Breeding for low input conditions and consequences for participatory plant breeding: Examples from tropical maize and wheat

Participatory plant breeding (PPB) has been suggested as an effective alternative to formal plant breeding (FPB) as a breeding strategy for achieving productivity gains under low input conditions. With genetic progress through PPB and FPB being determined by the same genetic variables, the likelihood of success of PPB approaches applied in low input target conditions was analyzed using two case studies from FPB that have resulted in significant productivity gains under low input conditions: (1) breeding tropical maize for low input conditions by CIMMYT, and (2) breeding of spring wheat for the highly variable low input rainfed farming systems in Australia. In both cases, genetic improvement was an outcome of long-term investment in a sustained research effort aimed at understanding the detail of the important environmental constraints to productivity and the plant requirements for improved adaptation to the identified constraints, followed up by the design and continued evaluation of efficient breeding strategies. The breeding strategies used differed between the two case studies but were consistent in their attention to the key determinants of response to selection: (1) ensuring adequate sources of genetic variation and high selection pressures for the important traits at all stages of the breeding program, (2) use of experimental procedures to achieve high levels of heritability in the breeding trials, and (3) testing strategies that achieved a high genetic correlation between performance of germplasm in the breeding trials and under on-farm conditions. The implications of the outcomes from these FPB case studies for realizing the positive motivations for adopting PPB strategies are discussed with particular reference for low input target environment conditions.

Tillage and traffic effects on runoff

Traffic and tillage effects on runoff and crop performance on a heavy clay soil were investigated over a period of 4 years. Tillage treatments and the cropping program were representative of broadacre grain production practice in northern Australia, and a split-plot design used to isolate traffic effects. Treatments subject to zero, minimum, and stubble mulch tillage each comprised pairs of 90-m 2 plots, from which runoff was recorded. A 3-m-wide controlled traffic system allowed one of each pair to be maintained as a non-wheeled plot, while the total surface area of the other received a single annual wheeling treatment from a working 100-kW tractor. Rainfall/runoff hydrographs demonstrate that wheeling produced a large and consistent increase in runoff, whereas tillage produced a smaller increase. Treatment effects were greater on dry soil, but were still maintained in large and intense rainfall events on wet soil. Mean annual runoff from wheeled plots was 63 mm (44%) greater than that from controlled traffic plots, whereas runoff from stubble mulch tillage plots was 38 mm (24%) greater than that from zero tillage plots. Traffic and tillage effects appeared to be cumulative, so the mean annual runoff from wheeled stubble mulch tilled plots, representing conventional cropping practice, was more than 100 mm greater than that from controlled traffic zero tilled plots, representing best practice. This increased infiltration was reflected in an increased yield of 16% compared with wheeled stubble mulch. Minimum tilled plots demonstrated a characteristic midway between that of zero and stubble mulch tillage. The results confirm that unnecessary energy dissipation in the soil during the traction process that normally accompanies tillage has a major negative effect on infiltration and crop productivity. Controlled traffic farming systems appear to be the only practicable solution to this problem.

Scavenging of siliceous grain-boundary phase of 8-mol%-ytterbia-stabilized zirconia without additive

The grain-boundary conductivity (sigma (gb),) of 8-mol%-ytterbiastabilized zirconia increased markedly with heat treatment between 1000 degrees and 1300 degreesC with a slow heating rate (0.1 degreesC/min) before sintering. The extent of the sigma (gb) improvement was the same or larger than that via Al2O3 addition. The heat treatment did not affect the grain-interior conduction when sintered at 1600 degreesC, while Al2O3-derived scavenging significantly did, given the larger increment of total conductivity in the heat-treated sample. The formation of a silicon-containing phase in a discrete form was suggested as a possible route of scavenging the resistive phase from the correlation between average grain size and sigma (gb).

