Rotation and deformation of the dinuclear system formed in dissipative reaction of F-19+Al-27

Excitation functions of the reaction products B, C, N, O, F and Ne emitted from the dissipative reaction of (19) F+(27) Al have been measured at incident energies from 110.25MeV to 118.75MeV in steps of 250keV. The moments of inertia of the intermediate dinuclear system formed in the reaction are extracted from the energy autocorrelation functions of the products. Comparing the moment of inertia extracted from the experimental data with the calculated one by using the sticking limit, it indicates that the formed dinuclear system has a large deformation in the reaction process.

Melting of Au and Al in nanometer Fe/Au and Fe/Al multilayers under swift heavy ions: A thermal spike study

Knowing that Fe is sensitive to swift heavy ion irradiations whereas Au and Al are not, the behavior of nanometric metallic multilayer systems, like [Fe(3 nm)/Au(x)](y) and [Fe(3 nm)/Al(x)](y) with x ranging between 1 and 10 mn, were studied within the inelastic thermal spike model. In addition to the usual cylindrical geometry of energy dissipation perpendicular to the ion projectile direction, the heat transport along the ion path was implemented in the electronic and atomic sub-systems. The simulations were performed using three different values of linear energy transfer corresponding to 3 MeV/u of Pb-208, Xe-132 and Kr-84 ions. For the Fe/Au system, evidence of appearance of a molten phase was found in the entire Au layer, provided the Au thickness is less than 7 nm and 3 nm for Pb and Xe ions, respectively. For the Fe/Al(x) system irradiated with Pb ions, the Al layers with a thickness less than 4 nm melt along the entire ion track. Surprisingly, the Fe layer does not melt if the Al thickness is larger than 2 nm, although the deposited energy surpasses the electronic stopping power threshold of track formation in Fe. For Kr ions melting does not occur in any of the multilayer systems.

Non-reproducibility of the cross sections of the products induced from dissipative reaction of F-19+Al-27

The differential cross sections of the dissipative products B, Q N, O, F, Ne, Na and Mg induced from the reactions of F-19+Al-27 at two incident energies have been measured at the HI-13 tandem accelerator, Beijing. In the case of a fixed beam incident energy 114MeV or 118.75MeV respectively, identical reaction system and the same detection system, 20 target points in steps of 2mm on(.)a 10mmx50mm rectangular Al foil have been bombarded. The experimental results indicate that the probability distribution of the cross sections is much wider than a standard Gaussian distribution. This non-reproducibility of the cross sections can't be interpreted by the statistical property of a finite count rate.

基于激光诱导击穿光谱技术的铝合金成分定量分析；Quantitative analysis of element concentration in Al alloy by using laser-induced breakdown spectroscopy

利用Nd:YAG激光器输出的532nm激光束对位于空气中的标准变形铝合金样品进行烧蚀产生了激光诱导等离子体.对测量的230—440nm波长范围的光谱进行了谱线标定,同时基于自由定标方法对样品成分进行了定量分析,确定了样品中的元素含量.分析结果与标准值具有较好的一致性.

Quantitative analysis analysis of element concentration in Al alloy by using laser-induced breakdown spectroscopy

Laser-induced breakdown plasma is produced by using Q-switched Nd: YAG laser operating at 532 nm, which interacts with the Al alloy sample target in air. The spectral lines in the 230-440 nm wavelength range have been identified, and based on the calibration-free method, the mass concentration of Al alloy are obtained, which is in good agreement with the standard value of the sample.

Measurement of K*(892)(0) and K-0 mesons in Al plus Al collisions at 1.9A GeV

A new measurement of subthreshold K*(892)(0) and K-0 production is presented. The experimental data complete the measurement of strange particles produced in Al + Al collisions at 1.9A GeV measured with the FOPI detector at SIS at GSI (Darmstadt). The K*(892)(0)/K-0 yield ratio is found to be 0.0315 +/- 0.006(stat.) +/- 0.012(syst.) and is in good agreement with the transport model prediction. These measurements provide information on the in-medium cross section of K+-pi(-) fusion, which is the dominant process in subthreshold K*(892)(0) production.

Effect of substrate and annealing on the structural and optical properties of ZnO:Al films

ZnO:Al thin films with c-axis preferred orientation were deposited on glass and Si substrates using RF magnetron sputtering technique. The effect of substrate on the structural and optical properties of ZnO:Al films were investigated. The results showed a strong blue peak from glass-substrate ZnO:Al film whose intensity became weak when deposited on Si substrate. However, the full width at half maxima (FWHM) of the Si-substrate ZnO:Al (0 0 2) peaks decreased evidently and the grain size increased. Finally, we discussed the influence of annealing temperature on the structural and optical properties of Si-substrate ZnO:Al films. After annealing, the crystal quality of Si-substrate ZnO:Al thin films was markedly improved and the intensity of blue peak (similar to 445 nm) increased noticeably. This observation may indicate that the visible emission properties of the ZnO:Al films are dependent more on the film crystallinity than on the film stoichiometry. Crown Copyright (C) 2009 Published by Elsevier Ltd. All rights reserved.

