A simulation study of unified GPS and roadside ranging technologies for vehicle positioning

The future vehicle navigation for safety applications requires seamless positioning at the accuracy of sub-meter or better. However, standalone Global Positioning System (GPS) or Differential GPS (DGPS) suffer from solution outages while being used in restricted areas such as high-rise urban areas and tunnels due to the blockages of satellite signals. Smoothed DGPS can provide sub-meter positioning accuracy, but not the seamless requirement. A disadvantage of the traditional navigation aids such as Dead Reckoning and Inertial Measurement Unit onboard vehicles are either not accurate enough due to error accumulation or too expensive to be acceptable by the mass market vehicle users. One of the alternative technologies is to use the wireless infrastructure installed in roadside to locate vehicles in regions where the Global Navigation Satellite Systems (GNSS) signals are not available (for example: inside tunnels, urban canyons and large indoor car parks). The examples of roadside infrastructure which can be potentially used for positioning purposes could include Wireless Local Area Network (WLAN)/Wireless Personal Area Network (WPAN) based positioning systems, Ultra-wide band (UWB) based positioning systems, Dedicated Short Range Communication (DSRC) devices, Locata’s positioning technology, and accurate road surface height information over selected road segments such as tunnels. This research reviews and compares the possible wireless technologies that could possibly be installed along roadside for positioning purposes. Models and algorithms of integrating different positioning technologies are also presented. Various simulation schemes are designed to examine the performance benefits of united GNSS and roadside infrastructure for vehicle positioning. The results from these experimental studies have shown a number of useful findings. It is clear that in the open road environment where sufficient satellite signals can be obtained, the roadside wireless measurements contribute very little to the improvement of positioning accuracy at the sub-meter level, especially in the dual constellation cases. In the restricted outdoor environments where only a few GPS satellites, such as those with 45 elevations, can be received, the roadside distance measurements can help improve both positioning accuracy and availability to the sub-meter level. When the vehicle is travelling in tunnels with known heights of tunnel surfaces and roadside distance measurements, the sub-meter horizontal positioning accuracy is also achievable. Overall, simulation results have demonstrated that roadside infrastructure indeed has the potential to provide sub-meter vehicle position solutions for certain road safety applications if the properly deployed roadside measurements are obtainable.

Studying Mobile Media : Cultural Technologies, Mobile Communication, and the iPhone

The iPhone represents an important moment in both the short history of mobile media and the long history of cultural technologies. Like the Walkman of the 1980s, it marks a juncture in which notions about identity, individualism, lifestyle and sociality require rearticulation. This book explores not only the iPhone’s particular characteristics, uses and "affects," but also how the "iPhone moment" functions as a barometer for broader patterns of change. In the iPhone moment, this study considers the convergent trajectories in the evolution of digital and mobile culture, and their implications for future scholarship. Through the lens of the iPhone—as a symbol, culture and a set of material practices around contemporary convergent mobile media—the essays collected here explore the most productive theoretical and methodological approaches for grasping media practice, consumer culture and networked communication in the twenty-first century.

Saying sorry in the 21st century : public apologies in a digital world

The public apology to the Forgotten Australians in late 2009 was, for many, the culmination of a long campaign for recognition and justice. The groundswell for this apology was built through a series of submissions which documented the systemic institutionalised abuse and neglect experienced by the Forgotten Australians that has resulted, for some, in life-long disadvantage and marginalisation. Interestingly it seems that rather than the official documents being the catalyst for change and prompting this public apology, it was more often the personal stories of the Forgotten Australians that resonated and over time drew out quite a torrent of support from the public leading up to, during and after the public apology, just as had been the case with the ‘Stolen Generation.’ Research suggests (cite) that the ethics of such national apologies only make sense if their personal stories are seen as a collective responsibility of society, and only carry weight if we understand and seek to Nationally address the trauma experienced by such victims. In the case of the Forgotten Australians, the National Library of Australia’s Forgotten Australians and Former Child Migrants Oral History Project and the National Museum’s Inside project demonstrate commitment to the digitisation of the Forgotten Australians’ stories in order to promote a better public understanding of their experiences, and institutionally (and therefore formally) value them with renewed social importance. Our project builds on this work not by making or collecting more stories, but by examining the role of the internet and digital technologies used in the production and dissemination of individuals’ stories that have already been created during the period of time between the tabling of the senate inquiry, Children in Institutional Care (1999 or 2003?) and a formal National apology being delivered in Federal Parliament by PM Kevin Rudd (9 Nov, 2009?). This timeframe also represents the emergent first decade of Internet use by Australians, including the rapid easily accessible digital technologies and social media tools that were at our disposal, along with the promises the technology claimed to offer — that is that more people would benefit from the social connections these technologies allegedly were giving us.