Mining wheat germplasm collections for yield enhancing traits

The material in genebanks includes valuable traditional varieties and landraces, non-domesticated species, advanced and obsolete cultivars, breeding lines and genetic stock. It is the wide variety of potentially useful genetic diversity that makes collections valuable. While most of the yield increases to date have resulted from manipulation of a few major traits (such as height, photoperiodism, and vernalization), meeting future demand for increased yields will require exploitation of novel genetic resources. Many traits have been reported to have potential to enhance yield, and high expression of these can be found in germplasm collections. To boost yield in irrigated situations, spike fertility must be improved simultaneously with photosynthetic capacity. CIMMYT's Wheat Genetic Resources program has identified a source of multi-ovary florets, with up to 6 kernels per floret. Lines from landrace collections have been identified that have very high chlorophyll concentration, which may increase leaf photosynthetic rate. High chlorophyll concentration and high stomatal conductance are associated with heat tolerance. Recent studies, through augmented use of seed multiplication nurseries, identified high expression of these traits in bank accessions, and both traits were heritable. Searches are underway for drought tolerance traits related to remobilization of stem fructans, awn photosynthesis, osmotic adjustment, and pubescence. Genetic diversity from wild relatives through the production of synthetic wheats has produced novel genetic diversity.

Precursor scavenging of resistive grain-boundary phase in 8 mol % ytterbia-stabilized zirconia

The grain-boundary conduction of 8 mol % ytterbia-stabilized zirconia (8YbSZ) was improved markedly by precursor scavenging via the two-stage sintering process. The most significant increase in the grain-boundary conductivity was found when the sample, whose conductivity was higher than that via Al2O3-derived scavenging, was heat-treated at 1250degreesC for greater than or equal to 20 h. The formation of a stable Si-containing phase such as ZrSiO4 during the first-stage heat-treatment was suggested as one probable scavenging route from the optimal heat-treatment temperature (HTT), long duration time (>20 h) at HTT, and the stability of the formed phase up to sintering temperatures (1500degrees C). (C) 2002 The Electrochemical Society.

Genetic linkage analysis of the lesser grain borer Rhyzopertha dominica identifies two loci that confer high-level resistance to the fumigant phosphine

High levels of inheritable resistance to phosphine in Rhyzopertha dominica have recently, been detected in Australia and hi art effort to isolate the genes responsible For resistance we have used random amplified DNA fingerprinting (RAF) to produce a genetic linkage map of R. dominica. The map consists of 94 dominant DNA markers with art average distance between markers of 4.6 cM and defines nine linkage groups with a total recombination distance of 390.1 cM. We have identified two loci that are responsible for high-level resistance. One provides similar to50x resistance to phosphine while the other provides 12.5x resistance and in combination, the two genes act synergistically to provide a resistance level 250 x greater than that of fully susceptible beetles. The haploid genome size has been determined to be 4.76 x 10(8) bp, resulting in an average physical distance of 1.2 Mbp per map unit. No recombination has been observed between either of the two resistance loci and their adjacent DNA markers in a population of 44 fully resistant F-5 individuals, which indicates that the genes are likely to reside within 0.91 cM (1.1 Mbp) of the DNA markers.

Sediment yield and impacts from river catchments to the Great Barrier Reef lagoon

Land use intensification is estimated to result in an overall increase in sediment delivery to the Great Barrier Reef lagoon by a factor of approximately four. Modelling suggests that, following land use intensification, croplands cause the greatest increase of sediment yield and sediment concentration, whereas erosion of grazing land is the main contemporary source of sediments, primarily owing to the large spatial extent of this land use. The spatial pattern of sediment yield to the coast after land use intensification is strongly correlated with the pattern under natural conditions, although the greatest increase is estimated to have occurred in the wet-dry catchments. Sediment transport and resuspension processes have led to the development of a strongly sediment-partitioned shelf, with modern mud-rich sediments almost exclusively restricted to the inner and inner-middle shelf, northward-facing embayments and in the lee of headlands. Elevated sediment concentrations increase the potential transport rates of nutrients and other pollutants. Whether increased sediment supply to the coastal zone has impacted on reefs remains a point of contention. More sediment load data need to be collected and analysed in order to make detailed estimates of catchment yields and establish the possible sediment impact on the Great Barrier Reef.

Minor genes are involved in ascochyta blight resistance in lentils

In addition to a gene with major effect, minor genes were found to contribute to the genetic regulation of foliar resistance to Ascochyta blight in two crosses between two resistant and one susceptible lentil cultivars (lines). This was established by comparing inbred lines with and without the major resistance gene. The effects of minor genes were not large enough to change the phenotypic performance determined by its major gene qualitatively (from resistant to susceptible, or vice versa) based on the measurement scale used. However, they did substantially and significantly modify the resistance level. The major gene for foliar resistance was linked to the gene(s) for seed infection rate and/or had a positive pleiotrophic effect on seed infection rate. Similarly, the major gene for foliar resistance was linked to the gene(s) for seed yield/plant in disease free environments and/or had negative pleiotrophic effects on yield/plant. Selection for resistance and yield among inbreds with the same major resistance gene may be necessary to enhance the resistance level, and to reduce the negative effect on yield of the major resistance gene.

