An energy efficient vertical handover decision algorithm

As wireless communications evolve towards heterogeneousnetworks, mobile terminals have been enabled tohandover seamlessly from one network to another. At the sametime, the continuous increase in the terminal power consumptionhas resulted in an ever-decreasing battery lifetime. To that end,the network selection is expected to play a key role on howto minimize the energy consumption, and thus to extend theterminal lifetime. Hitherto, terminals select the network thatprovides the highest received power. However, it has been provedthat this solution does not provide the highest energy efficiency.Thus, this paper proposes an energy efficient vertical handoveralgorithm that selects the most energy efficient network thatminimizes the uplink power consumption. The performance of theproposed algorithm is evaluated through extensive simulationsand it is shown to achieve high energy efficiency gains comparedto the conventional approach.

Small scale energy production in Helsinki Metropolitan area in emission trading point of view

Emission trading with greenhouse gases and green certificates are part if the climate policy the main target of which is reduce greenhouse gas emissions. The carbon dioxide and fine particle emissions of energy production in Helsinki Metropolitan area are calculated in this study. The analysis is made mainly by district heating point of view and the changes of the district heating network are assessed. Carbon dioxide emissions would be a bit higher, if the district heating network is expanded, but then the fine particle emissions would be much lower. Carbon dioxide emissions are roughly 10 % higher, if the district heating network is expanded at same rate as it has in past five years in the year 2030. The expansion of district heating network would decrease the fine particle emissions about 40 %. The cost of the expansion is allocated to be reduction cost of the fine particle emissions, which is considerably higher than the traditional reduction methods costs. The possible new nuclear plant would reduce the emissions considerably and the costs of the nuclear plant would be relatively low comparing the other energy production methods.

Small wind energy

Master thesis represents the literature overview of small wind energy. I have given the description of principles of work wind turbines, the description of the types of wind turbines, their advantages and disadvantages, the characteristics of small wind turbines, have shown how to count the payback period, have given an overview of currently market wind turbines and the future forecast.

Optimization of energy in a pulp mill

This study presents examination of ways to increase power generation in pulp mills. The main purpose was to identify and verify the best ways of power generation growth. The literature part of this study presented operation of energy pulp mill departments, energy consumption and generation by the recovery and power boilers. The second chapter of this part described the main directions for increase of electricity generation rise of black liquor dry solid content, increase of main steam parameters, flue gas heat recovery technologies, feed water and combustion air preheating. The third chapter of the literature part presented possible technical, environment and corrosion risks appeared from described alternatives. In the experimental part of this study, calculations and results of possible models with alternatives was presented. The possible combinations of alternatives were generated in 44 `models of energy pulp mill. The target of this part was define extra electricity generation after alternatives using and estimate profitability of generated models. The calculations were made by computer programme PROSIM. In the conclusions, the results were estimated on the basis of extra electricity generation and equipment design data of models. The profitability of cases was verified by their payback periods and additional incomes.

The International Distribution of Energy Intensities: some synthetic results

The paper examines the international distribution of energy intensities as a conventional proxy indicator of energy efficiency and sustainability in the consumption of resources, by employing some descriptive tools from the analysis of inequality and polarization. The analysis specifically focuses on the following points: firstly, inequalities are evaluated synthetically based on diverse summary measures and Lorenz curves; secondly, different factorial decompositions are undertaken that assist in investigating some explanatory factors (weighting factors, multiplicative factors and decomposition by groups); and thirdly, an analysis is made of the polarization of intensities when groups of countries are defined endogenously and exogenously. The results obtained have significant implications from both academic and political perspectives.

Quantification of the bond-angle dispersion by Raman spectroscopy and the strain energy of amorphous silicon

A thorough critical analysis of the theoretical relationships between the bond-angle dispersion in a-Si, Δθ, and the width of the transverse optical Raman peak, Γ, is presented. It is shown that the discrepancies between them are drastically reduced when unified definitions for Δθ and Γ are used. This reduced dispersion in the predicted values of Δθ together with the broad agreement with the scarce direct determinations of Δθ is then used to analyze the strain energy in partially relaxed pure a-Si. It is concluded that defect annihilation does not contribute appreciably to the reduction of the a-Si energy during structural relaxation. In contrast, it can account for half of the crystallization energy, which can be as low as 7 kJ/mol in defect-free a-Si

