Validação de métodos para determinação do teor de 3-hidroxibutirato e 3-hidroxivalerato em polímero biodegradável

The efficiency of two methods for determining 3-hydroxybutyrate and 3-hydroxyvalerate content in the biopolymer (poly(3-hydroxybutyrate-co-3-hydroxyvalerate) has been evaluated. Both methods are based on (a) the hydrolysis of polymers, (b) the esterification with methyl (method A) and isoamilic alcohol (method B) and (c) analysis of the esters by gas chromatography using flame ionization detection (GC-FID). After optimization of the analytical conditions, the main validation parameters (linearity, quantification limit, detection limit, recovery, sensitivity and precision) were determined showing that both analytical procedures can be applied to control the process of poly(3-hydroxybutyrate) production. However, method B gives better analytical results than method A and has the advantage of not using chlorinated solvents.

Sufentanil-2-hydroxypropyl-beta-cyclodextrin inclusion complex for pain treatment: Physicochemical, cytotoxicity, and pharmacological evaluation

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Chemical Composition of Metapleural Gland Secretions of Fungus-Growing and Non-fungus-growing Ants

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Influence of the cultivation system in the aroma of the volatile compounds and total antioxidant activity of passion fruit

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Niobium to alcohol mol ratio control of the concurring esterification and etherification reactions promoted by NbCl5 and Al2O3 catalysts under microwave irradiation

Alcohols and acids can be switched to produce ethers or esters by varying the alcohol to catalyst mol ratio, in a new etherification and esterification method using NbCl5/Al2O3 catalyst under "solvent free" conditions and promoted by MW (microwave) irradiation. A "two sites" mechanism for the reaction is proposed, in an attempt to clarify the tendency of the catalyst to be dependent on the alcohol alone during the esterification process. (c) 2008 Elsevier B.V. All rights reserved.

Characterization of gallotannins from Astronium species by flow injection analysis-electrospray ionization-ion trap-tandem mass spectrometry and matrix-assisted laser desorption/ionization time-of-flight mass spectrometry

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Comparison of the effects of epidural or intravenous methadone on the minimum alveolar concentration of isoflurane in dogs

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Assessment of vitamin A status in chronic obstructive pulmonary disease patients and healthy smokers

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Associacao de opioides lipofilicos a bupivacaina na anestesia peridural. Ha vantagem no aumento da dose do opioide?

Background and Objectives: - The effects of associating lipophilic opioids to local anesthetics in epidural anesthesia are not well defined. There are still questions and controversies about opioid doses to be used and their major effects in the epidural block. This study aimed at evaluating the epidural block effects in humans of the association of different fentanyl and sufentanil doses to bupivacaine with 1:200.000 epinephrine. Methods: - A double-blind randomized study was performed in 94 patients of both genders, physical status ASA I, aged between 18 and 60 years, submitted to lower abdomen, perineal or lower limb surgery. Patients without preanesthetic medication were epidurally injected with 100 mg (20 ml) 0.5% bupivacaine, 0.1 mg (0.1 ml) 1%o epinephrine plus a combination of the following drugs: BUPI Group (15 patients): 2 ml of 0.9% saline solution (SS); FENT50 Group (19 patients): 50 μg (1 ml) fentanyl + 1 ml SS; FENT100 Group (20 patients): 100 μg (2 ml) fentanyl; SUF30 Group (20 patients): 30 μg (0.6 ml) sufentanil + SS (1.4 ml); SUF100 Group (20 patients): 50 μg (1 ml) sufentanil + SS (1 ml). The following parameters were studied: onset of sensory block, analgesic block (onset time) in T12, T10 and T8, analgesic block duration in T10 and T12, motor block degree, consciousness degree, need for supplemental perioperative sedation and analgesia, hypotension, bradycardia and peri and post operative side-effects, analgesia duration, proportion of patients needing supplemental analgesia and evaluation of postoperative pain (pain analog visual scale). Results: Groups were demographically uniform. The addition of fentanyl or sufentanil did not alter major characteristics of perioperative epidural block and has not significantly increased postoperative analgesia duration as compared to the use of bupivacaine only. However, the addition of lipophilic opioids has increased the quality of perioperative anesthetic block, translated into a lesser need for supplemental analgesia (p < 0.02). The increased dose of fentanyl and especially of sufentanil has increased the incidence of perioperative drowsiness (p < 0.001) without significant increase in other side effects. Conclusions: In the conditions and doses used, the addition of lipophilic opioids to bupivacaine and the increased dose of lipophilic opioids have improved anesthetic block quality without changes in the epidural block characteristics or a significant increase in side effects, with the exception of drowsiness mainly caused by sufentanil. However, they were not able to provide a significant increase in postoperative analgesia duration.

Morfina nasal: Avaliacao da analgesia e dos efeitos colaterais no tratamento da dor pos-operatoria em criancas

Background and Objectives - Postoperative pain is one of the major discomforts but often under treated, especially in the pediatric patient. The aim of this study was to evaluate nasal morphine postoperative analgesia as an alternative drug administration route and show its applicability, effectiveness, tolerability and side effects. Methods - Participated in this study 20 patients aged 3 to 13 years, physical status ASA I and II sequentially submitted the different small and medium-size surgeries. Analgesia was obtained with nasal morphine hydrochloride in aqueous solution in variable concentrations of 2%, 1%, 0.5%, 0.25% and 0.125%. The dose for each instillation has been 0.1 mg.kg -1 at three-hour intervals for 36 postoperative hours. Quality of analgesia in pre-verbal age patients was evaluated by a pain intensity scale based on facial expression and crying, sleep, motor activity, sociability and food ingestion was used. Standardized evaluations were performed at 3-hour intervals. A four-grade scale was used to evaluate tolerability, where: 1) Good; 2) Regular; 3) Bad; 4) Very bad. Result - Postoperative analgesia results have proven to be good and safe, especially from the third evaluation on (6 hours). Drug tolerability has been good, although side effects were observed, especially nausea and vomiting. Conclusions - Patients and relatives accepted the method very well. The nasal route was considered an adequate way for opioid administration although more studies are needed to accept it as a routine for postoperative morphine analgesia.

