Physical soil characteristics of waterlogged and saline lands of five districts of Haryana, India

Physical characteristics of waterlogged and saline soils of five districts, namely Rohtak, Faridabad, Gurgaon, Sonipat and Jhajjar, of Haryana were studied to evaluate the aquaculture potential. The soil samples from 76 sites were procured and analysed for pH, electrical conductivity, soil particles and water retention capacity, since the knowledge of these parameters is essential for the preliminary evaluation of a site for aqua-farming. Six soil types were identified and clay-loam was observed to be the maximum at 45 (59.21%) sites, followed by silty-clay loam at 14 (18.42%), sandy-clay loam at six (7.89%), silty-loam at four (5.26%), sandy-loam at four (5.26%) and loam at three (3.94%) sites. The pH of soil indicated moderate to high alkaline conditions ranging between 8.01and 9.00 at 53 (69.73%) sites, 9.01 and 10.00 at 17 (22.36%) sites, and low between 7.01 and 8.00 at six (7.89%) sites. The electrical conductivity was found to range between <1 and 10 mmho cmˉ¹ with the value of <1.0 mmho cmˉ¹ at 36 (47.36%) sites. The water retention capacity was observed mostly to be moderate. The paper describes the interrelationship between these parameters with reference to the suitability for aqua-farming.

21 Port self wavelength switching of 40 Gb/s spectral-amplitude-encoded DPSK signals

Ultrafast self-switching of spectral-amplitude-encoded 40 Gb/s DPSK signals is demonstrated for the first time. Switching between 21 ports with 15nm maximum bin separation is achieved using a single correlator based on HNLF and an AWG. © 2009 IEEE.

Ecological imbalances in the coastal areas of Pakistan and Karachi Harbour

The marine environment of Pakistan has been described in the context of three main regions : the Indus delta and its creek system, the Karachi coastal region, and the Balochistan coast. The creeks, contrary to concerns, do receive adequate discharges of freshwater. On site observations indicate that freshwater continues flowing into them during the lean water periods and dilutes the seawater there. A major factor for the loss of mangrove forests as well as ecological disturbances in the Indus delta is loss of the silt load resulting in erosion of its mudflats. The ecological disturbance has been aggravated by allowing camels to browse the mangroves. The tree branches and trunks, having been denuded of leaves are felled for firewood. Evidence is presented to show that while indiscriminate removal of its mangrove trees is responsible for the loss of large tracts of mangrove forests, overharvesting of fisheries resources has depleted the river of some valuable fishes that were available from the delta area. Municipal and industrial effluents discharged into the Lyari and Malir rivers and responsible for land-based pollution at the Karachi coast and the harbour. The following are the three major areas receiving land-based pollution and whose environmental conditions have been examined in detail: (l) the Manora channel, located on the estuary of the Lyari river and serving as the main harbour, has vast areas forming its western and eastern backwaters characterized by mud flats and mangroves. The discharge of industrial wastewater from the S.I.T.E. and municipal effluents from the northern and central districts into the Lyari has turned this river into an open drain. This, in turn, has caused a negative impact on the environment of the port, fish harbour, and the adjacent beaches. (2) The Gizri creek receives industrial and municipal effluents from the Malir river as well as from several industries and power stations. The highly degraded discharges from the Malir have negatively impacted the environment in this creek. (3) The coastline between the Manora channel and Gizri creek where the untreated municipal effluents are discharged by the southern districts of Karachi, is responsible for the degraded environment of the Chinna creek, and also of the beaches and the harbour. The Balochistan coast is relatively safe from land-based pollution, mainly because of the lack of industrial, urban or agricultural activity, except the Hingol river system where some agricultural activities have been initiated.

Comparative economic analysis of pond fish production in Mymensingh and Jessore Districts, Bangladesh

The study was conducted to determine the cost, return and relative profitability of pond fish production of Mymensingh and Jessore districts. A total of 75 ponds were selected on the basis of purposive random sampling technique from 7 villages under 2 Upazila (Trishal and Gouripur) of Mymensingh districts and 8 villages under 4 Upazila (Monimmpur, Jhikorgacha, Chowgacha and Sadar) of Jessore district. It was found that per hectare per year gross cost of pond fish production in Mymensingh and Jessore were Tk 333457.75 and Tk 54327.74, while gross return were Tk 434131.16 and Tk. 96640.00 and net return were Tk 100673.41 and Tk. 42312.26, respectively. The findings of this study revealed that the pond fish production in Jessore district was more profitable than that of Mymensingh district. Cobb-Douglas production function was applied to realize the specific effect of the factors on pond fish production. Out of six variables included in the function three variables had positive impact on return from pond fish production, in Mymensingh district but five variables had positive impact on return from pond fish production in Jessore district

