Oscillation flow induced by underwater supersonic gas jets

This paper describes an experimental study on the oscillation flow characteristics of submerged supersonic gas jets issued from Laval nozzles. The flow pattern during the jet development and the jet expansion feedback phenomenon are studied using a high-speed camera and a pressure measurement system. The experimental results indicate that along the downstream distance, the jet has three flow regimes: (1) momentum jet; (2) buoyant jet; (3) plume. In the region near the nozzle exit a so-called bulge phenomenon is found. Bulging of the jet occurs many times before the more violent jet expansion feedback occurs. During the feedback process, the jet diameter can become several times that of the original one depending on the jet Mach number. The frequencies of the jet bulging and the jet expansion feedback are measured.

Research on the mechanics of underwater supersonic gas jets

An experimental research was carried out to study the fluid mechanics of underwater supersonic gas jets. High pressure air was injected into a water tank through converging-diverging nozzles (Laval nozzles). The jets were operated at different conditions of over-, full-and under-expansions. The jet sequences were visualized using a CCD camera. It was found that the injection of supersonic air jets into water is always accompanied by strong flow oscillation, which is related to the phenomenon of shock waves feedback in the gas phase. The shock wave feedback is different from the acoustic feedback when a supersonic gas jet discharges into open air, which causes screech tone. It is a process that the shock waves enclosed in the gas pocket induce a periodic pressure with large amplitude variation in the gas jet. Consequently, the periodic pressure causes the jet oscillation including the large amplitude expansion. Detailed pressure measurements were also conducted to verify the shock wave feedback phenomenon. Three kinds of measuring methods were used, i.e., pressure probe submerged in water, pressure measurements from the side and front walls of the nozzle devices respectively. The results measured by these methods are in a good agreement. They show that every oscillation of the jets causes a sudden increase of pressure and the average frequency of the shock wave feedback is about 5-10 Hz.

Wide-band underwater acoustic absorption based on locally resonant unit and interpenetrating network structure

The interpenetrating network structure provides an interesting avenue to novel materials. Locally resonant phononic crystal (LRPC) exhibits excellent sound attenuation performance based on the periodical arrangement of sound wave scatters. Combining the LRPC concept and interpenetrating network glassy structure, this paper has developed a new material which can achieve a wide band underwater strong acoustic absorption. Underwater absorption coefficients of different samples were measured by the pulse tube. Measurement results show that the new material possesses excellent underwater acoustic effects in a wide frequency range. Moreover, in order to investigate impacts of locally resonant units, some defects are introduced into the sample. The experimental result and the theoretical calculation both show that locally resonant units being connected to a network structure play an important role in achieving a wide band strong acoustic absorption.

Counterions in polyelectrolyte multilayers: A vehicle for introducing functionalities

Counterions present at the surface of polyelectrolyte multilayers were utilized for the introduction of charged species into the multilayer via ion exchange. A typical polyelectrolyte multilayer film with Na+ counterions in the outermost layer was immersed in an AgNO3 aqueous solution and the rapid ion-exchange process was complete within 1 min. The silver ions thus introduced were then reduced in situ and silver nanoparticles were produced at the surface of the multilayer assembly. This example demonstrates that the counterions naturally occurring in every polyelectrolyte multilayer film can be a convenient vehicle for the introduction of various functionalities to the film.

A moored underwater energy conservation system for profiling measurement

There is a need to obtain the hydrologic data including ocean current, wave, temperature and so on in the South China Sea. A new profiling instrument which does not suffer from the damage due to nature forces or incidents caused by passing ships, is under development to acquire data from this area. This device is based on a taut single point mid-water mooring system. It incorporates a small, instrumented vertically profiling float attached via an electromechanical cable to a winch integral with the main subsurface flotation. On a pre-set schedule, the instrument float with sensors is winched up to the surface if there is no strip passing by, which is defined by an on-board miniature sonar. And it can be immediately winched down to a certain depth if the sonar sensor finds something is coming. Since, because Of logistics, the area can only be visited once for a long time and a minimum of 10 times per day profiles are desired, energy demands are severe. To respond to these concerns, the system has been designed to conserve a substantial portion of the potential energy lost during the ascent phase of each profile and subsequently use this energy to pull the instrument down. Compared with the previous single-point layered measuring mode, it is advanced and economical. At last the paper introduces the test in the South China Sea.

