981 resultados para Sequence-dependent setup times
Resumo:
Concepts such as righteousness, equality, tolerance and freedom are nowadays considered fundamental issues that should prevail in any society. Balance and righteousness thrive however on a very thin layer. We are, in fact, living in an era of duality and antithetical paradigms. This essay approaches two Renaissance authors who dealt with the same matters in their works, at a very different time and through different ways of reflection: Thomas More and Sir Walter Raleigh.
Resumo:
This paper is on the problem of short-term hydro scheduling (STHS), particularly concerning head-dependent reservoirs under competitive environment. We propose a novel method, based on mixed-integer nonlinear programming (MINLP), for optimising power generation efficiency. This method considers hydroelectric power generation as a nonlinear function of water discharge and of the head. The main contribution of this paper is that discharge ramping constraints and start/stop of units are also considered, in order to obtain more realistic and feasible results. The proposed method has been applied successfully to solve two case studies based on Portuguese cascaded hydro systems, providing a higher profit at an acceptable computation time in comparison with classical optimisation methods based on mixed-integer linear programming (MILP).
Resumo:
This paper is on the problem of short-term hydro scheduling (STHS), particularly concerning a head-dependent hydro chain We propose a novel mixed-integer nonlinear programming (MINLP) approach, considering hydroelectric power generation as a nonlinear function of water discharge and of the head. As a new contribution to eat her studies, we model the on-off behavior of the hydro plants using integer variables, in order to avoid water discharges at forbidden areas Thus, an enhanced STHS is provided due to the more realistic modeling presented in this paper Our approach has been applied successfully to solve a test case based on one of the Portuguese cascaded hydro systems with a negligible computational time requirement.
Resumo:
This paper is an elaboration of the DECA algorithm [1] to blindly unmix hyperspectral data. The underlying mixing model is linear, meaning that each pixel is a linear mixture of the endmembers signatures weighted by the correspondent abundance fractions. The proposed method, as DECA, is tailored to highly mixed mixtures in which the geometric based approaches fail to identify the simplex of minimum volume enclosing the observed spectral vectors. We resort then to a statitistical framework, where the abundance fractions are modeled as mixtures of Dirichlet densities, thus enforcing the constraints on abundance fractions imposed by the acquisition process, namely non-negativity and constant sum. With respect to DECA, we introduce two improvements: 1) the number of Dirichlet modes are inferred based on the minimum description length (MDL) principle; 2) The generalized expectation maximization (GEM) algorithm we adopt to infer the model parameters is improved by using alternating minimization and augmented Lagrangian methods to compute the mixing matrix. The effectiveness of the proposed algorithm is illustrated with simulated and read data.
Resumo:
Este Trabalho refere-se ao Projecto de Execução de Fundações e Estruturas de uma Ponte Rodoviária em betão armado pré-esforçado, realizado no âmbito do Trabalho Final de Mestrado em Engenharia Civil – Especialização em Estruturas, do Instituto Superior de Engenharia de Lisboa. O Projecto de Execução é composto de Peças Escritas e Peças Desenhadas. Nas Peças Escritas estão incluídos: Memória Justificativa e Descritiva; Cálculos Justificativos e Anexos. A ponte é composta por dois tabuleiros paralelos com 10,28m de largura cada um e afastados entre si de 0,10m. A obra é constituída de 8 tramos; os tramos correntes com 31m de comprimento e os tramos extremos com 25 e 20m de comprimento, perfazendo um comprimento total de 231m. A obra foi parcialmente isolada dos sismos pela introdução, em todos os pilares, de aparelhos de apoio de elevado amortecimento sísmico do tipo HDRB (High Damping Rubber Bearings). Encontram-se particularmente discriminadas e detalhadas neste projecto as seguintes situações: - Cálculo do Pré-esforço e respectivas perdas; - Acção das sobrecargas rodoviárias; - Diferença de comportamento da obra na entrada em serviço e no longo prazo; - Análise sísmica e do isolamento sísmico; - Estudo dos efeitos diferidos: retracção e fluência. Tendo as abordagens de cálculo e as verificações de segurança seguido a regulamentação nacional em vigor, nomeadamente RSA e REBAP, foi no entanto feita uma aproximação às regras do “Capacity Design” previstas no EC8, em que se privilegia a actuação do projectista sobre o comportamento da estrutura, procurando uma resposta não linear da mesma, visando garantir que: - A rotura não ocorrerá nos elementos de fundação; - Nos pilares a dissipação de energia se faz através de rótulas plásticas, evitando-se roturas associadas a esforços transversos. A aplicação destas regras neste Projecto demonstrou haver um agravamento substancial na definição dos esforços a que devem resistir alguns dos componentes da estrutura, designadamente os pilares e as fundações, originando soluções de secções de betão e armaduras bem mais exigentes do que aqueles que resultariam da simples verificação de segurança, pela comparação entre esforços actuante e esforços resistentes “secção a secção”, imposta pela actual regulamentação nacional.
