Carrier transport assisted by dopants in doped poly(N-vinylcarbozole) light-emitting diodes

We have investigated the transient electroluminescence (EL) onset of the double-layer light-emitting devices made from poly(N-vinylcarbozole) (PVK) doped with 4-(dicyanomethylene)-2-t-butyl-6(1,1,7,7-tetramethyljulolidyl-9-enyl)-4H-pyran (DCJTB) and tris(8-hydroxy-quinoline) aluminium (Alq(3)). For the double-layered device in which PVK was doped with 0.1 wt% DCJTB, the EL onset of PVK lags that of DCJTB and Alq(3), while the EL onset of DCJTB and Alq(3) is simultaneous. However, the EL emission of the double-layered device of PVK/Alq(3) originates only from Alq(3). The results show that DCJTB dopants can not only help to tunnel electrons from Alq(3) zone to PVK but can also assist electrons transfer in PVK under high electric field by hopping between DCJTB molecules or from DCJTB to PVK sites at a low doping concentration of 0.1 wt%. When the DCJTB doping concentration is 4.0 wt%, the EL onset of Alq(3) lags that of DCJTB. The difference in the EL onsets of DCJTB, Alq(3) and PVK is attributed to the slow build-up of the internal space charge in the vicinity of the interface between PVK and Alq(3). The electron potential difference of the interface between Alq(3) and PVK doped by DCJTB can be adjusted by changing the DCJTB doping concentration in double-layer devices.

Luminescence emission originating from nitrogen doping of beta-Ga2O3 nanowires

Nitrogen-doped beta-Ga2O3 nanowires (GaO NWs) were prepared by annealing the as-grown nanowires in an ammonia atmosphere. The optical properties of the nitrogen-doped GaO NWs were studied by measurements of the photoluminescence and phosphorescence decay at the temperature range between 10 and 300 K. The experimental results revealed that nitrogen doping in GaO NWs induced a novel intensive red-light emission around 1.67 eV, with a characteristic decay time around 136 mus at 77 K, much shorter than that of the blue emission (a decay time of 457 mus). The time decay and temperature-dependent luminescence spectra were calculated theoretically based on a donor-acceptor pair model, which is in excellent agreement with the experimental data. This result suggests that the observed novel red-light emission originates from the recombination of an electron trapped on a donor due to oxygen vacancies and a hole trapped on an acceptor due to nitrogen doping.

Parameters determining crystallinity in beta-SiC thin films prepared by catalytic chemical vapor deposition

The effects of deposition gas pressure and H-2 dilution ratio (H-2/SiH4+CH4+H-2), generally considered two of dominant parameters determining crystallinity in beta-SiC thin films prepared by catalytic chemical vapor deposition (Cat-CVD), often called hot-wire CVD method, on the films properties have been systematically studied. As deposition gas pressure increase from 40 to 1000 Pa, the crystallinity of the films is improved. From the study of H-2 dilution ratio, it is considered that H-2 plays a role as etching gas and modulating the phases in beta-SiC thin films. On the basis of the study on the parameters, nanocrystalline beta-SiC films were successfully synthesized on Si substrate at a low temperature of 300degreesC. The Fourier Transform Infrared Spectroscopy (FTIR) and X-ray diffraction (XRD) spectra show formation of beta-SiC. Moreover, according to Sherrer equation, the average grain size of the films estimated is in nanometer-size. (C) 2003 Elsevier B.V. All rights reserved.

Quantifying the effectiveness of SiO2/Au light trapping nanoshells for thin film poly-Si solar cells

In order to enhance light absorption of thin film poly-crystalline silicon (TF poly-Si) solar cells over a broad spectral range, and quantify the effectiveness of nanoshell light trapping structure over the full solar spectrum in theory, the effective photon trapping flux (EPTF) and effective photon trapping efficiency (EPTE) were firstly proposed by considering both the external quantum efficiency of TF poly-Si solar cell and scattering properties of light trapping structures. The EPTF, EPTE and scattering spectrum exhibit different behaviors depending on the geometric size and density of nanoshells that form the light trapping layer. With an optimum size and density of SiO2/Au nanoshell light trapping layer, the EPTE could reach up to 40% due to the enhancement of light trapping over a broad spectral range, especially from 500 to 800 nm.

Electropolymerized poly(3,4-ethylenedioxythiophene):poly(styrene sulfonate) (PEDOT:PSS) film on ITO glass and its application in photovoltaic device

Poly(3,4-ethylenedioxythiopliene):poly(styrene sulfonate) (PEDOT:PSS) films have been electrochemically polymerized in situ on ITO glass substrate in boron trifluoride diethyl etherate electrolyte (BFEE). Cyclic voltammograms show good redox activity and stability of the PEDOT films. These films had been directly used to fabricate organic-inorganic hybrid solar cells with the structure of ITO/PEDOT/ZnO:MDMC-PPV/Al. The solar cells made of electrochemically polymerized films exhibit higher energy conversion efficiencies compared with that prepared by the spin-coating method, and the highest value is 0.33%. This in-situ electropolymerized method effectively simplifies fabricating procedures and may blaze a facile and economical route for producing high-efficiency solar cells.