Marketing of Lappeenranta University of Technology energy auditing services

The objective of this study was to find out how LUT Energy should start marketing its energy audit services, what would be the optimal pricing policy for its services and how LUT Energy could manage customer expectations towards quality of its auditing services. In order to answer these questions, a quantitative survey questionnaire was sent by e-mail to 56 companies from the regions of South Karelia and Kymenlaakso. The empirical data of the study was the answers and opinions of the companies, previous researches about energy efficiency and articles and presentations about the current situation in the energy efficiency market. The results of the study were that there is a great potential for energy audit services and also the legislation requires companies to improve their energy efficiency. To start marketing its services, LUT Energy should first clarify its service concept and divide its service offering into two offers. It should also clarify the marketing message it wants to send its customers and then do the marketing with the help of three-way-model. The best pricing policy for the service would be that the price is proportioned to the future savings. In order to ensure the quality of its services, LUT Energy has to make sure that both dimensions of the quality are managed properly and to fade out customer expectations towards the quality the auditing work has to be monitored.

Energy intensity in road freight transport of heavy goods vehicles in Spain

This paper examines the factors that have influenced the energy intensity of the Spanish road freight transport of heavy goods vehicles over the period 1996–2012. This article aims to contribute to a better understanding of the factors behind the energy intensity change of road freight and also to inform the design of measures to improve energy efficiency in road freight transport. The paper uses both annual single-period and chained multi-period multiplicative LMDI-II decomposition analysis. The results suggest that the decrease in the energy intensity of Spanish road freight in the period is explained by the change in the real energy intensity index (lower energy consumption per tonne-kilometre transported), which is partially offset by the behaviour of the structural index (greater share in freight transport of those commodities the transportation of which is more energy intensive). The change in energy intensity is analysed in more depth by quantifying the contribution of each commodity through the attribution of changes in Divisia indices.

Consumer valuation of energy-saving features of residential air conditioners with hedonic and choice models

The promotion of energy-efficient appliances is necessary to reduce the energetic and environmental burden of the household sector. However, many studies have reported that a typical consumer underestimates the benefits of energy-saving investment on the purchase of household electric appliances. To analyze this energy-efficiency gap problem, many scholars have estimated implicit discount rates that consumers use for energy-consuming durables. Although both hedonic and choice models have been used in previous studies, a comparison between two models has not yet been done. This study uses point of sale data about Japanese residential air conditioners and estimates implicit discounts rates with both hedonic and choice models. Both models demonstrate that a typical consumer underinvests in energy efficiency. Although choice models estimate a lower implicit discount rate than hedonic models, the latter models estimate the values of other product characteristics more consistently than choice models.

Development of a microprocessor controlled energy harvester using a Peltier element

Nowadays it is necessary to research other types of energy alternatives and find the way to supply and save the energy we waste. The aim of the project consist of programming a microprocessor to measure if an oven radiates heat to the exterior, for the measure It is used a Peltier element that generates a voltage depending of the temperature difference between the oven and the air of the place where the oven is situated; The energy generated by the oven will be recollected in a condensor. A sensor will be used to know the exact measure. The second part of the project the main propose, is the development of a harvester. The microprocessor will use the voltage produced by the Peltier element to supply the electricity that it needs to work. A low power circuit and the appropriate software are needed to save the voltage generated.

Sustainable Waste-to-Energy Production: Performance Evaluation of Distributed Generation fuelled by Landfill Gas

The environmental impact of landfill is a growing concern in waste management practices. Thus, assessing the effectiveness of the solutions implemented to alter the issue is of importance. The objectives of the study were to provide an insight of landfill advantages, and to consolidate landfill gas importance among others alternative fuels. Finally, a case study examining the performances of energy production from a land disposal at Ylivieska was carried out to ascertain the viability of waste to energy project. Both qualitative and quantitative methods were applied. The study was conducted in two parts; the first was the review of literatures focused on landfill gas developments. Specific considerations were the conception of mechanism governing the variability of gas production and the investigation of mathematical models often used in landfill gas modeling. Furthermore, the analysis of two main distributed generation technologies used to generate energy from landfill was carried out. The review of literature revealed a high influence of waste segregation and high level of moisture content for waste stabilization process. It was found that the enhancement in accuracy for forecasting gas rate generation can be done with both mathematical modeling and field test measurements. The result of the case study mainly indicated the close dependence of the power output with the landfill gas quality and the fuel inlet pressure.