Underwater topography detection of Shuangzi Reefs with SAR images acquired in different time

Imaging mechanism of underwater topography by SAR and a underwater topography SAR detection model built on the theory of underwater topography detection with SAR image presented by Yuan Yeli are used to detect the underwater topography of Shuangzi Reefs in the Nansha Islands with three scenes of SAR images acquired in different time. Detection results of three SAR images are compared with the chart topography and the detection errors are analyzed. Underwater topography detection experiments of Shuangzi Reefs show that the detection model is practicable. The detection results indicate that SAR images acquired in different time also can be used to detect the underwater topography, and the detection results are affected by the ocean conditions in the SAR acquiring time.

基于立体视觉的移动机器人楼梯识别

本文提出了一种结构化环境下,基于立体视觉的机器人楼梯识别算法,并将算法该应到自主移动机器人上。该算法首先利用二维图像分析的方法搜索楼梯的疑似区域;进而利用立体视觉对各个疑似区域进行精确三维重建,结合三维信息重构楼梯平面,排除虚假疑似楼梯区域;最后判定机器人和楼梯的相对位姿关系,引导机器人爬楼梯。最终我们将该算法应用到了自主移动机器人上,通过在各种光照条件下的实验,进一步验证了该算法的准确性和快速性。

基于模糊推理水下作业系统运动控制研究

水下作业系统是运动学冗余系统,本文将模糊推理方法融入基于任务优先运动学控制算法,对系统载体与机械手进行协调运动分配,同时对系统多个任务进行优化。通过带有3自由度水下机械手的水下作业系统进行算例仿真研究,说明运动控制算法的有效性。

一种遥控水下机器人视频监控系统

本文介绍一种应用在遥控水下机器人上的视频传输与监控技术。采用光多路复用器实现水面与水下的数据及视频传输,通过工业以太网实现整个系统的摄像机及灯光控制,并对传输到水面视频信号进行显示、叠加及存储。该技术成功的应用在新开发的遥控水下机器人中,效果良好。

光纤微缆对SARV操纵性的影响分析

以新概念小型自治遥控水下机器人SARV及其光纤微缆系统为研究对象,在对光纤微缆进行受力分析的基础上,采用集中质量法建立了光纤微缆的动力学模型。结合作业中SARV载体的实际运动,利用直接计算法分析了不同运动状态下光纤微缆对SARV载体产生的附加力和附加力矩及其对SARV载体操纵性的影响,并提出了合理的操纵建议。为SARV载体端设计光纤微缆释放装置张力控制提供了一定的理论依据,在一定程度上有助于完善SARV控制系统,提高SARV航行的稳定性。

浮力调节系统在作业型AUV上的应用研究

本文根据我国正在研制开发的作业型水下机器人的特性及其对浮力调节和姿态控制的要求,应用PID控制策略,设计了一个浮力调节系统,仿真结果证明该设计方案可以达到预期的目标。(100039北京市中国科学院研究生院)常海龙

Multi-sensors data acquisition and information fusion for manned submersible vehicle

本文介绍了一种用于载人潜水器的导航传感器的数据采集及信息融合技术。航行控制计算机通过基于工业以太网的数据通信系统对各传感器进行数据采集,采用卡尔曼滤波器完成对各传感器数据信息的融合,以便提高数据的精度和控制系统的性能,并将结果送给监控计算机,用于载人潜水器的姿态显示。

水下机器人多功能作业工具包

本文首先阐述了水下机器人作业工具包的重要性 ,重点研究了水下机械手的原理、功能及两种主要结构 .并以沈阳自动化所研制的缆控水下机器人为背景 ,讨论了水下作业工具包的一些专用工具的原理及其结构

基于超短基线的缆控水下机器人动力定位

动力定位 (DynamicPositioning(DP) )技术是水下机器人的关键技术之一。因此针对当前动力定位主要在缆控水下机器人 (ROV)中应用的情况 ,给出了ROV动力定位技术的实施方法。通过声学定位技术确定ROV的坐标 ,计算出与期望位姿的差 ,将其作为神经网络控制器的输入量来控制ROV ,从而进行动力定位。同时还重点研究了ROV动力定位中的主要研究内容即水声定位技术和定位控制技术的构建。