916 resultados para Dispositions, gap, circulariry, insufficiency.
Resumo:
Aim A recent Monte Carlo based study has shown that it is possible to design a diode that measures small field output factors equivalent to that in water. This is accomplished by placing an appropriate sized air gap above the silicon chip (1) with experimental results subsequently confirming that a particular Monte Carlo design was accurate (2). The aim of this work was to test if a new correction-less diode could be designed using an entirely experimental methodology. Method: All measurements were performed on a Varian iX at a depth of 5 cm, SSD of 95 cm and field sizes of 5, 6, 8, 10, 20 and 30 mm. Firstly, the experimental transfer of kq,clin,kq,msr from a commonly used diode detector (IBA, stereotactic field diode (SFD)) to another diode detector (Sun Nuclear, unshielded diode, (EDGEe)) was tested. These results were compared to Monte Carlo calculated values of the EDGEe. Secondly, the air gap above the EDGEe silicon chip was optimised empirically. Nine different air gap “tops” were placed above the EDGEe (air depth = 0.3, 0.6, 0.9 mm; air width = 3.06, 4.59, 6.13 mm). The sensitivity of the EDGEe was plotted as a function of air gap thickness for the field sizes measured. Results: The transfer of kq,clin,kq,msr from the SFD to the EDGEe was correct to within the simulation and measurement uncertainties. The EDGEe detector can be made “correction-less” for field sizes of 5 and 6 mm, but was ∼2% from being “correction-less” at field sizes of 8 and 10 mm. Conclusion Different materials will perturb small fields in different ways. A detector is only “correction-less” if all these perturbations happen to cancel out. Designing a “correction-less” diode is a complicated process, thus it is reasonable to expect that Monte Carlo simulations should play an important role.
Resumo:
Women, Peace and Security (WPS) scholars and practitioners have expressed reservations about the Responsibility to Protect (R2P) principle because of its popular use as a synonym for armed humanitarian intervention. On the other hand, R2P’s early failure to engage with and advance WPS efforts such as United Nations Security Council (UNSC) resolution 1325 (2000) has seen the perpetuation of limited roles ascribed to women in implementing the R2P principle. As a result, there has been a knowledge and practice gap between the R2P and WPS agendas, despite the fact that their advocates share common goals in relation to the prevention of atrocities and protection of populations. In this article we propose to examine just one of the potential avenues for aligning the WPS agenda and R2P principle in a way that is beneficial to both and strengthens the pursuit of a shared goal – prevention. We argue that the development and inclusion of gender-specific indicators – particularly economic, social and political discriminatory practices against women – has the potential to improve the capacity of early warning frameworks to forecast future mass atrocities.
Resumo:
There is a general perception that public confidence in the insolvency profession is low as the result of the recent unethical practices of a few high profile liquidators. As a result, the effectiveness of the current regulatory mechanisms has been questioned, leading to a review of the performance of insolvency practitioners and subsequent regulation proposals. The challenge for the insolvency profession is balancing the expectations of the general public whilst ensuring that the obligations and duties imposed upon them are performed to acceptable and realistic standards. It is difficult (if not impossible) for the profession to meet this challenge in the absence of a cohesive framework which identifies those issues that require further regulation as opposed to those that relate to general education on the insolvency process. This paper will examine the audit expectations gap theory in the context of insolvency practitioners and suggests that a model based on this theory provides an effective framework for evaluating the regulation of the insolvency industry.
Resumo:
Objectives This study aims to develop a better understanding of mothers’ knowledge, understanding, and attitude towards children’s measles immunization and explore the relationship between mothers’ understanding of measles immunization and health promotion programs in North Vietnam. Methods Semi-structured interviews were conducted with 15 mothers of children aged 1 or 6 years old between 2006 and 2010 in two provinces in North Vietnam. Ten interviews were transcribed and analysed to explore themes while other five interviews were cross-referenced for congruency. Among the ten mothers whose interviews were analysed, there were five mothers whose children received the full measles immunization schedule (two doses) and five mothers whose children received one or none of measles vaccination. Results Mothers had different levels of understanding and a strong positive attitude towards measles immunization. Mothers considered health officers at the commune health centres who played an important role in the promotion of measles immunization, as the main source of information. The relationship between the mother’s understanding about measles immunization and health promotion programs was found to be both positive and negative. Conclusion Mothers whose children received the full measles immunization schedule paid more attention to measles immunization and health promotion programs compared with mothers whose children received one or none of measles vaccination. Mothers’ misunderstanding about the measles immunization schedule was the main reason for choosing not to receive the measles immunizations. These findings help to improve communication with mothers about measles immunization and close the gap for 100% measles immunization in North Vietnam.
