Modeling bus rapid transit station bus queuing for operational analysis

This paper presents mathematical models for BRT station operation, calibrated using microscopic simulation modelling. Models are presented for station capacity and bus queue length. No reliable model presently exists to estimate bus queue length. The proposed bus queue model is analogous to an unsignalized intersection queuing model.

How transit route passenger load and distance can together influence quality of service

This paper investigates quality of service and resource productivity implications of transit route passenger loading and travel distance. Weekday Automatic Fare Collection data for a premium radial bus route in Brisbane, Australia, is used to investigate correlation between load factor and distance factor. Relationships between boardings and transit work indicate that distance factor generally increases with load factor. Time series analysis is then presented by examining each direction on an hour by hour basis. Inbound correlation is medium to strong across the entire span of service and strong for daytime services up to 19:30, while outbound correlation is strong across the entire span. Passengers tend to be making longer distance, peak direction commuter trips under the least comfortable conditions under stretched peak schedules than off-peak. Therefore productivity gains may be possible by adjusting fleet utilization during off-peak times. Weekday profiles by direction are established for a composite load-distance factor. A threshold corresponding to standing passengers on the Maximum Load Segment reveals that on-board loading and travel distance combined are more severe during the morning inbound peak than evening outbound peak, although the sharpness of the former suggests that encouraging shoulder peak travel during the morning would be more effective than evening peak. Further research suggested includes: consideration of travel duration factor, relating noise within hour to Peak Hour Factor, profiling load-distance factor across a range of case studies, and relating load-distance factor threshold to line length.

Modeling Bus Rapid Transit station bus queuing for Bus Rapid Transit station bus operation analysis

Stations on Bus Rapid Transit (BRT) lines ordinarily control line capacity because they act as bottlenecks. At stations with passing lanes, congestion may occur when buses maneuvering into and out of the platform stopping lane interfere with bus flow, or when a queue of buses forms upstream of the station blocking inflow. We contend that, as bus inflow to the station area approaches capacity, queuing will become excessive in a manner similar to operation of a minor movement on an unsignalized intersection. This analogy is used to treat BRT station operation and to analyze the relationship between station queuing and capacity. In the first of three stages, we conducted microscopic simulation modeling to study and analyze operating characteristics of the station under near steady state conditions through output variables of capacity, degree of saturation and queuing. A mathematical model was then developed to estimate the relationship between average queue and degree of saturation and calibrated for a specified range of controlled scenarios of mean and coefficient of variation of dwell time. Finally, simulation results were calibrated and validated.

Transit passenger segmentation using travel regularity mined from Smart Card transactions data

Transit passenger market segmentation enables transit operators to target different classes of transit users to provide customized information and services. The Smart Card (SC) data, from Automated Fare Collection system, facilitates the understanding of multiday travel regularity of transit passengers, and can be used to segment them into identifiable classes of similar behaviors and needs. However, the use of SC data for market segmentation has attracted very limited attention in the literature. This paper proposes a novel methodology for mining spatial and temporal travel regularity from each individual passenger’s historical SC transactions and segments them into four segments of transit users. After reconstructing the travel itineraries from historical SC transactions, the paper adopts the Density-Based Spatial Clustering of Application with Noise (DBSCAN) algorithm to mine travel regularity of each SC user. The travel regularity is then used to segment SC users by an a priori market segmentation approach. The methodology proposed in this paper assists transit operators to understand their passengers and provide them oriented information and services.

Patterns of social capital associated with transit oriented development

In policy circles, transit oriented development (TOD) is believed to enhance social capital, however empirical evidence of this relationship is lacking. This research compares levels of social capital between TOD vs. non-TOD areas in Brisbane, Australia. Using a Two Step cluster analysis technique, three types of neighbourhood groupings were identified based on net employment density, net residential density, land use diversity, intersection density, and public transport accessibility: TODs, transit adjacent development (TADs) and traditional suburbs. Two dimensions of social capital were measured (trust and reciprocity, connections with neighbours) based on factor analysis of eight items representing elements of social capital. Multivariate regression analyses were conducted to identify links between the distributions of the dimensions of social capital on areas defined as TODs, TADs, and traditional suburbs controlling for socio-demographics and environmental factors. Results show that individuals living in TODs had a significantly higher level of trust and reciprocity and connections with neighbours compared with residents of TADs. It appears that TODs may foster the development of social sustainability.

High-load transit line passenger transmission and productiveness efficiencies

Performance of urban transit systems may be quantified and assessed using transit capacity and productive capacity in planning, design and operational management activities. Bunker (4) defines important productive performance measures of an individual transit service and transit line, which are extended in this paper to quantify efficiency and operating fashion of transit services and lines. Comparison of a hypothetical bus line’s operation during a morning peak hour and daytime hour demonstrates the usefulness of productiveness efficiency and passenger transmission efficiency, passenger churn and average proportion line length traveled to the operator in understanding their services’ and lines’ productive performance, operating characteristics, and quality of service. Productiveness efficiency can flag potential pass-up activity under high load conditions, as well as ineffective resource deployment. Proportion line length traveled can directly measure operating fashion. These measures can be used to compare between lines/routes and, within a given line, various operating scenarios and time horizons to target improvements. The next research stage is investigating within-line variation using smart card passenger data and field observation of pass-ups. Insights will be used to further develop practical guidance to operators.

