Investigation of the spectroscopic properties of Yb3+-doped yttrium lanthanum oxide transparent ceramic

Spectroscopic properties of (Y0.9-xLa0.1Ybx)(2)O-3 transparent ceramic were studied. Two main absorption peaks of the specimen are centered at 940 and 970 nm, which are suitable for InGaAs laser diode pumping. The main emission peaks were located at 1032 and 1075 nm with larger emission cross-section and longer fluorescence lifetime than those of Yb:Y2O3. These properties of (Y0.9-xLa0.1Ybx)(2)O-3 transparent ceramic are favorable to achieve high efficiency and high power laser output. (c) 2007 Elsevier B.V. All rights reserved.

Spectral investigation of Yb-doped calcium pyroniobate crystal

Ytterbium-doped calcium pyroniobate single crystal has been grown for the first time. Spectral properties of Yb: Ca2Nb2O7 were investigated by emission and absorption spectra. Its cooperative luminescence and fluorescence lifetime were also studied. Yb ions in Ca2Nb2O7 showed very broad absorption and emission bandwidth and relatively large absorption and emission cross-sections. Along with other optical properties, this Yb-doped crystal would be a potential self-frequency doubling femtosecond laser gain material. (C) 2007 Published by Elsevier B.V.

An investigation into the potential losses of fish on the filter plates at the Hodder Water Treatment Works Stocks Reservoir

Stocks Reservoir is situated amidst the Forest of Bowland in the upper reaches of the old river valley of the Hodder. The reservoir was built in 1927 for the Fylde Water Board who primarily supplied water to Blackpool. The objective of this study is to assess the degree and likelihood of fish ingress onto the fish plates at the present and proposed stocking densities. An additional aim is to evaluate the operational implications, and if necessary suggest methods of alleviating the problem. Three spheres of study have been undertaken to achieve these objectives, these being: 1. To selectively stock the reservoir and monitor the angling club catches in order to assess the total population, relating it to fish plate losses and proposed stocking densities. 2. To monitor the fish taken from the fish plates and assess the reasons for their ingress. 3. To study the draw off tower and fish plates, and suggest ways of ameliorating or halting the loss of fish and consequent operational problems.

An investigation of the recaptures rates for tagged brown trout stocked into the River Ribble

The angling season for non-migratory brown trout, in the Environment Agency (EA) North West Region, runs from March 15th to September 30th. Each year, large numbers of farm reared brown trout are stocked into the rivers of the North West Region's Central Area. In 1994, approximately 20,000 brown trout were introduced into the River systems of the Lune, Wyre and Ribble by local angling clubs and fishery owners. Most of these fish were stocked at a length greater than that defined by local byelaws as the takeable size (200mm). Introductions are made to supplement the existing wild brown trout populations within the river and increase the probability of an angler catching a fish. Stocking with fish of a sufficient length allows the successful angler to remove the catch for their own use. In this way, stretches of the rivers are effectively managed as "put and take" fisheries for brown trout. A number of brown trout fingerlings are also introduced each year by angling clubs and fishery owners. These are stocked with the expectation that the fish will survive in the river to grow, over-winter, and eventually attain a takable size with an increased degree of "wildness". The lower cost of fingerlings, as opposed to trout of a takable length, makes their introduction more attractive to angling clubs since a greater number can be stocked for a given cost. Although the practise of stocking brown trout has occurred for many years in the Central Area, there is little information of its success in terms of increasing anglers catches, or the survival offish introduced. This study was initiated to determine the recapture rates by angling of brown trout following their introduction into a river fishery. The information gained from this study can then be used to give guidance to angling clubs and fishery owners on the optimal strategies for stocking fish.

Investigation of laser-induced damage on multi-layer dielectric gratings

We investigate mechanisms of laser induced damage thresholds (LIDTs) of multi-layer dielectric gratings (AIDG,). It is found that the laser damage thresholds of MDGs and unstructured dielectric multi-layer coatings (the substrate of MDG) are 3.15J/cm(2) and 9.32 J/cm(2), respectively, at 1064nm (12ns) with the Littrow angle 51.2 degrees and the TEM00 mode. The laser-induced damage mechanism of multi-layer dielectric is presented with the analysis of the following factors: The dominant factor is the pollution on the corrugated surface, which is induced by the complex manufacture process of multi-layer dielectric gratings; another is the electric field distribution along the corrugated surface. The third reason is due to the reduction in stoichiometry of oxide films, resulting from the manufacture process of etching.

Investigation on microstructure and optical properties of titanium dioxide coatings annealed at various temperature

TiO2 coatings were prepared on fused silica with conventional electron beam evaporation deposition. After TiO2 thin films were annealed at different temperatures for 4 h, several properties were investigated by X-ray diffraction (XRD), spectrometer.. photoelectron spectroscopy (XPS) and AFM. It was found that with the annealing temperature increasing, the transmittance of TiO2 coatings decreased, and the cutoff wavelength shifted to long wavelength in near ultraviolet band. Especially, when coatings were annealed at high temperature, the optical loss is very serious, which can be attributed to the scattering and the absorption of TiO2 coatings. XRD patterns revealed that only anatase phase was observed in TiO2 coatings regardless of the different annealing temperatures. XPS results indicated that the fine chemical shift of TiO2 2p(1/2) should be attributed to existence of oxygen vacancies around Ti+4 ion. The investigation on surface morphology by AFM showed that the RMS of titania thin films gradually increases from less than 0.40 nm to 5.03 nm and it should be ascribed to the growth of titanium dioxide grain size with the increase of annealing temperature. (C) 2005 Elsevier B.V. All rights reserved.