MEASUREMENT OF TWO-PROTON CORRELATION FROM THE BREAK-UP OF Al-23

Experiments of Al-23 and Mg-22 radioactive beams bombarding a C-12 target at an energy of 60 similar to 70 A MeV have been performed at the projectile fragment separator beamline (RIPS) in the RIKEN Ring Cyclotron Facility to study the two-proton emission from Al-23 and Mg-22 excited states, respectively. The trajectorie of the decay products, namely Na-21 + p + p from Al-23 and Ne-20 + p + p from Mg-22, are clean identified. The relative momentum and opening angle between two protons in the rest frame of three body decay channels are obtained by relativistic-kinematics reconstruction. The results demonstrate that there are some di-proton emission components from He-2 cluster for the excited Al-23 and Mg-22.

Au LX射线发射截面和Al、Ti、Ni表面可见、红外光谱测量

本实验工作是在中国原子能科学研究院的HI-13串列加速器国家实验室第二测量厅原子物理实验平台上完成。本工作采用能量为20-50MeV的高电荷态O5+离子去轰击Au, 测量了不同能量下Au的L1、Lα、Lβ、Lγ的X射线谱，计算了不同能量下各条X射线的产生截面，并与ECPSSR理论计算结果进行了比较。实验结果表明σ（Ll）/σ(Lα) 和σ（Lγ）/σ(Lα)与ECPSSR理论计算结果符合比较好，而对于σ（Lβ）/σ(Lα)，在较低能区实验值略高于理论值。在中国科学院近代物理研究所320kV高电荷态离子实验研究平台上测量了Xeq+ (q=17-29)入射Al、Ti和Ni等表面诱发的可见光和红外光。通过对靶原子光谱线的研究，实验发现，随着入射离子的电荷态增高，原子和离子的各种光谱线可得到有效地激发。低速高电荷态离子入射金属固体表面，靶原子的特征谱线的激发强度，与入射离子的电荷态q密切相关。qc的实验测量值和理论计算值符合的较好

TI／AL系统离子束混合研究

本文用100KW Ar~2离子在低温下对Tl/AL薄膜进行了混合束研究。实验试样是在单晶硅上蒸镀约5000A的铝膜，相继再蒸上所需不同厚度的钛膜。用2.0Hev α粒子对注入前后的样品进行了RBS分析。经过仔细的实验数据处理，结果发现：T1／AL界面原子混合量σ~2跟注入剂量φ成线性关系，界面的氧化层对T1／AL界面区原子间的相互混合有一定的影响；在相同注入条件下，界面原子混合σ~2随钛膜厚度的变化成一定的规律。另外，还就Ti/AL离子事混合进行了计算机Nonte Carto模拟计算，并与实验结果进行了比较和讨论

Cr/Al系统的离子束混合

用600kev的kr~+对Cr/Al薄膜系统进行了离子束混合研究。实验样品是在单晶硅上蒸镀约5000 A厚的铝膜，相继再上所需不同厚度的铬膜。Kr~+注入剂量范围在2.0 * 10~(15)～2.5 * 10~(16) kr~+/cm~2之间。用2.0 Mev的α粒子对注入前后的样品进行了背散射分析，发现铝谱的前沿和铬谱的后沿有明显的展宽，且随剂量的增大而加宽，Cr/Al界面原子混合扩展量的平方α~2注入剂量φ成线性关系；当注入剂量大于1.0 * 10~(16) kr~+/cm~2时，铝谱前沿和铬谱的后沿出现有明显的平坦，经理论拟合计算，发现有化合物形成，x射线衍射实验结果证明化合物形式为Al_(13)Cr_2。本文还得到了混合量Q与剂量的线性关系。最后，对混合机制进行了讨论

NOx storage-reduction over Pt/Mg-Al-O catalysts with different Mg/Al atomic ratios

A series of Pt/Mg-Al-O catalysts with different Mg/Al atomic ratios were prepared. The NOx storage capacities of these catalysts were measured by isothermal storage at 350 degreesC. It was found that the NOx storage capacity increased with increasing Mg/Al atomic ratios. The catalytic behaviors of Pt/Mg-Al-O and Pt/MgO were studied with storage-reduction cycles at 400 degreesC. Under oxidizing conditions, NOx concentration in the outlet gas gradually increased with time, which indicated the catalysts could store NOx effectively. After a switch from oxidizing conditions to reducing conditions, NOx desorption peak emerged immediately due to the incomplete reduction of stored NOx, which lowered the total NOx conversion. With increasing Mg/Al atomic ratio in the catalysts, NOx conversion increases. Pt/MgO has the highest NOx conversion because of its best activity in the reduction of NOx by C3H6. It seems that with an increasing amount of MgO in the catalysts, the self-poisoning of Pt-sites by adsorbed species during the reaction of NOx with C3H6 may be inhibited effectively.