Environmental policy instruments concerning industrial end-use energy efficiency

Energy efficiency and saving energy are the main question marks when thinking of reducing carbon dioxide emissions or cutting costs. The objective of thesis is to evaluate policy instruments concerning end-use energy efficiency of heavy industry in European Union. These policy instruments may be divided in various ways, but in this thesis the division is to administrative, financial, informative and voluntary instruments. Administrative instruments introduced in this thesis are Directive on Integrated Pollution Prevention and Control, Directive on Energy End-use Efficiency and Energy Services, and Climate and Energy Package. Financial means include energy and emission taxation, EU Emission Trading Scheme and diverse support systems. Informative instruments consist of horizontal BAT Reference Document for Energy Efficiency, as well as substantial EU documents including Green Paper on Energy Efficiency, Action Plan for Energy Efficiency and An Energy Policy for Europe. And finally, voluntary instruments include environmental managements systems like ISO 14001 and EMAS, energy auditing and benchmarking. The efficiency of different policy instruments vary quite a lot. Informative instruments lack the commitment from industry and are thus almost ineffective, contrary to EU Emission Trading Scheme, which is said to be the solution to climate problems. The efficiency of administrative means can be placed between those mentioned and voluntary instruments are still quite fresh to be examined fruitfully. However, each instrument has their potential and challenges. Cases from corporate world strengthen the results from theoretical part. Cases were written mainly on the basis of interviews. The interviewees praised the energy efficiency contract of Finnish industry, but the EU ETS takes the leading role of policy instruments. However, for industry the reductions do not come easily.

Cryptographic Energy Costs are Assumable in Ad Hoc Networks

Performance of symmetric and asymmetriccryptography algorithms in small devices is presented. Both temporaland energy costs are measured and compared with the basicfunctional costs of a device. We demonstrate that cryptographicpower costs are not a limiting factor of the autonomy of a deviceand explain how processing delays can be conveniently managedto minimize their impact.

Strategic choices and performance – an empirical analysis of largest European and North American energy companies

Energy industry has gone through major changes globally in past two decades. Liberalization of energy markets has led companies to integrate both vertically and horizontally. Growing concern on sustainable development and aims to decrease greenhouse gases in future will increase the portion of renewable energy in total energy production. Purpose of this study was to analyze using statistical methods, what impacts different strategic choices has on biggest European and North American energy companies’ performance. Results show that vertical integration, horizontal integration and use of renewable energy in production had the most impact on profitability. Increase in level of vertical integration decreased companies’ profitability, while increase in horizontal integration improved companies’ profitability. Companies that used renewable energy in production were less profitable than companies not using renewable energy.

On Value Creation at an Industrial Intersection – Bioenergy in the Forest and Energy Sectors

The traditional forest industry is a good example of the changing nature of the competitive environment in many industries. Faced with drastic challenges forestindustry companies are forced to search for new value-creating strategies in order to create competitive advantage. The emerging bioenergy business is now offering promising avenues for value creation for both the forest and energy sectors because of their complementary resources and knowledge with respect to bioenergy production from forest-based biomass. The key objective of this dissertation is to examine the sources of sustainable competitive advantage and the value-creation opportunities that are emerging at the intersection between the forest and energy industries. The research topic is considered from different perspectives in order to provide a comprehensive view of the phenomenon. The study discusses the business opportunities that are related to producing bioenergy from forest-based biomass, and sheds light on the greatest challenges and threats influencing the success of collaboration between the forest and energy sectors. In addition, it identifies existing and potential bioenergy actors, and considers the resources and capabilities needed in order to prosper in the bioenergy field. The value-creation perspective is founded on strategic management accounting, the theoretical frameworks are adopted from the field of strategic management, and the future aspect is taken into account through the application of futures studies research methodology. This thesis consists of two parts. The first part provides a synthesis of the overall dissertation, and the second part comprises four complementary research papers. There search setting is explorative in nature, and both qualitative and quantitative research methods are used. As a result, the thesis lays the foundation for non-technological studies on bioenergy. It gives an example of how to study new value-creation opportunities at an industrial intersection, and discusses the main determinants affecting the value-creation process. In order to accomplish these objectives the phenomenon of value creation at the intersection between the forest and energy industries is theorized and connected with the dynamic resource-based view of the firm.