Resumo:
The estimation of the critical gap has been an issue since the 1970s, when gap acceptance was introduced to evaluate the capacity of unsignalized intersections. The critical gap is the shortest gap that a driver is assumed to accept. A driver’s critical gap cannot be measured directly and a number of techniques have been developed to estimate the mean critical gaps of a sample of drivers. This paper reviews the ability of the Maximum Likelihood technique and the Probability Equilibrium Method to predict the mean and standard deviation of the critical gap with a simulation of 100 drivers, repeated 100 times for each flow condition. The Maximum Likelihood method gave consistent and unbiased estimates of the mean critical gap. Whereas the probability equilibrium method had a significant bias that was dependent on the flow in the priority stream. Both methods were reasonably consistent, although the Maximum Likelihood Method was slightly better. If drivers are inconsistent, then again the Maximum Likelihood method is superior. A criticism levelled at the Maximum Likelihood method is that a distribution of the critical gap has to be assumed. It was shown that this does not significantly affect its ability to predict the mean and standard deviation of the critical gaps. Finally, the Maximum Likelihood method can predict reasonable estimates with observations for 25 to 30 drivers. A spreadsheet procedure for using the Maximum Likelihood method is provided in this paper. The PEM can be improved if the maximum rejected gap is used.
Resumo:
The rapid pace of urbanisation in China has seen a massive increase in the movement of the rural population to work and live in urban regions. In this large-scale migration context, the educational, health, and psychological problems of floating children are becoming increasingly visible. Different from extant studies, we focus our investigation on the rural dispositions of floating children through interviews with leaders, teachers, and students in four schools in Beijing. Drawing on Bourdieu’s key notions of habitus, capital, and field, our study indicates that the rural habitus of floating children can differentiate these children from their urban peers. This habitus can be marginalised and stigmatised in certain fields but can be recognised and valued as capital in other fields. Our paper offers some implications for research and practice in relation to the schooling of floating children.
Resumo:
Evidence from economic evaluations is often not used to inform healthcare policy despite being well regarded by policy makers and physicians. This article employs the accessibility and acceptability framework to review the barriers to using evidence from economic evaluation in healthcare policy and the strategies used to overcome these barriers. Economic evaluations are often inaccessible to policymakers due to the absence of relevant economic evaluations, the time and cost required to conduct and interpret economic evaluations, and lack of expertise to evaluate quality and interpret results. Consistently reported factors that limit the translation of findings from economic evaluations into healthcare policy include poor quality of research informing economic evaluations, assumptions used in economic modelling, conflicts of interest, difficulties in transferring resources between sectors, negative attitudes to healthcare rationing, and the absence of equity considerations. Strategies to overcome these barriers have been suggested in the literature, including training, structured abstract databases, rapid evaluation, reporting checklists for journals, and considering factors other than cost effectiveness in economic evaluations, such as equity or budget impact. The factors that prevent or encourage decision makers to use evidence from economic evaluations have been identified, but the relative importance of these factors to decision makers is uncertain.
Resumo:
This thesis explored safety culture in a large Australasian construction and mining organisation, with a view to understanding how theory and practice can be integrated to improve safety culture and related outcomes within the industry. The research comprised three studies that investigated the relationship between safety culture, safety motivation, leadership and safety behaviour, and examined differences in perceptions of safety culture across the organisation. Research methodologies and samples included a modified Delphi method with safety leaders (n=41), a quantitative survey with a cross-section of the organisation (n=2,957), and group interviews with frontline supervisors and workers (n=29).
Resumo:
Density functional theory (DFT) calculations were performed to study the structural, mechanical, electrical, optical properties, and strain effects in single-layer sodium phosphidostannate(II) (NaSnP). We find the exfoliation of single-layer NaSnP from bulk form is highly feasible because the cleavage energy is comparable to graphite and MoS2. In addition, the breaking strain of the NaSnP monolayer is comparable to other widely studied 2D materials, indicating excellent mechanical flexibility of 2D NaSnP. Using the hybrid functional method, the calculated band gap of single-layer NaSnP is close to the ideal band gap of solar cell materials (1.5 eV), demonstrating great potential in future photovoltaic application. Furthermore, strain effect study shows that a moderate compression (2%) can trigger indirect-to-direct gap transition, which would enhance the ability of light absorption for the NaSnP monolayer. With sufficient compression (8%), the single-layer NaSnP can be tuned from semiconductor to metal, suggesting great applications in nanoelectronic devices based on strain engineering techniques.
