Influence of molten-state annealing on the phase structure and crystallization behaviour of high impact polypropylene copolymer

The phase structure evolution of high impact polypropylene copolymer (IPC) during molten-state annealing and its influence on crystallization behaviour were studied. An entirely different architecture of the IPC melt was observed after being annealed, and this architecture resulted in variations of the crystallization behaviour. In addition, it was found that the core-shell structure of the dispersed phase was completely destroyed and the sizes of the dispersed domains increased sharply after being annealed at 200 degrees C for 200 min. Through examination of the coarseness of the phase morphology using phase contrast microscopy (PCM), it was found that a co-continuous structure and an abnormal 'sea-island' structure generally appeared with an increase in annealing time. The original matrix PP component appeared as a dispersed phase, whereas the copolymer components formed a continuous 'sea-island' structure. This change is ascribed to the large tension induced by solidification at the phase interface and the great content difference between the components. When the temperature was reduced the structure reverted to its original form. With increasing annealing time, the spherulite profiles became more defined and the spherulite birefringence changed from vague to clear. Overall crystallization rates and nucleation densities decreased, but the spherulite radial growth rates remained almost constant, indicating that molten-state annealing mainly affects the nucleation ability of IPC, due to a coarsened microstructure and decreased interface area. (C) 2011 Elsevier Ltd. All rights reserved.

PHOTOMINERALISATION OF 4-CHLOROPHENOL SENSITIZED BY TITANIUM-DIOXIDE - A STUDY OF THE EFFECT OF ANNEALING THE PHOTOCATALYST AT DIFFERENT TEMPERATURES

The results of a study of the variation in photocatalytic activity of TiO2, as measured by its ability to photomineralise 4-chlorophenol, as a function of temperature used to anneal the TiO2, are reported. Heat treatment of the TiO2 leads to a marked decrease in its photocatalytic activity at annealing temperatures above 600-degrees-C. This decrease is associated with a concomitant drop in the specific surface area of the TiO2, owing to particle sintering, rather than the anatase to rutile transformation, which occurs largely at temperatures above 700-degrees-C. There is a reasonable correlation between photocatalytic activity and the surface area of the aggregate particles in the dispersions of the different heat-treated TiO2 samples.

Investigation of the effect of simulated lens yellowing, transparency loss and refractive error on in vivo resonance Raman spectroscopy

To separately investigate the impact of simulated age-related lens yellowing, transparency loss and refractive error on measurements of macular pigment (MP) using resonance Raman spectroscopy.

Can Imagined Interactions Produce Positive Perceptions? Reducing Prejudice Through Simulated Social Contact

The contact hypothesis states that, under the right conditions, contact between members of different groups leads to more positive intergroup relations. The authors track recent trends in contact theory to the emergence of extended, or indirect, forms of contact. These advances lead to an intriguing proposition: that simply imagining intergroup interactions can produce more positive perceptions of outgroups. The authors discuss empirical research supporting the imagined contact proposition and find it to be an approach that is at once deceptively simple and remarkably effective. Encouraging people to mentally simulate a positive intergroup encounter leads to improved outgroup attitudes and reduced stereotyping. It curtails intergroup anxiety and extends the attribution of perceivers' positive traits to others. The authors describe the advantages and disadvantages of imagined contact compared to conventional strategies, outline an agenda for future research, and discuss applications for policymakers and educators in their efforts to encourage more positive intergroup relations.

Assessment of the solubility and bioaccessibility of arsenic in realgar wine using a simulated gastrointestinal system

Consumption of arsenic (As) wine is a traditional activity during the classic Chinese festival of Duanwu, colloquially known worldwide as the Dragon Boat Day. Arsenic wine is drunk on the morning of the fifth day of the fifth lunar calendar month to commemorate the death of Qu Yuan, a famed Chinese poet who drowned himself in protest of a corrupt government, and to protect against ill fortune. Although realgar minerals are characteristically composed of sparingly soluble tetra-arsenic tetra-sulfides (As(4)S(4)), purity does vary with up to 10% of As being present as non-sulfur bound species, such as arsenate (As(v)) and arsenite (As(III)). Despite, the renewed interest in As speciation and the bioaccessibility of the active As components in realgar based Chinese medicines, little is known about the safety surrounding the cultural practice of drinking As wine. In a series of experiments the speciation and solubility of As in a range of wines were investigated. Furthermore, a simulated gastrointestinal system was employed to predict the impact of digestive processes on As bioavailability. The predominant soluble As species found in all the wines were As(III) and As(v). Based on typical As wine recipes employing 0.1 g realgar mL(-1) wine, the concentration of dissolved As ranged from ca. 100 to 400 mg L(-1) depending on the ethanol content of the preparation: with the As solubility found to be higher in wines with a lower proportion of ethanol. Based on a common 100 mL measure of wine with a concentration of 400 mg As L(-1), the amount of soluble As would equate to around half of the acute minimal lethal dose for adults. This is likely an underestimate of the bioaccessible concentration, as a three-fold increase in bioaccessibility could be observed in the intestinal phase based on the results from the stimulated gastrointestinal system. (C) 2011 Elsevier B.V. All rights reserved.

Effect of post-weld-annealing on the tensile deformation characteristics of laser-welded NiTi thin foil

Laser welding is an important process for fabricating complex components involving NiTi shape memory
alloy. As welding is a thermal process, the amount of heat input and the rate of cooling have significant
impact on the microstructure and hence the resultant characteristics of NiTi. In this study, the effect of
laser welding and post-weld-annealing from 573 K to 1173 K on the thermal phase transformation behaviors,
tensile deformation and micro-hardness characteristics of the laser-welded NiTi thin foils were investigated.
It was found that the as-welded sample exhibited inferior super-elasticity compared to the base
material, and the super-elasticity could be partially restored by annealing at 573 K. On the other hand,
annealing of the weldment above the recrystallization temperature would lower the super-elasticity.

Landfill cap models under simulated climate change precipitation::Impacts of cracks and root growth

Desiccation crack formation is a key process that needs to be understood in assessment of landfill cap performance under anticipated future climate change scenarios. The objectives of this study were to examine: (a) desiccation cracks and impacts that roots may have on their formation and resealing, and (b) their impacts on hydraulic conductivity under anticipated climate change precipitation scenarios. Visual observations, image analysis of thin sections and hydraulic conductivity tests were carried out on cores collected from two large-scale laboratory trial landfill cap models (∼80 × 80 × 90 cm) during a year of four simulated seasonal precipitation events. Extensive root growth in the topsoil increased percolation of water into the subsurface, and after droughts, roots grew deep into low-permeability layers through major cracks which impeded their resealing. At the end of 1 year, larger cracks had lost resealing ability and one single, large, vertical crack made the climate change precipitation model cap inefficient. Even though the normal precipitation model had developed desiccation cracks, its integrity was preserved better than the climate change precipitation model.

Monte Carlo studies of quantum and classical annealing on a double well

We present results for a variety of Monte Carlo annealing approaches, both classical and quantum, benchmarked against one another for the textbook optimization exercise of a simple one-dimensional double well. In classical (thermal) annealing, the dependence upon the move chosen in a Metropolis scheme is studied and correlated with the spectrum of the associated Markov transition matrix. In quantum annealing, the path integral Monte Carlo approach is found to yield nontrivial sampling difficulties associated with the tunneling between the two wells. The choice of fictitious quantum kinetic energy is also addressed. We find that a "relativistic" kinetic energy form, leading to a higher probability of long real-space jumps, can be considerably more effective than the standard nonrelativistic one.