Sulfur-containing palladacycles as catalyst precursors for the heck reaction

(formula presented) The air, water, and highly thermally stable sulfur-containing palladacycles, mainly derived from the ortho-palladation of benzylic thioethers, are exceptional catalyst precursors for the Heck reaction. The reaction can be performed with aryl iodides, bromides, and chlorides, with acrylic esters and styrene, leading to turnover numbers up to 1 850 000.

Unsaturated polyester based composites reinforced with curauá fiber - Preliminary studies

Curauá fiber processing characterization has been performed throughout the different processing steps. Unsaturated polyester has been used as matrix in the production of curauá reinforced composite samples. Compression molding process has been used to prepare the samples. Tensile strength, impact resistance, flexural strength, Young's modulus and elongation at break have been accessed for curauá composites in comparison with fiberglass composites. Mechanical properties were found not to attend the company's internal standards specification. However, the work has shown some alternatives to solve these problems such as the modification of equipment characteristics and resin formulation, the necessity of incorporation of a higher content of fiber and the possibility of using a new type of filler. Copyright © 2000 Society of Automotive Engineers, Inc.

Natural fiber reinforced unsaturated polyester composites - An approach on compression molding

This work has been performed at Tapetes Sao Carlos-Brazil with the cooperation of the DaimlerChrysler Research Center Team in Ulm - Germany. The objective of the present paper is to report the results obtained with natural fiber reinforced unsaturated polyester (UP) composites, concerning surface quality measurements. The fibers that have been chosen for this work were sisal and curaua. The samples were produced by compression molding technique and afterwards submitted to three different tests, namely: a) thermal aging; b) water absorption and c) artificial weathering. The surface parameters measured before and after the tests were gloss, haze, short and long-waviness. The results have shown that after the tests there is a high loss of gloss, a high increase in haze, and a high increase in short and long-waviness as well. Curaua reinforced composites had a slightly better behavior when compared with sisal reinforced composites. The effect of the presence of filler and the addition of thermoplastic polyester (TP) on the material behavior has not been evidently detected. This result shows that the conventional technology/methods applied to UP-Fiberglass systems cannot be transferred to natural fibers without any modification. The fiber-matrix interaction and its response to the presence of additives must be fully understood before a successful processing route can be developed for painted natural fibers reinforced UP. Copyright © 2001 Society of Automotive Engineers, Inc.

Anti-ulcerogenic and analgesic activities of the leaves of Wilbrandia ebracteata in mice

Wilbrandia ebracteata (Cogn.) Cogn. is a medicinal plant belonging to the Cucurbitaceae family used popularly as an antiulcer and analgesic medicine. The hydromethanol extract of leaves was investigated to determine its anti-ulcerogenic (ethanol and indomethacin induced gastric damage) and analgesic (writhing and tail-flick tests) activities in mice (efficacy), its acute toxicity (safety), and its phytochemistry (quality control). Oral administration of leaf extract at a dose of 1000 mg/kg body wt. significantly reduced 73.3% of the total area of lesion in ethanol-induced gastric damage, but was inactive in an indomethacin-induced gastric damage test. The hydromethanol extract was also inactive in both analgesic tests. Oral administration of the leaf extract did not produce mortality in mice, while the LD50 value of the roots was 22.10 mg/kg body wt. in female mice and 58.31 mg/kg body wt. in male mice. Leaves of W. ebracteata reacted positively for steroids, flavonols, flavanones, saponins, tannins and xanthones and negative for other compounds, including cucurbitacins. Leaf extract of W. ebracteata was active as an anti-ulcerogenic, probably through increasing gastric defensive factors, and flavonoids might be the main constituent responsible for this activity.

Dielectric and viscoelastic properties of cross-linked polyethylene aged under multi stressing conditions

Different measurements were performed in cross-linked polyethylene (XLPE) employed as insulating material in coaxial cables that were field-aged and laboratory-aged under multi-stressing conditions at room temperature. Samples were peeled from the XLPE cable insulation in three different positions: just below the external semiconductor layer (outer layer), in the middle (middle layer) and just above the internal semiconductor layer of the cable (inner layer). The imaginary part of the electric susceptibility showed three peaks that obey the Dissado-Hill model. For laboratory-aged XLPE samples peeled from the inner and from the middle positions the peak at very low frequency region increased while in samples from the outer position a quasi-DC conduction process was observed. In medium frequency range a broadening of the peak was observed for all samples. Viscoelastic properties determined through dynamic mechanical analysis suggested that the aging generates processes that promoted changes of the crystallinity and the cross-linking degrees of the polymer. Fourier transform infrared spectroscopy (FTIR) measurements revealed an increase of oxidation products (esters), evidence of polar residues of the bow-tie tree and the presence of cross-linking by-products (acetophenone). Optical and scanning electronic microscope (SEM) measurements in aged samples revealed the existence of voids and bow-tie trees that were formed during aging in the middle region of the cable.