Investigation of taste tainting in salmon flesh in the Ribble catchment

This report presents the findings of the first phase of an investigation into the cause(s) of taints in salmonid fish in the River Ribble, commissioned by the North West Region of the Environment Agency. There have been reports of tainting in fish taken from both the estuary and the freshwater river for many years, but the contaminants involved and their source and transport pathway are unknown. Tainting by phenols has been of specific concern in the past. The work programme comprised: examination of tainting reports; collection of salmonids; their submission for taste testing; literature review; analysis of fish flesh using gas chromatography-mass spectrometry (GCMS) and analysis of river bed sediments. From enquiries, three common descriptors of the 'taint' were identified: disinfectanty; diesely; and muddy. The incidence of taints appears transient/irregular and may therefore relate to the incidence of discharges and specific threshold concentrations of pollutants. The literature review showed that a wide range of organic compounds including many industrial chemicals, and others which are naturally occurring, can taint fish flesh. Taste testing confirmed the presence of tainted salmon and trout in the Ribbie Catchment. It identified a low incidence of 'untainted' fish but demonstrated the 'taint' to be not specific to one tainting substance. Differences were found both between the species and fish from different parts of the catchment. Overall, most fish exhibited an unpleasant flavour, though this may have been influenced to some extent by the fact that most were sexually mature. The worst tainting was found in trout from the river Calder: a soapy/chemical aftertaste. An unpleasant earthy/musty flavour distinguished the salmon from the trout. Phenol was shown to have been a minor issue during the present study, whilst no hydrocarbon taints were identified. Examination of tissue from the eight salmon exhibiting the worst taints revealed the presence of aromatic hydrocarbons, but no phenolic compounds. Other notable substances present in the fish were siioxanes and benzophenone. Data from sediment analysis is presented which shows the main compounds present to be aromatic and polyaromatic hydrocarbons, that concentrations at two locations R. Darwen and R. Calder were significantly higher than at other sites, and that some phenolic compounds were detected at low levels. A paucity of fish flesh taste descriptors linked to specific compounds prevented an obvious correlation to be made between the tastes observed and the organic compounds detected. Descriptors frequently used by the taste testing panel (e.g. earthy, musty, astringency, chemical) cannot be linked to any of the compounds identified in the tissue analyses. No taste information was available from the literature on siioxanes. Aromatic hydrocarbons though present in tissue and sediments were not identified as tainting.

Investigation into channel angular extrusion and the UREAD energy absorption technique

.

Investigation into the factors associated with poor water quality in intensively cultured prawn ponds

Water quality problems are reported to be the factor limiting prawn production in the local prawn farm. This investigation was carried out to monitor water quality and its relationship to physical, chemical and biological conditions in the ponds in order to establish what factors should be monitored in order to predict problems. Pond collapse was found to be associated with high concentrations of ammonium, high pH and blue-green algae dominated phytoplankton populations. There was no easy means of predicting the imminent collapse of ponds as the phenomenon was never associated with the extreme of any of the conditions monitored. Rather it seemed to be related to the stability of the pond's algal population, which was largely unaccounted for. Recommendations toward improving water quality are proposed.

Investigation on the properties of high reflective mirror prepared by ion-beam sputtering

The single-sided and dual-sided high reflective mirrors were deposited with ion-beam sputtering (IBS). When the incident light entered with 45 degrees, the reflectance of p-polarized light at 1064 nm exceeded 99.5%. Spectrum was gained by spectrometer and weak absorption of coatings was measured by surface thermal lensing (STL) technique. Laser-induced damage threshold (LIDT) was determined and the damage morphology was observed with Lecia-DMRXE microscope simultaneously. The profile of coatings was measured with Mark III-GPI digital interferometer. It was found that the reflectivity of mirror exceeded 99.9% and its absorption was as low as 14 ppm. The reflective bandwidth of the dual-sided sample was about 43 nm wider than that of single-sided sample, and its LIDT was as high as 28 J/cm2, which was 5 J/cm2 higher than that of single-sided sample. Moreover, the profile of dual-sided sample was better than that of substrate without coatings.

Investigation of damage threshold to TiO2 coatings at different laser wavelength and pulse duration

Laser-induced damages to TiO2 single layers and TiO2/SiO2 high reflectors at laser wavelength of 1064 nm, 800 run, 532 urn, and pulse width of 12 ns, 220 ps, 50 fs, 8 ns are investigated. All films are prepared by electron beam evaporation. The relations among microstructure, chemical composition, optical properties and laser-induced damage threshold (LIDT), have been researched. The dependence of damage mechanism on laser wavelength and pulse width is discussed. It is found that from 1064 nm to 532 nm, LIDT is mainly absorption related, which is determined by film's extinction coefficient and stoichiometric defects. The rapid decrease of LIDT at 800 nm is due to the pulse width factor. TiO2 coatings are mainly thermally by damaged at long pulse (tau >= 220 ps). The damage shows ablation feature at 50 fs. (C) 2007 Elsevier B.V. All rights reserved.