Input-output relationship and economics of pangas monoculture and carp-pangas polyculture in two districts of Bangladesh

An attempt was made to study the input-output relationships and economics of pangas monoculture and carp-pangas polyculture in Bangladesh. By analyzing the data collected from 50 pangas farms and 55 carp-pangas farms, the study has investigated the production systems of two technologies and the effects of fingerling stocking and applications of feed and fertilizer on fisheries income. The data were collected from the fishermen of Trishal and Bhaluka of Mymensingh district, and Kahaloo and Adamdighee of Bogra district during 2001-02. For pangas monoculture, the stocking density was 31,561 per ha while it was 55,017 per ha in carp-pangas polyculture. Most of the farmers used urea, TSP and lime before stocking. Rice and wheat bran happened to be the most common feed ingredients for both types of culture in general. Other important ingredients used were mustard oil-cakes, rice polish, wheat flour, fish meal, bone meal, soybean meal and poultry litter. In terms of quantities, rice bran and wheat bran dominated the farmers list. Rice and wheat bran together constituted about 60% of all studied feeds. Feed cost constituted 59.13% of total costs for pangas monoculture and 67.44% for carp-pangas polyculture. Per ha productions of pangas and carp-pangas in a single culture cycle were 15,508 kg and 19,745 kg, respectively. Per ha gross profits were estimated to be Tk 310,311 and Tk 464,418 for pangas monoculture and carp-pangas polyculture, respectively. Net profit appeared to be Tk 264,216 per ha for pangas monoculture and Tk 416,509 per ha for carp-pangas polyculture. The BCRs calculated were 1.46 and 1.68 for monoculture and polyculture, respectively. The break-even costs per kg of fish were estimated at Tk 36.93 for pangas and Tk 30.93 for mixed species which was much lower than the prices the producers received. Break-even productions were estimated at 10,702 kg per ha for pangas monoculture and 11,784 kg per ha for carp-pangas polyculture. Fingerling and feed cost, and pond size significantly explained the variation of income from pangas monoculture. These factors have significantly influenced the income from the crop. Functional analysis shows that 1% increase in the feed cost might increase 0.51% of pangas income and 0.41% in carp-pangas income. No other inputs had shown this much of responses to increasing income from a fish.

Adoption, productivity and profitability of rice-fish and fingerling culture in three selected districts of Bangladesh

The study aimed to investigate the productivity and profitability of rice-fish farming. It also determined the factors affecting rice-fish and fingerling production in Bangladesh. Among the total respondents about 55% were involved in rice-fish farming, 37% in pond fish culture and rest 9% in fish nursery. Integrated rice-fish farming contributed about 83% of the annual farm income in Comilla while it was about 20% in both Kishoregonj and Chandpur districts. Among the different farming systems integrated rice-fish culture and rearing fingerlings in the nursery pond were more profitable at the farm level. Farmers earned a net return of Tk. 49,714/ha from integrated fish culture with boro rice while the net return of boro rice-alone was only Tk. 11,179/ha. This indicated that farmer could earn 218% higher net return from integrated rice-fish farming than that of boro rice only farming. Moreover, integrated rice-fish culture also reduced pesticides cost to about 77% and weeding cost to about 51% in boro season. Fingerling nursing earned highest net returns among the three technologies.

Biology of fouling in Neendakara port, a tropical estuary in the south west coast of India

Species composition and some aspects of the biology of the fouling community in Neendakara port (southwest coast of India) has been examined for a period of one year. Fouling organisms were collected with a system of glass panels exposed for varying durations and during different months in the port. One species of sponge, nine species of coelenterates, thirteen species of polyzoans, four species of mud-tube dwelling polychaetes, four species of serpulids, one species each of mud-tube forming amphipod and tanaid, two species of oysters, six species of mussels and not less than eight species of tunicates were the macro fouler which settled over the panels. Monthly and seasonal settlement of the different species has been recorded. Fouling has been a continuous process occurring throughout the year in Neendakara port with slightly fluctuating biomass and considerably varying species composition. Alternate species dominance of marine and brackish water forms has been an important feature of fouling in the area. Number of species of the sedentary fouling animals represented on test panels has been high during the highly saline pre-monsoon period and low during the monsoon period.

