anoxic interface of the overlying water column. The heavier isotope values are consistent with the activity of nitrifying bacteria and the lighter isotope values with that of aerobic methanotrophic bacteria. Therefore, intermediate delta13C values probably represent mixtures between the populations. In contrast, carbon isotopic compositions of n-C31 are roughly constant at ~31.4 ± 1.1 per mil PDB throughout the Holocene, indicating a uniform input from cuticular waxes of higher plants. Prior to ~6000 years BP, diploptene enriched in 13C of up to -26.3 per mil PDB is indicative of cyanobacteria living in the photic zone and suggests a period of lower primary productivity, more oxygenated bottom waters, and hence lower bacterial activity during the earliest Holocene.

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Digital image

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Digital image

Relevância:

20.00% 20.00%

Publicador:

Resumo:

High repetition rate passively mode-locked sources are of significant interest due to their potential for applications including optical clocking, optical sampling, communications and others. Due to their short excited state lifetimes mode-locked VECSELs are ideally suited to high repetition rate operation, however fundamentally mode-locked quantum well-based VECSELs have not achieved repetition rates above 10 GHz due to the limitations placed on the cavity geometry by the requirement that the saturable absorber saturates more quickly than the gain. This issue has been overcome by the use of quantum dot-based saturable absorbers with lower saturation fluences leading to repetition rates up to 50 GHz, but sub-picosecond pulses have not been achieved at these repetition rates. We present a passively harmonically mode-locked VECSEL emitting pulses of 265 fs duration at a repetition rate of 169 GHz with an output power of 20 mW. The laser is based around an antiresonant 6 quantum well gain sample and is mode-locked using a semiconductor saturable absorber mirror. Harmonic modelocking is achieved by using an intracavity sapphire etalon. The sapphire then acts as a coupled cavity, setting the repetition rate of the laser while still allowing a tight focus on the saturable absorber. RF spectra of the laser output show no peaks at harmonics of the fundamental repetition rate up to 26 GHz, indicating stable harmonic modelocking. Autocorrelations reveal groups of pulses circulating in the cavity as a result of an increased tendency towards Q-switched modelocking due to the low pulse energies.

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Consultoria de Orçamento e Fiscalização Financeira.