MEASUREMENT OF TWO-PROTON CORRELATION FROM THE BREAK-UP OF Al-23

Experiments of Al-23 and Mg-22 radioactive beams bombarding a C-12 target at an energy of 60 similar to 70 A MeV have been performed at the projectile fragment separator beamline (RIPS) in the RIKEN Ring Cyclotron Facility to study the two-proton emission from Al-23 and Mg-22 excited states, respectively. The trajectorie of the decay products, namely Na-21 + p + p from Al-23 and Ne-20 + p + p from Mg-22, are clean identified. The relative momentum and opening angle between two protons in the rest frame of three body decay channels are obtained by relativistic-kinematics reconstruction. The results demonstrate that there are some di-proton emission components from He-2 cluster for the excited Al-23 and Mg-22.

Au LX射线发射截面和Al、Ti、Ni表面可见、红外光谱测量

本实验工作是在中国原子能科学研究院的HI-13串列加速器国家实验室第二测量厅原子物理实验平台上完成。本工作采用能量为20-50MeV的高电荷态O5+离子去轰击Au, 测量了不同能量下Au的L1、Lα、Lβ、Lγ的X射线谱，计算了不同能量下各条X射线的产生截面，并与ECPSSR理论计算结果进行了比较。实验结果表明σ（Ll）/σ(Lα) 和σ（Lγ）/σ(Lα)与ECPSSR理论计算结果符合比较好，而对于σ（Lβ）/σ(Lα)，在较低能区实验值略高于理论值。在中国科学院近代物理研究所320kV高电荷态离子实验研究平台上测量了Xeq+ (q=17-29)入射Al、Ti和Ni等表面诱发的可见光和红外光。通过对靶原子光谱线的研究，实验发现，随着入射离子的电荷态增高，原子和离子的各种光谱线可得到有效地激发。低速高电荷态离子入射金属固体表面，靶原子的特征谱线的激发强度，与入射离子的电荷态q密切相关。qc的实验测量值和理论计算值符合的较好

TI／AL系统离子束混合研究

本文用100KW Ar~2离子在低温下对Tl/AL薄膜进行了混合束研究。实验试样是在单晶硅上蒸镀约5000A的铝膜，相继再蒸上所需不同厚度的钛膜。用2.0Hev α粒子对注入前后的样品进行了RBS分析。经过仔细的实验数据处理，结果发现：T1／AL界面原子混合量σ~2跟注入剂量φ成线性关系，界面的氧化层对T1／AL界面区原子间的相互混合有一定的影响；在相同注入条件下，界面原子混合σ~2随钛膜厚度的变化成一定的规律。另外，还就Ti/AL离子事混合进行了计算机Nonte Carto模拟计算，并与实验结果进行了比较和讨论

Cr/Al系统的离子束混合

用600kev的kr~+对Cr/Al薄膜系统进行了离子束混合研究。实验样品是在单晶硅上蒸镀约5000 A厚的铝膜，相继再上所需不同厚度的铬膜。Kr~+注入剂量范围在2.0 * 10~(15)～2.5 * 10~(16) kr~+/cm~2之间。用2.0 Mev的α粒子对注入前后的样品进行了背散射分析，发现铝谱的前沿和铬谱的后沿有明显的展宽，且随剂量的增大而加宽，Cr/Al界面原子混合扩展量的平方α~2注入剂量φ成线性关系；当注入剂量大于1.0 * 10~(16) kr~+/cm~2时，铝谱前沿和铬谱的后沿出现有明显的平坦，经理论拟合计算，发现有化合物形成，x射线衍射实验结果证明化合物形式为Al_(13)Cr_2。本文还得到了混合量Q与剂量的线性关系。最后，对混合机制进行了讨论

NOx storage-reduction over Pt/Mg-Al-O catalysts with different Mg/Al atomic ratios

A series of Pt/Mg-Al-O catalysts with different Mg/Al atomic ratios were prepared. The NOx storage capacities of these catalysts were measured by isothermal storage at 350 degreesC. It was found that the NOx storage capacity increased with increasing Mg/Al atomic ratios. The catalytic behaviors of Pt/Mg-Al-O and Pt/MgO were studied with storage-reduction cycles at 400 degreesC. Under oxidizing conditions, NOx concentration in the outlet gas gradually increased with time, which indicated the catalysts could store NOx effectively. After a switch from oxidizing conditions to reducing conditions, NOx desorption peak emerged immediately due to the incomplete reduction of stored NOx, which lowered the total NOx conversion. With increasing Mg/Al atomic ratio in the catalysts, NOx conversion increases. Pt/MgO has the highest NOx conversion because of its best activity in the reduction of NOx by C3H6. It seems that with an increasing amount of MgO in the catalysts, the self-poisoning of Pt-sites by adsorbed species during the reaction of NOx with C3H6 may be inhibited effectively.