Resumo:
O objectivo pretendido alcançar é o de obter uma redução nos consumos de energia eléctrica do Município de Vila Franca de Xira, recorrendo à URE. Esta URE consiste num conjunto de acções e/ou medidas e/ou procedimentos e/ou equipamentos cuja aplicação tem como fim, o de potenciar uma utilização e uma gestão mais racional e rentável da energia - daí se podendo dizer, cada vez mais, que a mesma é um factor essencial de economia energética, logo, de redução de custos. A aplicação destas acções e/ou medidas e/ou procedimentos e/ou equipamentos deverá, por isso, ser extensível aos Municípios, com o fim de fazer reduzir uma factura energética de grande peso e significado, a qual, em tempos que são de profunda crise económica, pode tornar problemático ou até mesmo hipotecar, o respectivo futuro. Assim e se por um lado existe no Município um conjunto alargado de situações estabelecidas sem critérios de racionabilidade energética e ás quais, todavia, é já possível fazer aplicar essas acções e/ou medidas e/ou procedimentos e/ou equipamentos de URE, por outro lado, é daí garantido que se poderá alcançar a pretendida redução dos consumos energéticos do Município, sempre assegurando e mantendo o conforto e a produtividade das actividades dependentes dessa energia. Com esse objectivo e partindo da análise de um conjunto de instalações e/ou equipamentos já existentes ou com possibilidades de virem a ser estabelecidas/os pelo Município, é pretendido definir, estudar e classificar, um conjunto de dados que tendam a desenvolver, potenciar e justificar a decisão da sua aplicação. Um conjunto alargado de exemplos práticos ou Casos de Estudo serão desenvolvidos, tentando chegar a conclusões sobre a viabilidade económica das soluções apresentadas e, daí, da decisão da oportunidade da execução do conjunto de trabalhos inerentes à aplicação desse tipo de situação.
Resumo:
This paper is on the problem of short-term hydro, scheduling, particularly concerning head-dependent cascaded hydro systems. We propose a novel mixed-integer quadratic programming approach, considering not only head-dependency, but also discontinuous operating regions and discharge ramping constraints. Thus, an enhanced short-term hydro scheduling is provided due to the more realistic modeling presented in this paper. Numerical results from two case studies, based on Portuguese cascaded hydro systems, illustrate the proficiency of the proposed approach.
Resumo:
A series of large area single layers and heterojunction cells in the assembly glass/ZnO:Al/p (SixC1-x:H)/i (Si:H)/n (SixC1-x:H)/Al (0
Resumo:
A series of large area single layers and glass/ZnO:AVp(SixC1-x:H)/i(Si:H)/n(SixC1-x:H)/AI (0 < x < 1) heterojunction cells were produced by plasma-enhanced chemical vapour deposition (PE-CVD) at low temperature. Junction properties, carrier transport and photogeneration are investigated from dark and illuminated current-voltage (J-V) and capacitance-voltage (C-V) characteristics. For the heterojunction cells atypical J-V characteristics under different illumination conditions are observed leading to poor fill factors. High series resistances around 106 Q are also measured. These experimental results were used as a basis for the numerical simulation of the energy band diagram, and the electrical field distribution of the structures. Further comparison with the sensor performance gave satisfactory agreement. Results show that the conduction band offset is the most limiting parameter for the optimal collection of the photogenerated carriers. As the optical gap increases and the conductivity of the doped layers decreases, the transport mechanism changes from a drift to a diffusion-limited process.
Resumo:
OBJECTIVE: Describe the overall transmission of malaria through a compartmental model, considering the human host and mosquito vector. METHODS: A mathematical model was developed based on the following parameters: human host immunity, assuming the existence of acquired immunity and immunological memory, which boosts the protective response upon reinfection; mosquito vector, taking into account that the average period of development from egg to adult mosquito and the extrinsic incubation period of parasites (transformation of infected but non-infectious mosquitoes into infectious mosquitoes) are dependent on the ambient temperature. RESULTS: The steady state equilibrium values obtained with the model allowed the calculation of the basic reproduction ratio in terms of the model's parameters. CONCLUSIONS: The model allowed the calculation of the basic reproduction ratio, one of the most important epidemiological variables.
