Two linear beetle-type scanning tunneling microscopes

Two beetle-type scanning tunneling microscopes are described. Both designs have the thermal stability of the Besocke beetle and the simplicity of the Wilms beetle. Moreover, sample holders were designed that also allow both semiconductor wafers and metal single crystals to be studied. The coarse approach is a linear motion of the beetle towards the sample using inertial slip–stick motion. Ten wires are required to control the position of the beetle and scanner and measure the tunneling current. The two beetles were built with different sized piezolegs, and the vibrational properties of both beetles were studied in detail. It was found, in agreement with previous work, that the beetle bending mode is the lowest principal eigenmode. However, in contrast to previous vibrational studies of beetle-type scanning tunneling microscopes, we found that the beetles did not have the “rattling” modes that are thought to arise from the beetle sliding or rocking between surface asperities on the raceway. The mass of our beetles is 3–4 times larger than the mass of beetles where rattling modes have been observed. We conjecture that the mass of our beetles is above a “critical beetle mass.” This is defined to be the beetle mass that attenuates the rattling modes by elastically deforming the contact region to the extent that the rattling modes cannot be identified as distinct modes in cross-coupling measurements.

Isotonic designs for phase I trials

The purpose of a phase I trial in cancer is to determine the level (dose) of the treatment under study that has an acceptable level of adverse effects. Although substantial progress has recently been made in this area using parametric approaches, the method that is widely used is based on treating small cohorts of patients at escalating doses until the frequency of toxicities seen at a dose exceeds a predefined tolerable toxicity rate. This method is popular because of its simplicity and freedom from parametric assumptions. In this payer, we consider cases in which it is undesirable to assume a parametric dose-toxicity relationship. We propose a simple model-free approach by modifying the method that is in common use. The approach assumes toxicity is nondecreasing with dose and fits an isotonic regression to accumulated data. At any point in a trial, the dose given is that with estimated toxicity deemed closest to the maximum tolerable toxicity. Simulations indicate that this approach performs substantially better than the commonly used method and it compares favorably with other phase I designs.

Using global formulary apportionment for international profit allocation: The case of Indonesia's mining industry

My thesis examined an alternative approach, referred to as the unitary taxation approach to the allocation of profit, which arises from the notion that as a multinational group exists as a single economic entity, it should be taxed as one taxable unit. The plausibility of a unitary taxation regime achieving international acceptance and agreement is highly contestable due to its implementation issues, and economic and political feasibility. Using a case-study approach focusing on Freeport-McMoRan and Rio Tinto's mining operations in Indonesia, this thesis compares both tax regimes against the criteria for a good tax system - equity, efficiency, neutrality and simplicity. This thesis evaluates key issues that arise when implementing a unitary taxation approach with formulary apportionment based on the context of mining multinational firms in Indonesia.

Landscape painting

The images in this exhibition were based on questioning relationships between the histories of painting and photography, which helped to establish the indexical references that became both photography’s most powerful attribute and most subtle illusion. Debates over the objectivity or subjectivity of the photograph and the uneasy relationship between painting and photography, as played out in the history of art, have been brought into sharp relief with the contemporary proliferation of digital images. The digital realm of photography gives rise to a general and relative skepticism of verity, but it can be argued that to artist/photographers, this representational malleability is precisely what their purpose becomes. In researching current issues of the indexical in photographic practice, landscape provides a potent vehicle for exploring issues of representation and illusion, the nexus of painting and photography, and the digital realm. One of contemporary photography’s most resonant themes is a return to pictorial subjects and methods, including a renewed interest in floribunda, still life and landscape. The resulting deconstruction and reconstruction of landscape ‘painting’ in this body of work- the monochrome, linear abstraction, painterly representationalsism and pictorialist detail is presented as a perceptual, aesthetic and digital act. The exhibition incorporates landscape painting’s simplicity and complexity, photography’s significance of representation and minimalist aesthetics in an over-mediated world.

Real-time wide-area loading margin sensitivity (WALMS) in power systems

Loading margin sensitivity (LMS) has been widely used in applications in the realm of voltage stability assessment and control. Typically, LMS is derived based on system equilibrium equations near bifurcation and therefore requires full detailed system model and significant computation effort. Availability of phasor measurement units (PMUs) due to the recent development of wide-area monitoring system (WAMS) provides an alternative computation-friendly approach for calculating LMS. With such motivation, this work proposes measurement-based wide-area loading margin sensitivity (WALMS) in bulk power systems. The proposed sensitivity, with its simplicity, has great potential to be embedded in real-time applications. Moreover, the calculation of the WALMS is not limited to low voltage near bifurcation point. A case study on IEEE 39-bus system verifies the proposed sensitivity. Finally, a voltage control scenario demonstrates the potential application of the WALMS.