Direct synthesis of Al-SBA-15 mesoporous materials via hydrolysis-controlled approach

Aluminum-substituted mesoporous SBA-15 (Al-SBA-15) materials were directly synthesized by a hydrolysis-controlled approach in which the hydrolysis of the silicon precursor (tetraethyl orthosilicate, TEOS) is accelerated by fluoride or by using tetramethyl orthosilicate (TMOS) as silicon precursor rather than TEOS. These materials were characterized by powder X-ray diffraction (XRD), N-2 sorption isotherms, TEM, Al-27 MAS NMR, IR spectra of pyridine adsorption, and NH3-TPD. It is found that the matched hydrolysis and condensation rates of silicon and aluminum precursors are important factors to achieve highly ordered mesoporous materials. Al-27 MAS NMR spectra of Al-SBA-15 show that all aluminum species were incorporated into the silica framework for the samples prepared with the addition of fluoride. A two-step approach (sol-gel reaction at low pH followed by crystallization at high pH) was also employed for the synthesis of Al-SBA-15. Studies show that the two-step approach could efficiently avoid the leaching of aluminum from the framework of the material. The calcined Al-SBA-15 materials show highly ordered hexagonal mesostructure and have both Bronsted and Lewis acid sites with medium acidity.

Kinetics of acetic acid esterification with 2-ethoxyethanol over an Al-pillared clay catalyst

The Al-pillared clay catalyst obtained by exposing activated clay powder to sulfuric acid and aluminium salts and calcining in air at 373-673 K, was found to be highly active for the title reaction. The results indicated that pillared layer clay of the mixed oxide has been employed as parent catalysts for their definite structure and special properties which can be modified by the substitution of L and B acid sites cations. Solid acid catalyst of Supported aluminium was found to be highly active and selective at the 373-473 K temperature range for heterogeneous esterification. The activity is mainly attributed to the Lewis (and a considerably small number of Bronsted) acid sites whose number and strength increased due to pillaring. The water produced in the esterification can be induced by Al3+, which makes the catalyst surface to form strong B acid. Their acidities are obtained by pH measurement. If only B acid sites are > 70%, and pH < 1 in the 2-ethoxyethanol, there exists an activity of esterification. The used catalyst gave identical results with that of the fresh one. X-ray diffraction spectra show that the composition and active phase of the used catalysts are the same as the fresh ones. The kinetic study of the reaction was carried out by an integral method of analysis. The kinetic equation of surface esterification is y = 2.36x - 0.98.

腐殖质对白浆土中Fe、Mn、Al形态转化及磷生物有效性的影响

在三江平原布置长期试验，研究连年施用有机肥后土壤腐殖质变化及其对白浆±Fe、Mn、Al形态转化及磷生物有效性的影响。结果表明，施用牛粪后土壤腐殖质含量升高，且以松结态腐殖质的增长为主；土壤的DTPA提取态和有机络合态Fe、Mn、Al含量上升，使土壤有效态磷含量上升。因此，生物措施是治理白浆土，促进土壤磷素养分有效性上升，增大土壤缓冲容量和抗逆性的有效措施。

Electrochemical corrosion behavior of cast Mg-Al-RE-Mn Alloys in NaCl solution

The electrochemical corrosion behavior of Mg-6Al-0.4Mn and Mg-6Al-4RE-0.4Mn (RE = Mischmetal) alloys is investigated in 3.5% NaCl solution. The results of corrosion process, polarization behavior, and electrochemical impedance spectroscopy of the alloys reveal that Mg-6Al-4RE-0.4Mn exhibits enhanced corrosion resistance. The addition of RE stabilizes the solid solution and modifies the passive film through a finer microstructure.