可生物降解脂肪族聚酯的反应接枝与相形态

聚（β-轻基丁酸醋-co-β-经基戊酸酷）（PHBV）是一种生物降解脂肪族聚酷，其结晶成核密度低，结晶速度比较慢且易生成大尺寸的球晶。以球晶中心向外扩展形成许多圆环状的开裂以及沿球晶生长方向形成许多劈裂，从而导致了PHBV呈脆性断裂。只要能有效地降低其结晶度，减小球晶尺寸，就可以达到增韧的目的。通过PHBV与二氧化碳一环氧丙烷共聚物（PPC）反应接枝来调控PHBV的结构和相形态，具有实际的理论意义和应用前景。开展了PPC的封端和与PHBv的接枝反应。首次提出了甲基丙烯酸缩水甘油醋（GMA）与PHBV及PPC与PHBV－GMA的接枝反应机理。确信PHBV接枝GMA的接枝点发生在PHBV骨架上的季碳原子上，反应过程中没有交联反应和降解反应的发生。发现PHBv-g-Gh1A共聚物上环氧基能与封端的PPc上的梭基熔融反应原位生成了PHBv-g-PPC共聚物。在机械共混物中两大分子之间的接枝和醋交换反应几乎不发生。GMA的引入阻止了PHBV的降解行为，从而改善了PHBV的加工性能。成功地调控了PHBVPC结构及相形态。证实了PHBV与PPC在反应共混过程中的接枝反应。加入PPC阻碍了PHBV的结晶，这在反应体系中更加明显。通过控制反应条件和反应物的组成，可以使非反应共混物中PHBV球晶变得不规则，发生扭曲变形，球晶尺寸降低；而在反应共混物中，可以使其球晶已很难辨认。SEM结果表明在PHBV用PC（30／70）和PHBV用PC（70／30）共混物中发生了相转变。尤其在反应共混物中淬断面表现为塑性。力学性能随共混组成而发生较大幅度的改变。发现通过改变组成及对反应共混相结构的控制，PHBV共混物的断裂伸长率可变化1一2个数量级，从而实现了制得一系列从脆性断裂塑料到高韧性弹性体的高分子材料。研究了反应接枝共混体系的熔融、结晶行为、等温和非等温结晶动力学。发现加入的GMA对PHBV有成核作用。引入的PPC阻碍了PHBV的结晶，降低PHBV的结晶度，球晶径向生长速率，平衡熔点和结晶能力。结晶速率与冷却速率有较大的依赖性。修正的Avrami方程能很好地描述PHBv和PHBv爪PC共混物非等温结晶过程。对动态力学性能的分析发现，反应共混物相比于非反应共混物聚合物玻璃化温度都有不同程度的内移，说明两组分间相容性增加，接枝共聚物具有良好的增容效果，显著地改善了两相界面性能。PHBV可以部分进入PPC相区，使共混物分子运动特征发生改变。发现在熔体加工条件下，PHBV与PPC之间很难发生酷交换反应，但是以辛酸亚锡为催化剂，氯苯为溶剂，在120℃条件下，两者可以发生醋交换反应。在聚己内醋（PCL）用PC熔融共混过程中GMA可以有效地抑制过氧化二异丙苯（DCP）所引起的PCL交联反应。在DCP和OMA存在下得到的样品之球晶具有十字消光现象，球晶规整度增大。同在溶液中醋交换催化剂存在下PPC和PCL发生了酷交换反应后所形成的球晶相结构相类似，而PCL／PPCOCP体系所形成的球晶中含有大量的非晶相区。从而，确信了GMA在脂肪族聚醋，脂肪族聚碳酸醋等生物降解高分子反应共混体系中的双重作用：一是引入具有高反应活性的官能团；二是减少在过氧化物作用下PHBV类高分子的降解及PCL类高分子的交联反应。PCL共混组分可以提高PPC相区的稳定性。提高反应时间或催化剂浓度同样能够改善热稳定性。

Laterally Electrostatically Driven Poly 3C-SiC Folded-Beam Resonant Microstructures

Micromachined comb-drive electrostatic resonators with folded-cantilever beams were designed and fabricated. A combination of Rayleigh＇s method and finite-element analysis was used to calculate the resonant frequency drift as we adjusted the device geometry and material parameters. Three micromachined lateral resonant resonators with different beam widths were fabricated. Their resonant frequencies were experimentally measured to be 64.5,147.2, and 255.5kHz, respectively, which are in good agreement with the simulated resonant frequency. It is shown that an improved frequency performance could be obtained on the poly 3C-SiC based device structural material systems with high Young＇s modulus.

RTCVD工艺制备poly-Si薄膜太阳电池的研究

报道了快速热化学气相沉积(RTCVD)工艺制备多晶硅(poly -Si)薄膜及电池的实验和结果。采用SiH_2Co_2作为原料气体，衬底温度为1030℃时，薄膜的生长速率为10nm/s。发现薄膜的平均晶粒度及载流子迁移率与衬底温度和材料有关。用该薄膜在未抛光重掺杂磷的硅衬底上制备1cm~2的p~+n结样品电池，无减反射涂层，其转换效率为4.54%(AM1.5,100mW/cm~2,25℃)。

Electrical bistability and negative differential resistance in diodes based on silver nanoparticle-poly(N-vinylcarbazole) composites

An electrically bistable device has been fabricated using nanocomposite films consisting of silver nanoparticles and a semiconducting polymer by a simple spin-coating method. The current-voltage characteristics of the as-fabricated devices exhibit an obvious electrical bistability and negative differential resistance effect. The current ratio between the high-conducting state and low-conducting state can reach more than 103 at room temperature. The electrical bistability of the device is attributed to the electric-filed-induced charge transfer between the silver nanoparticles and the polymer, and the negative differential resistance behavior is related to the charge trapping in the silver nanoparticles. The results open up a simple approach to fabricate high quality electrically bistable devices by doping metal nanoparticles into polymer.