The popular mechanicals

In Shakespeare's play, A Midsummer Night's Dream, six workers aspire to present a play for the Royal Wedding. We see their efforts and their antics in the framework of the Royal Court and the supernatural fairy world. We love them for their simplicity, laugh at their homespun ways and forgive their stumbles as they perform their play in the royal presence. In the marvellous irreverence of The Popular Mechanicals, Keith Robinson and Tony Taylor have thrown Shakespeare to the mercy of Australian larrikin humour and placed the lowly workers centre stage. This is A Midsummer Night's Dream without the Royals. Shakespeare's mechanicals become the stars, the kings of their own world, where dreams can come true, if only for a moment. With the innocence of clowns they love life, feel joy, know fear, bear sadness. In the end it is we the audience who become the Royal presence, to judge them if we dare.

Protection and Switching-Aid Networks for Transistor Bridge Inverters

The present trend in the industry is towards the use of power transistors in the development of efficient Pulsewidth Modulated (PWM) inverters, because of their operation at high frequency, simplicity of turn-off, and low commutation losses compared to the technology using thyristors. But the protection of power transistors, minimization of switching power loss, and design of base drive circuit are very important for a reliable operation of the system. The requirements, analysis, and a simplified procedure for calculation of the switching-aid network components are presented. The transistor is protected against short circuit using a modified autoregulated and autoprotection drive circuit. The experimental results show that the switching power loss and voltage stress in the device can be reduced by suitable choice of the switching-aid network component values.

Quality Assessment of a Forest Inventory Based on Airborne Laser Scanning

In this study, a quality assessment method based on sampling of primary laser inventory units (microsegments) was analysed. The accuracy of a laser inventory carried out in Kuhmo was analysed as a case study. Field sample plots were measured on the sampled microsegments in the Kuhmo inventory area. Two main questions were considered. Did the ALS based inventory meet the accuracy requirements set for the provider and how should a reliable, cost-efficient and independent quality assessment be undertaken. The agreement between control measurement and ALS based inventory was analysed in four ways: 1) The root mean squared errors (RMSEs) and bias were calculated. 2) Scatter plots with 95% confidence intervals were plotted and the placing of identity lines was checked. 3) Bland-Altman plots were drawn so that the mean difference of attributes between the control method and ALS-method was calculated and plotted against average value of attributes. 4) The tolerance limits were defined and combined with Bland-Altman plots. The RMSE values were compared to a reference study from which the accuracy requirements had been set to the service provider. The accuracy requirements in Kuhmo were achieved, however comparison of RMSE values proved to be difficult. Field control measurements are costly and time-consuming, but they are considered to be robust. However, control measurements might include errors, which are difficult to take into account. Using the Bland-Altman plots none of the compared methods are considered to be completely exact, so this offers a fair way to interpret results of assessment. The tolerance limits to be set on order combined with Bland-Altman plots were suggested to be taken in practise. In addition, bias should be calculated for total area. Some other approaches for quality control were briefly examined. No method was found to fulfil all the required demands of statistical reliability, cost-efficiency, time efficiency, simplicity and speed of implementation. Some benefits and shortcomings of the studied methods were discussed.

Speckle-based fibre-optic current sensor

A new fibre-optic sensor, based on the speckle phenomenon, for the measurement of current is described. The technique has the advantages of simplicity and sensitivity, but requires a two-step measurement procedure.

Studies on the fractionation of total transfer ribonucleic acid and purification of an alanine transfer ribonucleic acid from chick embryo

Chick embryo tRNA, prepared by a simple large-scale method, was fractionated on three different ion-exchange columns. In all cases simple chromatographic patterns for various tRNA species were observed, indicating the presence of only a few major species of tRNA for each amino acid. By repeated chromatography one species of alanine tRNA was purified to approx. 80% purity. T1 ribonuclease digest of this purified tRNA gave a simple chromatographic pattern. Because of the simplicity of the method of preparation of tRNA from this readily available source and the presence of only a few species of tRNA for each amino acid, chick embryo is suited for the study of tRNA and its various functions in higher systems.