A deconvolution method for deriving the transit time spectrum for ultrasound propagation through cancellous bone replica models

The acceptance of broadband ultrasound attenuation for the assessment of osteoporosis suffers from a limited understanding of ultrasound wave propagation through cancellous bone. It has recently been proposed that the ultrasound wave propagation can be described by a concept of parallel sonic rays. This concept approximates the detected transmission signal to be the superposition of all sonic rays that travel directly from transmitting to receiving transducer. The transit time of each ray is defined by the proportion of bone and marrow propagated. An ultrasound transit time spectrum describes the proportion of sonic rays having a particular transit time, effectively describing lateral inhomogeneity of transit times over the surface of the receiving ultrasound transducer. The aim of this study was to provide a proof of concept that a transit time spectrum may be derived from digital deconvolution of input and output ultrasound signals. We have applied the active-set method deconvolution algorithm to determine the ultrasound transit time spectra in the three orthogonal directions of four cancellous bone replica samples and have compared experimental data with the prediction from the computer simulation. The agreement between experimental and predicted ultrasound transit time spectrum analyses derived from Bland–Altman analysis ranged from 92% to 99%, thereby supporting the concept of parallel sonic rays for ultrasound propagation in cancellous bone. In addition to further validation of the parallel sonic ray concept, this technique offers the opportunity to consider quantitative characterisation of the material and structural properties of cancellous bone, not previously available utilising ultrasound.

Using pulse transit delay in Z-scan to discriminate between excited-state absorption and other nonlinear processes in ZnO nanocones

We report a new approach that uses the single beam Z-scan technique, to discriminate between excited state absorption (ESA) and two and three photon nonlinear absorption. By measuring the apparent delay or advance of the pulse in reaching the detector, the nonlinear absorption can be unambiguously identified as either instantaneous or transient. The simple method does not require a large range of input fluences or sophisticated pulse-probe experimental apparatus. The technique is easily extended to any absorption process dependent on pulse width and to nonlinear refraction measurements. We demonstrate in particular, that the large nonlinear absorption in ZnO nanocones when exposed to nanosecond 532 nm pulses, is due mostly to ESA, not pure two-photon absorption.

Investigating the link between transit oriented development and sustainable travel behavior in Brisbane : a case-control study

The purpose of this research is to empirically test the prevailing view that transit oriented development enhances the use of more sustainable modes of transport using Brisbane, Australia as a case. Transit oriented development has been adopted as a new policy tool to reduce car-based travel worldwide. Despite being a billion dollar investment, the impacts of transit oriented development on promoting sustainable travel behavior is not conclusive. The research uses a case-control approach to empirically investigate this relationship based on travel behavior data collected from 88 individuals living in two contrasting neighborhoods in Brisbane: Kelvin Grove Urban Village – a transit oriented development, and Annerley – a traditional suburb (non-transit oriented development). A comparative investigation of travel behavior was subsequently conducted using distance travelled by modes and purposes between the neighborhoods. Results show that the availability of opportunity and services located within the transit oriented development reduces the car use by 5% and increases the use of active transport by 4%. The findings in this research support the implementation of TOD policies in Brisbane.

Do dissonants in transit oriented development adjust commuting travel behaviour?

Residential dissonance signifies a mismatch between an individual’s preferred and actual proximal land use patterns in residential neighbourhoods, whereas residential consonance signifies agreement between actual and preferred proximal land uses. Residential dissonance is a relatively unexplored theme in the literature, yet it acts as a barrier to the development of sustainable transport and land use policy. This research identifies mode choice behaviour of four groups living in transit oriented development (TOD) and non-TOD areas in Brisbane, Australia using panel data from 2675 commuters: TOD consonants, TOD dissonants, non-TOD consonants, and non-TOD dissonants. The research investigates a hypothetical understanding that dissonants adjust their travel attitudes and perceptions according to their surrounding land uses over time. The adjustment process was examined by comparing the commuting mode choice behaviour of dissonants between 2009 and 2011. Six binary logistic regression models were estimated, one for each of the three modes considered (e.g. public transport, active transport, and car) and one for each of the 2009 and 2011 waves. Results indicate that TOD dissonants and non-TOD consonants were less likely to use the public transport and active transport; and more likely to use the car compared with TOD consonants. Non-TOD dissonants use public transport and active transport equally to TOD consonants. The results suggest that commuting mode choice behaviour is largely determined by travel attitudes than built environment factors; however, the latter influence public transport and car use propensity. This research also supports the view that dissonants adjust their attitudes to surrounding land uses, but very slowly. Both place (e.g. TOD development) and people-based (e.g. motivational) policies are needed for an effective travel behavioural shift.

Workers' attitude towards bus rapid transit : considering Dhaka, Bangladesh

The Government of Bangladesh is planning to develop and implement Bus Rapid Transit (BRT) in Dhaka city. This paper presents a stated choice survey conducted to understand workers’ attitudes toward BRT in Dhaka. The survey data are analysed using a multinomial logit (MNL) model to scrutinize social and economic factors’ impact on participant’s mode choices. Analysis results reveal that males, and workers with higher age, education qualification, and income have greater tendency towards choosing BRT.

Workers' attitude towards bus rapid transit in Dhaka, Bangladesh

This study investigates: –how travel and socio-demographic attributes act on workers’ mode choice decisions in Dhaka –whether Dhaka’s commuters would choose BRT for their work trip once implemented •Very limited research exists on users’ perceptions of BRT in developing countries’ megacities •We adopted a discrete choice modelling approach •As BRT has not yet been implemented in Dhaka, we collected Stated Choice (SC) survey data including a hypothetical BRT mode to understand factors important to workers’ mode choice decisions •We compare the impact of travel factors between Dhaka and cities of developed countries