Factors affecting cane yield and commercial cane sugar in the Tully district

The Tully Sugar Mill has collected information about sugarcane supplied for crushing from every block in the mill district from 1970 to 1999. Data from 1988 to 1999 were analysed to understand the extent of the variation in cane yield per hectare and commercial cane sugar in the Tully mill area. The key factors influencing the variation in cane yield and commercial cane sugar in this commercial environment were identified and the variance components computed using a restricted maximum likelihood methodology. Cane yield was predominantly influenced by the year in which it was harvested, the month when the crop was ratooned (month of harvest in the previous year) and the farm of origin. These variables were relatively more important than variety, age of crop or crop class (plant crop, first ratoon through to fourth or older ratoons) and fallowing practice (fallow or ploughout-replant). The month-of-ratooning effect was relatively stable from year-to-year. Commercial cane sugar was influenced by the year of harvest, the month of harvest and their interaction, in that the influence of the month of harvest varied from year to year. Variety and farm differences were also significant but accounted for a much lower portion of the variation in commercial cane sugar. An empirical model was constructed from the key factors that influenced commercial cane sugar and cane yield to quantify their combined influence on sugar yield (t/ha). This may be used to assist mill personnel to predict their activities more accurately, for example to calculate the impact of a late finish to the current harvest season on the following year's crop.

Tree yield and fruit minerals concentrations influence 'Hass' avocado fruit quality

To investigate the variation in quality of 'Hass' avocado fruit within an orchard, fruit were harvested at commercial maturity from 15 'Hass' trees of similar appearance, growing in three adjacent rows on the same soil type, and receiving similar management. Fruit were harvested at commercial maturity, and either ripened at 22 degreesC or stored at 2 or 7 degreesC for 3 or 5 weeks and then ripened. Significant positive correlations (based, on the mean for each datum tree) were noted between fruit flesh calcium (Ca) and magnesium (Mg) concentrations and the (Ca + Mg)/potassium ratio, and the number of days for the fruit to reach the eating ripe stage (DTR). Negative correlations were also observed between these minerals and anthracnose and mesocarp discolouration (MD) severity. Negative correlations were observed between fruit potassium (K) and phosphorus (P) concentrations and DTR. Fruit from trees with high fruit yield were generally smaller, with lower anthracnose and MD severity, ripened more slowly, and had higher flesh Ca concentrations. It is likely that cultural practices that maintain moderate to high fruit yield and reduce variation in yield will improve avocado fruit quality and reduce variability in quality. Since the main differences between adjacent trees in this trial were the seedling rootstocks of unknown origin, it is suggested that rootstocks can have a significant impact on avocado yield and fruit quality. (C) 2002 Elsevier Science B.V. All rights reserved.

Osmoregulative capacity in birdseed millet under conditions of water stress. I. Variation in Setaria italica and Panicum miliaceum

Experiments involving 14 accessions of Panicum miliaceum L. (Proso millet) and 11 accessions of Setaria italica L. (Foxtail millet) have demonstrated variability in the degree of osmoregulative capacity among these accessions. Birdseed millet is generally claimed to be sensitive to drought stress, apparently because of a shallow root system. Accessions with high osmoregulative capacity demonstrate at least some drought tolerance. Osmoregulative capacity was measured on flag leaves of headed millet plants in pots undergoing water stress in a controlled environment chamber. Osmoregulative capacity was determined from the relationship between osmotic potential and leaf water potential; and the logarithmic relationship between osmotic potential and relative water content. The group of accessions of S. italica showed an overall level of osmoregulative capacity which was greater than that observed for the group of P. miliaceum accessions. Four accessions of S. italica (108042, 108463, 108541 and 108564) and one accession of P. miliaceum (108104) demonstrated high osmoregulative capacity. Differences of 1.05 MPa or more between observed and estimated osmotic potential were found at relative water contents of 80 % among these accessions. The extent of osmoregulative capacity was associated with osmotic potential at full turgor and the rate of decline in osmotic potential as leaf water potentail declined.