1000 resultados para José de Resende Costa
Resumo:
Aim: Optimise a set of exposure factors, with the lowest effective dose, to delineate spinal curvature with the modified Cobb method in a full spine using computed radiography (CR) for a 5-year-old paediatric anthropomorphic phantom. Methods: Images were acquired by varying a set of parameters: positions (antero-posterior (AP), posteroanterior (PA) and lateral), kilo-voltage peak (kVp) (66-90), source-to-image distance (SID) (150 to 200cm), broad focus and the use of a grid (grid in/out) to analyse the impact on E and image quality (IQ). IQ was analysed applying two approaches: objective [contrast-to-noise-ratio/(CNR] and perceptual, using 5 observers. Monte-Carlo modelling was used for dose estimation. Cohen’s Kappa coefficient was used to calculate inter-observer-variability. The angle was measured using Cobb’s method on lateral projections under different imaging conditions. Results: PA promoted the lowest effective dose (0.013 mSv) compared to AP (0.048 mSv) and lateral (0.025 mSv). The exposure parameters that allowed lower dose were 200cm SID, 90 kVp, broad focus and grid out for paediatrics using an Agfa CR system. Thirty-seven images were assessed for IQ and thirty-two were classified adequate. Cobb angle measurements varied between 16°±2.9 and 19.9°±0.9. Conclusion: Cobb angle measurements can be performed using the lowest dose with a low contrast-tonoise ratio. The variation on measurements for this was ±2.9° and this is within the range of acceptable clinical error without impact on clinical diagnosis. Further work is recommended on improvement to the sample size and a more robust perceptual IQ assessment protocol for observers.
Resumo:
ABSTRACT OBJECTIVE To evaluate clinical evidence on the safety and efficacy of fenproporex for treating obesity. METHODS MEDLINE, LILACS and Cochrane Controlled Trials Register were searched as well as references cited by articles and relevant documents. Two authors independently assessed the studies for inclusion and regarding risk of bias, collected data, and accuracy. Eligible studies were all those placebo-controlled that provided data on the efficacy and safety of Fenproporex to treat obesity. RESULTS Only four controlled studies met the inclusion criteria. One randomized, placebo-controlled trial on Fenproporex was found on electronic databases. Three placebo-controlled studies (in non-indexed journals) were identified by hand-searching. Patients with cardiovascular and other comorbidities were excluded in all studies. Trials lasted from 40 to 364 days and doses ranged from 20 to 33.6 mg/d. All controlled studies found that weight loss among Fenproporex-treated patients was greater than that produced by the placebo, but drug effect was modest. Fenproporex produced additional weight reductions of 4.7 kg (one year), 3.8 kg (six months) and 1.55 kg (two months) in average, in relation to diet and exercise only (three trials). Insomnia, irritability, and anxiety were the most frequently reported side effects in the four studies. CONCLUSIONS There is a paucity of randomized, placebo-controlled trials on Fenproporex and those identified here present major methodological flaws. These studies suggest that Fenproporex is modestly effective in promoting weight loss. Nonetheless, they failed to provide evidence that it reduces obesity-associated morbidity and mortality. Data from these studies are insufficient to determine the risk-benefit profile of Fenproporex. Abuse potential and amphetamine-like adverse effects are causes for concern.