Hydrothermal technologies for the production of fuels and chemicals from biomass

Biomass and non-food crop residues are seen as relatively low cost and abundant renewable sources capable of making a large contribution to the world’s future energy and chemicals supply. Signifi cant quantities of ethanol are currently produced from biomass via biochemical processes, but thermochemical conversion processes offer greater potential to utilize the entire biomass source to produce a range of products. This chapter will review thermochemical gasifi cation and pyrolysis methods with a focus on hydrothermal liquefaction processes. Hydrothermal liquefaction is the most energetically advantageous thermochemical biomass conversion process. If the target is to produce sustainable liquid fuels and chemicals and reduce the impact of global warming as a result of carbon dioxide, nitrous oxide, and methane emissions (i.e., protect the natural environment), the use of “green” solvents, biocatalysts and heterogeneous catalysts must be the main R&D initiatives. As the biocrude produced from hydrothermal liquefaction is a complex mixture which is relatively viscous, corrosive, and unstable to oxidation (due to the presence of water and oxygenated compounds), additional upgrading processes are required to produce suitable biofuels and chemicals.

Regulating assisted reproductive technologies in Victoria : the impact of changing policy concerning the accessibility of in vitro fertilisation for preimplantation tissue-typing

On 1 January 2010, the Assisted Reproductive Treatment Act 2008 (Vic) came into force. The legislation was the outcome of a detailed review and consultation process undertaken by the Victorian Law Reform Commission. Arguably, the change to the regulatory framework represents a significant shift in policy compared to previous regulatory approaches on this topic in Victoria. This article considers the impact of the new legislation on eligibility for reproductive treatments, focusing on the accessibility of such services for the purpose of creating a “saviour sibling”. It also highlights the impact of the Victorian regulatory body’s decision to abolish its regulatory policies on preimplantation genetic diagnosis and preimplantation tissue-typing, concluding that the regulatory approach in relation to these latter issues is similar to other Australian jurisdictions where such practices are not addressed by a statutory framework.

Using game technologies to improve the safety of construction plant operations

Many accidents occur world-wide in the use of construction plant and equipment, and safety training is considered by many to be one of the best approaches to their prevention. However, current safety training methods/tools are unable to provide trainees with the hands-on practice needed. Game technology-based safety training platforms have the potential to overcome this problem in a virtual environment. One such platform is described in this paper - its characteristics are analysed and its possible contribution to safety training identified. This is developed and tested by means of a case study involving three major pieces of construction plant, which successfully demonstrates that the platform can improve the process and performance of the safety training involved in their operation. This research not only presents a new and useful solution to the safety training of construction operations, but illustrates the potential use of advanced technologies in solving construction industry problems in general.

Physicochemical characterization of particulate emissions from a compression ignition engine employing two injection technologies and three fuels

Alternative fuels and injection technologies are a necessary component of particulate emission reduction strategies for compression ignition engines. Consequently, this study undertakes a physicochemical characterization of diesel particulate matter (DPM) for engines equipped with alternative injection technologies (direct injection and common rail) and alternative fuels (ultra low sulfur diesel, a 20% biodiesel blend, and a synthetic diesel). Particle physical properties were addressed by measuring particle number size distributions, and particle chemical properties were addressed by measuring polycyclic aromatic hydrocarbons (PAHs) and reactive oxygen species (ROS). Particle volatility was determined by passing the polydisperse size distribution through a thermodenuder set to 300 °C. The results from this study, conducted over a four point test cycle, showed that both fuel type and injection technology have an impact on particle emissions, but injection technology was the more important factor. Significant particle number emission (54%–84%) reductions were achieved at half load operation (1% increase–43% decrease at full load) with the common rail injection system; however, the particles had a significantly higher PAH fraction (by a factor of 2 to 4) and ROS concentrations (by a factor of 6 to 16) both expressed on a test-cycle averaged basis. The results of this study have significant implications for the health effects of DPM emissions from both direct injection and common rail engines utilizing various alternative fuels.

Emergent innovation through the co-evolution of informal and formal media economies

Well-established distinctions between amateur and professional are blurring as the impact of social media, changes in cultural consumption, and crises in copyright industries’ business models are felt across society and economy. I call this the increasingly rapid co-evolution of the formal market and informal household sectors and analyse it through the concept of ‘social network markets’ – individual choices are made on the basis of other’s choices and such networked preferencing is enhanced by the growing ubiquity of social media platforms. This may allow us better to understand sources of disruption and innovation in audiovisual production and distribution in wealthy Western markets which are as significant as those posed by informal practices outside the West. I examine what is happening around the monetization and professionalization of online video (YouTube, for example) and the socialization of professional production strategies (transmedia, for example) as innovation from the margins.

Regional integration 2.0 : facilitating regional integration and development with collaborative technologies

The current global economic instability and the vulnerability of small nations provide the impetus for greater integration between the countries of the South Pacific region. This exercise is critical for their survival. Past efforts of regional integration in the South Pacific have mostly failed. However, today’s IT collaborative capabilities provide the opportunity to develop a shared IT infrastructure to facilitate integration in the South Pacific. In developing an IT-backed model of regional integration, this study identifies and reports on the antecedents of the current stage for integration in the Pacific. We conducted interviews with twenty five individuals from various sectors and find that while most respondents were optimistic about the potential of IT-backed regional integration, significant challenges exists. The study identifies and discusses these challenges providing policy implications to stakeholders in the regional integration process. The findings will assist in suggesting a model of regional integration 2.0 for the Pacific region.