An incident database for improving metro safety: The case of shanghai

Large cities depend heavily on their metro systems to reduce traffic congestion, which is particularly the case with Shanghai, the largest and most developed city in China. For the purposes of enhancing the possibility in quantitative risk assessment and promoting the safety management level in Shanghai metro, an adaptable metro operation incident database (MOID) is therefore presented for containing details of all incidents that have occurred in metro operation. Taking compatibility and simplicity into consideration, Microsoft Access 2010 software is used for the comprehensive and thorough design of the MOID. Based on MOID, statistical characteristics of incident, such as types, causes, time, and severity, are discovered and 24 accident precursors are identified in Shanghai metro. The processes are demonstrated to show how the MOID can be used to identify trends in the incidents that have occurred and to anticipate and prevent future accidents. In order to promote the application of MOID, an organizational structure is proposed from the four aspects of supervision, research, implementation, and manufacturer. This research would be conducive to safety risk analysis in identifying relevant precursors in safety management and assessing safety level as a qualitative tool.

Understanding the heterogeneity of entrepreneurship education: going beyond Gartner

This paper seeks to draw attention to the importance of appreciating and using ever-present diversity to achieve increased legitimacy for entrepreneurship education. As such, it aims to draw the reader into a reflective process of discovery as to why entrepreneurship education is important and how such importance can be prolonged. Design/methodology/approach - The paper revisits Gartner's 1985 conceptual framework for understanding the complexity of entrepreneurship. The paper proposes an alternative framework based on the logic of Gartner's framework to advance the understanding of entrepreneurship education. The authors discuss the dimensions of the proposed framework and explain the nature of the dialogic relations contained within. Findings - It is argued that the proposed conceptual framework provides a new way to understand ever-present heterogeneity related to the development and delivery of entrepreneurship education. Practical implications - The paper extends an invitation to the reader to audit their own involvement and proximity to entrepreneurship education. It argues that increased awareness of the value that heterogeneity plays in student learning outcomes and programme branding is directly related to the presence of heterogeneity across the dimensions of the conceptual framework. Originality/value - The paper introduces a simple yet powerlu1 means of understanding what factors contribute to the success or otherwise of developing and delivering entrepreneurship education. The simplicity of the approach suggested provides all entrepreneurship educators with the means to audit all facets of their programme.

Finitary Abstract Elementary Classes

The research in model theory has extended from the study of elementary classes to non-elementary classes, i.e. to classes which are not completely axiomatizable in elementary logic. The main theme has been the attempt to generalize tools from elementary stability theory to cover more applications arising in other branches of mathematics. In this doctoral thesis we introduce finitary abstract elementary classes, a non-elementary framework of model theory. These classes are a special case of abstract elementary classes (AEC), introduced by Saharon Shelah in the 1980's. We have collected a set of properties for classes of structures, which enable us to develop a 'geometric' approach to stability theory, including an independence calculus, in a very general framework. The thesis studies AEC's with amalgamation, joint embedding, arbitrarily large models, countable Löwenheim-Skolem number and finite character. The novel idea is the property of finite character, which enables the use of a notion of a weak type instead of the usual Galois type. Notions of simplicity, superstability, Lascar strong type, primary model and U-rank are inroduced for finitary classes. A categoricity transfer result is proved for simple, tame finitary classes: categoricity in any uncountable cardinal transfers upwards and to all cardinals above the Hanf number. Unlike the previous categoricity transfer results of equal generality the theorem does not assume the categoricity cardinal being a successor. The thesis consists of three independent papers. All three papers are joint work with Tapani Hyttinen.

Specificity of anti-nucleoside antibodies

The method of conjugation of a nucleoside or related compound to a carrier protein may have a significant effect on the specificity of the antibodies elicited. It is demonstrated, by means of the membrane-filtration assay, that anti-isopentenyladenosine antibodies produced by the `periodate procedure' are much more reactive with the periodate-oxidized form of the nucleoside than with the parent compound. In addition, the simplicity and specificity of the assay used suggests its use as a sensitive radioimmunoassay for this multifunctional nucleoside.

Activity recognition using binary tree SVM

This paper presents an effective classification method based on Support Vector Machines (SVM) in the context of activity recognition. Local features that capture both spatial and temporal information in activity videos have made significant progress recently. Efficient and effective features, feature representation and classification plays a crucial role in activity recognition. For classification, SVMs are popularly used because of their simplicity and efficiency; however the common multi-class SVM approaches applied suffer from limitations including having easily confused classes and been computationally inefficient. We propose using a binary tree SVM to address the shortcomings of multi-class SVMs in activity recognition. We proposed constructing a binary tree using Gaussian Mixture Models (GMM), where activities are repeatedly allocated to subnodes until every new created node contains only one activity. Then, for each internal node a separate SVM is learned to classify activities, which significantly reduces the training time and increases the speed of testing compared to popular the `one-against-the-rest' multi-class SVM classifier. Experiments carried out on the challenging and complex Hollywood dataset demonstrates comparable performance over the baseline bag-of-features method.