Resumo:
Objetivo: avaliar as modificações ocorridas no âmbito da sequência de ativação o da sinergia extensora do MS e na sua influência sobre a capacidade de placing do polegar face à aplicação de um programa de intervenção em fisioterapia. Pretendeu-se também verificar as repercussões ao nível da participação dos indivíduos nas AVD`s. Metodologia: esta série de estudos de casos foi constituída por dois indivíduos com modificações nas componentes neuromotoras de movimento após AVE predominantes no MS. A avaliação dois indivíduos foi realizada em dois momentos PRE e POST separados por um período de intervenção de cerca de quinze semanas. Em cada momento de avaliação foi aplicada a F-MAMR, foi recolhido sinal electromiográfico dos músculos GD, DP, TLONG, TLAT e ABDPOL durante o movimento de alcance e usaram-se seis itens da CIF selecionadas de acordo com as necessidades sentidas. No momento PRE aplicou-se a MMSE para detetar défices cognitivos que interferissem com o processo de avaliação e de intervenção. O programa de intervenção foi individualizado e devidamente ajustado aos indivíduos, procurando que estes mantivessem um papel ativo durante a reabilitação. Esta foi realizada com a frequência de três vezes por semana e cada sessão teve cerca de quarenta e cinco minutos de trabalho ativo. Resultados: encontraram-se modificações na sequência de ativação muscular nos dois indivíduos e entre os indivíduos nos dois momentos de avaliação, nomeadamente no tempo de ativação muscular. O ABDPOL modificou o tempo em que iniciou atividade muscular e passou a recrutar atividade quase simultaneamente ao início do movimento da mão, verificando-se uma influência positiva da sinergia extensora do MS na capacidade de placing do polegar. Verificaram-se resultados positivos no estado sensório-motor do MS e na capacidade do indivíduo em participar em diversas AVD`s selecionadas de acordo com as necessidades. Conclusão: este estudo parece apontar para uma influência positiva nas modificações do nível de atividade da sinergia extensora do MS e na influência desta sobre a capacidade de placing do polegar durante o movimento de alcance, face a um programa de intervenção. Este estudo parece apontar também para uma influência positiva sobre a capacidade do indivíduo em participar em AVD`s selecionadas para a avaliação de acordo com necessidades sentidas.
Resumo:
Background: With the decrease of DNA sequencing costs, sequence-based typing methods are rapidly becoming the gold standard for epidemiological surveillance. These methods provide reproducible and comparable results needed for a global scale bacterial population analysis, while retaining their usefulness for local epidemiological surveys. Online databases that collect the generated allelic profiles and associated epidemiological data are available but this wealth of data remains underused and are frequently poorly annotated since no user-friendly tool exists to analyze and explore it. Results: PHYLOViZ is platform independent Java software that allows the integrated analysis of sequence-based typing methods, including SNP data generated from whole genome sequence approaches, and associated epidemiological data. goeBURST and its Minimum Spanning Tree expansion are used for visualizing the possible evolutionary relationships between isolates. The results can be displayed as an annotated graph overlaying the query results of any other epidemiological data available. Conclusions: PHYLOViZ is a user-friendly software that allows the combined analysis of multiple data sources for microbial epidemiological and population studies. It is freely available at http://www.phyloviz.net.
Resumo:
O documento em anexo encontra-se na versão post-print (versão corrigida pelo editor).
Resumo:
We study a model consisting of particles with dissimilar bonding sites ("patches"), which exhibits self-assembly into chains connected by Y-junctions, and investigate its phase behaviour by both simulations and theory. We show that, as the energy cost epsilon(j) of forming Y-junctions increases, the extent of the liquid-vapour coexistence region at lower temperatures and densities is reduced. The phase diagram thus acquires a characteristic "pinched" shape in which the liquid branch density decreases as the temperature is lowered. To our knowledge, this is the first model in which the predicted topological phase transition between a fluid composed of short chains and a fluid rich in Y-junctions is actually observed. Above a certain threshold for epsilon(j), condensation ceases to exist because the entropy gain of forming Y-junctions can no longer offset their energy cost. We also show that the properties of these phase diagrams can be understood in terms of a temperature-dependent effective valence of the patchy particles. (C) 2011 American Institute of Physics. [doi: 10.1063/1.3605703]
Resumo:
Electricity markets are complex environments, involving a large number of different entities, playing in a dynamic scene to obtain the best advantages and profits. MASCEM is a multi-agent electricity market simulator to model market players and simulate their operation in the market. Market players are entities with specific characteristics and objectives, making their decisions and interacting with other players. MASCEM provides several dynamic strategies for agents’ behavior. This paper presents a method that aims to provide market players with strategic bidding capabilities, allowing them to obtain the higher possible gains out of the market. This method uses a reinforcement learning algorithm to learn from experience how to choose the best from a set of possible bids. These bids are defined accordingly to the cost function that each producer presents.