Resumo:
This study uses the reverse salient methodology to contrast subsystems in video game consoles in order to discover, characterize, and forecast the most significant technology gap. We build on the current methodologies (Performance Gap and Time Gap) for measuring the magnitude of Reverse Salience, by showing the effectiveness of Performance Gap Ratio (PGR). The three subject subsystems in this analysis are the CPU Score, GPU core frequency, and video memory bandwidth. CPU Score is a metric developed for this project, which is the product of the core frequency, number of parallel cores, and instruction size. We measure the Performance Gap of each subsystem against concurrently available PC hardware on the market. Using PGR, we normalize the evolution of these technologies for comparative analysis. The results indicate that while CPU performance has historically been the Reverse Salient, video memory bandwidth has taken over as the quickest growing technology gap in the current generation. Finally, we create a technology forecasting model that shows how much the video RAM bandwidth gap will grow through 2019 should the current trend continue. This analysis can assist console developers in assigning resources to the next generation of platforms, which will ultimately result in longer hardware life cycles.
Resumo:
The evolution of technological systems is hindered by systemic components, referred to as reverse salients, which fail to deliver the necessary level of technological performance thereby inhibiting the performance delivery of the system as a whole. This paper develops a performance gap measure of reverse salience and applies this measurement in the study of the PC (personal computer) technological system, focusing on the evolutions of firstly the CPU (central processing unit) and PC game sub-systems, and secondly the GPU (graphics processing unit) and PC game sub-systems. The measurement of the temporal behavior of reverse salience indicates that the PC game sub-system is the reverse salient, continuously trailing behind the technological performance of the CPU and GPU sub-systems from 1996 through 2006. The technological performance of the PC game sub-system as a reverse salient trails that of the CPU sub-system by up to 2300 MHz with a gradually decreasing performance disparity in recent years. In contrast, the dynamics of the PC game sub-system as a reverse salient trails the GPU sub-system with an ever increasing performance gap throughout the timeframe of analysis. In addition, we further discuss the research and managerial implications of our findings.
Resumo:
OBJECTIVES: Gender bias has been found in medical literature, with more men than women as first or senior authors of papers, despite about half of doctors being women. Nursing is about 90% female, so we aimed to determine if similar biases exist in nursing literature. DESIGN: Taking the eight non-specialist nursing journals with the highest impact factors for that profession, we counted the numbers of men and women first authors over 30 years. SETTING: We used nursing journals from around the world which attract the highest impact factors for nursing publication. PARTICIPANTS: Eight journals qualified for entry, three from the United Kingdom, four from the United States of America, and one from Australia. MAIN OUTCOME MEASURES Using Chi-square and Fisher exact tests, we determined differences between the numbers of men and women across all the journals, between countries (USA, UK and Australia), changes over the 30 years, and changes within journals over time. RESULTS Despite the small proportion of men in the nursing workforce, up to 30% of first authors were men. UK journals were more likely to have male authors than USA journals, and this increased over time. USA journals had proportions of male first authors consistent with the male proportion of its nursing workforce. CONCLUSIONS In the UK (though not in the USA) gender bias in nursing publishing exists, even though the nursing workforce is strongly feminized. This warrants further research, but is likely to be due to the same reasons for the gender gap in medical publishing; that is, female nurses take time out to have families, and social and family responsibilities prevent them taking opportunities for career progression, whereas men's careers often are not affected in such ways.
Resumo:
Disconnector switch operation in GIS generates VFT voltages in the system. It is important, for insulation co-ordination purposes, to obtain accurate VFT V-t data for typical gap geometries found in GIS. This paper presents experimentally obtained VFT V-t data for a 180/1 lOmm co-axial gap. The VFT has a time to first peak of 35 ns and a oscillation frequency of 13,6 MHz. Due to the location of the voltage divider in a compartment adjacent to the gap, a correction factor of 1.1 is used to relate the measured breakdown voltage to that in the gap. Positive polarity VFT V-t data is presented for 1, 2, 3 and 4 bar absolute and negative polarity VFT data for 3 and 4 bar absolute. Two methods of generating the VFT's are used. The first is to power up the test transformer at power frequency. The second is to generate a switching impulse by discharging a capacitor into the primary of the test transformer.