Fisheries profile mapping of coastal districts in Maharashtra state through GIS

In recent times, GIS is being increasingly used as a decision support system for management of fisheries and aquaculture. It provides new innovative approaches of the dynamic relations that characterize this sector. In this context, a study is conducted based on the secondary data of a major maritime state, Maharashtra, where mapping of fisheries profile of coastal districts in the state is performed through GIS tool having critical geographic dimensions. This paper aims to map information of the state which can be used for the purpose of planning and decision making as each aspect of map has a different component involved. For this purpose, at the core of the system, the data were accessed and integrated from different sources mainly from the five coastal districts of Maharashtra state. Data were brought in tabular form through Microsoft Excel and then joined to Map info Professional version 8.0 GIS software was used with the digitized map of Maharashtra state to enable mapping. This was further synchronized and integrated to generate four thematic maps searchable on several criteria. Map 1 contains the searchable criteria as regards to the fish growth for the year 1997-2004 and fish seed production for the year 2003-04. Map 2 contains fisher population along with their occupation for the year 1992. Map 3 contains brackish water and shrimp farming production and culture area. Map 4 contains infrastructural facilities which include type of boats etc. With this mapping, planners and various stakeholders have accessible information as regards to the various components of fisheries in the state of Maharashtra.

Modular hybrid dilated Mach-Zehnder switch with integrated SOAs for large port count switches

A modular dilated MZI based optical switch with integrated SOAs is demonstrated with excellent -40dB crosstalk/extinction ratio, 3ns switching time and nearly penalty-free operation. Studies show an 8×8 switch with 14dB IPDR for 0.5dB penalty. © 2014 OSA.

Silicon-Based Asymmetric Add-Drop Microring Resonators with Ultra-Large Through-Port Extinctions

We theoretically simulate and experimentally demonstrate ultra-large through-port extinctions in silicon-based asymmetrically-coupled add-drop microring resonators (MRs). Through-port responses in an add-drop MR are analyzed by simulations and large extinctions are found when the MR is near-critically coupled. Accurate fabrication techniques are applied in producing a series of 20 mu m-radii add-drop microrings with drop-side gap-widths in slight differences. A through-port extinction of about 42.7 dB is measured in an MR with through-and drop-side gap-width to be respectively 280 nm and 295 nm. The large extinction suggests about a 20.5 dB improvement from the symmetrical add-drop MR of the same size and the through-side gap-width. The experimental results are finally compared with the post-fabrication simulations, which show a gap-width tolerance of > 30 nm for the through-port extinction enhancement.

Two-port InGaAsP/InP square resonator microlasers

Two-port InGaAsP/InP square resonator microlasers with a side length of 20 mm have been fabricated by the planar technology process, which have two 1 mu m-wide output ports connected to the vertices of the square resonator. Continuous-wave electrically injected microsquare lasers have been realised at room temperature with mode Q-factors of 1.75 x 10(4) at the threshold current.

Investigation on multiple-port microcylinder lasers based on coupled modes

Microcylinder resonators with multiple ports connected to waveguides are investigated by 2D finite-difference time-domain (FDTD) simulation for realizing microlasers with multiple outputs. For a 10 mu m radius microcylinder with a refractive index of 3.2 and three 2 mu m wide waveguides, confined mode at the wavelength of 1542.3 nm can have a mode Q factor of 6.7 x 10(4) and an output coupling efficiency of 0.76. AlGaInAs/InP microcylinder lasers with a radius of 10 mu m and a 2 mu m wide output waveguide are fabricated by planar processing techniques. Continuous-wave electrically injected operation is realized with a threshold current of 4 mA at room temperature, and the jumps of output power are observed accompanying a lasing mode transformation.

Design of novel three port optical gates scheme for the integration of large optical cavity electroabsorption modulators and evanescently-coupled photodiodes

This paper presents a novel scheme to monolithically integrate an evanescently-coupled uni-travelling carrier photodiode with a planar short multimode waveguide structure and a large optical cavity electroabsorption modulator based on a multimode waveguide structure. By simulation, both electroabsorption modulator and photodiode show excellent optical performances. The device can be fabricated with conventional photolithography, reactive ion etching, and chemical wet etching.

An improved TM method for full two-port calibration of the asymmetric test fixtures

Three known standards, including at least one transmission standard, are normally required for the full two-port calibration of test fixtures. Based on the triple-through method, a new general-purpose calibration procedure using only one known reflection standard is proposed in this paper. The experimental results show that our method call provide a simple and accurate approach to fall two-port calibration of the asymmetric test fixtures. (c) 2005 Wiley Periodicals, Inc.