Resumo:
New highly fluorescent calix[4]arene-containing phenylene-alt-ethynylene-3,6- and 2,7-carbazolylene polymers (CALIX-PPE-CBZs) have been synthesized for the first time and their photophysical properties evaluated. Both polymers were obtained in good isolated yields (70-84%), having M-w ranging from 7660-26,700 g mol(-1). It was found that the diethynyl substitution (3,6- or 2,7-) pattern on the carbazole monomers markedly influences the degree of polymerization. The amorphous yellow polymers are freely soluble in several nonprotic organic solvents and have excellent film forming abilities. TG/DSC analysis evidences similar thermal behaviors for both polymers despite their quite different molecular weight distributions and main-chain connectivities (T-g, in the range 83-95 degrees C and decomposition onsets around 270 degrees C). The different conjugation lengths attained by the two polymers dictates much of their photophysical properties. Thus, whereas the fully conjugated CALIX-PPE-2,7-CBZ has its emission maximum at 430 nm (E-g = 2.84 eV; Phi(F) = 0.62, CHCl3), the 3,6-linked counterpart (CALIX-PPE-3,6-CBZ) fluoresces at 403 nm with a significant lower quantum yield (E-g = 3.06 eV; Phi(F) = 0.31, CHCl3). The optical properties of both polymers are predominantly governed by the intrachain electronic properties of the conjugated backbones owing to the presence of calix[4]arenes along the polymer chain which disfavor significant interchain interactions, either in fluid- or solid-state.
Resumo:
Dissertação apresentada na Faculdade de Ciências e Tecnologia da Universidade Nova de Lisboa para obtenção do Grau de Mestre em Ecologia, Gestão e Modelação dos Recursos Marinhos
Resumo:
The most important processes for the creation of S12+ to S14+ ions excited states from the ground configurations of S9+ to S14+ ions in an electron cyclotron resonance ion source, leading to the emission of K X-ray lines, are studied. Theoretical values for inner-shell excitation and ionization cross sections, including double KL and triple KLL ionization, transition probabilities and energies for the deexcitation processes, are calculated in the framework of the multi-configuration Dirac-Fock method. With reasonable assumptions about the electron energy distribution, a theoretical K$\alpha$ X-ray spectrum is obtained, which is compared to recent experimental data.
Resumo:
This study is primarily focused in establishing the solid-state sensory abilities of several luminescent polymeric calix[4]arene-based materials toward selected nitroaromatic compounds (NACs), creating the foundations for their future application as high performance materials for detection of high explosives. The phenylene ethynylene-type polymers possessing bis-calix[4]arene scaffolds in their core were designed to take advantage of the known recognition abilities of calixarene compounds toward neutral guests, particularly in solid-state, therefore providing enhanced sensitivity and selectivity in the sensing of a given analyte. It was found that all the calix[4]arene-poly(para-phenylene ethynylene)s here reported displayed high sensitivities toward the detection of nitrobenzene, 2,4-dinitrotoluene and 2,4,6-trinitrotoluene (TNT). Particularly effective and significant was the response of the films (25-60 nm of thickness) upon exposure to TNT vapor (10 ppb): over 50% of fluorescence quenching was achieved in only 10 s. In contrast, a model polymer lacking the calixarene units showed only reduced quenching activity for the same set of analytes, clearly highlighting the relevance of the macrocyclics in promoting the signaling of the transduction event. The films exhibited high photostability (less than 0.5% loss of fluorescence intensity up to 15 min of continuous irradiation) and the fluorescence quenching sensitivity could be fully recovered after exposure of the quenched films to saturated vapors of hydrazine (the initial fluorescence intensities were usually recovered within 2-5 min of exposure to hydrazine).
Resumo:
New sensory materials based on p-phenylene ethynylene trimers integrating calix[4]arene receptors (CALIX-PET) and tert-butylphenol (TBP-PET) moieties have been synthesized and their sensitivity and selectivity for the detection of nitroaromatic compounds (NACs) such as nitrobenzene (NB), 2,4-dinitrotoluene (2,4-DNT), 2,4,6-trinitrotoluene (TNT) and picric acid (PA) investigated in fluid phase and solid-state. It was found that both fluorophores displayed high sensitivities toward NACs detection in solution as evaluated by the Stern-Volmer formalism. For all the tested explosives, the ratio of fluorescence intensities (F-0/F) is a linear function of the quencher concentration only after appropriate correction of fluorescence quenching data for inner-filter effects. The quenching efficiencies for CALIX-PET and TBP-PET follow the order PA >> TNT > DNT > NB, which correlate well with the quenchers electron affinities as evaluated from their LUMOs energies thereby suggesting a photoinduced electron transfer as the dominant mechanism of fluorescence quenching. The selectivity of these sensors was checked against exemplar interferents possessing differentiated electronic properties (benzoic acid, 2,4-dichlorophenol and benzoquinone) and reduced quenching activity was detected. The quenching efficiencies and response times of the two fluorophores in the solid-state toward NB, 2,4-DNT and TNT vapors were evaluated through steady-state fluorescence quenching experiments with the materials dispersed in polymeric matrices or as neat films. The most significant fluorescence quenching responses were achieved for drop-casted films of TBP-PET upon exposure to nitroaromatics.