Anticipating the use of life extension technologies : possible pointers from the adoption of assisted reproductive technologies

The first effective life extension technologies might well become available within the next few years. Experts from the University of Queensland, Australia, explore the possible public reaction to these therapies and the ethical and social concerns they raise, drawing on the experience of assisted reproduction technologies

An investigation of gaseous and particulate emissions from compression ignition engines operated with alternative fuels, injection technologies, and combustion strategies

Whilst the compression ignition (CI) engine exhibits many design advantages relative to its spark ignition engine counterpart; such as: high thermal efficiency, fuel economy and low carbon monoxide and hydrocarbon emissions, the issue of Diesel Particulate Matter (DPM) emissions continues to be an unresolved problem for the CI engine. Primarily, this thesis investigates a range of DPM mitigation strategies such as alternative fuels, injection technologies and combustion strategies conducted with a view to determine their impact on the physico-chemical properties of DPM emissions, and consequently to shed light on their likely human health impacts. Regulated gaseous emissions, Nitric oxide (NO), Carbon monoxide (CO), and Hydrocarbons (HCs), were measured in all experimental campaigns, although the major focus in this research program was on particulate emissions...

Using information communication technologies to develop dynamic curriculum frameworks for diverse cohorts: a case study from event management

This article investigates the role of information communication technologies (ICTs) in establishing a well-aligned, authentic learning environment for a diverse cohort of non-cognate and cognate students studying event management in a higher education context. Based on a case study which examined the way ICTs assisted in accommodating diverse learning needs, styles and stages in an event management subject offered in the Creative Industries Faculty at Queensland University of Technology in Brisbane, Australia, the article uses an action research approach to generate grounded, empirical data on the effectiveness of the dynamic, individualised curriculum frameworks that the use of ICTs makes possible. The study provides insights into the way non-cognate and cognate students respond to different learning tools. It finds that whilst non-cognate and cognate students do respond to learning tools differently, due to a differing degree of emphasis on technical, task or theoretical competencies, the use of ICTs allows all students to improve their performance by providing multiple points of entry into the content. In this respect, whilst the article focuses on the way ICTs can be used to develop an authentic, well-aligned curriculum model that meets the needs of event management students in a higher education context, with findings relevant for event educators in Business, Hospitality, Tourism and Creative Industries, the strategies outlined may also be useful for educators in other fields who are faced with similar challenges when designing and developing curriculum for diverse cohorts.

Emergent participant interaction

Emergence has the potential to effect complex, creative or open-ended interactions and novel game-play. We report on research into an emergent interactive system. This investigates emergent user behaviors and experience through the creation and evaluation of an interactive system. The system is +-NOW, an augmented reality, tangible, interactive art system. The paper briefly describes the qualities of emergence and +-NOW before focusing on its evaluation. This was a qualitative study with 30 participants conducted in context. Data analysis followed Grounded Theory Methods. Coding schemes, induced from data and external literature are presented. Findings show that emergence occurred in over half of the participants. The nature of these emergent behaviors is discussed along with examples from the data. Other findings indicate that participants found interaction with the work satisfactory. Design strategies for facilitating satisfactory experience despite the often unpredictable character of emergence, are briefly reviewed and potential application areas for emergence are discussed.

Constructing Technology Projects with Young Children : Four Detailed Case Studies of Mounting Constructivist Learning Projects Using Dimple Technologies for Young Children

The work by graduate teachers in this volume represent intentional design of learning experiences using technology for Early Childhood settings. They were given a two-part design task: a sequence of lessons organised around a themed project; and the collection of resources to support such activities. The project had to be constructive in nature where the children built objects and representations that were meaningful to them. The excellent works presented here offer a range of approaches that would be suitable in a variety of contexts. Because they are reasoned, these projects offer flexibility in implementation along with confidence that they would be effective.

Attitudes and expectations of technologies to manage high risk wandering and elopement in persons with dementia : an Australian perspective

Wandering is aimless and repetitive locomotion that may expose persons with dementia (PWD) to elopement, getting lost and death. This study is an Australian replication of a US study. Cross-disciplinary consensus- based analysis was applied to data from five focus groups (N =47: cognitively intact LTC residents (5), carers of PWD (11), home care workers (13) allied health professionals and health-focused engineers (7) and RNs (11). Groups received briefing about wandering monitoring and elopement management systems. Consistent with US attitudes, participants in all groups agreed on what a wandering technology should do, how it should do it, and necessary technical specifications. Within each group participants raised the need for a continuum of care for PWD and the imperative for early recognition of potentially dangerous wandering and getting lost when they occur. Global Positioning System elopement management was the preferred option. Interestingly, the prospective value of GPS to recover a lost or eloped wanderer far outweighed privacy concerns, as in the US. A pervasive theme was that technologies need to augment, but cannot replace, attentive, compassionate caregiver presence. A significant theme raised only by Australian carers of PWD was the potential for development of implantable GPS technologies and the need for public debate about attendant ethical issues. Given that 60% or more of over 200,000 Australians and 4.5 million Americans with dementia will develop wandering, there is a pressing need to develop effective locator systems that may delay institutionalization, help allay carer concern and enhance PWD safety.