Resumo:
Este trabalho teve como principal objectivo optimizar um equipamento de produção de perfis pultrudidos já existente na empresa ALTO – PERFIS PULTRUDIDOS, Lda. O trabalho surgiu na sequência de um Projecto financiado pelo Programa QREN – Quadro de Referência Estratégico Nacional, determinadas debilidades identificadas no processo de pultrusão, principalmente ao nível da eficiência térmica na fieira e de alguma falta de produtividade devida às diversas operações necessárias à mudança da fieira consoante o tipo de perfil a produzir. Após um levantamento prévio da situação e uma adequada segmentação da máquina nas diferentes partes que a constituem e que contribuem activamente para o processo de produção dos perfis, foi elaborada uma lista de prioridades e foram sendo procuradas as soluções mais adequadas para cada caso, sempre com a participação activa da empresa, com vista à sua implementação final. A metodologia adoptada passou sempre por uma reunião inicial com os representantes da empresa e com os orientadores, efectuando-se a tradicional “tempestade de ideias”. Depois da correspondente maturação, desenvolvimento e aprovação prévia, por parte da empresa, as ideias foram desenvolvidas e até implementadas na sua maioria. O saldo poderá considerar-se extremamente positivo, tanto para a empresa que, ao implementar as soluções, as validou e ganhou competitividade, como para as pessoas envolvidas neste projecto, através da enorme aprendizagem adquirida.
Resumo:
Se determinó el grado de infección de los crustáceos Ptychophallus tristani presentes en una área endémica de Paragonimus mexicanus, encontrándose que de un total de 182 cangrejos, 161 resultaron positivos (88,5%) por metacercarias. Al comparar la infección entre machos y hembras no se encontró diferencias estadísticamente significativas y en relación a su tamaño se observó una relación directa entre tamaño y porcentaje y grado de infección. Se estableció que no existen diferencias significativas en relación a la época del año en que los cangrejos fueron capturados lo que epidemiológicamente es importante pues indica que las fuentes de infección permanecen potencialmente activas durante todo el año.
Resumo:
Dissertação apresentada na Faculdade de Ciências e Tecnologia da Universidade Nova de Lisboa para a obtenção do grau de Mestre em Engenharia Electrotécnica e de Computadores
Resumo:
Projeto de Intervenção apresentado à Escola Superior de Educação de Lisboa para obtenção do grau de Mestre em Didática da Língua Portuguesa no 1.º e 2.º Ciclos do Ensino Básico
Resumo:
Web-based course management and delivery is regarded by many institutions as a key factor in an increasingly competitive education and training world, but the systems currently available are largely unsatisfactory in terms of supporting collaborative work and access to practical science facilities. These limitations are less important in areas where “pen-and-paper” courseware is the mainstream, but become unacceptably restrictive when student assignments require real-time teamwork and access to laboratory equipment. This paper presents a web-accessible workbench for electronics design and test, which was developed in the scope of an European IST project entitled PEARL, with the aim of supporting two main features: full web access and collaborative learning facilities.
Resumo:
Congrès de l’Association de Sociologues de Langue Française, Comité de Recherche n° 21 « Transactions Sociales », Istambul